Multi-wavelength erbium-doped fiber ring laser based on wavelength-dependent polarization rotation with a phase modulator and an in-line comb filter

A stable room-temperature multi-wavelength erbium-doped fiber ring laser has been proposed and investigated experimentally. A phase modulator composed of a piece of fiber wrapped around a cylindrical piezoelectric transducer is used to suppress the mode competition. And the combined action between optical fiber and polarization-dependent isolator provides the wavelength-dependent loss induced by wavelength-dependent polarization rotation mechanism to flatten the output spectrum, tune the locations and improve the number of the lasing lines. Stable multi-wavelength lasing with wavelengths up to 23 and the wavelength spacing of 0.4 nm is demonstrated. Moreover, the pulse train output was also observed.     

Tunable single-longitudinal-mode Ytterbium all fiber laser with saturable-absorber-based auto-tracking filter

A broadband tunable, single-longitudinal-mode (SLM) Ytterbium fiber laser with unpumped Ytterbium-doped Sagnac loop is proposed and demonstrated experimentally. The unpumped Ytterbium-doped Sagnac loop is employed as a saturable absorber based auto-tracking filter to ensure single-longitudinal-mode oscillation. And a tunable band pass optical filter with large tuning range is applied to achieve broadband tuning ability. With 1-m Ytterbium-doped fiber as the gain medium, the SLM operation is achieved with over 60-nm wavelength tuning range at 160-mW pump power. The laser is very stable with output power of about 3 dBm and optical signal to noise ratio of higher than 50 dB in all the 60-nm tuning range.     

Dual-wavelength narrow-linewidth fiber laser based on F-P fiber ring filter

A dual-wavelength fiber laser with a narrow-linewidth, based on a P-F fiber filter has been proposed. Polarization-maintaining fiber Bragg grating (PM-FBG) and a F-P fiber filter are introduced based on the traditional fiber laser. PM-FBG is used as the wavelength selection device. The fiber F-P filter consists of two optical couplers and a section of un-pumped erbium-doped fiber (EDF). Due to the delay of cavity and the loss generated by the EDF, the filter has comb spectral response. The incorporation of the fiber F-P filter leads to the suppression of undesirable modes. At the room temperature, under 980 nm LD pumped, the maximum output of the two wavelengths is respectively ?2.259 dBm and 0.568 dBm, with the 3-dB bandwidth separately 0.1 nm and 0.14 nm, realizing the narrow linewidth and dual-wavelength output.     

Multiwavelength Brillouin-erbium fiber laser incorporating a fiber Bragg grating filter

In this paper, we demonstrate a multiwavelength Brillouin erbium fiber laser in a Fabry-Perot cavity. The design utilized a bidirectional oscillation provided by a fiber Bragg grating filter and a fiber loop mirror at each end of the laser cavity. A stable operation of 25 Brillouin-Stokes lines was obtained at around a 1559-nm band.     

Miniature in-line photonic crystal fiber etalon fabricated by 157 nm laser micromachining

A miniature in-line fiber-optic Fabry-Perot etalon is fabricated on a photonic crystal fiber (PCF) by using 157 nm laser micromachining for the first time to our knowledge. Experimental results show that such a PCF-based etalon has an excellent fringe visibility of up to approximately 26 dB due to the mirror-finish quality of the two cavity surfaces inside the PCF. This etalon can be used as an ideal sensor for precise strain measurement under high temperature of up to 800 degrees C. It can also offer some other outstanding advantages, such as fast and easy fabrication, high reproducibility, capacity of mass production, low cost, low temperature-strain cross-sensitivity, and high signal-to-noise ratio.     

Tunable erbium doped fiber ring laser using fiber Bragg grating-assisted add-drop filter

A stable and low costless tunable erbium doped fiber ring laser using fiber Bragg grating-assisted add-drop filter is proposed and demonstrated. A stable laser output is obtained with a 4 nm tuning range. The power fluctuation, full-width at half maximum and SMSR are measured to be less than 0.50 dB, smaller than 0.015 nm and better than 55 dB in this tuning range.     

