Group-velocity-dispersion-compensated femtosecond optical parametric amplifier

A tilted pulse front geometry is known to allow group-velocity-dispersion (GVD) compensated propagation of short pulses of different wavelengths in dispersive media. This scheme is shown to be applicable to an optical parametric amplifier (OPA) pumped at 450nm. A numerical calculation shows that a certain combination of the tilt of the pulse front and the angle between the interacting beams provides optimum GVD compensation for each wavelength. The parameters providing broadband tunability are identified. The tunability of the GVD-compensated OPA pumped with 55fs pulses was experimentally demonstrated between 545nm and 645nm. This revised version was published online in November 2006 with corrections to the Cover Date.     

Carrier-envelope phase offset for pulses from a tunable optical parametric amplifier

The carrier-envelope phase (CEP) characteristics of the tunable infrared laser pulses from a noncollinear optical parametric amplifier (OPA) with passively stabilized CEP are investigated experimentally. We compare the CEP fluctuation of different wavelength outputs from the OPA which is seeded by the idler pulse of a difference frequency generation (DFG) process. It is found that when the OPA output is tuned to a longer wavelength, the CEP fluctuation becomes less sensitive to the jitter of laser intensity and the phase mismatch, and therefore more stable CEP for the longer wavelength output pulses is realized.     

基于单个BBO晶体载波包络相位稳定的高效率光参量放大器

基于单个BBO非线性晶体,利用非共线光参量放大技术,研究了载波包络相位稳定的高效率可调谐近红外脉冲产生.以载波包络相位稳定的飞秒激光放大系统产生的白光作为种子光,注入一个二类匹配的二级光参量放大器,在1350 nm波段获得抽运-信号光34%的转换效率.利用f—2f光谱相干测量技术,放大脉冲载波包络相位的抖动30 min内小于137 mrad.该方法提供了一种简单高效的载波包络相位稳定的红外脉冲产生技术.     

A 61-mJ, 1-kHz cryogenic Yb: YAG laser amplifier

We report a diode-pumped rod-type Yb:YAG laser amplifier operating at 1 kHz. Cryogenic cooling method was adopted to make the Yb:YAG crystal work with four-level behavior. A single-frequency fiber laser acts as the seed in an actively Q-switched Yb:YAG oscillator. The resonator delivers 5.75-mJ pulses at 1 kHz with a pulse duration of approximately 40 ns. The pulses were amplified to 61 mJ in a four-pass rod-type Yb:YAG amplifier with optical-to-optical efficiency of 24% in the main amplifier. The M² parameter of the output laser is <1.4.     

Pulsed-pumped optical fiber amplifier

With the use of pulsed pumping, an optical fiber amplifier with all-fiber structure is developed based on the fused tapered fiber combiner and Yb^3＋-doped double cladding fiber （YDCF）. From the experimental results, 47-dBm peak power and 100-ns pulse duration are obtained when the repetition rate of pumping pulses is 100 Hz. The gain of the amplifier is up to 30 dB. It is shown that due to the use of pulsed pumping, pump light emits only when the signal light reaches the amplifier and thus the amplified spontaneous emission （ASE） is significantly suppressed.     

A CW seeded femtosecond optical parametric amplifier

1 Introduction Optical parametric amplification (OPA) based on femtosecond Ti:sapphire regen-erative amplifiers has been widely adopted in wavelength extension of ultrashort opticalpulses[1]. While BBO-based femtosecond optical parametric amplifiers have alreadycommercialized, the tuning range of such an 800 nm-pumped OPA is typically between1.15 μm and 2.6 μm due to the limited transparent range of BBO. From application’spoint of view, ultrashort pulses near 1 μm and between 3 and 4 …     

300 kHz femtosecond Yb:KGW regenerative amplifier using an acousto–optic Q-switch

We report a diode-pumped high-repetition-rate chirped-pulse Yb:KGW regenerative amplifier delivering tens of microjoules pulse energy at repetition rates of up to 300 kHz. High repetition rates are obtained by using an acousto-optic modulator as switching element in the regenerative amplifier cavity. The output pulses were compressed down to 600 fs pulse duration. Even shorter pulses in the 100 fs range are obtained using an amplifier configuration without chirped pulse amplification. PACS 42.55.Xi; 42.60.Da; 42.65 Re     

Ultrashort-pulse Yb3+-fiber-based laser and amplifier system producing >25-W average power

We have demonstrated an ultrashort-pulse Yb3+-fiber laser and amplifier system that produces >400-nJ pulses at a repetition rate of 62 MHz (>25-W average power). The output pulses were recompressed to a duration of 110 fs with good pulse quality by use of a standard bulk grating-based compressor.     

