Temperature profiles in nitrous oxide supported acetylene flames at atmospheric pressure

Temperature profiles have been established at three mixture strengths of the nitrous oxide-acetylene flame used in atomicabsorption spectroscopy. Measurement of the electronic excitation temperature of the red-feather zone by the sodium line-reversal and iron two-line methods yields average maximum temperatures of 3070 and 3025 +/- 50 degrees K respectively. This is significantly lower than the only previously reported value, 3228 degrees K. Other temperature measurements obtained by studying intensity distribution of NH rotational fine structure and CN vibrational structure yielded less precise results, but suggest a state of thermal equilibrium in the flame. The temperature gradient within the flame shows a steady decrease with height above the primary zone. A study of CN spectra and the zones of persistence of free atoms and of metal oxide species suggests a mechanism of free atom production within the cyanogen zone whereby the removal of oxidizing radicals by CN promotes dissociation of metal oxide species previously formed in the primary zone of the flame.     

Emission spectra of organic liquids in oxy-hydrogen flames

Organic compounds were aspirated into an oxy-hydrogen flame and the emission spectra studied. Spectra from terminal combustion products were observed and some emission in the infrared may be attributed to larger molecular fragments. Qualitative analysis of combustion processes may be feasible using this process, but numerous problems made quantitative analysis difficult.     

Hydrogenation of CO and acetylene a fused iron catalyst at atmospheric pressure

Measurements have been made on the hydrogenation of acetylene on a fused iron catalyst, where the product distribution has been compared with those for synthesis gas alone or mixed with acetylene.Translated from Teoreticheskaya i Éksperimental/naya Khimiya, Vol. 26, No. 5, pp. 615–619, September–October, 1990.     

Surface functionalization of silicon oxide at room temperature and atmospheric pressure

A novel method to derivatize silicon surfaces with 3-mercaptopropylsilane molecules has been developed and optimized. This method is based on an argon flow that increases the evaporation rate of the silane molecules by lowering the partial pressure of the silane molecules in gas phase above the liquid silane, at room temperature. X-ray photoelectron spectroscopy studies of the surfaces showed a dense monolayer coverage as well as hydrolysis of the silane methoxy groups. Atomic force microscopy was used to investigate the roughness of the surfaces after each step of the derivatization process. Since the final surface has a measured surface roughness of 0.19 nm, this method will be especially useful for further synthetic routes and advanced single molecule detection studies of interactions on surfaces as well as improvement of existing conventional techniques for surface derivatization and analysis.     

Theoretical study on the gas phase reaction mechanism of acetylene with nitrous oxide

The reaction mechanism of C₂H₂ and N₂O on the singlet potential energy surface is investigated in this study, at the B3LYP/6-311++G(3df,3pd), MP2/6-311++G(d,p), and CCSD(T) levels of theory. We have obtained three kinds of products in both methods, B3LYP and MP2, which have enough thermodynamic stability. The results reveal that the product P1, CH₂CO + N₂, is spontaneous and exothermic with ?86.176 and ?83.149 kcal/mol in Gibbs free energy and enthalpy of reaction at the MP2 level, respectively. Hence, the product P1 is thermodynamically the most favored adduct of the C₂H₂ + N₂O gas phase reaction at atmospheric pressure and 298.15 K temperature.     

New examples of the vinylation of NH-heterocycles with acetylene at atmospheric pressure in the KOH-DMSO system

Vinylation of 2-hetarylpyrroles, 4,5-dihydrobenzo[g]indole, and 1,2,3,4-tetrahydro--carbinols at atmospheric pressure in the superbasic system KOH-DMSO at 100–120 ° C has given the corresponding N-vinyl derivatives in yields of 92–99%.Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 4, pp. 481–485, April, 1986.     

Some observations on the chemiluminescence of atoms in acetylene flames supported by air and argon-oxygen mixtures

A study has been made of the chemiluminescent emission of As, Bi, Cd, Ge, Hg, I, Mo, Pb, Sb, Se, Sn, Te, V and Zn in the primary combustion zones of air-acetylene and argon-oxygen-acetylene flames, supported at an open burner port during the aspiration of aqueous solutions of their salts. In general, elements having excitation, potentials greater than 4 eV show considerably greater atomic chemiluminescence in the primary zone than “thermal” atomic emission in the interconal region. Various mechanisms are suggested for the energy-transfer reactions between metal atoms and excited flame species, particularly carbon monoxide.     

Effects of cooling of a nitrous oxide—acetylene burner in atomic absorption spectrometry

A water-cooled burner is used for the determination of silicon, aluminium and calcium geological samples by a.a.s. The cooling modifies and stabilizes the nitrous oxide—acetylene flame so that sensitivity increases and the relative standard deviation decreases significantly in comparison with measurements in which traditional burners are used.     

