(Liquid + liquid) equilibrium of (water + 2-propanol + 1-butanol + salt) systems at T = 313.15 K and T = 353.15 K: Experimental data and correlation

(Liquid + liquid) equilibrium data for the quaternary systems (water + 2-propanol + 1-butanol + potassium bromide) and (water + 2-propanol + 1-butanol + magnesium chloride) were measured at T = 313.15 K and T = 353.15 K. The overall salt concentrations were 5 and 10 mass percent. Ternary (liquid + liquid) equilibrium data for the salt-free system (water + 2-propanol + 1-butanol) were also determined and found to be in good agreement with data from the literature. The NRTL model for the activity coefficient was used to correlate the data. New interaction parameters were estimated, using the Simplex minimization method and a concentration-based objective function. The results are very satisfactory, with root mean square deviations between experimental and calculated compositions of both phases being less than 0.5%.     

(Liquid + liquid) equilibria for (water + 1-propanol + diisopropyl ether + octane,or methylbenzene,or heptane) systems at T = 298.15 K

(Liquid + liquid) equilibria (LLE) data were presented for one ternary system of {water + octane + diisopropyl ether (DIPE)} and three quaternary systems of (water + 1-propanol + DIPE + octane, or methylbenzene, or heptane) at T = 298.15 K and p = 100 kPa. The experimental LLE data were correlated with the modified and extended UNIQUAC models. Distribution coefficients were derived from the experimental LLE data to evaluate the solubility behavior of components in organic and aqueous phases.     

Thermophysical properties of the binary mixtures (1,8-cineole + 1-alkanol) at T = (298.15 and 313.15) K and at atmospheric pressure

This work presents the measurements of the density, speed of sound, refractive index and enthalpy of binary mixtures containing {1,8-cineole + 1-alkanol (ethanol, 1-propanol, 1-butanol, and 1-pentanol)} at two temperatures (298.15 and 313.15) K and atmospheric pressure. The determination of excess molar volume, speed of sound deviation, refractive index deviation, molar refraction, molar refraction deviation, excess isentropic compressibility, and excess molar enthalpy are also given. Redlich–Kister equation was used to fit these derivate properties. The experimental data of the constituent binaries were analysed to discuss the nature and strengths of intermolecular interactions. Eventually some models, SAFT and PC-SAFT for density, Free Length and Collision Factor for speed of sound, Gladstone-Dale Arago-Biot for refractive index, and UNIFAC for excess molar enthalpy, among others, were successfully applied.     

(Liquid + liquid) equilibria for ternary mixtures of (water + propionic acid + organic solvent) at T = 303.2 K

Experimental tie-line results and phase diagrams were obtained for the ternary systems of {water + propionic acid + organic solvent (cyclohexane, toluene, and methylcyclohexane)} at T = 303.2 K and atmospheric pressure. The organic solvents were two cycloaliphatic hydrocarbons (i.e., cyclohexane and methylcyclohexane) and an aromatic hydrocarbon (toluene). The experimental tie-lines values were also compared with those calculated by the UNIQUAC and NRTL models. The consistency of the values of the experimental tie-lines was determined through the Othmer–Tobias and Hands plots. Distribution coefficients and separation factors were evaluated over the immiscibility regions and a comparison of the extracting capabilities of the solvents was made with respect to distribution coefficients and separation factors. The Kamlet LSER model was applied to correlate distribution coefficients and separation factors in these ternary systems. The LSER model values showed a good regression to the experimental results.     

Ternary (liquid + liquid) equilibria for mixtures of (methanol + aniline + n-octane or n-dodecane) at T = 298.15 K

(Liquid + liquid) equilibrium (LLE) data for the ternary mixtures of (methanol + aniline + n-octane) and (methanol + aniline + n-dodecane) at T = 298.15 K and ambient pressure are reported. The compositions of liquid phases at equilibrium were determined and the results were correlated with the UNIQUAC and NRTL activity coefficient models. The partition coefficients and the selectivity factor of methanol for the extraction of aniline from the (aniline + n-octane or n-dodecane) mixtures are calculated and compared. Based on these comparisons, the efficiency of methanol for the extraction of aniline from (aniline + n-dodecane) mixtures is higher than that for the extraction of aniline from (aniline + n-octane) mixtures. The phase diagrams for the ternary mixtures including both the experimental and correlated tie lines are presented. From the phase diagrams and the selectivity factors, it is concluded that methanol may be used as a suitable solvent in extraction of aniline from (aniline + n-octane or n-dodecane) mixtures.     

