Roughness-trapped shear horizontal surface acoustic waves

Shear horizontal surface acoustic waves do not exist on the flat surface of a semi-infinite elastic medium. It has been shown by several authors recently that such waves can exist on a periodically corrugated, planar surface. We show here on the basis of the Rayleigh method that shear horizontal surface acoustic waves exist on a randomly rough planar surface of an isotropic elastic medium. These waves are only weakly localized to the surface and they have a lifetime that is long due to their roughness-induced scattering into other surface acoustic waves and into bulk waves.     

声表面波在厚金属栅阵中的耦合模参数

提出了一种研究声表面波在压电晶体厚金属栅阵中传播特性的理论方法。将有限元和声表面波在周期栅阵中的变分原理分析方法相结合,在陈东培和H.A.Haus理论基础上、用有限元分析金属短路栅对声表面波传输特性的影响,将力学负载贡献的耦合模参数用有限元矩阵表示,使其适用于声表面波在厚金属或任意形状栅条中传输情况,给出了具体理论分析方法和相应的理论表达式。最后,具体研究了几种压电晶体上金、铝或银栅阵中声表面波的传输特性,通过数值计算给出了声表面波的耦合模参数。      

Influence of ultrasonic surface acoustic waves. on local friction studied by lateral force microscopy

We studied dynamic friction phenomena introduced by ultrasonic surface acoustic waves using a scanning force microscope in the lateral force mode and a scanning acoustic force microscope. An effect of friction reduction was found when applying surface acoustic waves to the micro-mechanical tip-sample contact. Employing standing acoustic wave fields, the wave amplitude dependent friction variation can be visualized within a microscopic area. At higher wave amplitudes, a regime was found where friction vanishes completely. This behavior is explained by the mechanical diode effect, where the tip's rest position is shifted away from the surface in response to ultrasonic waves.     

水下声辐射激励水表面声波的特征参数测量

采用激光干涉方法对水下声辐射激励水表面声波的特征参数频率和振幅进行了测量研究。从理论上对水表面声波激光相干测量信号的频谱构成进行了分析,在此基础上提出了水表面声波两个重要声学参数频率和振幅的解算方法,并通过数值仿真进行了验证。搭建了一套简单的激光干涉测量实验系统,对不同频率和声压激励的水表面声波进行了测量实验,验证了水表面声波频率和振幅解调方法的准确性。对水表面声波横向传播的振幅衰减现象进行了初步的实验研究,结果表明水表面声波的频率越高,振幅的横向衰减越快。研究表明激光相干检测方法能够准确地实现水表面声波振幅和频率的测量。      

Enhancement of photoelastic constant of optical thin film waveguide assisted by surface acoustic wave

In the present research, we proposed a method of controlling the photoelastic constant using surface acoustic waves, which had not previously been reported, and carried out experimental studies thereof. A Bragg diffraction was carried out to determine the photoelastic constants of Ta2O5. As a result, it is confirmed that the photoelastic constant of a Ta2O5 thin film undergoing a sputtering process, during which surface acoustic waves were excited on the substrate, was about 2.19-2.27 times larger than those of thin films on which surface acoustic waves were not excited.     

Interaction of surface acoustic waves with moving vortex structures in superconducting films

A method is proposed for describing a moving film vortex structure and its interaction with surface acoustic waves. It is shown that the moving vortex structure can amplify (generate) surface acoustic waves. In contrast to a similar effect in semiconductor films, this effect can appear when the velocity of the vortex structure is much lower than the velocity of the surface acoustic waves. A unidirectional collective mode is shown to exist in the moving vortex structure. This mode gives rise to an acoustic analogue of the diode effect that is resonant in the velocity of the vortex structure. This acoustic effect is manifested as an anomalous attenuation of the surface acoustic waves in the direction of the vortex-structure motion and as the absence of this attenuation for the propagation in the opposite direction.     