Single-longitudinal-mode erbium-doped fiber laser based on a fiber Bragg grating Fabry-Perot filter

A novel single-longitudinal-mode (SLM) erbium-doped fiber laser with a simple linear cavity based on a fiber Bragg grating Fabry-Perot filter (FBG-FPF) and a narrowband (～0.06 nm) FBG is proposed and demonstrated experimentally. Two uniform FBGs form the FBG-FPF, which has two ultranarrow transmission bands with a bandwidth of 0.12 pm and a wavelength spacing of 0.095 nm. By slightly tuning the central wavelength of the narrowband FBG, SLM lasing at 1549.658 or 1549.563 nm (corresponding to the two transmission peaks of the FBG-FPF) is achieved with a laser output power of ～4 mW, when the pump power is ～75 mW.     

Tunable fiber ring laser employing a Sagnac interferometric filter

A tunable erbium-doped fiber ring laser employing an all-polarization-maintaining fiber loop filter is proposed and demonstrated. The lasing frequencies can be selected by properly adjusting the polarization controller in the cavity.     

Multiwavelength fiber laser with fine adjustment, based on nonlinear polarization rotation and birefringence fiber filter

We have proposed and demonstrated a multiwavelength fiber laser based on nonlinear polarization rotation (NPR). The mechanism for stable room-temperature multiwavelength operation contributes to the ability of the intensity-dependent loss in NPR to effectively alleviate mode competition. In addition, through tuning the birefringence fiber filter, the lasing wavelength can be accurately tuned in the free spectrum range of the in-line periodic filter.     

Digital in-line holography with a sub-picosecond laser beam

The diffraction of an ultrashort pulsed laser beam by an opaque particle is studied. The case of a pulse with a Gaussian spectrum is investigated analytically by using the steepest descent method. This analytical solution allows us to calculate the intensity distribution of the diffraction field. This result enables to determine the optimal fractional orders Fourier transform to reconstruct digital in-line particle hologram.     

Stable multi-wavelength erbium-doped fiber laser based on dispersion-shifted fiber and Sagnac loop filter

A multi-wavelength erbium-doped fiber laser (MEDFL) with simple line structure is experimentally demonstrated by using a Sagnac interferometer as a comb filter. It is shown that the multi-wavelength lasing is quite stable at room temperature due to the four-wave mixing (FWM) effect among different laser channels in the dispersion-shifted fiber cooperated in the laser cavity.     

Switchable multi-wavelength fiber ring laser using a side-leakage photonic crystal fiber based filter

A switchable multi-wavelength fiber ring laser is proposed and experimentally demonstrated with a novel side-leakage photonic crystal fiber (SLPCF) based filter incorporated into the ring cavity at room temperature. Stable multi-wavelength laser operations can be achieved due to the spatial mode beating, polarization hole burning and spectral hole burning effects. By adjusting the polarization controller appropriately, the laser can be switched among the single-, dual- and triple-wavelength lasing oscillations whose signal-to-noise ratio is up to 50 dB. In addition, the lasing wavelength can be also tuned and switched by applying the strain to the filter.     

Stable single frequency Er-doped all-fiber ring laser with fiber Bragg grating Fabry-Perot filter

Using a fiber Bragg grating (FBG) and a Fabry-Perot cavity composed of two fiber Bragg gratings (FBGFP) as its frequency-selective components, a type of single frequency all-fiber ring laser permits oscillation only on one longitudinal mode of the main cavity without modehopping while the cavity length can be up to tens of meters. The salient feature is due to the single narrowband resonance of the FBGFP filter. Such a fiber ring laser is achieved experimentally, and the laser mode is limited inside the single resonance of the FBGFP.     

Tunable single- and dual-wavelength erbium-doped fiber laser based on Sagnac filter with a high-birefringence photonic crystal fiber

In this paper, we observed and experimentally investigated a high-performance single- and dual-wavelength erbium-doped fiber ring laser based on a Sagnac filter which contains a section of high-birefringence photonic crystal fiber (HB-PCF) and a polarization controller. Incorporation of the high-birefringence photonic crystal fiber can suppress multimode oscillation, improve power stability and increase the optical signal-to-noise ratio (SNR). Wavelength tunable was achieved by using a polarization controller in the Sagnac filter. Highly stable single-, dual-wavelength oscillations are tunable within a wavelength range from 1550 to 1562 nm and SNR as high as 57 dB with narrow line width about 0.011 nm, is experimentally demonstrated.     

