Determination of manganese in iron and steels by u.h.f. plasma-torch emission spectrometry

The determination of manganese in iron and steels by u.h.f. plasma torch spectrometry is described. The intensity of the Mn II 257.16-nm ion line decreased with increasing concentration of iron, whereas the intensity of the Mn I 403.07-nm atom line increased; only the Mn I 279.48-nm atom line showed constant intensity as the concentration of iron increased. This behavior can be explained in terms of plasma temperature. The effects of acids were examined; the influence of small amounts of diverse elements was depressed by a large amount of iron. A simple and rapid method for the determination of manganese in iron and steels was established, the relative standard deviation being 2.6 % for 0.10 % Mn.     

Determination of silver in biological reference materials by neutron activation analysis

Silver in selected, predominantly biological, reference materials (NIST SRM 1515, 1547, 1549, 1566a, 1571, 1577b, 2704, CTA-OTL-1, and Bowen’s Kale) was determined using neutron activation analysis (NAA) in two different analytical modes: instrumental NAA with epithermal neutrons (ENAA), and NAA with radiochemical separation (RNAA). The ENAA mode was based on long-time 5-hour irradiation of samples in a special Cd lined box with counting after 8-month decay. The RNAA procedure consisted in 20-hour irradiation of samples, their decomposition/dissolution by alkaline-oxidative fusion, and precipitation of AgCl including several purification steps. Both methods provided Ag contents in the analyzed reference materials consistent with certified and/or literature values down to the ng·g⁻¹ level.     

Determination of boron in geological materials by inductively-coupled plasma emission spectrometry

Determination of boron in international silicate reference materials with an argon plasma is demonstrated. Detection limits are about 5 ppm for rock samples.     

Determination of aluminum and silicon in biological materials by inductively coupled plasma atomic emission spectrometry with electrothermal vaporization

An atomic emission spectrometric method is described for the determination of trace elements in microvolume samples especially of biological materials. Based upon the arrangement of a commercial electrothermal vaporizer and a 40-MHz inductively coupled plasma, the direct determination of aluminum and silicon in human body fluids such as urine and serum and aluminum in hemodialysis solution is performed. The instrumental system involves vaporizing the sample from a modified graphite electrode followed by atomization and excitation of the vapors in the ICP discharge. Compromise experimental conditions are reported and calibration functions compared. Limits of detection in 5-μl samples were 8 pg Al and 2.5 ng Si, and after preconcentration of Al with a poly(acrylamidoxime) resin, the detection limit was 1 pg Al. Recovery of 5 μg $\text{Si}\text{ml}$ and 10 ng $\text{Al}\text{ml}$ from aqueous and synthetic standards was 80–85% and 96–103%, respectively.     

Determination of gallium in biological materials by electrothermal atomic absorption spectrometry

In this determination of gallium, the condition of the graphite tubes influences the peak height. Common acids and salts seriously affect the results, but in the presence of EDTA, interferences of nitric and hydrochloric acids are suppressed completely, and interferences of phosphoric acid and some salts are suppressed partly. To compensate for the effects, a standard addition procedure is proposed, and is applied to healthy and tumor.bearing mice. A linear calibration is obtained for 0.12–12 ng Ga in 50-μl aliquots. The method is applied to tissues and body fluids with good recovery and precision.     

Determination of lead in biological materials by constant-temperature electrothermal atomic absorption spectrometry

A comparison is made between a platform-equipped Perkin-Elmer HGA-500 and a recently designed two-step constant-temperature graphite furnace with respect to susceptibility to interference effects as well as attainable detection limits. It is shown that larger quantities of biological samples can be used with the constant-temperature furnace without suppressing the analyte signal, resulting in lower detection limits. Materials studied include NBS Olyster Tissue and Bovine Liver, and human lung tissue and human blood.     

A simple flow-injection on-line clean-up system for microwave plasma-torch atomic emission spectrometry

A simple flow injection (FI) on-line clean-up system has been developed for microwave plasma-torch atomic emission spectrometry (MPT-AES). A non-selective strongly acidic cation-exchange resin was used to achieve the goal of "on-line clean-up". Ag and Zr, which form halogen-complex anions in halide acid media, and Cr, Mo, and P, which exist as acid group anions or acids (neutral) in acidic solution, were determined and the interfering matrix cations were removed on-line. Satisfactory analytical results were obtained from some practical samples by use of this procedure.     

