Analytical Study of Fluid Flow and Heat Transfer during Forced Convection in a Composite Channel Partly Filled with a Brinkman–Forchheimer Porous Medium

In this paper, the problem of fully developed forced convection in a parallel-plate channel partly filled with a homogeneous porous material is considered. The porous material is attached to the walls of the channel, while the center of the channel is occupied by clear fluid. The flow in the porous material is described by a nonlinear Brinkman–Forchheimer-extended Darcy equation. Utilizing the boundary-layer approach, analytical solutions for the flow velocity, the temperature distribution, as well as for the Nusselt number are obtained. Dependence of the Nusselt number on several parameters of the problem is extensively investigated.     

The Onset of Convection in an Anisotropic Porous Layer Using a Thermal Non-Equilibrium Model

The stability of a horizontal fluid saturated anisotropic porous layer heated from below and cooled from above is examined analytically when the solid and fluid phases are not in local thermal equilibrium. Darcy model with anisotropic permeability is employed to describe the flow and a two-field model is used for energy equation each representing the solid and fluid phases separately. The linear stability theory is implemented to compute the critical Rayleigh number and the corresponding wavenumber for the onset of convective motion. The effect of thermal non-equilibrium and anisotropy in both mechanical and thermal properties of the porous medium on the onset of convection is discussed. Besides, asymptotic analysis for both very small and large values of the interphase heat transfer coefficient is also presented. An excellent agreement is found between the exact and asymptotic solutions. Some known results, which correspond to thermal equilibrium and isotropic porous medium, are recovered in limiting cases.     

Effects of viscous dissipation on thermally developing forced convection in a porous saturated circular tube with an isoflux wall

The viscous dissipation effect on forced convection in a porous saturated circular tube with an isoflux wall is investigated on the basis of the Brinkman flow model. For the thermally developing region, a numerical study is reported while a perturbation analysis is presented to find expressions for the temperature profile and the Nusselt number for the fully developed region. The fully developed Nusselt number found by numerical solution for the developing region is compared with that of asymptotic analysis and a good degree of agreement is observed.     

Turbulent forced convective heat transfer in two-phase evaporating droplet flow through a vertical pipe

A physical model was developed to study heat transfer in turbulent dispersed flow at very high vapor quality in a vertical pipe by numerically solving the coupling governing differential equations for both phases. Major heat transfer mechanisms included in the model were the thermal nonequilibrium effects, droplet vaporization, droplet deposition on the duct wall and thermal radiative transfer. The predicted results indicated that vapor superheating is dominant for the cases with high wall superheat, otherwise droplet vaporization dominates the energy transport processes. Heat transfer during the droplet-wall interaction only exists at low wall superheat but in small amounts.     

Convective heat transfer for cold tube bundles with ice formations in a stream of water at steady state

Experiments were conducted on cold-tube banks subjected to a cross-flow of water. The tubes were internally cooled below the freezing temperature and became enveloped in ice. The resulting ice shapes, which formed on the outside surfaces of the tubes, were allowed to stabilize, and their impact on the total steady-state rate of energy exchange between the tubes and the flowing water was investigated.

Both in-line and staggered tube-bank geometries were considered, with tests conducted in the low to moderate Reynolds number range (Re_d = 100−2,000) and for cooling-temperature ratio variations of 0.5 < Θ < 8. The ice formations were directly observed and photographed, and the total heat transfer rate for the tube bank was inferred from a simple energy balance on the system.

The ice shapes that formed around the tubes were described by one of three distinct categories: ice formutions with no linkage occurring between any adjacent tubes; ice formations with partial linkage of some adjacent tubes; and, for the staggered tube bank, a complete linkage of a majority of the tubes.

The experiments showed that the ice formations dramatically affected the convective heat transfer rate of the tube banks (when compared to nonicing tube banks at the same Re_d) and that the change in heat transfer rate is dependent on the tube-bank geometry. In the no-link category, the ice formations were found to either increase or decrease the tube-bank heat transfer rate depending on the amount of ice-build accumulation, the staggered configuration showing a greater overall rise with Θ than the in-line geometry. Ice linkage between adjacent tubes was found to be detrimental to the heat transfer rate of the staggered bank; however, the same phenomenon on the in-line tube bank did not seriously impede its heat transfer rate. Correlations expressing the heat transfer behavior of both in-line and staggered tube banks with ice formations at steady state have been developed.     