Broadband high-energy diode-pumped Yb:KYW multipass amplifier

We report a diode-pumped Yb:KYW amplifier delivering up to 27 mJ pulses at a repetition rate of 100 Hz and a spectral bandwidth of 5.5 nm, centered at around 1030 nm. The system is based on a double-head multipass amplifier configuration where the pump thermal load is distributed over two relatively thin laser crystals, which permits a sufficiently large number of passes with minimal passive losses, thus maximizing the energy extraction efficiency. The amplified pulse bandwidth theoretically supports 340 fs pulses, and as a demonstration, a small fraction of the amplified pulses has been compressed to 560 fs.     

All-fiber laser seeded femtosecond Yb:KGW solid state regenerative amplifier

A high efficiency compact Yb:KGW regenerative amplifier using an all-fiber laser seed source was comprehensively studied. With thermal lensing effect compensated by the cavity design, the compressed pulses with energy of 1 m J at 1 k Hz and 0.4 m J at 10 k Hz in sub-400-fs pulse duration using chirped fiber Bragg grating(CFBG) stretcher were demonstrated.A modified Frantz–Nodvik equation was developed to emulate the dynamic behavior of the regenerative amplifier. The simulation results were in good agreement with the experiment. Numerical simulations and experimental results show that the scheme can be scalable to higher energy of multi-m J, sub-300 fs pulses.     

Compact diode-pumped 1.1 kW Yb:YAG Innoslab femtosecond amplifier

We demonstrate a compact diode-pumped Yb:KGW femtosecond oscillator-Yb:YAG Innoslab amplifier master oscillator power amplifier (MOPA) with nearly transform-limited 636 fs pulses at 620 W average output power, 20 MHz repetition rate, and beam quality of M(x)(2) = 1.43 and M(y)(2) = 1.35. By cascading two amplifiers, we attain an average output power of 1.1 kW, a peak power of 80 MW, and a 615 fs pulse width in a single linearly polarized beam. The power-scalable MOPA is operated at room temperature, and no chirped-pulse amplification technique is used.     

Ultrafast thin-disk Yb:KY(WO4)2 regenerative amplifier with a 200-kHz repetition rate

We report an Yb:KYW thin-disk amplifier system that provides ultrashort pulses in the 10-microJ energy range at high repetition rates. The thin-disk concept uses large laser beam cross sections to avoid high peak intensities. Without using a traditional diffraction-grating stretcher, pulse energies of approximately 9 microJ with pulse durations of 280 fs at repetition rates of 200 kHz were generated.     

Yb:YAG Innoslab amplifier: efficient high repetition rate subpicosecond pumping system for optical parametric chirped pulse amplification

We report on a Yb:YAG Innoslab laser amplifier system for generation of subpicsecond high energy pump pulses for optical parametric chirped pulse amplification (OPCPA) at high repetition rates. Pulse energies of up to 20 mJ (at 12.5 kHz) and repetition rates of up to 100 kHz were attained with pulse durations of 830 fs and average power in excess of 200 W. We further investigate the possibility to use subpicosecond pulses to derive a stable continuum in a YAG crystal for OPCPA seeding.     

Picosecond pulses from a cryogenically cooled, composite amplifier using Yb:YAG and Yb:GSAG

A cryogenic Yb amplifier using two laser materials, Gd3Sc2Al3O12 and Y3Al5O12 (YAG), has been used to obtain 70 W average power at 5 kHz pulse repetition frequency; the output was compressed to 1.6 ps, compared with an input compressible to 1.4 ps. The gain broadening obtained by combining two media enables shorter pulses than using Yb:YAG alone but retains the power-scaling advantages of cryogenic Yb:YAG.     

