引出口的几何参数对团簇形成影响的DSMC研究

利用直接模拟蒙特卡洛方法(DSMC),模拟了气体凝聚团簇源的引出口尺寸和中心位置不同的条件下,Cu团簇的尺寸分布以及模拟了随着时间的增长,腔内团簇数目的变化.模拟结果表明:引出口的直径越大,产生大团簇的比例越小;在引出口的直径相同的情况下,引出口的中心位置偏离坐标原点比在原点产生的大团簇的比例要大;随着时间的增长,腔内团簇数目先变多后变少.     

Effect of ausforming temperature and strain on the bainitic transformation kinetics of a low carbon boron steel

The effect of ausforming temperature and strain on the bainitic transformation kinetics was investigated in a low carbon boron steel. A new mechanism, which is based on the competition between the increase in nucleation rate and the decrease in average volume of bainite sheaf after deformation, is proposed. The increase in nucleation rate is due to the decrease in boron concentration at the grain boundaries after small deformation and the formation of sub-grain boundaries at the grain interior after large deformation. The decrease in average volume of bainite sheaf is ascribed to the frequent impingement of bainite sub-units after deformation. The increase in nucleation rate after deformation results in the decrease in incubation time, which is confirmed from the experiment. The increase in nucleation rate overcomes the decrease in average volume of bainite sheaf, resulting in the increase in transformation velocity and volume fraction after small deformation. On the contrary, the decrease in the average volume of bainite sheaf overcomes the increase in nucleation rate after large deformation, leading to the decrease in transformation velocity and volume fraction of bainite.     

Photostability of a C<Subscript>60</Subscript> fullerene coating as a solid-phase photosensitizer of singlet oxygen

The stability of the optical properties and the generation efficiency of singlet oxygen of a solidphase photosensitizer based on fullerene in an aqueous suspension subjected to prolonged intense irradiation with visible light are studied in comparison with a photosensitizer based on methylene blue in an aqueous solution. Changes in the absorption spectra show that, as a result of 20-min irradiation, the content of fullerene decreases by 2% from its initial value, while that of methylene blue decreases by 19%. In both cases, the dynamics of the decrease in the photosensitizing ability of the photosensitizers in the course of their irradiation correlates with the changes in their spectra, but the magnitude of this decrease in the case of the solid-phase photosensitizer is greater than the magnitude of its spectral changes because of the surface nature of the photosensitization process. The study of the absorption spectra of fullerene coatings shows that their irradiation in water or in air causes the same photodegradation of fullerene. At the same time, studies with the help of the electron spin resonance (ESR) technique reveal differences in the nature of processes undergone by fullerene in water and in air.     

Self-assembled monolayer resists and nanoscale lithography of silicon dioxide thin films by chemically enhanced vapor etching (CEVE)

We report on the use of electron-beam exposed monolayers of undecylenic acid in the etch rate enhancement of silicon dioxide films in HF vapor for the formation of nanoscale features in the oxide. Variations of the etching characteristics with electron beam parameters are examined and the results analyzed in terms of proposed models of the etching mechanism. Apparent variations in the relative concentrations of etch initiator with the thermal history of the samples prior to etching provides support for the dominant etch initiator within this system as the carboxylic acid moiety bound at the oxide surface. Other variations in the etching characteristics are discussed in terms of differences in localized concentrations of hydrocarbon crosslinks and the effect that this has upon the etch initiation. The process has been employed in the production of features in silicon dioxide surface masks with sizes down to 50 nm.     

Waveguide modes of 1D photonic crystals in a transverse magnetic field

We analyze waveguide modes in 1D photonic crystals containing layers magnetized in the plane. It is shown that the magnetooptical nonreciprocity effect emerges in such structures during the propagation of waveguide modes along the layers and perpendicularly to the magnetization. This effect involves a change in the phase velocity of the mode upon reversal of the direction of magnetization. Comparison of the effects in a nonmagnetic photonic crystal with an additional magnetic layer and in a photonic crystal with magnetic layers shows that the magnitude of this effect is several times larger in the former case in spite of the fact that the electromagnetic field of the modes in the latter case is localized in magnetic regions more strongly. This is associated with asymmetry of the dielectric layers contacting with the magnetic layer in the former case. This effect is important for controlling waveguide structure modes with the help of an external magnetic field.     