A simple flow-injection on-line clean-up system for microwave plasma-torch atomic emission spectrometry

A simple flow injection (FI) on-line clean-up system has been developed for microwave plasma-torch atomic emission spectrometry (MPT–AES). A non-selective strongly acidic cation-exchange resin was used to achieve the goal of “on-line clean-up”. Ag and Zr, which form halogen-complex anions in halide acid media, and Cr, Mo, and P, which exist as acid group anions or acids (neutral) in acidic solution, were determined and the interfering matrix cations were removed on-line. Satisfactory analytical results were obtained from some practical samples by use of this procedure.     

Determination of sulfur in biological samples by vacuum-ultraviolet inductively-coupled plasma atomic emission spectrometry

Sulfur is most sensitively determined at 180.7 nm, the detection limit being 10 μg l^?1. A comparison of digestion procedures shows that acid digestion in a teflon bomb gives least loss of analyte. Only calcium interferes spectrally at this wavelength. Results for various reference materials are presented.     

Determination of trace selenium in biological material by preconcentration and x-ray emission spectrometry

Selenium is determined in the ng g^?1 to μg g^?1 range in biological and environmental samples. A wet digestion procedure was optimized with respect to volatility losses and recovery yields, by using ⁷⁵Se metabolically incorporated into rat organs. Selenium is preconcentrated from the digestion liquid by a two-step reduction with 4 M HCl and ascorbic acid. The colloidal selenium formed is adsorbed on activated carbon and filtered on a Nucleopore membrane for measurement by energy-dispersive x-ray fluorescence. Almost complete recovery was obtained, and the detection limit was 20 ng, corresponding to 10 ng g^?1 for a 2-g sample. Biological reference materials were analyzed with satisfactory results, and the accuracy of the method was good.     

Determination of strontium in biological samples by atomic emission spectrometry with electrothermal atomization

Summary Strontium showed a high atomic emission in a molybdenum microtube. The addition of hydrogen in the argon gas atmosphere served to increase the atomic emission. No interferences from less than 5 ng of potassium, calcium and magnesium were found. Other elements also had no interferences at the concentration levels usually found in biological samples. Samples were digested with nitric acid in a Uni-Seal decomposition vessel. The results obtained showed good agreement with the certified values. Atomic emission spectrometry with a molybdenum microtube atomizer permits a simple and sensitive determination of strontium in biological samples (coefficient of variation 2.5% for 10 pg Sr).

---

Strontiumbestimmung in biologischem Material durch Atomemissions-Spektrometrie mit elektrothermischer Atomisierung

Zusammenfassung Eine hohe Atomemission wurde für Strontium bei Verwendung einer Molybdän-Mikroröhre beobachtet. Durch Wasserstoffzusatz zum Argon konnte sie noch weiter erhöht werden. Weniger als 5 ng K, Ca und Mg verursachen keine Störung. Andere Elemente stören nicht in den Konzentrationsbereichen, wie sie üblicherweise in biologischen Materialien vorkommen. Der Aufschluß der Proben wurde mit Salpetersäure in Uni-Seal-Gefäßen vorgenommen. Die erhaltenen Werte stimmten gut mit zertifizierten Daten überein. Die vorgeschlagene Methode ermöglicht eine einfache und empfindliche Strontiumbestimmung in biologischen Proben (Variationskoeffizient 2,5% bei 10 pg Sr).

---

---

This work was supported by the Ministry of Education, Science and Culture of Japan through a Grant-in-Aid for Special Project Research.     

Determination of iodine in biological materials and in some standard reference materials by X-ray fluorescence spectrometry

Summary A new method for the determination of iodine in biological samples is described. If series of samples of uniform matrix are to be analyzed no mineralization is required: water soluble iodide coprecipitated on a carrier and tissue-bound iodine are both collected on a filter and simultaneously determined by X-ray fluorescence thin layer technique. In the particular case of the determination of iodine in rat thyroids this procedure allows a satisfactory screening of drugs influencing the iodine balance. In the general case of trace iodine determination in quite different matrices the organic material is ashed prior to the precipitation and measuring step. The trace iodine content of several reference materials from NBS, BCR and IAEA obtained by this method is given.

---

Iodbestimmung in biologischen Proben und einigen Standardreferenzmaterialien mit Hilfe der Röntgenfluoreszenzspektrometrie

     

电感耦合等离子体原子发射光谱(ICP-AES)法测定银钯合金中银和钯

建立健全测定银钯合金中银和钯含量的检测方法,对实现银钯合金中银和钯的高精度分析以及资源化利用有着重大意义。实验建立了电感耦合等离子发射光谱法(ICP-AES)同时测定银钯合金中银钯含量的分析方法。实验采用先加入10mL硝酸,再加入50mL过量盐酸混合,采用加热套混合消解银钯合金并混合定容在酸性浓度为18%HCl为介质中,然后通过控制不同的HCl浓度来测定银钯含量。实验结果表明：银的最佳检测酸性浓度为18%、钯的最佳酸性检测浓度为4%且该方法的加标回收率在97%-100%之间,相对标准偏差(RSD, n=10)小于2%。     

