InGaN/GaN light‐emitting diodes (LEDs) are known to exhibit a strongly non‐uniform vertical carrier distribution within the multi‐quantum well (MQW) active region. We propose to eliminate “dark” quantum wells by insertion of multiple tunnel junctions into the MQW which allow for the repeated use of electrons and holes for photon generation. In good agreement with available measurements, we demonstrate by self‐consistent numerical simulation that such tunnel junction LED design promises quantum efficiencies as high as 250% as well as a strongly enhanced output power at high input power, compared to conventional LED concepts.
Multicrystalline silicon wafer solar cells reveal performance‐ reducing defects by luminescence. X‐ray fluorescence spectra are used to investigate the elemental constituents from regions of solar cells yielding reverse‐bias or sub‐bandgap luminescence from defects. It is found that a higher concentration of metals is present in regions yielding reverse‐bias electroluminescence than in regions yielding sub‐bandgap electroluminescence. This suggests, dislocations do not create strong breakdown currents in the absence of impurity precipitates.
Write‐once–read‐many‐times memory (WORM) devices were fabricated using Ti/Au and Au as top contacts on ZnO thin films on Si. Electrical characterization shows that both types of WORM devices have large resistance OFF/ON ratio (R ratio), small resistance distribution range, long retention and good endurance. WORM devices with Au top contact have better performance of higher R ratio because of a larger work function of Au compared to Ti.
The properties of transition‐metal (V, Cr, Mn, Fe, Co, Ni) δ‐doped ZnO are reported based on ab‐initio electronic structure calculations where the on‐site electronic correlations are included using the Hubbard parameters. The calculated electronic and magnetic properties are considerably altered with respect to usual band‐structure calculations. Most of the studied systems are found to be either half‐metals or ferromagnetic/antiferromagnetic semiconductors and thus can be employed in a variety of spintronic applications as spin‐filter materials.
The metastability of the bixbyite‐ and corundum‐type In2O3 polymorphs up to 33 GPa (at room temperature) is shown. While compressed (in diamond anvil cells) and laser‐heated, both polymorphs undergo a phase transition to the Rh2O3‐II‐type structure (space group Pbcn, No. 60). The direct transition from bixbyite to Rh2O3‐II structure has not yet been observed for any other oxide.
We report on solution‐processible polymer solar cells (PSCs) fabricated on a papery substrate using carton. Highly conductive PEDOT:PSS was used as a bottom anode and planarization layer, and a semi‐transparent top cathode was applied. This research could be an important approach to the development of all‐solution‐processible papery PSCs as well as paper electronics.
Utilizing three‐dimensional vectorial electromagnetic simulation, we propose a new refractive index sensing mechanism based on Fano resonance enhanced two‐photon‐absorption induced luminescence (TPL). The TPL from gold nanodisk heptamer (GNDH), which is affected by the refractive index of surrounding material, is used as an example to demonstrate the sensing mechanism facilitated by Fano resonance. The sensitivity of our method is about one order of magnitude better than the conventional refractive index sensing strategy employing plasmonic Fano resonance, while the size of the sensing probe can be further reduced at the same time.
We present a computational study based on time‐dependent density functional theory of the optical absorption spectra of TiO2 nanowires sensitized with organic dye molecules. We concentrate on catechol and squaraine dyes. For those molecules, we compute adsorption geometries and energies and investigate the optical properties of the combined dye– nanowire system. We find that although the molecules have qualitatively different optical spectra in the gas phase, both lead to an enhancement of the absorption in the visible frequency range when adsorbed on a nanowire.
By means of first‐principles calculations we predict the stability of silicene as buckled honeycomb lattice on passivated substrates of group‐IV(111)1 × 1 surfaces. The weak van‐der‐Waals interaction between silicene and substrates does not destroy its linear bands forming Dirac cones at the Brillouin zone corners. Only very small fundamental gaps are opened around the Fermi level.
A passive micro‐displacement sensor (for ～μm displacement) was fabricated based on a magnetoelectric laminate, in which the displacement change can result in a change of the magnetic flux around the magnetoelectric sensor. The displacement measurement was realized by measuring the magnetoelectric output voltage. The displacement detecting coefficient was ～2.5 mV/μm at a frequency of ～1 kHz. This passive displacement sensor possesses the advantages of low cost, high resolution, low energy consumption and good linearity and has potential for application in future displacement detectors.
Quaternary kesterite‐type Cu2ZnSnS4 (CZTS) nanoparticles (NPs) were successfully synthesized by a single‐step solvothermal process. Semiconductor CZTS nanoparticles were obtained from ethylene glycol (EG) and CZTS precursor after solvothermal process at 180 °C for 30 h in polyvinylpyrrolidone (PVP) medium. The synthesized CZTS NPs were further annealed at 450 °C in nitrogen atmosphere and used for further characterizations. The CZTS NPs were characterized using X‐ray powder diffraction (XRD), field emission scanning electron microscopy (FESEM), micro Raman spectroscopy, high resolution transmission electron microscopy (HRTEM) and X‐ray photoelectron spectroscopy (XPS). The optical properties of the CZTS NPs were recorded by UV–vis absorption spectroscopy. The results showed that the synthesized CZTS nanoparticles are kesterite‐type CZTS, with good crystallinity and a stoichiometric composition. Moreover, the prepared nanoparticles have a size ranging from 5–7 nm and a band gap of ～1.5 eV.
