Copolymérisations de l'acrylonitrile. XII. Phénomènes de solvatation préférentielle et effet de conversion dans la copolymérisation (acrylonitrile–styrène)

Kinetic deviations with the conversion observed in free-radical-initiated [acrylonitrile (A)–styrene (S)] copolymerization carried out in DMF solution have been interpreted in terms of preferential solvation of the polymer by one of the monomers or the solvent. First it is well established that the initial styrene content of the PAS copolymer increases if a slight amount of polymer is introduced before the beginning of polymerization. Next the preferential solvation has been studied and characterized in various solvents (toluene or DMF) from the results of differential refractometry at dialysis equilibrium of the ternary solution (solvent–monomer–polymer) versus its solvent mixture. It was found that the most polar monomer, acrylonitrile, is already adsorbed by the polymer, mostly in copolymerizations carried out in DMF, from initially rich acrylonitrile mixtures. It is suggested that this phenomenon implies a heterogeneous repartition of the monomer mixture in the solution, which may affect the kinetic copolymerization when the conversion increases.     

Effect solvatant des copolymères styrène–macromère a chaîne polyoxyéthylène. Influence du support polymère

Polyoxyethylene macromers were used to prepare functionalized linear and crosslinked copolymers with styrene and divinylbenzene. Gel or macroporous resins were prepared. These copolymers and resins were used as anionic activators for the Williamson reaction of potassium phenoxide and alkyl bromides under solid–liquid or solid–liquid–liquid (triphase) conditions. In contrast to similar resins obtained from chemical grafting of polyoxyethylene onto chloromethylated styrene–divinylbenzene polymers, the activity factors were strongly dependent on the composition of the resins and their morphology: an optimum activity was obtained for a 0.05M fraction of macromers in soluble copolymers and crosslinked resins. In addition, a macroporous resin with large pores was more efficient than a gel-type resin of similar composition. These effects are discussed in terms of accessibility of the activating group and compatibility of the support with the medium.     

Polymérisation anionique des diènes. III. Etude thermodynamique de la propagation du butadiène et de i'isoprène par les organo-alcalins

The present work is concerned with the influence of the polymerization temperature on the propagation mechanisms of polyisoprenyl- and polybutadienyl-alkali metals. The thermodynamic parameters of the contact ion pairs and free ions propagations have been calculated. With Li⁺ in dioxane solvent, the vinyl propagation is stereospecific (for isoprene, the propagation is mainly 4–3). In comparison with benzene, the vinyl propagation of the polydienyl-Li contact ions pairs should be due to complexation of Li⁺ by dioxane, an electron donor having a weak dielectric constant. In general, the stereospecificity of the propagation of contact ion pairs decreases with increasing counterion size; little difference has been observed with K⁺ and Cs⁺ ion pairs in dioxane and benzene media. For isoprene, the methyl substituant should have chiefly a steric effect in the propagation of free ions, whereas it should confer a polar character to the isoprene molecule in the presence of ions pairs.     

Étude par rayons X de copolymères téléchéliques butadiène acide méthacrylique

The telechelic polybutadiene–methacrylic acid copolymer (Hycar CTB) containing 2 mole percent acid and neutralized (5–100%) by alkali ions, Na⁺, K⁺, and Cs⁺, has been studied by small-angle x-ray scattering. Salt groups form clusters, and the average value of the radii of gyration is approximately 8 Å; this value seems to be independent of the nature of the cation and the degree of neutralization. The existence of a low-angle maximum in the scattering intensity gives evidence of a mean distance of 80 Å between clusters in the fully neutralized sample. This distance increases slightly with a decreasing degree of neutralization. A more precise analysis of the small-angle scattering curve gives further information on the cluster structure: the ionic groups may form small bilayer disks while the polymer chains maintain a regular distance of 80 Å between the disks.     

Etude par RMN 13C à 62,89 MHz des branchements éthyles dans les copolymères ethylène-butène et polyéthylène basse densité

Carbon 13 nuclear magnetic resonance spectra (at 62,89 MHz) were obtained for a series of branched heavy alcanes (12-ethyl tricosane, 11,20-diethyl tricontane, 11,18-diethyl octacosane, 11,17-diethyl heptacosane, 11,16-diethyl hexacosane, 9,12-diethyl heneicosane, 5,7-diethyl docosane, 6,7-diethyl docosane, 2 éthyl-hexyl-12 tricosane), which provide a model set for describing the ethyl branched sequences in ethylene butene copolymers and low-density polyethylene (LDPE). For ethylene-butene copolymers we do not detect any head-to-head polymerization of butene as reported recently (the existence of a 1,2-ethyl pair has not been confirmed by the low-field signal at 41,3 ppm), but only isolated ethyl and 1-3-diethyl branches. The three peaks observed in the methyl region (broad signal) of the spectrum are assigned to butene centered triads, as opposed to branches in positions having different tacticities as reported earlier. Carbon 13 nuclear magnetic resonance spectra of high-pressure polymerized low-density polyethylene have been measured at 62,89 MHz. On the basis of Willbourn's double back biting mechanism, two kinds of complex branches, the 1,3-ethyl pair and 2-ethyl-hexyl, have been assigned. Finally, these results suggest that the ethyl branches in low-density polyethylene are not isolated branches.     

Contributions au fractionnement des copolymères. II. Copolymères ternaires acrylonitrile–acétate de vinyle–α-méthylstyréne

Acrylonitrile, vinyl acetate, and α-methyl styrene copolymers, were synthesized in aqueous solution, and the resulted products were studied viscometrically by fractionation and by cloud-point titration. The values of the intrinsic viscosities of the polymers in DMF at 20°C are not influenced by the overall composition of the copolymers and the distribution mode of the comonomers. The solubility of the products is directly dependent on the composition, namely, it increases as the acrylonitrile content decreases. The differential fractionation curves are influenced by the chemical composition and by the mode of distribution of the monomers along the macromolecular chain. The successive precipitation method for the fractionation of the ternary copolymers is recommended.     

