Laser Mode-Dependent Size of Plasma Zones Induced by Femtosecond Laser Pulses in Fused Silica

We carry out the numerical simulations of femtosecond laser propagation with TEMoo mode, TEM10 mode and a beam combining both the modes in fused silica. It is found that the transverse size of plasma zones induced by laser pulses with the TEM10 mode is smaller than that induced by the TEM00 mode, while the longitudinal size is almost the same, and the saturated plasma density is higher. The transverse size, the longitudinal size and the ratio of the longitudinal to transverse size, for the beam combining both the modes, all could be reduced at the same time in comparison with the TEM00 mode under the same focusing conditions.     

封离式He-N$lt;sub$gt;2$lt;/sub$gt;-CO$lt;sub$gt;2$lt;/sub$gt;激光器横模特性的测量与分析

利用激光光束分析仪,实时在线测量了一根He-N₂-CO₂封离式激光管的横模分布特性,得到了激光模式随放电电流的变化关系.实验表明该激光器在最佳工作电流时,容易形成低阶模运转,但很难获得基模运转,通过改善对称性以及加快冷却水流速可以获得基模运转.通过激光动力学过程分析了模式变化的形成原因,为大功率激光器模式控制与改善提供了一定的理论和实验借鉴. 关键词： 2激光')" href="#">CO₂激光 横模 激光模式分析 光束质量     

Cross focusing of two coaxial spatial modes of a single frequency of a laser beam in a nonlinear dielectric

The cross-focusing of two co-axial transverse modes of a laser beam viz. TEM₀₀ and TEM₀₁ modes of the same frequency in a non-linear dielectric has been studied. When the TEM₀₀ mode is stronger than the TEM₀₁ mode, both modes focus on the axis. In the opposite case, defocusing occurs at the axis and energy concentrates in a ring.     

Frequency splitting phenomenon of dual transverse modes in a Nd:YAG laser

We observed frequency splitting phenomenon of dual transverse modes (TEM_00q and TEM_01q) in a Nd:YAG microchip standing wave laser utilizing intracavity stress birefringence effects. Four resonance frequencies (ν_00qe, ν_00qo, ν_01qe, and ν_01qo, respectively) were produced and tuned by changing the diametral compression force applied on the laser crystal. The transverse mode frequency spacing for the same longitudinal mode number (Δν_trans) was 1.16 GHz, and the magnitude of frequency splitting (Δν) ranged from 0 MHz to 1.16 GHz. Based on this phenomenon, a four-mode differential standing wave laser, whose signal characteristics were a little like those of a four-mode differential travelling wave laser gyro however with a much larger frequency splitting range, was produced. The theoretical analysis is in good agreement with the experimental results. This phenomenon not only can be used to make lasers with two or more frequency differences, but also can be used to make high-resolution self-sensing laser sensors (e.g. laser force sensors and laser accelerometers).     

Frequency stabilization of an internal mirror HeNe laser at 543.5 nm to I2-Saturated absorptions

An internal mirror green HeNe (GRENE) laser at 543.5 nm has been frequency stabilized to I₂-Doppler free absorption signals with a frequency stability of few parts in 10¹⁰. The saturated absorption signals were detected using doubly-differential saturated absorption which eliminates the Doppler background and allows first-derivative locking methods. Two absorption lines R(12)26-0 and R(106)28-0 of ¹²⁷I² were investigated and the hyperfine structure was resolved. Random polarization flips of the GRENE were suppressed by applying a transverse magnetic field to the laser tube near the anode.Present address: Physikalisch-Technische Bundesanstalt, Bundesallee 100, D-3300 Braunschweig, Fed. Rep. Germany     

Diffraction losses and selection of transverse modes in complex resonators

Diffraction losses are estimated for TEM₀₀, TEM₀₁, and TEM₁₀ modes which can be generated in complex resonators. Dependences of the output power of the laser operating in the regime of transverse oscillation suppression on the transmission of the mirror are obtained. Optimal relationships between the field stop aperture area and the optical beam cross section are determined as functions of the gain of the active medium.     

Influence of the modal composition of the radiation on the oscillation dynamics of a CO2-laser with a saturable absorber

The influence of the modal composition (transverse modes of a single longitudinal mode) of the laser radiation on the oscillation dynamics of a CO₂-laser with a saturable absorber in the cavity is investigated. Passive Q-switching in initiation of the fundamental mode TEM₀₀ and the modes of the first family TEM₀₁ and TEM₁₀ is considered. It is established that in the case of multimode oscillations sequences of single pulses with an irregular change in their amplitude can be observed. The multimode oscillations obtained are compared with similar single-mode oscillations, and their special features and differences are discussed. Reported at the Second International Scientific and Technical Conference on Quantum Electronics, Minsk, November 23–25, 1998. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 66, No. 5, pp. 681–687, September–October, 1999.     

