负二进制编码的光学阵列化复数运算

建立一套新颖的光学负二进制并行算法体系，包括加权－移位加法、列阵乘法等。一切运算无符号位、无进位、无再编码。利用两层阵列可实现高精度的复数运算，三层阵列可实现复数矩阵－矢量运算。该算法体系非常适合于光学执行。相应地，文中给出了两层列阵复数相乘光学系统及实验结果。原理上，该算法是可级联的。     

双路可编程光学多重成像并行二值逻辑处理器

基于多重成像原理，在本文中提出一种光学并行图像逻辑处理系统。对输入图案用两个正像和两个补偿进行编码。通过光调制器控制，可以实现逻辑操作的实时可编程。而且，该系统可以通过控制一组四个偏振片的状态实现独立的双输出逻辑通道，每一个输出通道各有十六种逻辑功能。文中也给出了实验结果。     

基于4F系统光学逻辑编码的实验

设计了用4F系统进行光学逻辑编码的方法.根据4F系统的工作原理,通过分析光栅衍射屏横向位移量与衍射光相位改变量之间的关系,约定两衍射级光强相加时为“1”,两衍射级光强相消时为“0”的光学逻辑编码规则.实验结果表明:输出信号线性好,符合编码要求.     

Cellular processing for edge detection in an optical shadow casted architecture

The principles of two-dimensional cellular processing are utilized to obtain the edges of a binary image in an optical shadow casted architecture. The processing steps, based on image logic algebra are introduced where operation kernels are set by the on/off states of four light sources. The input binary image is shifted, superimposed, then logically operated and finally decoded to obtain the edges. The whole process is controlled by a microcomputer. Experimentally simulated results are presented.     

二维空间紫外LED阵列实现单光斑辐照固化系统的设计

新型大功率紫外LED具有电光转化效率高、光谱纯度高和体积小等优点,但单管LED功率仍很难满足光固化的要求,针对单光斑辐照要求,提出采用空间阵列UV-LED排布实现能量累加的方案。该方案通过单管LED聚光系统与集成阵列系统综合设计实现了各单元单光斑辐照度在辐照面上的合成,最终得到的光斑辐照度分布均匀、尺寸合理,阵列系统后工作距离长,完全满足现场应用的具体指标要求。通过外围电子线路控制阵列LED的电流强度及通断状态可实现光斑辐照度在(1000～1800) mW/cm²可调,光斑尺寸为1cm²,后工作距离为10cm。     

Performance Comparison and Evaluation of Options for Arranging Data in Digital Optical Parallel Computing

Performances of options for arranging data in the input images of digital optical computing are analyzed and evaluated on the basis of the characteristic functions that the authors formularized. The methods for arranging the data are classified into two options: the spatially expanded bit-pattern arrangement (SEPA) and the bit-slice arrangement (BSA). To analyze and evaluate the performance, the options are applied to the parallel operations based on the optical array logic that is a paradigm of digital parallel computing. Processing steps, storage capacity, and scale of the operation kernel required for performing various parallel operations are analyzed as the characteristic functions. The performances of the SEPA and the BSA are evaluated by comparing these functions. The features of each option are clarified and a guideline for choosing the optimal option is proposed to efficiently perform digital parallel optical operations.     

BILED／BILD组合回路的光学逻辑运算

利用激光二极管或发光二极管混合双稳态回路(BILD/BILED)的组合,得到了光学多稳态,光学异或逻辑门和光学R-S触发器.这种光电子学的逻辑回路与大规模集成技术完全相容,因此有希望应用于光学信息处理,光通信和光计算.     

应用在相控阵雷达上的光学实时延迟线

相控阵天线是雷达技术的重要发展方向之一。电子相控阵雷达所遇到的问题是天线阵列孔径效应限制了雷达信号的瞬时带宽,使其不能满足通信和雷达技术的发展需要。光学实时延迟技术,可以解决这一问题。介绍了相控阵天线光实时延迟控制原理。并对几种典型的光实时延迟线的工作原理和技术特点作了简要的分析。     

丝阵负载Z箍缩可见光图像诊断系统

主要介绍了为“强光一号”加速器丝阵负载Z箍缩实验设计的可见光图像诊断系统,系统时间分辨约为5 ns,空间分辨约为6.5 lp/mm,光谱响应范围365~750 nm。系统能够满足从早期单丝电离到等离子体柱飞散整个Z箍缩过程的诊断要求, 给出了系统在Z箍缩实验中获得的丝阵负载内爆图像序列,并对其反映的内爆现象进行了初步的唯象分析。     

Design of midwave infrared athermalization optical system with a large focal plane array

Based on the most advanced staring focal plane array which had a format of 640 × 480 and the pixel pitch of 15 μm, a set of all-sphere midwave infrared ahermalization optical system was designed. The working wavelength was in 3–5 μm, the full field of view was 8.58°, the relative aperture was 1/2, the efficient focal length (EFL) was 80 m. The opticalsystem consisted of four lenses with three kinds of material – Ge, ZnSe and Si. All surfaces were sphere, which was easier to process test, making the cost inexpensive, and it could avoid using diffractive surface and aspheric surface. The image quality of the system approaches the diffraction limit in the temperature range −60 °C-180 °C. The design results proved that, the high resolution midwave infrared optical system had compact structure, small volume, high resolution and excellent image quality, meeting the design requirements, so that it could be used for photoelectric detection and tracking system.     