Synthèse de copolymères greffés à base de polyéthylène—1

Polyethylene macromolecular free radical initiators, obtained by ozonization, are used to prepare graft copolymers with methyl methacrylate, styrene and vinyl chloride. The reactions parameters are the number of initiator groups (found by DPPH), peroxide and hydroperoxide proportions (respectively 36 and 64%), decomposition rate (K_d at 90° 10⁻¹sec⁻¹) and monomer concentration. The molecular structure of these copolymers is defined.     

Les anions-radicaux de l'isoprène et du butadiène intermédiaires de synthèse en chimie organique

We have synthesized a series of alkadiene and dialcohol homologs of terpenoid natural products by using anion-radicals of isoprene and butadiene. The reactions of the two monomers were initiated anionically by use of alkali metal–aromatic hydrocarbon complexes. The polymerization was stopped at the dimer stage. This method constitutes a route of synthesis for numerous organic compounds, such as alcohols and hydrocarbons.     

Etude du mécanisme de perte d'ethylène (propène) des N-ethyl (propyl) bromo-1,2,4-triazoles

C-bromo-1,2,4-trizole is generated in three different tautomeric forms by ethylene elimination from the N-ethyl compounds and these toutomes are shown to retain their structure prior to further fragmentation. The analysis of mass analysed ion kinetic energy and collision incuded dissociation spectra confrrms that ethylene loss proceeds by a tw-step mechanism with a five- (or four-) centred hydrogen transfer. The results show also that the 3- and 5-bromotriazole structures only are responsible for the mass spectrum of the parent heterocycle. Similar data are dicussed for the loss of propene from N-propylbromotriazoles.     

Diazoalcanephosphonates. Etude par RMN du proton de la configuration de Δ1-pyrazolines dérivées du norbornadiène

The NMR spectra of eleven pyrazolines 1 to 11 derived from norbornadiene are interpreted and discussed. The configurations are deduced from the vicinal P?C?C?H₁₀ coupling: this is ～20 Hz in the anti derivatives and ～6·0 Hz in their syn epimers. The long-range P,H₉ coupling is stereospecific, being maximum for a syn configuration.     

Nucléosides de synthèse XIV. Du choix des paramètres réactionnels pour l'obtention préférentielle de nucleosides en série benzoazole par réaction de fusion

By a judicious choice of the fusion reaction parameters, mainly the percentage of catalyst, we have obtained the corresponding benzotriazole and benzimidazole nucleosides substituted at N-2. We have also obtained the α N-1 anomers. Thus, we have shown it is possible, to confer some selectivity to the acid-catalyzed fusion-reaction.     

Nouvelle méthode de détermination des taux de réativité des copolymères par résonance magnétique nucléaire: Application aux poly(méthacrylate de méthyle–chlorure de vinylidène)

Constant-composition copolymers of methyl methacrylate and vinylidene chloride produced by radical copolymerization are studied by ¹H-NMR at 60 and 250 MHz. The different methods of the literature for the derivation of reactivity ratios from either the copolymer composition or the sequence average lengths, or even the diad distribution, are applied but lead to rather dispersed results. A new graphical method is proposed, based on the use of peculiar values of the triad distribution functions. It allows us to detect a penultimate effect for the vinylidene chloride-rich region. In the same range, a change in tacticity of the diads and triads on the methylmethacrylate sequences, as compared with homopolymers, is observed; it suggests that the anomaly is caused by the competition of the depropagation reaction.     

Etude des systèmes binaires formées par le chlorure de cyanogène et par les tétrachlorures de carbone,de silicium,de germanium et d'étain

Study of binary systems formed by cyanogen chloride and the tetrachlorides of carbon, silicon, germanium and tin. The diagrams of binary mixtures of cyanogene chloride with the tetrachlorides of carbon, silicon, germanium and tin were studied. Only SnCl₄ gives an addition compound: SnCl₄ · 2ClCN. The existence of the complex was confirmed by X-ray diffraction and vapour pressure measurements. This complex gives SnCl₄ · 2NOCl on treatment with nitrosyl chloride.     

Etude par RMN 13C à 62,89 MHz de ramifications longues d'alcanes lourds branchés. Modèles de PEbd et des copolymères éthylène-α oléfines

A series of 12-alkyl tricosanes (four compounds) was examined by use of ¹³C nuclear magnetic resonance at 62,89 MHz as model compounds for isolated short- and long-chain (C₅, C₆, C₇, C₈) branches in low-density polyethylene and ethylene-α olefin copolymers. An array of ¹³C resonances was observed and we note that the ¹³C chemical shifts became insensitive to branch length with octyl and longer branches at this field.     

Polymérization anionique de l'isoprène par les insertions ternaires graphite–métal alcalin–solvant

The examination by HR–NMR of the microstructure of polyisoprenes synthesized in the presence of alkali metal–graphite compounds reveals that the polymerization has an anionic character. The microstructure of the polymers depends on the nature of the active centers, which depends on the solvent used in the preparation of the graphite compounds or as polymerization medium. With powdered alkali metal–graphite compounds, the propagation does not differ from the anionic one occurring in a homogeneous medium. Except for K–graphite, an enhancement of the 1–4 addition mode is observed if grains of Li or Na–graphite are used in mass polymerization. This change in the microstructure could be explained by the competition between the rate of propagation and the rate of diffusion of the growing chains from the grains to the homogeneous phase of the polymerization medium.