Sulfurization of Pt/Al2O3?Cl catalysts. IV. Adsorption sites of H2S on Al2O3, Al2O3?Cl and Pt/Al2O3?Cl

Chemisorption of H₂S on Al₂O₃, Al₂O₃–Cl and Pt/Al₂O₃–Cl has been studied by gravimetry and IR spectroscopy. The influence of the amount of Cl on the H₂S adsorption equilibrium value and the nature of the adsorption sites at low and high coverages are discussed.

---

H₂S Al₂O₃, Al₂O₃–Cl Pt/Al₂O₃–Cl . Cl H₂S, .

     

LaCoO3对H2S选择氧化性能的影响

使用溶胶-凝胶法制备了LaCoO₃催化剂,采用XRD、BET和XPS等方式对催化剂进行了表征,考察了该催化剂制备过程中煅烧温度、表面活性剂PEG-6000和PEG-20000含量对其H₂S选择氧化制硫磺反应催化活性的影响。结果表明,表面活性剂PEG-6000及PEG-20000的添加能明显提高LaCoO₃的催化活性。0.02 mol La（NO₃）₃+0.02mol Co（NO₃）₂溶液中添加0.30 g PEG-20000、煅烧温度为650℃时所制备的LaCoO₃催化活性最好;在最佳反应温度260℃下,H₂S的转化率达到96.10%,硫选择性为93.77%。     

Interaction of propylene with a V2O5/Al2O3 catalyst

IR-spectroscopic studies indicate that on the oxidized surface of V₂O₅/Al₂O₃ catalysts propylene interacts mainly with Brönsted acid centers to form an alcoholate type complex transforming into acetone. On the reduced surface propylene is stabilized as a -complex of V³⁺ and V⁴⁺ ions.

---

- , V₂O₅/Al₂O₃ , . - V³⁺ V⁴⁺.

     

Al_(2)O_(3)-Zn-K催化水解COS和CS_(2)的研究北大核心CSCD

以活性氧化铝为载体,浸渍负载Zn、K活性组分,制备优选Al_(2)O_(3)-Zn-K催化剂.考察了反应工艺条件对COS、CS_(2)脱除精度的影响,并对失活的催化剂进行表征,分析催化剂的失活原因.结果表明,负载Zn、K活性组分后,催化剂的弱碱性中心显著提高,负载量为4%时催化剂具有最优的水解活性.在180℃催化水解过程中,工艺条件对CS_(2)脱除精度的影响较COS更为明显.无氧条件下,反应过程中生成的硫酸盐和表面活性物质发生迁移导致催化剂碱性中心减少是催化剂失活的主要原因.     

Effect of H2S on pyridine HDN over Ir, Mo and Ir-Mo/Al2O3 sulfide catalysts

The effect of H₂S on hydrodenitrogenation (HDN) of pyridine over alumina supported Mo, Ir and mixed Ir-Mo sulfide catalysts was studied. The pyridine hydrogenation was inhibited by H₂S on all catalysts, while the cleavage of the C-N bond of intermediate piperidine was facilitated on the Mo and inhibited on the Ir and Ir-Mo catalysts. The promotional offect between Ir and Mo was observed in the piperidine cleavage both in the presence and absence of H₂S.     

AC electrical conductivity measurements during H2-TPD experiments on a Pt/Al2O3 catalyst

The kinetics of the reaction of cyclopentanol with PhNCO or OCN(C₆H₁₂)NCO was studied in toluene, di-n-butyl ether and acetonitrile. The results suggest a predominant influence of the aggregation state of alcohol.     

Enhancement of H2- and retardation of O2-adsorption during O2?H2 titration cycles on Pt?Al2O3 catalyst surfaces

The title effects can be eliminated if the slow bleeding of H₂ from freshly reduced CuO-towers (often used as O₂-getters in purifying N₂ carrier gas) can be avoided, then H₂–O₂ titrations of Pt surfaces give consistent values from almost the first titration. Water injected at 25 °C also hardly affects the titer values.

---

H₂ O₂ , H₂ CuO ( O₂ N₂ — -). H₂–O₂ Pt . , 25° C, .

     

Sulfuration of Pt/Al2O3, Pt?Re/Al2O3 and Pt?Ir/Al2O3 catalysts

Three reforming catalysts Pt/Al₂O₃, Pt–Ir/Al₂O₃ and Pt–Re/Al₂O₃ have been sulfurated by H₂S and tested by their activities in benzene hydrogenation. By treatment at 500°C under hydrogen flow only a part of the initial activity of the non-sulfurated catalyst is retained. So only a part of the adsorbed sulfur is easily removed in these conditions. The remaining sulfur for each of the catalysts (Pt/Al₂O₃, Pt–Ir/Al₂O₃ and Pt–Re/Al₂O₃) gives the same atomic ratio of 0.5 sulfur atom per accessible metallic atom.

---

Pt/Al₂O₃, Pt–Ir/Al₂O₃ Pt–Pe/Al₂O₃ . 500°C H₂ . . ., . (Pt/Al₂O₃, Pt–Ir/Al₂O₃ Pt–Pe/Al₂O₃) 0,5.

     

Active site for hydrogenation on reduced V2O5/Al2O3 catalyst

Active sites for C₂H₄ hydrogenation produced by reduction of V₂O₅/Al₂O₃ catalyst pretreated at 450°C were found to be composed of both strong Lewis acid sites associated with V⁴⁺ and basic sites of Al₂O₃. C₂H₄ polymerization concurrent with hydrogenation was assumed to occur on Lewis acid sites with higher acid strengths than those of the hydrogenation sites.

---

C₂H₄, V₂O₅/Al₂O₃, 450°C, , Al₂O₃. , , , C₂H₄.