Thermal fields in laser–multi-layer structures interaction

In the present paper, we are dealing with the thermal fields for laser–periodic multilayer structures interaction. Our point of view is originally that we consider any order transverse laser beams, like heating sources. We consider that the laser beam acts in IR (Nd:YAG or CO₂ laser beam) and it is in one transverse mode or in only a few decoupled modes. In order to solve this problem, we will use the Green function method. Specific results are presented for a laser beam (Nd:YAG laser) operating in the mode TEM₀₁ and a two-layer structure.     

Simultaneous self-mode-locking of TEM<Subscript>0,0</Subscript> and TEM<Subscript>1,0</Subscript> modes in a Nd:YVO<Subscript>4</Subscript> laser: Application for measuring the thermal focal length

We demonstrate that the simultaneous self-mode-locking of TEM_0,0 and TEM_1,0 modes can be achieved in a standard end-pumped Nd:YVO₄ laser. With this simultaneous self-mode-locking, the transverse beat frequency can be accurately measured as a function of the absorbed power. We employ the measured beat frequency and the cavity theory to precisely determine the effective focal length of the thermal lens in the gain medium.     

Amplitude modulation of the cw laser light in the TEM mn mode by means of a mechanical chopper

Amplitude modulation of the laser beam in a TEM _mn mode by means of a mechanical chopper is investigated on the basis of the chopping model represented by a moving system of infinitely long, parallel slots and mark spaces. The cases of rectangular and axial symmetry of the laser beam are both treated. The explicit expressions for the waveform of the modulated normalized transmitted laser power are deduced and their consequences investigated. It is found that in the case of rectangular symmetry, unlike the case of axial symmetry, the TEM _mn modes give, for a constant value of the mode numbern and for any value ofm, the same time dependence of the amplitude modulated laser power. The notion of the equivalent modulation widths is introduced and conditions for the efficient amplitude modulation are found.     

Transverse mode frequency pulling in free electron lasers

We consider the spectral evolution of transverse modes in free electron lasers. While the gain maxima of the various transverse modes occur at different frequencies, coupling between the modes via the electron beam causes the modes to shift frequency such that the final laser frequency differs from what one would expect if only the TEM₀₀ mode were present. This can strongly effect the turn-on behavior in lasers with short electron pulses.     

Hyperfine structure in Iodine at the 612-nm and 640-nm helium-neon laser wavelengths

The hyperfine structure of iodine-127 at 612 nm and 640 nm is observed by saturated absorption in a gas cell placed within a He-Ne laser cavity modified to operate at these wavelengths. At 612 nm, all the 21 components of the strong R 47 9-2 line lie within the laser gain profile, and the resulting saturated absorption peaks have a contrast of 10% at a gas pressure of 3 Pa.     

激光横模相位补偿的远场分布

本文分析了激光TEM_m0和TEM_0l模相位补偿的远场分布。结果表明,其远场分布特性均有本质的改进。 关键词：     

Diffraction properties of opaque disks outside and inside a laser cavity

Diffraction of symmetrical Laguerre-Gauss TEM_p0 beams incident on an opaque disk known as a stop is considered. The near- and far-field patterns are studied. Thanks to zero-field occluding, conversion from TEM₁₀ beam to dark hollow beam can be achieved with better efficiency than from a TEM₀₀ beam. It is shown that the fundamental mode of a laser cavity including a diaphragm and a stop can be TEM₀₀- or TEM₁₀-like in shape depending on their size. This result is interpreted from the new divergence hierarchy, which characterises the diffracted TEM_p0 beams emerging from the stop.     

High-power Q-switched laser with high-order Laguerre–Gaussian modes: application for extra-cavity harmonic generations

We present a compact efficient scheme for generation of high-order Laguerre–Gaussian TEM _p,0 modes in a diode-pumped actively Q-switched Nd:YVO₄ laser. The resonator is composed of two plane mirrors with an intracavity concave lens to expand the cavity mode size for generating a high-power Laguerre–Gaussian TEM_5,0 mode. We further confirm that the TEM_5,0 mode is noticeably superior to the TEM_0,0 mode in the processes of second and third harmonic generations.     

