Diffraction micro gratings have been written in ZnO:Al thin films using a picosecond laser operating at 355 nm. Micro gratings of 20 µm diameter with a period of 860 nm show a groove depth up to 120 nm. The total transmittance of square‐centimeter‐size grating‐textured ZnO:Al films was almost unchanged after grating formation, while the sheet resistance increased moderately. The textured films reached haze values of 9% at 700 nm. This simple texturing method can be applied also to ZnO:Al films that cannot be texture etched.
Epitaxial TiC/SiC multilayers were grown by magnetron sputtering at a substrate temperature of 550 °C, where SiC is normally amorphous. The epitaxial TiC template induced growth of cubic SiC up to a thickness of ～2 nm. Thicker SiC layers result in a direct transition to growth of the metastable amorphous SiC followed by renucleation of nanocrystalline TiC layers.
A very thin (250 nm), highly conductive (annealed), non‐texturized DC‐sputtered aluminum‐doped zinc oxide layer (ZnO:Al) deposited on a textured glass is used as substrate for thin‐film silicon solar cells. Compared to the classical approach, where wet‐chemically texturized ZnO:Al on planar glass is used, this approach allows a reduction in the as‐deposited ZnO:Al thickness of almost 70% while at the same time, thanks to the good light trapping capability of the glass texture the efficiency of the cells was maintained at the high level of 10.9%.
Optically transparent and high‐quality hybrid ZnO nanoparticle and anthracene embedded polyphenylsiloxane (PPS) glass films were spin‐coated on quartz substrates. A strong Förster resonant energy transfer (FRET) process was indicated by the observation of quenching of the ZnO emission and an enhancement of the anthracene emission at room temperature. The efficiency of this energy transfer between ZnO and the S1 vibronic states of the anthracene molecules can be optimized to exceed 90%.
Write‐once–read‐many‐times memory (WORM) devices were fabricated using Ti/Au and Au as top contacts on ZnO thin films on Si. Electrical characterization shows that both types of WORM devices have large resistance OFF/ON ratio (R ratio), small resistance distribution range, long retention and good endurance. WORM devices with Au top contact have better performance of higher R ratio because of a larger work function of Au compared to Ti.
We report the maskless fabrication of ultrathin suspended GaN membranes designed by focused ion beam treatment of the GaN epilayer surface with subsequent photoelectrochemical etching. This technological approach allows the fabrication of ultrathin membranes, as well as supporting micro/nanocolumns in a controlled fashion. The analysis of the spatial and spectral distribution of microcathodoluminescence demonstrates that the membranes exhibit mainly yellow luminescence. These results pave the way for the fabrication of ultrathin suspended GaN membranes for MEMS/NEMS applications.
Persistent layer‐by‐layer growth is demonstrated for pulsed‐laser homoepitaxy of ZnO thin films on $(000\bar 1)$ ZnO single crystals. Employing interval pulsed‐laser deposition (PLD), RHEED oscillations are stabilized over a film thickness of about 90 nm. For interval pulsed laser deposited films a considerably decreased root‐mean‐square surface roughness of 0.26 nm was found, in comparison to 0.74 nm for conventional PLD. A small asymmetry in the X‐ray diffraction (XRD) 2θ –ω scan reveals compressive strain in the thin film being slightly larger for interval PLD as compared to conventional PLD. The FWHM of the photoluminescence (PL) I6 line is higher with about 500 µeV as compared to 350 µeV for the conventional PLD. Consequently, both XRD as well as PL indicate a slightly higher amount of charged defects for the interval PLD.
A facile metal catalyst free route to synthesize boron doped (0.6%–1.0%) carbon nanotubes via ceramic nanowires in which the formation of the nanowires (probably serving as templates), the carbon nanotubes and their doping all occur unanimously in the reaction, is presented.
Heteroepitaxial growth of kesterite Cu2ZnSnS4 (CZTS) thin film on cubic ZnS(100) single crystal substrate was achieved by radio frequency magnetron sputtering from a single CZTS target. An optimal substrate temperature in the range of 470–500 °C is found suitable for this epitaxial growth. The growth of CZTS was confirmed to be along a‐axis. The sputtered CZTS thin film is homogeneous throughout the whole film. The band gap of the film is found to be approximately 1.51 eV, i.e., promising for high efficiency thin film solar cells.
