光致聚合物全混洗光互连全息元件的制备

采用只对红光敏感的光致聚合物全息干版通过 Ｈｅ－Ｎｅ ６３２ｎｍ激光波长两次掩膜曝光,在面积为３０ｍｍ × ６０ｍｍ的全息干版上制备出全息光学元件,并成功地用于全混洗光学互连的实验演示。全息光学元件的衍射效率为 ４０～ ５２％。     

大调制度表面正弦图形制作工艺研究

表面起伏靶是惯性约束聚变（ＩＣＦ）分解实验中的重要实验用靶。为了得到调制深度大于１０μｍ光刻胶表面正弦图形，采用激光全息光刻的方法，固定曝光条件，同时保证曝光量足够，然后通过控制显影条件来实现起伏深度的变化。成功得到了调制深度分别为１５μｍ，２５μｍ，３５μｍ，周期分别为２０μｍ，５５μｍ和７５μｍ的表面正弦调制图形     

用空间滤波方法制作θ调制全息物片

给出了一种制作θ调制全息物片的新方法.在空间滤波光学系统的频谱面上放置只允许±1级频谱通过的滤波器,当单色平行光垂直照射物平面上的一维光栅时,将在像平面上得到两个重叠的一维光栅像,同时在成像区域形成光强按余弦规律变化的干涉条纹.用装有镂空模板和全息干版的可旋转组合干版夹对干涉条纹进行3次等时曝光,记录下3种不同干涉条纹方向的图案,即可制作出θ调制全息物片.     

激光全息照相实验探讨

1962年由杰尼休克提出的反射全息图的制法至今还是实验教学的一个内容。本文介绍对干版仅仅曝光一次的条件下,将白光反射再现全息图和激光透射再现全息图同时记录于同一干版上的实验。由此得到的全息照片不仅可在白光下再现。而且可在激光下再现,且两次再现的像既可相同也可不同。图1为实验光路图。如将图中物Ⅱ去掉,该图即变成记录激光透射再现全息图的光路;而将物     

体积相位全息光栅的设计与制备

本文指出全息干版薄膜在曝光后处理过程中的收缩性和折射率变化对制备全息光栅的周期、倾斜度、布喇格入射角及衍射角的影响问题，并根据实验数据对光栅设计进行修正，再结合Ｋｏｇｅｌｎｉｋ衍射方程及折射率调制度和曝光量的线性关系，在实验中基本上能准确设计出指定周期、倾斜度和衍射效率的全息光栅。     

散射光数字全息检测过程的统计光学讨论

从统计光学及标量衍射的基本理论出发,研究散射光数字全息重构波面与原散射波的关系,提出非平滑物体双曝光全息过程中散射光传播及干涉的简化模型.基于简化模型及计算机数值计算,对一个双曝光全息干涉系统转动形变的检测过程进行了理论模拟,并通过与该系统实验测量的比较,证实了简化模型的可行性.     

一种激光彩虹全息印刷品的颜色测量方法

由于激光彩虹全息印刷品表面光栅的特殊光学特性,其在白光下的成像会产生随机的彩虹干涉条纹,增加了全息印刷品颜色测量的难度。针对激光彩虹烟包印刷品的颜色测量问题,设计了一种全息印刷品的专用全息照明光源——穹顶光源,并以穹顶光源为照明基础构建了6通道线扫描电荷耦合器件(CCD)成像系统。在该环境下,采用基于主成分分析的光谱反射率重建方法对激光彩虹全息印刷品进行颜色测量。实验证明,提出的颜色测量方法,具有光谱重建精度高的特点,可以有效解决激光彩虹全息印刷品的颜色测量难题。     

体积相位全息光栅的设计与制备

本文指出全息干版薄膜在曝光后处理过程中的收缩性和折射率变化对制备全息光栅的周期、倾斜度、布喇格入射角及衍射角的影响问题,并根据实验数据对光栅设计进行修正,再结合Kogelnik衍射方程及折射率调制度和曝光量的线性关系,在实验中基本上能准确设计出指定周期、倾斜度和衍射效率的全息光栅。     

载波相移全息干涉计量

本文报道了一项称为载波相移全息干涉计量的自动相位估算的新技术。该技术的主要特点是不同相移的条纹图案可用双曝光全息重视。这样即可用来对与时间相关的问题进行自动相位估算。     

基于双波长像面数字全息显微的微通道检测

针对微流控芯片通道三维形貌的可视化测量需求,搭建了一套反射式离轴双波长像面数字全息显微测量系统。首先,利用分辨率靶和标准样片对系统的横向、纵向分辨率和放大倍数进行标定实验,结果表明双波长全息显微系统在横向宽度及纵向深度测量中具有较好的准确性和可行性。然后,利用该系统分别对由PDMS材料制成的直通道、圆形小室结构微流控芯片以及硅基底微流控芯片通道进行三维形貌检测,并得到定量结果：直通道结构深度为48.6μm,宽度为75.8μm;圆形小室微通道深度为48.5μm,宽度为76.6μm;硅基底微流控芯片测量得到通道深度为61.6μm。上述结果与白光干涉仪的测量结果具有良好的一致性,说明双波长全息显微系统具有较高的可靠性和准确性,可为微流控芯片微通道检测提供新的成像检测方法。     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.