高掺镁LiNbO3晶体折射率温度系数的表示式

推导了掺５ｍｏｌ％ＭｇＯ的ＬｉＮｂＯ３晶体折射率温度系数的表示式。利用这些表示式可以计算２９３～４２８Ｋ温度和０．５３９８μｍ～１．３４１４μｍ波长范围内的折射率温度系度，结果表明：计算值和实验值的最大相对偏差是１２％，用具有最大相对偏差的折射率温度系数的计算值，计算１．０７９５μｍ波长的非临界相位匹配温度，其值为３８２．４Ｋ，它与实验值仅差６Ｋ。因此，本文得到的表示式，对于采用这种晶体，设计在上     

高掺镁铌酸钾晶体的主折射率及其温度系数的测量

本文报道掺5mol%MgO的铌酸锂(liNbO_3)晶体的主折射率n_o、n_o及其温度系数.用自准直法在0.5398μm、0.6328μm、1.0795μm和1.3414μm波长上,并在20℃～160℃温度范周内,测量了该晶体的主折射率,并获得在这些波长上的折射率温度系数.修正的Sellmeier方程的常数也在20℃～160℃温度内推算出.用此结果计算室温的二次谐波I类临界相位匹配角与实验值符合得很好,又计算二次谐波的非临界相位匹配温度,其结果也与实验值较符合.     

铁电单晶0.62Pb(Mg1/3Nb2/3)O3-0.38PbTiO3折射率的研究

用最小偏向角法在20℃下精确测量了0.62Pb(Mg1/3Nb2/3)O3-0.38PbTiO3(0.62PMN-0.38PT)单晶的折射率,给出了该温度下折射率色散的Sellmeier方程.研究了能带结构与折射率的关系,计算了样品的Sellmeier光学系数:对no,E0=5.50eV,λ0=0.226μm,S0=1.004×1014m-2,Ed=28.10eV;对ne,E0=5.57eV,λ0=0.223μm,S0=1.017×1014m-2,Ed=28.10eV.ABO3型钙钛矿材料中,BO6八面体基元决定了晶体的能带结构,对折射率产生重要影响.     

五磷酸镧钕激光晶体发光的温度效应

研究了低温下Nd0.9 La0.1 P5O14晶体中,Nd3+离子在0.9,1.05,以及1.35μm附近发光光谱的精细结构及相应的跃迁过程,并与Nd:YAG晶体中Nd3+离子发光光谱及相应的跃迁作了比较。在77K-500K的温度变化范围内,研究了Nd3+在两种晶体中最强的发光线的温度依赖关系,发现相反的变化规律,指出这是与两种晶体的结构及跃迁过程有关。     

YAlO_3:Nd~(3 )的吸收光谱

从0.33—5.7μm的波长范围内系统地测定了温度为10K、90K和30OK时YAlO_3:Nd~(3 )的吸收光谱,定出Nd~(3 )在晶体场作用下的斯塔克(Stark)子能级。并在10K到663K的温度范围内,观察了部分光谱线的温度效应,得到一些有意义的结果。     

KTP和 7.5 mol% Nb∶KTP晶体在 Nd∶YAG激光中的倍频和和频(英文)

本文在获得精确的 7.5mol% Nb∶ KTP晶体的 Sellmeier主折射率色散方程的基础上 ,计算 7.5mol% Nb∶ KTP晶体对 1 .0 6 42μm和 1 .3 1 88μm Nd∶ YAG激光的倍频和和频的 型相位匹配曲线 .通过研究 KTP和 7.5mol% Nb∶ KTP晶体的主折射率 ,双折射率和相位匹配 ,可以看出 Nb掺入 KTP晶体后产生的折射率和双折射率的色散和各向异型的变化是引起 KTP晶体相位变化的根本原因 .     

BiB3O6晶体主轴折射率及其温度系数

利用自准直法，在30℃到170℃温度范围内分别测量0.4880 μm、0.6328 μm、1.0640 μm、1.3414 μm等波长下BiB₃O₆(BIBO)晶体的主轴折射率.得到不同温度下的Sellmeier方程及各主轴折射率的温度系数.计算了1.0795 μm下BIBO晶体的的主轴折射率.与实验测量的结果进行比较，两者的差异不大于2×10－4.     

温度调谐MgO：LiNbO3晶体光参量振荡器

采用调Q Nd:YAG激光倍频光(0.532μm)泵浦温度调谐MgO:LiNbO_3晶体单、双谐振光参量振荡器(OPO包括DRO、SRO)的实验结果.双谐振(DRO)调谐范围达844.1～1411.3nm,最低泵浦阈值0.22mJ/pulse;单谐振(SRO)调谐范围达738.9～1032.2nm,最低泵浦阈值0.66mJ/pulse.最大能量转换效率为10.4%.     