InGaN/GaN light‐emitting diodes (LEDs) are known to exhibit a strongly non‐uniform vertical carrier distribution within the multi‐quantum well (MQW) active region. We propose to eliminate “dark” quantum wells by insertion of multiple tunnel junctions into the MQW which allow for the repeated use of electrons and holes for photon generation. In good agreement with available measurements, we demonstrate by self‐consistent numerical simulation that such tunnel junction LED design promises quantum efficiencies as high as 250% as well as a strongly enhanced output power at high input power, compared to conventional LED concepts.
Graphene, the two‐dimensional form of carbon presents outstanding electronic and transport properties. This gives hope for the development of applications in nanoelectronics. However, for industrial purpose, graphene has to be supported by a substrate. We focus here on the graphene‐on‐SiC system to discuss how the SiC substrate interacts with the graphene layer and to show the effect of the interface on graphene atomic and electronic structures.
We propose a new allotrope of graphane (named as ‘tricycle') with equivalent 4up/2down UUUDUD hydrogenation in each six‐carbon ring, which can be considered as the combination of previously proposed 3up/3down chair graphane and stirrup graphane. We find that tricycle graphane is more stable than stirrup graphane and its negative Gibbs free energy (–91 meV/atom) is very close to that of the most stable chair one (–103 meV/atom). Investigations on its vibrational property confirm its dynamical stability. Such a new two‐dimensional hydrocarbon may be produced in the process of graphene hydrogenation with a relatively high probability due to its remarkable stability.
We report on solution‐processible polymer solar cells (PSCs) fabricated on a papery substrate using carton. Highly conductive PEDOT:PSS was used as a bottom anode and planarization layer, and a semi‐transparent top cathode was applied. This research could be an important approach to the development of all‐solution‐processible papery PSCs as well as paper electronics.
We report a very simple and novel approach to produce anodic TiO2 nanotube arrays with highly defined and ordered tube openings. It is based on carrying out anodization through a slowly soluble photoresist coating. This eliminates the formation of undesired initiation layers on the tube tops and protects them to a certain extent from etching by the electrolyte.
Steady‐state and time‐resolved photoluminescence of silicon nanoparticles dispersed in low‐polar liquids at above room temperature is studied. The roles of low‐polar liquids as well as mechanisms responsible for their temperature‐dependent photoluminescence are discussed. The thermal sensitivity of the photoluminescence is estimated and application of the nanoparticles as nanothermometers is proposed.
We show, using Density Functional Theory (DFT) calculations, that compressed AgF2 should turn above 17 GPa into a layered narrow‐gap material with a huge intralayer antiferromagnetic (AFM) coupling constant, reminiscent of those seen for parent copper (II) oxides (e.g., La2CuO4). Compressed AgF2 is thus the first candidate for the non‐oxocuprate two‐dimensional antiferromagnet. Calculations indicate that AgF2 could subsequently be metallised above 38 GPa, likely giving rise to superconductivity (SC).
Polymer nanocomposites containing different concentrations of Au nanoparticles have been investigated by small angle X‐ray scattering and electronic absorption spectroscopy. The variation in the surface plasmon resonance (SPR) band of Au nanoparticles with concentration is described by a scaling law. The variation in the plasmon band of ReO3 nanoparticles embedded in polymers also follows a similar scaling law.
We report on the photoconductance in two‐dimensional arrays of gold nanorods. The arrays are formed by a combination of droplet deposition and stamping methods. We find that the plasmon induced photoconductance is sensitive to the linear polarization of the exciting photons consistent with the excitation of the longitudinal surface plasmon resonance of the nanorods.
The properties of transition‐metal (V, Cr, Mn, Fe, Co, Ni) δ‐doped ZnO are reported based on ab‐initio electronic structure calculations where the on‐site electronic correlations are included using the Hubbard parameters. The calculated electronic and magnetic properties are considerably altered with respect to usual band‐structure calculations. Most of the studied systems are found to be either half‐metals or ferromagnetic/antiferromagnetic semiconductors and thus can be employed in a variety of spintronic applications as spin‐filter materials.