Ti–Ni–Si glassy alloy supercapacitors, devices that store electric charge on their TiO2 surfaces that contain many nanometer‐sized cavities, display many advantages over other power‐source technologies. The use of de‐alloying and anodic oxidization methods has made possible the synthesis of a TiO2 surface accessible to electron trapping. Until recently, no studies have addressed the “dry” electric storage in light glassy alloys. Our device realizes AC electric storage from 193 to 453 K with a voltage variation from 10 to 150 V, and DC capacitance of ～4.8 F (～52.8 kF/cm3), on the basis of electric double layers, deep electronic trapping sites and Shottky barriers. Further gains could be attained with surface optimization.
We report the fabrication procedure and the characterization of an Al0.3Ga0.7As solar cell containing high‐density GaAs strain‐free quantum dots grown by droplet epitaxy. The production of photocurrent when two sub‐bandgap energy photons are absorbed simultaneously is demonstrated. The high quality of the quantum dot/barrier pair, allowed by the high quality of nanostructured strain‐free materials, opens new opportunities for quantum dot based solar cells.
Using the recently suggested method of processing the data on external quantum efficiency as a function of output optical power, we have estimated the dependence of light extraction efficiency of high‐power light‐emitting diodes (LEDs) on their emission wavelength varied between 425 nm and 540 nm. The extraction efficiency is found to increase with the wavelength from ～80% to ～85% in this spectral range and to correlate with the wavelength dependence of reflectivity of the large‐area p‐electrode being the essential unit of the LED chip design. The correlation found identifies the incomplete reflection of emitted light from the electrode as the major mechanism eventually controlling the spectral dependence of the efficiency of light extraction from the LEDs.
This Letter reports the novel use of poly(9‐vinylcarbazole) (PVK) as a dielectric interfacial layer for n‐type organic field‐effect transistors (n‐OFETs). With PVK, both the air stability and electron mobility of N,N′‐ditridecylperylene‐3,4,9,10‐tetracarboxylic diimide (PTCDI‐C13)‐based OFETs were improved. Among the PVKs with different weight‐average molecular weight (Mw), PVK with high Mw showed good performance. The high glass transition temperature of PVK enabled thermal post annealing of the active layer, which resulted in a high electron mobility of 0.61 cm2/Vs. This mobility was maintained at 90% and 59% after 4 days and 105 days in air, respectively. The PVK interfacial layer reduced the trapped charges in the PTCDI‐C13‐based n‐OFET for air‐exposure and caused a decrease in the threshold voltage shift.
We have fabricated multi‐peak and chromaticity‐stable top‐emitting white organic light‐emitting diodes (TEWOLEDs) using single blue emitter. Besides the intrinsic emission of blue emitter, the additional emission can be well realized by simply adjusting the thickness of hole transporting layer (HTL), thus modifying the optical cavity length to obtain different resonant wavelengths. The detailed variation process for multi‐peak spectra with the increase of HTL thickness is studied, which provides a guidance for the design of microcavity TEWOLEDs.
A new method for fabricating carbon nanotube‐conducting polymer (CNT‐CP) composite single nanowires is reported. The method developed is highly efficient, reliable, and economical because it obviates the time consuming process of template fabrication and the post‐synthesis task of positioning nanowires. Single nanowires with diameters of 50‐500 nm are fabricated between electrodes, self‐templated by dielectrophoresis and electropolymerization. Fabrication of an individually addressed nanowire array with cantilever electrodes on a microchip is demonstrated.
A very thin (250 nm), highly conductive (annealed), non‐texturized DC‐sputtered aluminum‐doped zinc oxide layer (ZnO:Al) deposited on a textured glass is used as substrate for thin‐film silicon solar cells. Compared to the classical approach, where wet‐chemically texturized ZnO:Al on planar glass is used, this approach allows a reduction in the as‐deposited ZnO:Al thickness of almost 70% while at the same time, thanks to the good light trapping capability of the glass texture the efficiency of the cells was maintained at the high level of 10.9%.
Dip‐coating of a colloidal suspension is investigated in situ with microbeam grazing incidence small‐angle X‐ray scattering. We focus on the real‐time monitoring of a vertical dip‐coating process yielding insights into structural changes during pattern formation of the thin film. With the selected configuration a fixed spot on the sample surface is probed and the structural information at the time the contact line passes this spot is obtained, hence revealing the structure at the vicinity of the flowing meniscus owing to the microfocused beam. After dip‐coating the morphology is analyzed with atomic force microscopy, yielding real space information about the arrangement of individual nanoparticles at the film surface.
下载免费PDF全文