CPL技术在空间飞行器上的应用

本文对ＣＰＬ技术进行了简要概述,介绍了其工作原理与工作特性,并讨论了ＣＰＬ技术在空间飞行器上的可能应用方式。其中,对ＣＰＬ技术应用于空间设备的散热进行了全面阐述,并给予理论分析;此外,对ＣＰＬ技术应用于空间设备的主动热控制,也作了简要介绍;对ＣＰＬ技术未来有发展前景的应用方式进行了展望。     

Spectral luminescence properties of indotricarbocyanine dye in biological tissues

We have established that the shape and position of the maximum in the fluorescence spectrum of an indotricarbocyanine dye in tumor and normal tissues in vivo change over time after intravenous injection of the dye. Based on analysis of the spectral properties of the dye in vivo and in blood plasma, the dependence of the properties on the time since injection has shown that in the living body, the environment of the dye molecule changes as the photosensitizer goes from the skin into the tissue. We have established that in tissues in vivo, the dye molecules are localized in a region with low dielectric constant of the medium. We have shown that the change in the ratio of the concentrations of the different forms of hemoglobin in the blood has an effect on the absorption and shape of the fluorescence spectrum of the dye in tissues in vivo.     

Influence of X-ray on the autophagic-lysosomal system in rat pancreatic acini

Lysosomes have an important role in radiation injury of cells and tissues. Activation of autophagy is frequently observed in different types of pathological tissue degeneration. In radiation response it increases in some cases, and lysosomes are responsible for regulated degradation of the autophagic vacuoles. Lysosomes are also involved in ionizing radiation induced cell death. In apoptosis lysosomes degrade content of the phagocytotic vacuoles derived from engulfed apoptotic blebs. On the other hand lysosomal enzymes discharged from disintegrated cells have a key role in induction of necrotic changes. In this work we investigate autophagy and lysosomal protein degradation in the relatively radiation insensitive exocrine pancreatic acini in vivo and in vitro. Type of cell death induced by X-ray was also examined in relation to the changes of the lysosomal processes. In 5h after 16 Gy in vivo whole body irradiation we observed significant increase in the cytoplasmic volume fraction of autophagic vacuoles and in the number of apoptotic cells in vivo. But in the acini isolated from irradiated rats we could not detect a change in the lysosomal degradation of intracellular proteins. Therefore irradiation probably influences the autophagy in an earlier step than lysosomal degradation. Extended necrotic lesions were not observed in vivo as long as 48 h. Isolated pancreatic acini usually contain more autophagic vacuoles than in vivo, but we could not observe additional increase in autophagy after 8 Gy, in vitro irradiation. Lysosomal degradation of intracellular proteins was also unaltered after 8 Gy, in vitro irradiation. Other biochemical functional parameters of the isolated pancreatic acini, like protein synthesis and amylase secretion were not changed either after 8 Gy, in vitro X-ray treatment. These results indicate that pancreatic acinar cells in vitro have a high tolerance to irradiation. The observed in vivo radiation induced changes of the exocrine pancreas are possibly indirectly induced by injuries of more sensitive mechanisms.     

Certain general questions of fast-electron transport II. Kinetic equations and conditions governing the accelerated motion of fast electrons in dielectrics in an electric field

A general kinetic equation for the differential density of fast particles moving in a medium in an external field is derived on the basis of the continuity equation in phase space. An equation is written for the differential flux in the case of fixed target particles. This equation is used to derive equations for fast electrons; account is taken of the coupling of energy-loss and scattering events in an electric field for various particular problems analogous to those studied in the theory of electron transport in the absence of a field. The kinetic equations are used to analyze the conditions governing accelerated motion of electrons in a dielectric in an external electric field in the continuous-deceleration approximation. Account is taken of fluctuations in the energy loss and of multiple scattering. There are two energy ranges of particles moving in a dielectric in which accelerated motion can occur; in the case of an electron beam with a continuous energy spectrum, this acceleration would be accompanied by monochromatization of the beam.Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 2, pp. 7–12, February, 1972.     

Technological applications of Mössbauer spectroscopy

A brief review is given of some recent industrial applications of Mossbauer spectroscopy. One of the most desirable futures of the Mossbauer effect is the feasibility of performing in situ measurements. Such measurements are extremely important especially in the upgrading of coal derived liquids. Such applications have been very successful in understanding the role of iron sulfides stoichiometries in direct coal liquefaction. The use of in situ techniques in invaluable in the investigation of the metal support interaction and their relation to carburization processes in Fischer-Tropsch reactions. Some examples of such applications will be presented in this paper. In this paper, emphasis will be placed in the use of a multiple technique approach to elucidate scientific problems of industrial importance.