YAlO3:Nd3+的吸收光谱

从0.33—5.7μm的波长范围内系统地测定了温度为10K、90K和30OK时YAlO₃:Nd³⁺的吸收光谱,定出Nd³⁺在晶体场作用下的斯塔克(Stark)子能级。并在10K到663K的温度范围内,观察了部分光谱线的温度效应,得到一些有意义的结果。 关键词：     

3～5μm角度调谐LiNbO3晶体光参量振荡器的技术研究

用LiNbO₃作参量晶体、调QNd:YAG(1.064μm)激光器做泵源,通过求出相位匹配点对有效非线性系数进行数值计算,找出有效非线性系数的最大值,从而求出该点对应的相位角和方位角,确定出进行角度调谐LiNbO₃晶体的切割角在理论计算过程中,用计算机模拟,得出了OPO的角度调谐曲线、有效非线性系数曲线和参量增益曲线实验研究中实现了369μm单点参量光输出,实验结果与理论计算结果相吻合.     

热效应对高功率b轴Nd+CrNd:YAP连续激光器输出的影响

本文在文献[1]的基础上提出了含有椭圆折射率分布介质谐振腔的设计方法。分析了b轴_Nd+Cr^Nd:YAP连续激光器中热效应对激光横向场分布,输出偏振方向以及输出功率的影响。考虑了这种影响后,已从φ5.8×111mm的Nd:YAP棒和φ6.4×100mm的Nd+Cr:YAP棒中得到了163W和152W的输出,器件效率分别为2.26％和2.11％,输出激光的退偏度为1/2900 关键词：     

Growth of active Nd-doped YAP thin-film waveguides by laser ablation

3 (YAP) thin films as a promising material for application in a planar waveguide laser has been studied. The films have been grown on sapphire(0001) and YAP(001) substrates by laser ablation. The influence of the substrate temperature and ambient oxygen pressure on the crystalline structure, concentration of Nd incorporated into films, and consequent luminescence spectra were investigated. The waveguiding properties were observed and refractive index of the films was evaluated. Received: 8 February 1998/Accepted: 9 February 1998     

石英晶体的色散方程及折射率温度系数

研究了石英晶体在不同温度下折射率随波长的变化规律.通过对Sellmeier方程严格求解,得出了其系数表达式,计算出了不同波长对应的折射率,经验证与实验值符合得很好.通过曲线拟合求解出了折射率温度系数表达式,由此式可计算出不同波长折射率温度系数;进一步求解出了Sellmeier方程常量随温度变化地数值,得到求解不同温度任意波长的石英晶体主折射率的一种方法.     

High-power diode-pumped continuous-wave Nd(3+) lasers at wavelengths near 1.44 microm

We demonstrate longitudinally diode-pumped operation of Nd:YAG and Nd:YAP lasers at the long-wavelength end of the (4)F(3/2) ? (4)I(13/2) transition in the eye-safe spectral region at 1444 and 1430 nm, respectively. Special crystal coatings were required for achievement of lasing at these wavelengths. Output powers of up to 4.9 and 2.2 W, with slope efficiencies of up to 22% and 8%, respectively, were achieved. Polarized operation of the Nd:YAG laser yielded output powers of 76% as compared with unpolarized operation. Because of thermal stress, both YAG and YAP crystals were fractured at roughly 25 W of absorbed longitudinal pump power.     

射频超导腔加速性能的改进

为提高超导加速腔的加速梯度和Q值，改进了薄膜型超导腔的加速性能。研究证明，对于铜铌溅射腔，在无氧铜衬底和铌膜之间加入NbN 层可以提高铌膜的超导转变温度，改善晶格结构；对纯铌超导腔提出了改进方法，在传统的纯铌超导腔表面制备多层的超导-绝缘-超导复合膜可以屏蔽Nb腔表面的界面场，提高超导腔的临界磁场，从而提高了铌腔的加速梯度。     

Optical multistability in silicon observed with a cw laser at 1.06 μm

A cw Nd: YAG-laser beam partially absorbed in a Si-crystal, produces refractive index changes. With an incident power of up to 3 W focussed to 150 μm spot radius, the optical cavity formed by the two surfaces of the crystal (thickness 500 μm) is tuned over four resonances. The transmitted power shows a steplike multi-stable behaviour. Free carrier production and thermal index changes are discussed as mechanisms.     

Review of the formula of thermal focal length in side-pumped laser rods

The expressions of focal length in side-pumped rod lasers are studied. Good agreement is obtained between simulation and experiments reported previously, using Koechner's theory. The results reveal that underestimation of thermal lens accrues from overestimating the material's thermal conduction and without considering the nonuniform heat deposit. In the case of Nd:YAG rods, temperature-dependent variation of the refractive index constitutes the major contribution of thermal lensing, whereas the temperature- and stress-dependent variations of the refractive index make the major contributions of thermal lensing for Nd:Glass rod lasers.     

Growth of high quality Ce~(3 ):YAP and (Ce~(3 ) Nd~(3 )): YAP single crystals

The effect of melt pretreatment of Ce~(3 ): YAP and (Ce~(3 ) Nd~(3 )): YAP and their growth ambient gases on the quality of the crystals are described. Firstly, a superheating pretreatment of YAP melt is adopted in a nitrogen atmosphere containing a little oxygen to eliminate carbon; then the YAP melt is superheated in a reduction atmosphere to fully reduce Ce~(4 ) ions into Ce~(3 ) ions in the melt. Finally, in a growth atmosphere of pure nitrogen, high quality Ce~(3 ): YAP and (Ce~(3 ) Nd~(3 )): YAP single crystals with high Ce~(3 ) concentration with only few light scattering centers were grown.