Simplification of Space-Variant Parallel Logic Operations Using the Temporal Method

A time-domain encoding method (temporal method) for space-variant parallel logic operations, which can execute different operations in parallel, is proposed. The temporal method is based on temporal encoding of two input patterns, temporal gating of the coded pattern, and decoding by temporal addition of the gated patterns. The first feature of the proposed method is that parallel logic operations can be performed without complex pattern transformations. The second feature is that the logical output can be directly fed to succeeding systems without specific decoding. Therefore, the logic operation system can be constructed using conventional optics and existing spatial light modulators. In order to confirm these features, an optoelectronic experimental system is constructed and space-variant parallel logic operations are performed.     

两层阵列二的补码复数并行算法及其光学实现

提出了直接的二的补码阵列算法，基于混合二的补码表达方式，加法，减法和阵列乘法都能全并行地实现。直接算法克服了传统算法中存在的困难，即原理上对操作数的编码位数无限制，更有效地利用了空间带宽积，卷积后的序更直接加权求和即为两数的乘积，复数运算由包含四个区域的两层阵列完成，并进行了光学实验。     

Optical and electronic design for a field prototype of a laser-based vehicle delineation detection system

A field prototype of a laser-based non-intrusive vehicle detection system has been developed for the measurement of delineations of moving vehicles on the highway. This prototype is based on our previous research on the principle of the measurement. The detection system uses two laser lines that are projected onto the ground as probes. The reflected light is collected and focused onto a photodiode array by an optical system. Vehicle presence is detected based on the absence of reflected laser light. By placing two identical laser/sensor pairs at a known distance apart, the speed of both the front and rear of a vehicle can be calculated based on the times when each sensor is triggered. The detector data are acquired and processed by a real-time system to obtain speed, acceleration, and length of a detected vehicle. The travel time of a vehicle can be acquired by detecting a vehicle at the beginning of a link and re-identifying the same vehicle at the end of the link. Several tests have been done with the field prototype system on the highway. The testing results show that the system can obtain the accuracy of measurement necessary to distinguish between moving vehicles on the highway. This article describes the design and implementation of each functional component of an advanced version of the field prototype system.     

Parallel Image Processing Algorithms Based on Mathematical Morphology Using a Multiple-Imaging System

Morphological techniques are applied to binary image processors in a multiple-imaging optical system and the following algorithms are proposed: performing morphological basic operations, extraction of boundary lines, detection of characteristic points in small-scale patterns, elimination of salt noises with few pixels, and smoothing of boundaries. Techniques for processing a complicated binary image are demonstrated using the algorithms and a hybrid parallel computing system with a simple optical multiple-imaging system and a personal computer.     

大相对孔径紧凑型无热化红外光学系统设计

根据目前搜索和跟踪系统要求其红外成像光学系统具有高成像质量、超轻小型化和高温度适应性的特点。采用折反射式光学系统结构形式,基于J-T制冷型320×320凝视焦平面阵列探测器,设计了一种大相对孔径紧凑型无热化红外光学系统,光学系统远摄比达到0.6。采用光学被动消热差方法进行设计,使该系统在-40℃～60℃温度范围内实现了无热化。同时采用杂散辐射分析软件对系统进行杂散辐射分析,提出合理杂辐射抑制方案,给出了完整的光学系统设计。结果表明,光学系统在不同温度环境下所有视场的调制传递函数(MTF)(17lp/mm)均接近衍射极限,80%的能量集中在1个像元内,且具有结构紧凑、体积小等优点,可满足搜索和跟踪红外光学系统的使用要求。     

When optical microscopy meets all-optical analog computing: A brief review

As a revolutionary observation tool in life science, biomedical, and material science, optical microscopy allows imaging of samples with high spatial resolution and a wide field of view. However, conventional microscopy methods are limited to single imaging and cannot accomplish real-time image processing. The edge detection, image enhancement and phase visualization schemes have attracted great interest with the rapid development of optical analog computing. The two main physical mechanisms that enable optical analog computing originate from two geometric phases: the spin-redirection Rytov-Vlasimirskii-Berry (RVB) phase and the Pancharatnam-Berry (PB) phase. Here, we review the basic principles and recent research progress of the RVB phase and PB phase based optical differentiators. Then we focus on the innovative and emerging applications of optical analog computing in microscopic imaging. Optical analog computing is accelerating the transformation of information processing from classical imaging to quantum techniques. Its intersection with optical microscopy opens opportunities for the development of versatile and compact optical microscopy systems.     

Real-Time Reconfigurable Interconnections for Parallel Optical Processing

In this letter we describe the advantages of a dynamic optical interconnection system for parallel information processing applications. The system is based on a liquid crystal television which acts as a binary phase-only spatial light modulator. We describe example algorithms where reconfigurable interconnects would be useful and present results of several interconnection topologies which have been implemented.Presented at the International Commission for Optics Topical Meeting, Kyoto, 1994.     

Improving the power coupling efficiency in a relay mirror system using a multiple laser array

We propose a new relay mirror system configuration in which the transmitting telescope is composed of an array of tightly tiled sub-apertures. By controlling the piston-type optical phase in each aperture using the stochastic parallel gradient descent (SPGD) algorithm, it is shown that the intensity distribution can be shaped at the receiving plane and that the power coupling efficiency can be improved.     

小轻型CCD遥感相机全反射光学系统设计

利用三反射镜的消像差理论 ,进行了一种小轻、大视场的全反射系统的设计。该系统通过同轴设计、离轴使用 ,使筒长达到 f′/7～ f′/9,视场达到 3°以上 ,遮光比在 6 %以下 ,像质达到衍射极限。这种系统特别适于长焦距遥感 CCD相机的应用。