二极管端面抽运的固体激光放大器自身热透镜焦距测量

通过分析激光经过热透镜后光束半径的变化，提出了利用放大器测量热透镜焦距的方法.根据激光束传输与变换理论，得到了热透镜焦距的表达式，并分析了其前提条件和近似偏差.最后，基于上述理论分析，测量了激光二极管端面抽运Tm,Ho∶GdVO₄放大器的热透镜焦距. 关键词： 热透镜焦距 固体激光 激光束传输与变换     

端面抽运固体激光器热透镜效应的实验研究

提出一种易于实现、对激光器本身没有干扰、高空间精度、可实时测量介质热透镜的干涉测量方法. 并利用此方法全面研究了端面抽运Nd:YVO4激光器的热透镜效应，为认识激光介质的热效应和设计此类激光器提供了参考.  关键词： 热透镜 端面抽运 固体激光器     

激光二极管抽运固体激光器场分布的热不稳定性研究

通过建立激光介质非热平衡状态的振荡散热模型，分析了激光二极管抽运固体激光器中，热透镜的不稳定性.研究表明，热透镜的这种热不稳定性是造成激光场不稳定的重要因素.会造成高斯半径的不稳定波动，会使激光光束的指向角波动，会造成激光光斑的非对称畸变，这种畸变也处于波动之中.通过对端面抽运条件下，热耗为1W的Nd:YAG激光介质的理论和实验研究，确定了这种原因下光场不稳定度的数量级. 关键词： 激光二极管 固体激光器 热透镜     

一种测量二极管侧面抽运固体激光器热焦距的方法

提出了一种能够简单、准确测量二极管侧面抽运固体激光器热透镜焦距的方法,明确提出采用非对称平平腔测量时,激光晶体端面与腔镜的间距不需要为零,并从实验上证明了方法的可靠性. 应用该方法的测量结果可以优化复合折叠和频黄光激光器的结构,保证两束基频在腔内达到最佳的空间重合,提高腔内和频效率. 关键词： 全固态激光器 Nd∶YAG激光器 热焦距 腔内和频     

激光二极管端面抽运的1342nmNd：YVO4激光器

报道了用高功率线列阵光纤耦合激光二极管端面抽运的１３４２ｎｍＤｄ：ＹＶＯ４激光器,在１３．３０Ｗ输入抽运功率下,１３４２ｎｍ激光输出功率达到３．２２Ｗ,斜效率为２５．５％。输出功率不稳定度小于１％。     

激光二极管端面抽运Nd:YVO4实现1386 nm连续波激光输出

在Nd:YVO4晶体的4F3/2-4I13/2跃迁带内,除了1342 nm激光辐射之外,其它的跃迁谱线由于小的受激发射截面和强的寄生振荡,很难形成激光振荡.通过调整谐振腔损耗,获得了光纤耦合激光二极管端面抽运1386 nmNd:YVO4激光器激光连续输出.在抽运功率达到4.24 W时,得到了305 mW的1386 nm激光连续输出,最高输出功率下的斜效率为13.9%.实验中还观察到了1342 nm和1386 nm的双波长运转.根据抽运阈值能量和实验数据,计算得到了Nd:YVO4晶体中1386 nm激光辐射处的受激发射截面大约为(3±1)×10-19cm2.     

激光二极管端面抽运Nd:YVO4板条激光器及其热效应

激光器中激光介质采用板条状几何结构可以极大地降低它的热效应,但仍然需要进一步分析其影响,进而优化激光器效率.利用有限元分析方法分析了部分端面抽运的混合腔板条激光器中激光介质的热效应,计算的热透镜焦距与实测结果基本相符.分析了热效应对模式匹配的影响,分析结果对于优化激光器效率、改进谐振腔设计具有一定的参考价值.并在分析的基础上进行了混合腔实验,抽运功率为110 W时,获得连续输出激光功率41.5 W,光光转换效率约38%,斜效率达58.8%,M2因子为非稳腔方向M2x＝1.59,稳定腔方向M2y＝1.55.     

激光二极管端面抽运的1.34μm Nd:YVO4平凹腔型激光器

理论上分析了端面抽运的1.34μm Nd:YVO4平凹腔型激光器的各项参数;实验上实现了LD端面抽运的1.34μm Nd:YVO4平凹腔型激光器的运转.     

大功率部分端面抽运混合腔板条激光器

在半导体抽运的全固态激光器中,激光晶体上的热畸变限制了激光器在大功率下输出时保持高光束质量的能力。板条结构的固体激光器具有优异的散热能力,再配合部分端面抽运以及稳一非稳柱面混合腔的使用,使大功率高光束质量的激光输出成为可能。在德国EdgeWave GmbH进行的对这一技术的合作研究中,利用不到100mm的腔长,在Nd：YVO4板条激光器上获得了110W近衍射极限的1．06μm连续激光输出,这时在非稳腔方向上的光束传播因子M^2为1．3。在稳腔方向上为1．5。通过对输出激光进行空间滤波切除腔镜造成的衍射旁瓣后,50W输出时M^2的典型值在非稳腔和稳腔方向上分别为1．09和1．2。     

LD端面泵浦Nd∶YAG激光器中的热透镜焦距

采用热透镜焦距的理论计算与实验测量相比较的研究方法，得到一种端泵固体激光器出激光时的在线测量方法.通过建立热透镜等效腔模型以及腔型分析求解得出腔内光束束腰半径,用刀口法测出DPL腔外的远场发散角,根据发散角与透镜变换前后的束腰关系，得出LD端面泵浦Nd∶YAG激光器中的热透镜焦距.结果表明,通过上述方法所得结果与理论计算的热透镜焦距吻合,证实此方法准确、可行.     