Excess enthalpies of ternary mixtures of (oxygenated additives + aromatic hydrocarbon) mixtures in fuels and bio-fuels: (Dibutyl-ether + 1-propanol + benzene), or toluene,at T = (298.15 and 313.15) K

New experimental excess molar enthalpy data of the ternary systems (dibutyl ether + 1-propanol + benzene, or toluene), and the corresponding binary systems at T = (298.15 and 313.15) K at atmospheric pressure are reported. A quasi-isothermal flow calorimeter has been used to make the measurements. All the binary and ternary systems show endothermic character at both temperatures. The experimental data for the systems have been fitted using the Redlich–Kister rational equation. Considerations with respect the intermolecular interactions amongst ether, alcohol and hydrocarbon compounds are presented.     

(Vapour + liquid) equilibrium in (N,N-dimethylacetamide + ethanol + water) at the temperature 313.15 K

Total vapour pressures, measured at the temperature 313.15 K, are reported for the ternary mixture (N,N-dimethylacetamide + ethanol + water), and for binary constituent (N,N-dimethylacetamide + ethanol). The present results are also compared with previously obtained data for (amide + ethanol) binary mixtures, where amide = N-methylformamide, N,N-dimethylformamide, N-methylacetamide, 2-pyrrolidinone, and N-methylpyrrolidinone. We found that excess Gibbs free energy of mixing for binary (amide + ethanol) mixtures varies roughly linearly with the molar volume of amide.     

(Vapour + liquid) equilibrium and excess Gibbs functions of ternary mixtures containing 1-butanol or 2-butanol,n-hexane,and 1-chlorobutane at T = 298.15 K

Isothermal (vapour + liquid) equilibrium data for the ternary mixtures 1-butanol + n-hexane + 1-chlorobutane and 2-butanol + n-hexane + 1-chlorobutane have been studied with a recirculating still at T = 298.15 K. The experimental data were satisfactorily checked for thermodynamic consistency using the method of van Ness. Activity coefficients and excess Gibbs function have been correlated with the Wilson equation. The G^E values obtained for the two ternary systems are very similar.     

(Liquid + liquid) equilibria in {water + acrylic acid + (1-butanol,or 2-butanol,or 1-pentanol)} systems at T = 293.2 K,T = 303.2 K,and T = 313.2 K and atmospheric pressure

(Liquid + liquid) equilibrium (LLE) data for {water + acrylic acid + (1-butanol, or 2-butanol, or 1-pentanol)} at T = 293.2 K, T = 303.2 K, and T = 313.2 K and atmospheric pressure (≈95 kPa) were determined by Karl Fischer titration and densimetry. All systems present type I binodal curves. The size of immiscibility region changes little with an increase in temperature, but increases according to the solvent, following the order: 2-butanol < 1-butanol < 1-pentanol. Values of solute distribution and solvent selectivities show that 1-pentanol is a better solvent than 1-butanol or 2-butanol for acrylic acid removal from water solutions. Quality of data was ascertain by Hand and Othmer-Tobias equations, giving R² > 0.916, mass balance and accordance between tie lines and cloud points. The NRTL model was used to correlate experimental data, by estimating new energy parameters, with root mean square deviations below 0.0053 for all systems.     

(Liquid + liquid) equilibria for the ternary mixtures (alkane + toluene + ionic liquid) at T = 298.15 K: Influence of the anion on the phase equilibria

(Liquid + liquid) equilibrium data for the ionic liquids 1-butyl-1-methylpyrrolidinium bis(trifluoromethylsulfonyl)imide, [BMpyr][NTf₂], and 1-butyl-1-methylpyrrolidinium trifluoromethanesulfonate, [BMpyr][TFO], with toluene, and heptane or cyclohexane were determined at T = 298.15 K and atmospheric pressure. In order to check if these ILs can be used as potential solvents for the extraction of toluene from aliphatic compounds, the ability of the ILs as solvents was evaluated in terms of selectivity and solute distribution ratio. The experimental data were correlated accurately with the Non Random Two-Liquid model.     