     

TPR studies on steam reforming of 2-propanol on Rh/Al2O3, Ru/Al2O3 and Pd/Al2O3

Reaction pathways for steam reforming of 2-propanol (isopropyl alcohol, IPA) on Rh/Al₂O₃, Ru/Al₂O₃ and Pd/Al₂O₃ have been studied by temperature-programmed reactions (TPRs) of IPA and acetone in the presence of steam. The results of TPRs suggest that that of IPA on Rh/Al₂O₃ and Ru/Al₂O₃ proceeds via acetone, while the steam reforming of IPA on Pd/Al₂O₃ takes place via propene from acetone. This revised version was published online in August 2006 with corrections to the Cover Date.     

Infrared spectroscopic studies of H2S adsorption on γ-Al2O3

IR spectra of H₂S adsorbed in various quantities on -Al₂O₃ have been studied. The method of spectral probes has been used to determine the extent of H₂S blocking of Lewis acid and basic centers.

---

- , -Al₂O₃. .

     

Kinetics of Co?Mo/Al2O3 catalyst reduction

According to kinetic studies on the reduction of commercial Co–Mo/Al₂O₃ and model catalysts in H₂ at 523–773 K, the kinetic curves for the reduction process have been determined. The reduction rate is shown to be higher for the commercial catalyst. Activation energies E_act for the reduction of several forms of Mo and Co in Co–Mo/Al₂O₃ catalysts are presented.

---

H₂ 523–773 . , : Mo Co .

     

Kinetic studies of Pt/Al2O3 catalyst pellets with nonuniform activity

Catalysts with nonuniform distribution of the catalytically active component (Pt) over their porous support (Al₂O₃) have been studied. A nonuniform activity distribution changes not only the reaction rate but also the kinetics can be different on these catalysts.

---

(Pt) (Al₂O₃). , , .

     

Isomerization and secondary metathesis of 2-butenes over a MoO3/Al2O3 catalyst

Transformation of cis- and trans-2-butene at 40°C was investigated over a MoO₃/A₂O₃ catalyst reduced with hydrogen and subjected to different pretreatments. Isomerization is accelerated by hydrogen preadsorbed either at low or high temperatures. The cometathesis of 2-butenes with the 1-butene intermediate, however, is enhanced only by hydrogen preadsorbed at low and suppressed by hydrogen adsorbed at high temperatures.

---

- -2- 40°C MoO₃/Al₂O₃, . , , . 2- 1- , ; , .

     

Investigation of the acidity of Ni/Al2O3 and Ni/SiO2?Al2O3 catalysts

Acidity of Ni-modified alumina and silica-alumina catalysts was determined using n-butylamine titration and pyridine adsorption methods. Strong influence of Ni²⁺ ions on the Brönsted acidity of silicaalumina was observed. Improved Brönsted acidity of such system was confirmed by the results of the test reaction.     

Structural changes resulting from doping Ti2O3 with Sc2O3 or Al2O3

The crystal structures of (Ti_1?xSc_x)₂O₃, x = 0.0038, 0.0109, and 0.0413, and of (Ti_0.99Al_0.01)₂O₃, have been determined from X-ray diffraction data collected from single crystals using an automated diffractometer, and have been refined to weighted residuals of 25–34. Cell constants have also been determined for x = 0.0005, 0.0019, and 0.0232. The compounds are rhombohedral, space group $\text{R}\text{3}\text{c}$, and are isomorphous with α-Al₂O₃. The hexagonal cell dimensions range from a = 5.1573(2)Å, c = 13.613(1)Å for (Ti_0.9995Sc_0.0005)₂O₃ to a = 5.1659(4)Å, c = 13.644(1)Å for (Ti_0.9587Sc_0.0413)₂O₃, and a = 5.1526(2)Å, c = 13.609(1)Å for (Ti_0.99Al_0.01)₂O₃. Sc and Al substitution cause similar increases in the short near-neighbor metal-metal distance across the shared octahedral face; for Sc doping the increase is from 2.578(1) Å in pure Ti₂O₃ to 2.597(1) Å in (Ti_0.9587Sc_0.0413)₂O₃. By contrast, changes in the metal-metal distance across the shared octahedral edge appear to be governed by ionic size effects. The distance increases from 2.994(1) Å in Ti₂O₃ to 3.000(1) Å in (Ti_0.9587Sc_0.0413)₂O₃ and decreases to 2.991(1) Å in (Ti_0.99Al_0.01)₂O₃.     

Strong H2 chemisorption on Al2O3 or SiO2 supported group VIII metals

Following hydrogen treatments at high temperature a decrease in hydrogen chemisorption at room temperature is observed in almost all group VIII elements supported on SiO₂ or Al₂O₃. The effect is attributed to self inhibition by strongly chemisorbed hydrogen on the metals.

---

VIII , SiO₂ Al₂O₃. .

     

Determination of the exposed surface area of V2O5 on a V2O5/Al2O3 catalyst

NH₃, NO and CO₂ were tested as adsorbates for selective determination of exposed surface area of V₂O₅ on a V₂O₅/Al₂O₃ catalyst. The most promising appears to be CO₂ which interacts with the support Al₂O₃ only.

---

NH₃, NO CO₂ V₂O₅ V₂O₅/Al₂O₃. CO₂, Al₂O₃.

     

Surface acidity of the La2O3/Al2O3 system

Surface acidity of aluminium oxide containing 5 wt. % lanthanum oxide has been determined by IR spectroscopy. Strength of Lewis sites of the La₂O₃/Al₂O₃ system was lower than that of pure aluminium oxide. However, the presence of La₂O₃ in aluminium oxide increased the thermostability of these sites in the mixed system.