Tunable microwave photonic notch filter using a dual-wavelength fiber laser with phase modulation

A novel tunable microwave photonic notch filter using a phase-modulated dual-wavelength fiber laser is presented. A stable dual-wavelength erbium-doped fiber laser with a linear cavity is formed by a polarization-maintaining uniform fiber Bragg grating (PM-FBG) and a polarization maintaining linearly chirped fiber Bragg grating (PM-LCFBG), both of which were fabricated on a high-birefringence (Hi-Bi) fiber. It is found that a stable room-temperature dual-wavelength operation can be achieved due to the presence of two reflection peaks arising from the orthogonal states of polarization (SOP) of the PM-FBG. Experimental results show stable dual-wavelength lasing operation with a wavelength separation of ∼0.36 nm and a large optical signal-to-noise ratio (OSNR) of over 40 dB under room temperature. The dual-wavelength fiber laser is combined with a phase modulator and a segment of single-mode fiber (SMF) as a dispersive device to form a tunable microwave photonic notch filter. By stretching the PM-FBG to tune the wavelength separation of the dual-wavelength fiber laser, a tunable microwave photonic notch filter with various free spectral ranges (FSRs) and a rejection ratio greater than 35 dB was developed.     

Dispersion-managed solitons in a fiber loop with in-line filtering.

We investigate both numerically and experimentally soliton propagation in a fiber loop with dispersion management, in-line filters, and frequency shifting. More than 90% of the fiber in the loop is in the normal-dispersion regime, but the net dispersion is anomalous. Stable pulses in the loop have an enhanced power relative to solitons in a fiber with uniform dispersion equal to the loop's path-averaged dispersion. Because the loop's path-averaged dispersion is small, the in-line filtering and the frequency shifting play an important role in pulse shaping. Recirculating loop experiments that demonstrate stable pulse propagation over 28,000 km are consistent with results from computer modeling.     

Study of in-line single-mode optical fiber polarizer

The theoretical calculation method of multilayer metal-clad planar optical waveguide presented by Y. YAMAMOTO is greatly improved and transplant into the optical fiber and a suitable waveguide model of in-line single-mode optical fiber polarizer is set up to study its characteristics, the theorical analyses are in accordance with the experimental re suits. The polarizer whose extinction ratio is more than 30 dB at 0.633μm wavelength with an insertion loss of 0.5 dB is formed by grinding off the cladding on one side of a single-mode fibre and evaporating metal onto the polished durface in our Lab.     

Ultrafast mode-locked dual-wavelength thulium-doped fiber laser using a Mach-Zehnder interferometric filter

A simple and robust method to generate a dual-wavelength mode-locked laser using a tunable Mach-Zehnder filter (TMZF) and a single-wall carbon nanotube (SWCNT) based saturable absorber (SA) is proposed and demonstrated. The proposed laser uses a thulium-doped fiber for lasing in the two-micron region and exploits the interferometric spectrum of the TMZF to produce dual peaks with nearly equal magnitude. SWCNT based SA enables mode-locking at a threshold value of 150.4?mW with distinct dual-wavelength peaks at 1919.2?nm and 1963.7?nm. The peaks have a calculated pulse width of 1.8?ps and 1.6?ps, respectively with a repetition rate of 9.1?MHz with a relatively high optical-signal-to-noise ratio value of 59.1?dB. The output is also observed to remain unchanged over time, indicating high stability. The proposed laser has a promising application, particularly in ultrafast gas molecular spectroscopy and sensing.     

All-fiber widely wavelength-tunable thulium-doped fiber ring laser incorporating a Fabry-Perot filter

We demonstrate 1940 to 2010 nm continuous CW wavelength-tuning in a thulium-doped fiber laser (TDFL), using only fiber-format components. A fiber Fabry-Perot (FP) tunable filter is employed to achieve the wavelength tunability of 70 nm. By imposing a 200 Hz triangle wave signal on the filter, rapid wavelength-sweeping is demonstrated from 1952 to 1992 nm every 5 ms, corresponding to 8 nm/ms. This all-fiber wavelength-tunable and swept laser may find applications such as gas monitoring in the wavelength region of 2 μm.