Laser ultrasonic surface wave inspection of alumina ceramics of varying density

In this paper, the surface acoustic wave velocity results acquired from the inspection of specially manufactured and characterised alumina ceramic materials are presented. Ultrasonic velocity data of alumina-based ceramics in the range 60-100% theoretical density was generated utilising non-contacting laser-ultrasonic measurements based on laser generation and detection of surface acoustic waves with the objective of creating a routine technique for industrial advanced alumina inspection. With linear fitting the surface acoustic wave velocity data serves as a calibration graph for using laser ultrasonics for routine monitoring of alumina. A second laser ultrasonic technique based on the laser generation and foil transducer detection of surface acoustic waves was used to validate the surface acoustic wave velocities measured by the laser generation/detection technique.     

Acoustic properties of proton exchanged LiNbO3 investigated by Brillouin scattering

The propagation of surface acoustic waves at microwave frequencies (10¹⁰ Hz) was studied on proton exchanged LiNbO₃ crystals by means of Brillouin scattering. The proton exchange causes a large velocity reduction for surface acoustic waves propagating in the x–y plane of ay-cut crystal as well as for longitudinal bulk acoustic waves travelling in the proton exchanged sub-surface region. The velocity reduction amounts to about 20% for both types of waves. The corresponding elastic constants are reduced even by about 40% since the density remains almost constant. This softening seems to involve both the shear and compressional elastic constants, but in an anisotropic way.Thus by proton exchange it is possible to build acoustic waveguides adjacent to the surface, similar to the construction of optical waveguides. By a lateral control of the proton exchange rate optical elements for ultrasonic waves, for example, acoustic lenses can be produced without deformation of the flat surface.The absorption of surface acoustic waves on proton exchanged surfaces is stronger than on pure LiNbO₃ indicating a novel absorption mechanism becoming active in the proton exchanged material.     

The analogy between acoustic waves and water surface waves with refraction

The similarity between acoustic waves in an inhomogeneous medium and water surface waves with variable water depth is established. The two systems are analogous if they both are characterized by the same index of refraction field. Based on this analogy, acoustic refraction problems are treated by utilizing a surface wave simulation achieved with a water wave tank. Experimental results obtained from the wave tank for various situations are used to deduce the behavior of the corresponding acoustic systems. It is concluded that there are two major advantages in employing a water wave tank. The first is that the entire wavefront configuration can visually be observed; the second is that water surface waves can be investigated in the laboratory much more readily and more economically than acoustic waves.     

Probing of laser-induced crack modulation by laser-monitored surface waves and surface skimming bulk waves

All-optical monitoring of the nonlinear motion of a surface-breaking crack is reported. Crack closing is induced by quasi-continuous laser heating, while Rayleigh surface acoustic pulses and bulk longitudinal surface skimming acoustic pulses are also generated and detected by lasers. By exploiting the strong dependence of the acoustic pulses reflection and transmission efficiency on the state-open or closed-of the contacts between the crack faces, the parametric modulation of ultrasonic pulses is achieved. It is observed that bulk acoustic waves skimming along the surface can be more sensitive to crack motion than Rayleigh surface waves.     

液体表面波振幅与激发深度的关系

研究了液体表面波振幅随激发深度的变化特性.采用探针式激发器激发,观察到液体表面波的衍射图样|改变激发深度,得到不同激发深度处的衍射图样|根据衍射图样分布与表面波振幅之间的关系并进行计算机编程,获得表面波振幅与激发深度之间的关系.用最小二乘法拟合,发现|液体表面波振幅随激发深度的增加而减小,并呈指数规律.     

液体表面低频声波的非线性声光效应

实现了液体表面上低频声波的光衍射,得到了稳定的、具有高阶衍射的高反衬衍射图样.理论上首次考虑到表面声波中的高次谐波,得到了相应的非线性条件下衍射强度分布的解析表达式,并将这种非线性理论与实验结果进行对比.对比结果表明,非线性理论与实验结果有更高的吻合程度.     

Interference acoustical method for measuring velocity,attenuation and reflection of acoustic surface waves

An interference acoustical method for measuring velocity, attenuation and reflection of acoustic surface waves was developed. Applications to diagnostics and nondestructive testing of acoustic surface wave devices are discussed.     