Determination of total fluorine in five coal reference materials by proton-induced gamma-ray emission spectrometry

The direct non-destructive proton-induced gamma-ray emission (PIGE) technique with a germanium detector was applied to the determination of total fluorine concentration in five coal reference materials (BCR 40, NIST 1632b, NIST 1635, SARM 20 and USGS CLB-1). Duplicate analyses were made from five randomly selected bottles of each coal. Individual data are presented and some problems (calibration, proton stopping power, effects of sample heating by the proton beam, background estimation) which were encountered during this study are discussed. Sensitivity and reproducibility of the determinations, and homogeneity of the coal samples with respect to fluorine contents by analysis of variance were investigated. The present data are also compared with the few published values for these reference samples, including other PIGE data. The use of synthetic standards and spiked samples in the present study suggested that the PIGE method was more accurate than other techniques.     

Determination of trace elements in plant materials by inductively coupled plasma optical emission spectrometry

The use of inductively coupled plasmas as spectrometric emission sources for the determination of Fe, Mn, Cu, Al, B and Zn in orchard leaves is investigated. The plasma is shown to be sufficiently sensitive for the direct determination of all of the above elements in solutions of the plant materials after a dry ashing procedure. Comparative values for the trace element concentrations by other analytical methods are given.     

Determination of lead in geological and biological materials by graphite furnace atomic absorption spectrometry

Summary Serious systematic errors inherent in the determination of lead in geological and biological samples by flameless atomic-absorption spectrometry are demonstrated. The reduced absorption of lead is due to partial interaction with alkaline, alkaline-earth and iron chlorides during the atomization stage. Incomplete dissociation of the volatile monochloride of lead in the gaseous phase reduces the absorption signal. An addition of 20% hydrogen to nitrogen (purge gas) diminishes signal suppression by removing the chlorine in form of volatile HCl. The detection limit is about 0.6 ppm in rocks and about 0.3 ppm in plant materials. Depending on the content in the samples the relative standard deviation is between 1 and 12%. The accuracy of the method was tested on 39 international standard reference samples.

---

Bestimmung von Blei in geologischen und biologischen Materialien durch AAS mit der Graphitrohrküvette

Zusammenfassung Schwerwiegende systematische Fehler bei der Bestimmung von Blei in geologischen und biologischen Materialien mit der Graphitrohrküvette werden aufgezeigt. Die Reaktion von Blei mit Alkali-, Erdalkali- und Eisenchloriden während der Atomisierungsphase führt zur Bildung von Bleimonochlorid, das nur unvollständig dissoziiert und eine Signalunterdrückung zur Folge hat. Ein Zusatz von 20% Wasserstoff zu Stickstoff als Spülgas vermindert die Signalunterdrückung, indem überschüssiges Chlor als Chlorwasserstoff entfernt wird. Die Nachweisgrenze liegt bei ca. 0,6 ppm für Gesteine und bei ca. 0,3 ppm für Pflanzenmaterialien. Je nach der Konzentration beträgt die relative Standardabweichung 1–12%. Die Genauigkeit der Methode wurde an 39 internationalen Standardreferenzproben überprüft.

     

Determination of arsenic by hollow-cathode emission spectrometry

The applicability of the hollow-cathode discharge source in the emission spectrometric determination of arsenic is described. Neutral and 10% nitric acid solutions, as well as solutions obtained by mineralization of biological materials, all containing 2.5 to 125 μg As cm^?3, were introduced into stainless steel cathodes, dried under i.r. radiation, and calcined in a muffle furnace; the loaded cathodes were then subjected to discharge. Acidic solutions were found to leach nickel from the steel of the cathode: this converted the analyte into thermally-stable nickel arsenide, thus minimizing losses. Matrix effects were small, and the r.s.d. was satisfactory (5–8%). The detection limit was 3 μg cm^?3.     

Determination of tungsten by plasma emission spectrometry

The emission spectrum of tungsten in an inductively coupled Ar/Ar-plasma (ICP) was investigated and relative intensities of 17 lines listed. Among the lines tested, W I 400.875 nm and W 207.911 nm are recommended for steel analysis. Several others suffer from severe spectral interferences. The line W 400.875 nm is very sensitive, but interfered with by titanium and very high iron concentrations. The line W 207.911 nm requires careful determination of adjacent background, but can be used even with low-resolution instruments. The influence of RF power, nebulizing conditions, burner height, and acid concentration was tested and found to be small enough for simple control in routine work. Steels and other alloys containing 0.02-80% W were analysed.