共查询到18条相似文献,搜索用时 122 毫秒
1.
基于拉曼散射的分布式光纤测温系统利用光纤作为温度的传导介质,测量沿光纤走向的连续空间的温度场分布。通过高速采集卡采集数据,并将数据进行去掉噪声干扰和累加的处理,得到准确的温度数据。这种系统的实用性是可以对光纤沿线的温度数据实时和定点监控。通过对拉曼散射所产生的斯托克斯光/反斯托克斯光与温度关系的研究,确定分布式光纤测温系统的温度测量方法,对所采集的信号利用小波变换进行去噪声和微弱信号的处理。 相似文献
2.
设计了基于拉曼光时域反射技术的船舶电缆分布式光纤测温系统.为了有效提高信号强度,系统硬件设计中改进了微弱光信号的探测及放大电路,并且基于FPGA+DSP高速数据处理模块来加快数据处理速度;针对拉曼反射信号信噪比低的特点,系统对采集信号采用数字累加平均与自适应阈值小波滤波相结合的去噪方法,在改善信噪比的同时缩短了测温时间.实验表明,设计系统测温距离达4 km,空间分辨率为1.5m,温度分辨率为0.1℃,系统响应时间为3.8s,满足设计要求,且综合指标优异. 相似文献
3.
4.
拉曼散射分布式光纤温度传感器的系统设计 总被引:2,自引:0,他引:2
拉曼散射分布式光纤温度传感器是集光学,电子,计算机应用技术和微弱信号检测技术于一体的复杂系统,它可以同时获取被测温度场的空间分布状态信息和时间变化信息,本文论述了分布式光纤温度传感器的设计方法,系统组成和实验评估。 相似文献
5.
6.
拉曼散射分布式光纤温度传感器的设计 总被引:7,自引:0,他引:7
文章论述了基于反斯托克斯/斯托克斯比值的分布式光纤温度传感器系统,对其信号处理技术进行了全面而深入的研究。采用光时域后向散射技术来获取温度信息,并用时域信号数字积累平均方法来提高系统的信噪比,据此建立了分布式温度传感器。 相似文献
7.
提出了一套基于现场可编程门阵列(FPGA)的分布式拉曼光纤传感系统,实现了信号的采集、传输、处理.为了提高系统的信噪比(SNR),提出了基于FPGA的累加迭代平均滤波算法和非线性小波变换阈值去噪法.首先对放大之后的斯托克斯光和反斯托克斯光信号进行累加迭代,然后再平均,经过8000次累加迭代平均之后,系统信噪比提高了36... 相似文献
8.
文章论述了基于反斯托克斯/斯托克斯比值的分布式光纤温度传感器系统,对其信号处理技术进行了全面而深入的研究。采用光时域后向散射技术来获取温度信息,并用时域信号数字积累平均方法来提高系统的信噪比,据此建立了分布式温度传感器。 相似文献
9.
10.
基于分布式拉曼温度传感器(RDTS)的温度解调 原理,研究了光纤温度附加损耗对传感器测温结果的影响。采用一条光纤的不同位置 同时测量两个温控箱温度的实验方法,得出当光纤温度在20.0~100.0℃范围内变化时,单位长度的光纤对该段光纤位置之后的 光纤产生测温附加误差与该段光纤温度成正比以及与受温度影响的光纤长度成正比的规律 ,进而实现了对RDTS测温结果的修正。实验结果表明,2km中一段700m长的光纤在温控箱 温度控制范围内,测量温度附加误差从修正前的最大4.09℃降低到 修正后的小于0.47℃。 相似文献
11.
12.
Distributed temperature sensor system based on raman scattering using correlation-codes 总被引:1,自引:0,他引:1
Soto M.A. Sahu P.K. Faralli S. Bolognini G. Di Pasquale F. Nebendahl B. Rueck C. 《Electronics letters》2007,43(16):862-864
A distributed sensor system employing spontaneous Raman scattering with use of correlation-coding techniques and a single-detector scheme is discussed and experimentally characterised. A sensing distance of up to 8 km is achieved with high spatial and temperature resolutions; use of correlation-coding significantly reduces measurement time and allows use of low-power laser sources. 相似文献
13.
针对目前电力电缆安全中突出的火灾探测问题,提出了一种分布式光纤测温系统,该系统采用光时域反射技术和拉曼散射测温技术,由测温主机、测温光缆及CSM主机构成,具有极高的灵敏度和定位精度。通过光缆获得电缆表面的温度,传递到测温主机中进行数据分析,并在CSM主机上显示电缆温度状态与报警。为了证实分布式光纤测温系统的有效性,在国内某隧道对该系统进行了温度测量试验,试验结果证明,系统能准确地反应现场运行电力电缆的实际运行情况,及时发现和定位温度异常点,当电缆表面温度超过系统设置的预报警温度值时,系统会立刻输出报警信号,为电缆故障提供温度预警功能,避免电力事故发生。 相似文献
14.
ZHANG Zai-xuan WANG Jian-feng LIU Hong-Iin XU Hai-fen DAI Bi-zhi LI Chen-xla LI Lan-xiao GENG Dan INSOO S. KIM 《光电子快报》2007,3(6):404-405
A 31 km long range distributed optical fiber Raman photon temperature sensor (DOFRPTS) system have been developed based on temperature effect of the amplified spontaneous Raman scattering in fiber, and using fiber laser as a pumped some. The results show that temperature measuring uncertainty is±2 ℃, temperature resolution is 0.1℃, measurement time is 432 s, spatial resolution is less than 4 m. 相似文献
15.
ZHANG Zai-xuan WANG Jian-feng LIU Hong-lin XU Hai-fen DAI Bi-zhi LI Chen-xia LI Lan-xiao GENG Dan INSOO S. KIM 《光电子快报》2007,3(6)
A 31 km long range distributed optical fiber Raman photon temperature sensor (DOFRPTS) system have been developed based on temperature effect of the amplified spontaneous Raman scattering in fiber, and using fiber laser as a pumped source. The results show that temperature measuring uncertainty is ±2 ℃, temperature resolution is 0.1 ℃, measurement time is 432 s, spatial resolution is less than 4 m. 相似文献
16.
光纤布里渊温度和应变分布同时传感方法研究 总被引:2,自引:1,他引:1
布里渊分布型光纤温度和应变同时传感的方法主要有3种:布里渊散射谱双参量同时测量的方法、双布里渊频移同时测量的方法及联合拉曼散射和布里渊散射效应法.文章对这3种方法进行了深入的研究,阐述了实现各种方法的具体方案,并对其性能及成本进行了比较,给出了一种可实现温度和应变高精度同时测量的传感方案. 相似文献
17.
18.
The distributed optical fiber temperature sensor system based on Raman scattering has developed rapidly since it was invented in 1970s. The optical wavelengths used in most of the distributed temperature optical fiber sensor system based on the Raman scattering are around from 840 to 1330 nm, and the system operates with multimode optical fibers. However, this wavelength range is not suitable for long-distance transmission due to the high attenuation and dispersion of the transmission optical fiber. A novel distributed optical fiber Raman temperature sensor system based on standard single-mode optical fiber is proposed. The system employs the wavelength of 1550 nm as the probe light and the standard communication optical fiber as the sensing medium to increase the sensing distance. This system mainly includes three modules: the probe light transmitting module, the light magnifying and transmission module, and the signal acquisition module. 相似文献