Simultaneous determination of δ15N and δ18O of N2O and δ13C of CH4 in nanomolar quantities from a single water sample

We have developed a rapid, sensitive, and automated analytical system to simultaneously determine the concentrations and stable isotopic compositions (δ¹⁵N, δ¹⁸O, and δ¹³C) of nanomolar quantities of nitrous oxide (N₂O) and methane (CH₄) in water, by combining continuous‐flow isotope‐ratio mass spectrometry and a helium‐sparging system to extract and purify the dissolved gases. Our system, which is composed of cold traps and a capillary gas chromatograph that use ultra‐pure helium as the carrier gas, achieves complete extraction of N₂O and CH₄ in a water sample and separation among N₂O, CH₄, and the other component gases. The flow path following exit from the gas chromatograph was periodically changed to pass the gases through the combustion furnace to convert CH₄ and the other hydrocarbons into CO₂, or to bypass the combustion furnace for the direct introduction of eluted N₂O into the mass spectrometer, for determining the stable isotopic compositions through monitoring the ions of m/z 44, 45, and 46 of CO and N₂O⁺. The analytical system can be operated automatically with sequential software programmed on a personal computer. Analytical precisions better than 0.2‰ and 0.3‰ and better than 1.4‰ and 2.6‰ were obtained for the δ¹⁵N and δ¹⁸O of N₂O, respectively, when more than 6.7 nmol and 0.2 nmol of N₂O, respectively, were injected. Simultaneously, analytical precisions better than 0.07‰ and 2.1‰ were obtained for the δ¹³C of CH₄ when more than 5.5 nmol and 0.02 nmol of CH₄, respectively, were injected. In this manner, we can simultaneously determine stable isotopic compositions of a 120 mL water sample with concentrations as low as 1.7 nmol/kg for N₂O and 0.2 nmol/kg for CH₄. Copyright © 2010 John Wiley & Sons, Ltd.     

δ13C, δ15N and δ2H isotope ratio mass spectrometry of ephedrine and pseudoephedrine: application to methylamphetamine profiling

Conventional chemical profiling of methylamphetamine has been used for many years to determine the synthetic route employed and where possible to identify the precursor chemicals used. In this study stable isotope ratio analysis was investigated as a means of determining the origin of the methylamphetamine precursors, ephedrine and pseudoephedrine. Ephedrine and pseudoephedrine may be prepared industrially by several routes. Results are presented for the stable isotope ratios of carbon (δ¹³C), nitrogen (δ¹⁵N) and hydrogen (δ²H) measured in methylamphetamine samples synthesized from ephedrine and pseudoephedrine of known provenance. It is clear from the results that measurement of the δ¹³C, δ¹⁵N and δ²H stable isotope ratios by elemental analyzer/thermal conversion isotope ratio mass spectrometry (EA/TC‐IRMS) in high‐purity methylamphetamine samples will allow determination of the synthetic source of the ephedrine or pseudoephedrine precursor as being either of a natural, semi‐synthetic, or fully synthetic origin. Copyright © 2009 Commonwealth of Australia. Published by John Wiley & Sons, Ltd.     

13C NMR of organosulfur compounds the 13C chemical shifts of monocyclic γ- and δ-sultones

The ¹³C NMR spectra of several monocyclic γ-sultones(1,2-oxathiolane 2,2-dioxides) and δ-sultones(1,2-oxathiane 2,2-dioxides) have been determined and are presented herein. The chemical shifts of the ring carbons of these compounds are compared in terms of conformational, electronic and anisotropic differences. Electric field effects may be responsible for the chemical shifts of the C-α carbon, but do not appear to be important for C-α. Anisotropic deshielding also appears to be important for the chemical shifts of C-α, but the effects on C-α appear to be small. Dipole changes at C-α and C-α, induced by back donation of electron density from the ring oxygen to sulfur, may explain the chemical shifts at C-α. Substituent effects are readily explained in terms of well-known effects. In general, the carbons closest to the sulfonate group are found to be the most affected, and the carbons of the δ-sultones proximate to the sulfonate group are found to be more deshielded than those of the γ-sultones.     

Simultaneous δ15N, δ13C and δ34S measurements of low‐biomass samples using a technically advanced high sensitivity elemental analyzer connected to an isotope ratio mass spectrometer

Conventional simultaneous CNS stable isotope abundance measurements of solid samples usually require high sample amounts, up to 1 mg carbon, to achieve exact analytical results. This rarely used application is often impaired by high C:S element ratios when organic samples are analyzed and problems such as incomplete conversion into sulphur dioxide occur during analysis. We introduce, as a technical innovation, a high sensitivity elemental analyzer coupled to a conventional isotope ratio mass spectrometer, with which CNS‐stable isotope ratios can be determined simultaneously in samples with low carbon content (<40 µg C corresponding to ～100 µg dry weight). The system includes downsized reactors, a temperature program‐controlled gas chromatography (GC) column and a cryogenic trap to collect small amounts of sulphur dioxide. This modified application allows for highly sensitive measurements in a fully automated operation with standard deviations better than ±0.47‰ for δ¹⁵N and δ³⁴S and ±0.12‰ for δ¹³C (n = 127). Samples collected from one sampling site in a Baltic fjord within a short time period were measured with the new system to get a first impression of triple stable isotope signatures. The results confirm the potential of using δ³⁴S as a stable isotope tracer in combination with δ¹⁵N and δ¹³C measurements to improve discrimination of food sources in aquatic food webs. Copyright © 2009 John Wiley & Sons, Ltd.