(Vapour + liquid) equilibria and excess Gibbs free energies of (cyclohexanone + 1-chlorobutane and + 1,1,1-trichloroethane) binary mixtures at temperatures from (298.15 to 318.15) K

The vapour pressures of binary (cyclohexanone + 1-chlorobutane, + 1,1,1-trichloroethane) mixtures were measured at the temperatures of (298.15, 308.15, and 318.15) K. The vapour pressures vs. liquid phase composition data have been used to calculate the excess molar Gibbs free energies G^E of the investigated systems, using Barker’s method. Redlich–Kister, Wilson, UNIQUAC, and NRTL equations, taking into account the vapour phase imperfection in terms of the 2-nd virial coefficient, have represented the G^E values. No significant difference between G^E values obtained with these equations has been observed.     

(Liquid + liquid) equilibria in ternary aqueous mixtures of phosphoric acid with organic solvents at T = 298.2 K

(Liquid + liquid) equilibrium (LLE) data for the ternary mixtures of {water (1) + phosphoric acid (2) + organic solvents (3)} were determined at T = 298.2 K and atmospheric pressure. The organic solvents were cyclohexane, 2-methyl-2-butanol (tert-amyl alcohol), and isobutyl acetate. All the investigated systems exhibit Type-1 behaviour of LLE. The immiscibility region was found to be larger for the (water + phosphoric acid + cyclohexane) ternary system. The experimental LLE results were correlated with the NRTL model, and the binary interaction parameters were obtained. The reliability of the experimental tie-line results was tested through the Othmer–Tobias and Bachman correlation equations. Distribution coefficients and separation factors were evaluated over the immiscibility regions and a comparison of the extracting capabilities of the solvents was made with respect to these factors. The experimental results indicate the superiority of cyclohexane as the preferred solvent for the extraction of phosphoric acid from its aqueous solutions.     

Isobaric (vapour + liquid) equilibria data for the binary systems {1,2-dichloroethane (1) + toluene (2)} and {1,2-dichloroethane (1) + acetic acid (2)} at atmospheric pressure

In this study for two binary systems {1,2-dichloroethane (1) + toluene (2)} and {1,2- dichloroethane (1) + acetic acid (2)}, the isobaric (vapour + liquid) equilibrium (VLE) data have been measured at atmospheric pressure. An all-glass Fischer–Labodest type capable of handling pressures from (0.25 to 400) kPa and temperatures up to 523.15 K was used. Experimental uncertainties for pressure, temperature, and composition have been calculated for each binary system. The data were correlated by means of the NRTL, UNIQUAC, UNIFAC, and Wilson models with satisfactory results.     

Thermophysical and sonochemical behaviour of binary mixtures of decan-1-ol with halohydrocarbons at (T = 293.15 and 313.15) K

Densities and ultrasonic velocities of binary mixtures of decan-1-ol with 1,2-dichloroethane, 1,2-dibromoethane, and 1,1,2,2-tetrachloroethene have been measured over the entire range of composition at T = (293.15 and 313.15) K and at atmospheric pressure. From these results, the excess molar volumes, molar free volumes, excess molar isentropic compressibilities, limiting excess partial molar volumes, and isentropic compressibilities, intermolecular free lengths, and available volumes by three methods, thermal expansion coefficients, parameters related to space-filling ability, intermolecular free lengths, and molecular radii have been calculated. The experimental ultrasonic velocities have been analyzed in terms of the ideal mixture relations of Nomoto and Van Dael, Jacobson’s free length, Schaaff’s collision factor, Flory’s statistical, and Prigogine–Flory–Patterson theories and thermoacoustical parameters.     

Isobaric (vapour + liquid) equilibria for the (1-propanol + 1-butanol) binary mixture at (53.3 and 91.3) kPa

In this work, isobaric (vapour + liquid) equilibrium data have been determined at (53.3 and 91.3) kPa for the binary mixtures of (1-propanol + 1-butanol). The thermodynamic consistency of the experimental values was checked by means the traditional area test and the direct test methods. According to the criteria for the test methods, the (vapour + liquid) equilibrium results were found to be thermodynamically consistent. The experimental values obtained were correlated by using the van Laar, Margules, Wilson, NRTL, and UNIQUAC activity-coefficient models. The binary interaction parameters of the activity-coefficient models have been determined and reported. They have been compared with those calculated by the activity-coefficient models. The average absolute deviation in boiling point and vapour-phase composition were determined. The calculated maximum average absolute deviations were 0.86 K and 0.0151 for the boiling point and vapour-phase composition, respectively. Therefore, it was shown that the activity-coefficient models used satisfactorily correlate the (vapour + liquid) equilibrium results of the mixture studied. However, the performance of the UNIQUAC model was superior to all other models mentioned.