Influence of pump beam size on laser diode end-pumped solid state lasers

Based on space-dependent rate equation, the lowest threshold input power for diode end-pumped solid state lasers is obtained for pump spot size w_p → 0. However, when the pump beam waist is decreased, the far-field half-angle increases due to the same beam quality, which will influence the match between the pump volume and mode volume. Most importantly, when the pump beam waist is decreased, the temperature and temperature gradient in the laser rod would be very high due to the resulting heat, which would cause material distortion, variation of refractive index, instability of laser resonator etc. We analyze the temperature distributions with different pump beam sizes and conclude that the condition w_p ≈ w₀ (the radius of the laser beam at the laser rod) is often taken as a rough guide to the optimum case.     

激光二极管端面抽运的1.34μm Nd:YVO4平凹腔型激光器

理论上分析了端面抽运的1.34μm Nd:YVO₄平凹腔型激光器的各项参数；实验 上实现了LD端面抽运的1.34μm Nd:YVO₄平凹腔型激光器的运转. 关键词： 固体激光 4晶体')" href="#">Nd:YVO₄晶体 平凹腔     

Experimental Investigation of Thermal Lensing in End-pumped Nd:YVO4 Crystal Using a New Simple Approach

The stability of linear planar resonators involved in solid-state lasers is entirely decided by the thermal lens of the laser crystal. There exists a critical point between stable state and unstable state at which the thermally focusing point falls on the surface of one end mirror. Based on this fact, a new method for measuring the thermal focal length has been presented, and applied to three different Nd3+-doped (2%, 0.8%, and 0.5% ) Nd:YVO4 crystals at various absorbed pump power levels up to 10 W, the results show a good agreement with those of theoretical calculation. It also indicates that the thermal lensing is strongly dependent on the Nd3+-doped concentration, and is affected by crystal surface temperature, especially in the situation of weak thermal lensing.     

LD端抽运平直腔Nd:YVO4固态激光器的输出功率特性研究

对LD端抽运平直腔Nd:YVO₄固态激光器输出功率特性受激光器内在诸因素(热透镜效应、腔长、激活孔径等)的制约关系进行了研究.并用传播圆-变换圆图解分析方法给出了合理的解释，同时，对进一步提高其输出功率特性指出了方向. 关键词： 固体激光器 热透镜 变换圆 平直腔     

激光热透镜焦距测量实验及其公式改进

通过平平非稳腔法对激光热透镜焦距进行了实验测量,研究了不同抽运光束腰位置对热透镜焦距的影响.从理论上引入抽运光远场发散角和束腰位置,对端面抽运激光晶体热透镜焦距公式进行了改进.     

Efficient Nd:YVO_4 laser in-band pumped by wavelength-locked 913.9-nm laser diode and Q-switch operation

An efficient 1064-nm Nd:YVO_4laser in-band pumped by a wavelength-locked laser diode(LD) at 913.9 nm was demonstrated. The maximum continuous wave(CW) output power of 23.4 W at 1064 nm was realized with the incident pump power of 40 W, corresponding to a total optical-to-optical efficiency of 58.5%. This is to the best of our knowledge the highest total optical-to-optical efficiency and output power of Nd:YVO_4laser in-band pumped by a 913.9-nm laser diode.The Q-switched operation of this laser was also investigated. Through a contrast experiment of pumping at 808 nm, the experimental results showed that an Nd:YVO_4laser in-band pumped by a wavelength-locked LD at 913.9 nm had excellent pulse stability and beam quality for high repetition rate Q-switching operation.     

Thermal effects of the diode end-pumped Nd:YVO4 slab

The thermal effects of the diode end-pumped Nd:YVO₄ slab laser crystal are investigated both analytically and numerically. The theoretical model is established with considering the divergence of the pump beam in the slab. A detailed theoretical analysis of the temperature, stress and the focal length of thermal lens are presented. Using 3D finite element analysis, an accurate numerical solution based on the theoretical model is achieved. Our analysis includes the thermal fracture damage of the thermally and optically anisotropic slab and the predicated values are compared with the experimental results.     

利用准直管法测凹透镜的焦距

介绍了利用准直管精确测量凹透镜焦距的方法，该方法借助一个焦距较长的凸透镜与被测凹透镜组成无焦系统，可以使准直管出射光束的张角发生改变；用一辅助凸透镜与一测微目镜进行平行光束的会聚，测出准直管玻罗板线对在辅助凸透镜焦平面上所成像的大小；经过相应计算可得到被测凹透镜的焦距。