A two-dimensional analysis of surface acoustic waves in finite elastic plates with eigensolutions

It is generally known that surface acoustic waves, or Rayleigh waves, have different mode shapes in infinite plates. To be precise, there are both exponentially decaying and growing components in plates appearing in pairs, representing symmetric and antisymmentric modes in a plate. As the plate thickness increases, the combined modes will approach the Rayleigh mode in a semi-infinite solid, exhibiting surface acoustic wave deformation and velocity. In this study, the two-dimensional theory for surface acoustic waves in finite plates is extended to include the exponentially growing modes in the expansion function. With these extra equations, we study the surface acoustic waves in a plate with different thickness to examine the coupling of the exponentially decaying and growing modes. It is found that for small thickness, the two groups of waves are strongly coupled, showing the significance of including the effect of thickness in analysis. As the thickness increases to certain values, such as more than five wavelengths, the exponentially decaying modes alone will be able to predict vibrations of surface acoustic wave modes accurately, thus simplifying the equations and solutions significantly. Supported by Qianjiang River Fund established by Zhejiang Provincial Government and Ningbo University and administered by Ningbo University and the National Natural Science Foundation of China (Grant No. 10572065)     

Numerical analysis of bulk conical waves in anisotropic cylinders; application to stiffness tensor measurement

A point source-point receiver technique, based on laser generation and laser detection of acoustic waves, allows determination of mechanical properties of an anisotropic cylinder. The nature of the material and the geometry of the sample give a dispersive behaviour to the diffracted waves and make the acoustic signature difficult to interpret. To overpass the intricacies, wave fronts (conical waves in the volume and helical waves on the surface) are synthesized from signals provided by scanning the primitive line of the cylinder with a laser point source. In order to distinguish between direct bulk conical waves and other contributions in the acoustic response, some considerations on line surface waves and on reflected bulk conical waves are supplied. The identification of the stiffness tensor components, based on the inversion of the bulk waves phase velocities, is applied to signals simulated for a composite material.     

Generation of acoustic surface waves on GaAs by photoexcitation

In the experiments reported here we observed the generation of non-thermal, large amplitude acoustic surface waves at GHz frequencies on the surface of a GaAs crystal under intense illumination with 514.5 nm radiation from an Ar⁺ laser at room temperature. The acoustic surface waves were detected by optical Brillouin spectroscopy.     

Acoustic analogue of graphene: observation of Dirac cones in acoustic surface waves

We demonstrate the presence of Dirac cones in the dispersion relation of acoustic waves propagating on the surface of a plate of methyl methacrylate containing a honeycomb lattice of cylindrical boreholes. This structure represents the acoustic analogue of graphene, the cylindrical cavities playing the role of carbon atoms while acoustic surface waves are the equivalent of electronic waves in graphene. Analytical expressions for the Dirac frequency and Dirac velocity in acoustics are given as a function of the radius and depth of boreholes. These parameters have been experimentally determined for a constructed structure and the data are in fairly good agreement with the predicted values.     

The viscous effects on shear horizontal surface acoustic waves in semi-infinite superlattices

In this paper, by a semi-analytical method, the propagation characteristics of shear horizontal surface acoustic waves in semi-infinite superlattices containing viscous materials are investigated. The factors that influence the attenuation and phase velocity of the surface waves are analyzed in detail. The results may be useful for the design of acoustic wave devices.     

声表面波在圆弧处反射及透射的数值研究*

为了研究直达表面波在圆弧过渡面处传播性能的变化,采用有限元方法模拟了热弹机制下,线性脉冲激光辐照金属铝块表面时激发的表面波在近表面传播过程中,在不同曲率半径的圆弧处发生的反射及透射现象,建立了圆弧半径与反射表面波以及透射表面波时域信号特征之间的联系。计算结果表明:曲率半径与表面波中心波长的数值关系对表面波在圆弧处的传播有显著的影响;同时证明了根据透射表面波信号的到达时间可以反演圆弧半径的大小,为之后利用表面波信号定量检测材料表面圆弧凹痕的深度提供了理论依据。