曲率效应对超小碳纳米管电子性质的影响

在考虑曲率效应的情况下,在螺旋坐标系下解析地推导了非手性的碳纳米管(SWNTs)(包括扶手椅型和锯齿型)的能量色散关系,并分析了曲率效应对超小扶手椅型SWNTs的能带、能隙和导电能力及其对超小锯齿型SWNTs(包括扶手椅型和锯齿型)的能隙的影响.     

单层碳纳米管的磁输运特性

依据磁场中Boltzmann输运方程及单层磁纳米管(SWNTs)的能量色散关系,对单个SWNTs中轴向磁场诱发的低温磁阻进行了数值计算.分析表明:当电子以低能输运时,SWNTs的磁阻有明显的Aharonov-Bohn(A-B)效应,与并SWNTs的能隙相对应.     

一种新的核磁共振手性溶解剂罗通定

以罗通定为手性溶解剂,用核磁共振方法分析了几种小消旋羧酸。考察了化学计量比和浓度对化学位移不等价（△δ）的影响,并比较了在溶剂ＣＤＣｌ３或Ｃ６Ｄ６中,作为羧酸用手性溶解剂罗通定和（Ｓ）－（－）－α－苯乙胺的效果。     

聚(2-甲氧基-5-辛氧基)对苯乙炔/单壁碳纳米管复合材料的光致发光特性

采用原位聚合法在无水四氢呋喃(THF)溶液中制备了聚(2-甲氧基-5-辛氧基)对苯乙炔(MOPPV)/单壁碳纳米管(SWNTs)复合材料。通过对该复合材料的红外光谱、X射线衍射、透射电镜、扫描电镜等的研究,证实SWNTs已聚合到MOPPV上且被MOPPV紧密有效地包覆,形成了纳米线网状结构。通过紫外-可见(UV-Vis)吸收光谱和光致发光(PL)谱发现:随着SWNTs掺杂量的增加,该复合材料的吸收强度逐渐增强且最大吸收峰出现红移,其发光强度呈现先升高后降低的趋势,发光峰蓝移。当SWNTs掺杂质量分数为3.85%时,复合材料的发光强度最大,此时最大发光峰位较纯MOPPV蓝移8 nm。研究结果表明:在MOPPV中掺入一定量的SWNTs,能有效地增强复合材料的光致发光强度。     

碳纳米管中封装富勒烯的机理

利用经典分子动力学模型,发现C60进入单壁碳纳米管(SWNTs)形成(C60)n@SWNTs的吸入和俘获机理.揭示了吸入和俘获势垒只局域于SWNTs的管口区,而在SWNTs的管内区,C60沿管轴方向的运动几乎不受力.最后,系统地计算了吸入和俘获势垒随SWNTs管径的变化,发现只有当SWNTs的管径大于阈值1238nm时才能吸入C 关键词： 富勒烯相关材料 碳纳米管 类虹吸作用     

双包层手性光纤中导模的光功率特性

在对W型阶跃双包层手性光纤进行解析求解的基础上,对几个低阶导模的功率特性进行了仔细的研究.对典型的内包层厚度,计算了几个低阶模留在纤芯中的光功率随纤芯和内外包层的手性参数的变化关系曲线,讨论了纤芯和内外包层的手性参量以及内包层厚度对不同符号模式的功率特性的影响.内包层厚度越大,功率越被限制在纤芯中.随着纤芯中手性参量的增大, HE－11模和HE－21模（HE01模）限制在纤芯中的光功率缓慢增加,而HE11模和HE21模（HE02模）限制在纤芯中的光功率则逐渐减小.包层手性参量的作用正好与此相反.     

非掺杂半导体型碳纳米管低温电导的非线性特征

依据相空间玻耳兹曼输运方程和碳纳米管的电子结构,对非掺杂单个半导体型单层碳纳米管（SWNTs）的低温电导特性进行数值计算,结果表明：SWNTs电导是量子化的,并呈现明显的非线性特征。     

手性schiff碱金属配合物N,N‘—双水杨醛缩—1,2—环己二胺合镍（Ⅱ） …

利用经外、拉曼光谱研究一种手性ｓｃｈｉｆｆ碱金属配合物Ｎ,Ｎ’－双水杨醛缩－１,２－环己二胺合镍（Ⅱ）的结构特点。表明（Ｒ,Ｒ）－ＳＡＬＥＮ－Ｎｉ（Ⅱ）和（Ｓ,Ｓ）－ＳＡＬＥＮ－Ｎｉ（Ⅱ）的光谱完全相同,而与外消旋体的光普有很大差别。     

磁场中手性碳纳米环的类超导效应

利用导出的任意手性碳纳米环（TCNTs）的电子状态－能量关系式,对磁场中任意手性TCNTs所具有的类似超导环的性质及持续电流的手性效应进行理论探讨。在T＝0K时,金属型和半导体型TCNTs象介观一维正常金属环一样具有类似超导环的性质、即持续电流以磁通量子φ0为周期随φ线性变化,且对手性角θ、环半径R极为敏感。手性TCNTs类似超导环的性质比高对称TCNTs明显得多,但随R增大而减弱,且减弱的快慢也与手性角θ有关。     

H-NMR测定手性化合物的对映体过量

概述了研究手性化合物的核磁共振方法,对１Ｈ－ＮＭＲ 测定手性化合物的对映体过量进行了综述。并将此法与旋光度测定法和色谱法进行了比较。     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.