共查询到16条相似文献,搜索用时 62 毫秒
1.
一种用于数字QAM接收机的盲均衡器实现 总被引:1,自引:1,他引:0
提出了一种适用于数字QAM接收机的自适应盲均衡器实现方案。该均衡器采用多模算法(MMA)和最小均方算法(LMS),称为MMA—LMS算法结合判决反馈结构(DFE),即采用前向滤波器和反馈滤波器两级滤波器组实现,提高了信道的适应性能和降低均衡器的阶数。仿真结果表明,该均衡器比一般采用恒模算法(CMA)的横式均衡器有更好的性能,更易于硬件实现。 相似文献
2.
一种全数字QAM接收机符号定时和载波相位恢复方案 总被引:18,自引:0,他引:18
本文提出的全数字QAM接收机同步系统的实现方案,将最大平均功率定时同步算法与最大似然载波相位恢复方法相结合,实现了符号定时的同步和载波相位的恢复,整个算法构成一个数字信号处理过程,将符号定时、载波相位和符号解调最佳问题的三维搜索分解为符号定时和载波相位最佳估计的一维搜索,在实现同步的同时也得到符号的最佳解调。算法在定时和相位估计过程中分别采用局部并行前向结构,运算速度快,不需要专门设计同步头就能用于TDAM突发模式。 相似文献
3.
4.
5.
全数字接收机平方定时恢复环路 总被引:1,自引:0,他引:1
本文着重研究全数字接收机中定时恢复环路的设计.该环路由内插滤波器,预滤波器,平方定时误差检测,环路滤波和定时控制单元组成,仿真结果表明.通过预滤波明显减小了定时抖动,该算法可以达到较好的性能,井由单片FPGA实现,该芯片已成功用于QM全数字接收机中。 相似文献
6.
本文介绍了具有同步锁定检测的符号定时恢复方法。此方法在Garder检测器的基础上,不改变整个定时环路的结构,巧妙的利用了原Garder检测器的采样点,在检测定时偏差的同时,它可以很好的指示出符号是否同步。本文阐述了它的基本原理,分析了它的性能,并经过推导,给出了相关的数学表达式和相应的电路实现模型以及特性曲线(S曲线)。最后给出了在QAM数据解调中其相应的仿真结果。 相似文献
7.
8.
介绍了一种中频数字化PCM/FM接收机的定时误差恢复方法,它采用准最佳定时误差提取算法以及多项式内插器进行定时误差提取和纠正。计算机仿真结果表明,该方法是可行的,适合DSP实现。 相似文献
9.
一种用于OFDM符号定时跟踪的盲估计算法 总被引:1,自引:0,他引:1
利用具有循环前缀和循环后缀的OFDM帧结构,该文提出了一种新的符号定时跟踪盲估计算法。理论分析及仿真表明,无论在AWGN还是多径衰落信道条件下,该定时算法估计的均方差都小于ML算法。 相似文献
10.
将零逼近和最小均方估计算法运用于盲匹配滤波接收机(MFR)中,并对这两种算法所得到的比特误码率(BER)作了仿真比较。在噪声存在时,使用常系数算法(CMA)对信道进行估计的效果变差;为此,改用了最大似然序列估计算法(MLSE)并对匹配滤波器(MF系数进行了修正,同时使用Matlab进行了仿真,仿真结果表明:MLSE方法在低信噪比时使接收机表现出良好的性能。 相似文献
11.
12.
A fast symbol timing recovery (STR) scheme suitable for flexible-symbol-rate, burst-mode M-ary QAM (M-QAM) and PAM (M-PAM)
demodulators used in broadband communications is proposed. The maximum- likelihood (ML) estimation is used to derive a feed-forward
STR strategy to achieve fast and accurate derivation of the optimum timing instant with a very short training preamble for
applications requiring short packet transmission. In addition, the signal sample at the optimum timing instant is reproduced
by interpolation. Analysis to derive the ML-based timing estimation algorithm and STR structure is presented. Analytical models
are developed to evaluate the effects of imperfect interpolation and channel additive white Gaussian noise (AWGN) on the timing
estimation performance. The derived expressions can be used for optimum interpolation filter design and selection of key parameters
to achieve the required mean squared timing error. Simulation results are in good agreement with the analytical prediction. 相似文献
13.
14.
本文提出了一种新的适合于OFDM系统的符号定时估计算法。该算法利用经过特殊处理的前后两段信息序列的内在相关性进行准确的符号定时估计。理论分析和仿真表明,该算法能在大频偏低信噪比的条件下完成定时捕获的任务,并且无需专门的训练符号,从而大大提高了系统传输的效率。 相似文献
15.
文章在研究Schmidl&Cox同步算法的基础上,提出了一种改进的符号定时同步算法。改进后的算法通过对原算法训练符号的加权,消除了定时同步中的峰值平台问题。仿真结果显示,该算法的定时同步性能优于原算法。 相似文献
16.
Axel Gesell Johannes B. Huber Berthold Lankl Georg Sebald 《AEUE-International Journal of Electronics and Communications》2002,56(5)
Timing phase estimation (TPE) plays the key role in feedforward (FF) symbol timing.For reasons of performance often data-aided (DA) methods are preferred. But frequently, they turn out to be critical with respect to theimplementation and the spectrum efficiency (due to the required overhead).This paper presents three DA TPE methods for quadrature pulse amplitude modulation (PAM). In spite of their very low complexity, these methods closelyapproach the theoretical limit for timing estimation with respect to the estimation variance, even at low SNR. This enables power efficient transmission.Further, they employ a CAZAC (constant amplitude, zero auto-correlation)sequence as training-sequence (TS), or a sequence with similar correlationproperties. Since such sequences are suited for almost all DA receiver tasks, a high spectrum efficiency can be obtained by the use of a single TS. A generalization of the proposed methods for DA TPE withrespect to the choice of the TS is also shown. The presented methods can be applied to noncoherent receivers. They are suited for high data-rate applications, since they can work with an oversampling factor of 2. 相似文献