Simple annular-beam generator with a laser-diode-pumped axially off-set power build-up cavity

We have developed a novel, compact-mode selective annular-beam generator that employs a laser-diode (LD)-pumped, passively locked power build-up cavity (PBC). The PBC functions as a flexible and compact light source that is capable of producing TEM_0n high-order Hermite-Gaussian (HG) beams. The generated HG beams can then be converted to LG modes, particularly to annular-beams, using two cylindrical lenses. The system was theoretically studied and a mode-matching condition was derived. The tailoring position of the active semiconductor laser medium relative to the external cavity of the PBC enabled the production of single high-order HG modes. The optimum position was calculated by model calculations of the mode-coupling efficiency. The desired TEM_0n modes of HG beams were generated by translating the axial position of the external cavity of the PBC in increments of ∼100 μm relative to the LD emission surface. High quality TEM₀₁ to TEM₀₁₅ of the HG beams and their conversion to the desired LG modes having powers of the order of 1 mW was successfully demonstrated. This system is suitable for optical tweezers.     

Characterisation of the potential of frequency modulation and optical feedback locking for cavity-enhanced absorption spectroscopy

A combination of optical feedback self-locking of a continuous-wave distributed feedback diode laser to a V-shaped high finesse cavity, laser phase modulation at a frequency equal to the free spectral range of the V-cavity and detection of the transmitted laser beam at this high modulation frequency is described for the possible application in cavity-enhanced absorption spectroscopy. In order to estimate the noise level of an absorbance baseline, the triplet of frequency modulated light, i.e. the central laser frequency and the two sidebands, were transmitted through both the V-cavity in open air and a 1.5-cm long optical cell placed behind the cavity output mirror and filled with acetylene (C₂H₂) at low pressure. The performance of the setup was evaluated from the measured relative intensity noise on the cavity output (normalised by the bandwidth) and the frequency modulation absorption signals induced by C₂H₂ absorption in the 1.5-cm cell. From these data, we estimate that the noise-equivalent absorption sensitivity of 2.1 × 10^?11 cm^?1 Hz^?1/2—by a factor of 11.7 above the shot-noise limit—can be achieved for C₂H₂ absorption spectra extracted from the heterodyne beat signals recorded at the transmission maxima intensity peaks of the successive TEM₀₀ resonances.     

Temperature profiles modeling in IR optical components during high power laser irradiation

In this paper the temperature profiles of heat propagation in homogeneous IR optical components during irradiation with a high power laser (e.g. CO₂ laser) having different cross-section power distributions are examined. A mathematical model to calculate the temperature variation was developed, and the analytical solution for the heat equation was found. The method is based on the integral transform techniques applied to the partial differential equation of heat conduction in solids. Thermal profiles are plotted as functions of the sample dimensions and exposure time, for laser beams operating in TEM₀₁ and TEM₃₀ modes. Our results indicate that: (i) temperature profile has an angular dependence; (ii) high temperatures can be achieved in the sample center, even in the situations when the laser beam has zero power densities in this point; and (iii) the temperature profile depends strongly on the heat transfer coefficient.     

A compact,sealed, single mode TEA CO2 laser

A compact, sealed, TEA-CO₂ laser utilizing a double-discharge technique has been constructed and operated under single-mode conditions. Sealed operational lifetimes exceeding 10⁶ pulses have been obtained by the addition of small quantities of hydrogen and CO to the initial gas mixtures. It has also been found that operation without helium is possible giving single-mode output energies of about 20 mJ/pulse at peak powers of about 150 kW. The pulse repetition frequency was 0.5 s^-1. The use of an 18 cm long laser cavity allowed the oscillation of only one longitudinal mode when the frequency of the cavity was tuned closely to the CO₂ line centre frequency. An iris was used to restrict transverse modes to the TEM₀₀. Beat frequency measurements using a stable, CW CO₂ laser indicate a “chirp” of about 5–6 MHz/μs in the tail of the pulse.     

Dynamics of helical-wave emission in a fiber-coupled diode end-pumped solid-state laser

We have generated TEM_0,l ^* modes in an end-pumped microchip laser using a standard fiber-coupled diode. A rich set of dynamic behaviors, such as periodic and quasi-periodic self-modulation, chaotic pulsing and frequency locking was observed in the generated TEM_0,l ^* modes. Experimental results confirm the theoretical predictions that the locking occurs as a subcritical bifurcation and that a region of coexisting locked and unlocked states exists. Received: 14 November 2000 / Revised version: 22 January 2001 / Published online: 23 May 2001