Heat transfer to non-Newtonian fluids in laminar flow through rectangular ducts

Heat transfer to non-newtonian fluids flowing laminarly through rectangular ducts is examined. The conservation equations of mass, momentum, and energy are solved numerically with the aid of a finite volume technique. The viscoelastic behavior of the fluid is represented by the Criminale-Ericksen-Filbey (CEF) constitutive equation. Secondary flows occur due to the elastic behavior of the fluid, and, consequently, heat transfer is strongly enhanced. It is observed that shear thinning yields negligible heat transfer enhancement effect, when compared with the secondary flow effect. Maximum heat transfer is shown to occur for some combinations of parameters. Thus, there are optimal combinations of aspect ratio and Reynolds numbers, which depend on the fluid's mechanical behavior. This result can be usefully explored in thermal designs of certain industrial processes.     

An experimental investigation of heat transfer characteristics for turbulent flow over staggered ribs in a square duct

An experimental study of developing and fully developed turbulent air flow in a square duct with two opposite rib-roughened walls in which the ribs are attached in a staggered fashion was conducted to determine the heat transfer characteristics. The rib height-to-hydraulic diameter ratio (e/D_H) was 0.19, the rib pitch-to-height ratio (p/e) was 5.31. The streamwise temperature distribution was measured, and a law of the wall for the thermal boundary layer at each free-stream turbulence level was obtained. The effects of free-stream turbulence intensity with variations of 4–11% on heat transfer coefficients were also examined. Finally, the relationship between Nusselt number and Reynolds number was correlated. The results might be used in the design of turbine blade cooling channels.     

Numerical study of flow and thermal behaviour of lid‐driven flows in cavities of small aspect ratios

Numerical study has been performed to investigate the effects of cavity shape on flow and heat transfer characteristics of the lid‐driven cavity flows. Dependence of flow and thermal behaviour on the aspect ratio of the cavities is also evaluated. Three types of the cross‐sectional shape, namely, circular, triangular, and rectangular, and four aspect ratios, 0.133, 0.207, 0.288, and 0.5, are taken into account to construct twelve possible combinations; however, attention is focused on the small‐aspect‐ratio situations. Value of the Reynolds number considered in this study is varied between 100 and 1800. For the cases considered in this study a major clockwise vortex driven by the moving lid prevailing in the cavity is always observed. When the Reynolds number is fixed, the rectangular cavity produces strongest lid‐driven flow, and the triangular cavity weakest. For the cases at small aspect ratio and low Reynolds number, the streamlines appear symmetric fore‐and‐aft with respect to the central line at x/L = 0.5. Data for the local and average Nusselt numbers are also provided. For rectangular cavities, it is observed that case 1/5R produces the highest average Nusselt number at any Reynolds number. Among the twelve possible geometric cases considered herein, the highest and lowest average Nusselt numbers are found with cases 1/6T and 1/2C, respectively. Copyright © 2006 John Wiley & Sons, Ltd.     

TEMPERATURE PROFILES OF LOCAL THERMAL NONEQUILIBRIUM FOR THERMAL DEVELOPING FORCED CONVECTION IN POROUS MEDIUM PARALLEL PLATE CHANNEL

Based on the two-energy equation model, taking into account viscous dissipation due to the interaction between solid skeleton and pore fluid flow, temperature expressions of the solid skeleton and pore fluid flow are obtained analytically for the thermally developing forced convection in a saturated porous medium parallel plate channel, with walls being at constant temperature. It is proved that the temperatures of the two phases for the local thermal nonequilibrium approach to the temperature derived from the one-energy equation model for the local thermal equilibrium when the heat exchange coefficient goes to infinite. The temperature profiles are shown in figures for different dimensionless parameters and the effects of the parameters on the local thermal nonequilibrium are revealed by parameter study.     

Radiation and laminar forced convection of non-Newtonian fluid in a circular tube

Interaction of radiation with thermally developing laminar forced convection of power-law, non-Newtonian, absorbing, emitting, isotropically scattering, gray fluid through an isothermal circular tube with a black boundary is investigated. The energy equation is solved by an implicit finite-difference scheme, while the radiation part of the problem is solved by the collocation method. Results are presented for the effects of conduction-to-radiation parameter, single scattering albedo, optical thickness and the inlet temperature on the local Nusselt number along the tube for the case of power-law index n=1/3, 1 and 3, where the case n=1 corresponds to the Newtonian fluid.