Solvent-free aerobic oxidation of ethylbenzene over supported Ni catalysts using molecular oxygen at atmospheric pressure

We investigated the aerobic oxidation of ethylbenzene in the absence of solvent or any additive carried out over Ni on different types of supports namely SiO2, hydroxyapatite, SBA-15, and USY Zeolites. The oxidation of ethylbenzene activities was measured in a round bottom flask immersed in oil bath at known reaction temperature. The physicochemical characteristics of the catalysts were examined by BET surface area, XRD, FT-IR and the oxidation activities were correlated with the acidities of the catalysts obtained by TPD of NH3. It was observed that both hydroxyapatite and USY （13% Na2O） supported Ni catalysts displayed higher ethylbenzene conversion and 80% selectivity towards acetophenone.     

Oligomerisation of phenyl acetylene over titanium oxide supported on silica - alumina catalyst

Titanium oxide on silica-alumina support is found to be effective for oligomerisation of phenyl acetylene. Cyclic trimerisation of the acetylene leading to trisubstituted benzene was also found to occur during the oligomerisation, in addition to the formation of small quantities of a ketone by the reaction of phenyl acetylene with moisture over the catalyst surface.     

大气压下甲烷火花放电制乙炔和合成气

用大气压下火花放电方法和发射光谱原位诊断技术, 对CH₄直接转化制乙炔和间接转化制合成气进行了研究, 并与介质阻挡放电进行了比较。结果表明, 火花放电具有能量效率高的突出优点, 能够高效地将CH₄活化成C原子、H原子和C₂等活泼物种。当CH₄单独进料时, 能得到以C₂H₂为主的烃类产物。当CH₄与CO₂和O₂共进料时, 能得到H₂/CO比值可调的合成气产物。在用火花放电转化CH₄和CO₂制合成气时, 添加O₂能够避免反应器的结炭问题, 反应温度只需225 ℃, 与常规催化法相比具有明显的低温优势。     

Evaporation of urea at atmospheric pressure

Aqueous urea solution is widely used as reducing agent in the selective catalytic reduction of NO(x) (SCR). Because reports of urea vapor at atmospheric pressure are rare, gaseous urea is usually neglected in computational models used for designing SCR systems. In this study, urea evaporation was investigated under flow reactor conditions, and a Fourier transform infrared (FTIR) spectrum of gaseous urea was recorded at atmospheric pressure for the first time. The spectrum was compared to literature data under vacuum conditions and with theoretical spectra of monomolecular and dimeric urea in the gas phase calculated with the density functional theory (DFT) method. Comparison of the spectra indicates that urea vapor is in the monomolecular form at atmospheric pressure. The measured vapor pressure of urea agrees with the thermodynamic data obtained under vacuum reported in the literature. Our results indicate that considering gaseous urea will improve the computational modeling of urea SCR systems.     

Rotational structure in the infrared spectra of carbon dioxide and nitrous oxide dimers

High-resolution infrared predissociation spectra have been measured for dilute mixtures of CO₂ and N₂O in helium. Rotational fine structure is clearly resolved for both (CO₂)₂ and (N₂O)₂, the linewidths being instrument-limited. This establishes that predissociation lifetimes are longer than approximately 50 ns.     

Gas temperature determination in microwave discharges at atmospheric pressure by using different Optical Emission Spectroscopy techniques

Non-thermal plasmas sustained at atmospheric pressure are considered as a very promising technology for different purposes, in which the knowledge of the gas temperature is an important issue. In this paper, the gas temperatures of different argon microwave (2.45 GHz) plasma torches were determined by using different Optical Emission Spectroscopy techniques. Thus, they were estimated through the analysis of N₂⁺(B-X) and OH(A-X) molecular spectra. On the other hand, a method based on the measurement of the van der Waals broadening of 588.99 nm Na I line was employed, and the temperatures obtained from it were compared to the rotational temperatures derived from N₂⁺(B-X) and OH(A-X) rotational bands. A reasonable good agreement was found between the values of temperatures obtained by using the 588.99 nm Na I line and those obtained from N₂⁺ rotational band.     

Computer-assisted interpretation of atmospheric pressure chemical ionization mass spectra of triacylglycerols

Current lipidomics approaches require simple and rapid algorithms enabling the interpretation of mass spectra of lipids. Most lipids are complex mixtures of related components in which the composition of the aliphatic fatty acid chains varies from one molecule to the next. Triacylglycerols (TAGs) are an example of such a lipid class. Fatty acid chains are the only parts of the molecule to change from one species to another. Fatty acids, and consequently also TAGs, can be characterized by two parameters; the number of carbon atoms and the number of double bonds. All calculations reflecting relations among ions in the spectra can be easily made using these parameters. An algorithm for the automated interpretation of TAGs from atmospheric pressure chemical ionization mass spectra (TriglyAPCI) is presented in this paper. The algorithm first identifies diacylglycerol fragments and molecular adducts. In the next step, relations among the ions are searched and possible TAG structures are suggested. Individual features of the algorithm are described in detail and the software performance is demonstrated for the liquid chromatography/mass spectrometric (LC/MS) analysis of TAGs isolated from the termite Prorhinotermes canalifrons.