Spectral broadening of femtosecond pulses in an nonlinear optical fiber amplifier

A promising method for the generation of a supercontinuum with a high spectral power density based on the spectral broadening of ultrashort pulses in a fiber amplifier is considered. The advantage of the method, as compared to the conventional way of the supercontinuum generation in a microstructure fiber, is a lower pulse spectral broadening rate, which allows one to achieve higher SC spectral power densities. The initial stage of the supercontinuum generation in an ytterbium fiber amplifier (a fiber core diameter of 7 μm) with side pumping from an array of laser diodes with a total power of 8 W at a wavelength of 976 nm is experimentally studied. Yb:KYW laser pulses with a duration of 250 fs, a central wavelength of 1046 nm, and an average power of 150 mW have been supplied to the input of the amplifier. In this case spectrally broadened radiation with an average spectral power density of higher than 65 mW/nm and a spectrum width of 50 nm has been obtained.     

Carrier envelope phase stabilization of a Yb:KGW laser amplifier

In this paper we report on the active stabilization of the carrier envelope phase (CEP) of a Yb:KGW chirped pulse amplifier laser system seeded by a Yb-doped solid-state Kerr-lens mode-locked oscillator. The regenerative amplifier delivers 180 fs CEP stable pulses of 30 μJ-1 mJ energy at a repetition rate tunable from 1 to 200 kHz. The bandwidth of the feedback loop was extended by a factor of 5 using a specially designed high-pass filter, which resulted in a dramatic decrease of CEP jitter below 0.45 rad after the amplifier.     

Directly diode-pumped Yb3+:SrY4(SiO4)3O regenerative amplifier

We report a regenerative amplifier based on an Yb-doped apatite crystal: Yb3+:SrY4(SiO4)3O (Yb:SYS). We obtained 420-fs pulses at a central wavelength of 1066 nm with an energy of 100 microJ at 300 Hz after compression. To the best of our knowledge, this system is the first regenerative amplifier based on an Yb:SYS crystal and provides duration among the shortest ones generated by a directly diode-pumped regenerative amplifier.     

Ultrawide tunable Er soliton fiber laser amplified in Yb-doped fiber

A Raman-shifted and frequency-doubled high-power Er-fiber soliton laser for seeding an efficient high-power Yb fiber femtosecond amplifier is demonstrated. The Raman-shifted and frequency-doubled Er-soliton laser is tunable from 1.00 to 1.070microm and produces bandwidth-limited 24-pJ pulses at a repetition rate of 50 MHz with a FWHM pulse width of 170 fs at 1.040microm . The Yb(3+) amplifier has a slope efficiency of 52% and generates 3-ps linearly chirped pulses with an average power of 0.8 W at 1.05microm . After pulse compression, 74-fs bandwidth-limited pulses with an average power of 0.4 W and a pulse energy of 8 nJ are generated.     

Sub-two-cycle light pulses at 1.6 microm from an optical parametric amplifier

We generate ultrabroadband pulses, spanning the 1200-2100 nm wavelength range, from an 800 nm pumped optical parametric amplifier (OPA) working at degeneracy. We compress the microjoule-level energy pulses to nearly transform-limited 8.5 fs duration by an adaptive system employing a deformable mirror. To our knowledge, these are the shortest light pulses generated at 1.6 microm.     

Wavelength-tunable high-power picosecond pulses from a fiber-pumped diode-seeded high-gain parametric amplifier

We describe a high-gain optical parametric amplifier (OPA) and optical parametric generator (OPG) system pumped by a fiber chirped-pulse amplification source based on novel large-mode-area fiber components. 45-nJ OPG thresholds and 34% pump-signal conversion efficiencies are obtained for ~4-ps pulses. OPA gains in excess of 75 dB and pump-signal conversion efficiencies of ~39% (external) are demonstrated. Furthermore, we show that injection seeding of such high-gain parametric devices by use of a low-power continuous-wave beam results in high-power (>18-kW) picosecond pulses with a time-bandwidth produce of ~0.65, some ten times less than from a free-running OPG. Using such an approach, we obtain 2.7-ps 50-nJ pulses at 1.310 mum .