间插取样光纤光栅多通道滤波器

对间插取样光纤光栅进行了理论分析和数值模拟,并依照理论分析及数值模拟的结果进行了实验研究,采用逐点扫描曝光工艺首次制作出具有10个以上通道数的光纤光栅梳状滤波器。这种方法工艺简单,控制精度要求低,是一种具有良好实用化前景的多通道光纤光栅滤波器制作技术。     

Novel optical comb filter based on full-duty-cycle sampled fiber Bragg grating with spectral Talbot effect

Spectral Talbot effect in full-duty-cycle sampled fiber Bragg grating is proposed and numerically demonstrated for the first time. Based on analysis and simulations, it is shown that high-performance comb filters can be realized with the proposed structure. Moreover, it is found that channel count scales linearly with the number of samples and that high-quality filtering is still available with some fabrication errors.     

Spectral Talbot phenomena in sampled arbitrarily chirped Bragg gratings

We derive the general conditions for which spectral Talbot phenomena, both integer and fractional self-imaging, can be observed in sampled arbitrarily chirped fiber Bragg gratings. These results are a generalization of those previously reported in [C. Wang, J. Azaña, L.R. Chen, Opt. Lett. 29(14) (2004) 1590] in which spectral Talbot phenomena were observed in sampled linearly chirped fiber Bragg gratings. We confirm our theoretical derivations with numerical simulations.     

取样布拉格光纤光栅的传输矩阵

根据在一般坐标系下均匀布拉格光纤光栅的传输矩阵,得到了取样布拉格光纤光栅的传输矩阵。利用傅里叶变换得到了取样布拉格光纤光栅的谐振方程。结果表明,在不考虑平均折射率变化的情况下,谐振峰的位置是由光栅的周期和取样周期共同确定的,与取样时的占空比、光栅长度和耦合系数没有关系。类似于物理光栅,取样布拉格光纤光栅也存在缺级现象,给出了出现缺级的条件。     

Analysis of sampled fiber Bragg gratings in polarization-maintaining fiber

A novel type of sampled fiber Bragg gratings （FBGs） written in polarization-maintaining fiber （PMF） is proposed. The reflection spectrum, time delay, and group velocity dispersion （GVD） of the gratings are analyzed. In addition, the reflection spectrum is optimized by apodization. The scheme of multi-wavelength output based on the gratings is proposed, which could be used as a multi-wavelength polarization filter in the density wavelength division multiplexed （DWDM） system.     

Group-delay ripple correction in chirped fiber Bragg gratings

Group-delay ripple (GDR) introduced by systematic and random errors in chirped fiber Bragg grating fabrication is the most significant impediment to application of these devices in optical communication systems. We suggest and demonstrate a novel iterative procedure for GDR correction by subsequent UV exposure by use of a simple solution of the inverse problem for the coupled-wave equation. Our method is partly based but does not fully rely on the accuracy of this solution. In the experiment we achieved substantial reduction of the low-frequency group-delay ripple, from +/- 15 to +/- 2 ps, which resulted in dramatic improvement of the optical signal-to-noise-ratio system penalty, from 7 to less than 1 dB, for a chirped fiber Bragg grating used as a dispersion compensator in a 40-Gbit/s carrier-suppressed return-to-zero system.     

Multiplexing technique using amplitude-modulated chirped fiber Bragg gratings

We propose a new multiplexing technique using amplitude-modulated chirped fiber Bragg gratings that have an identical center Bragg wavelength. Each grating is inscribed with a unique amplitude modulation that allows them to be multiplexed with complete overlapping within a certain bandwidth. To demodulate the multiplexed signal, the discrete wavelet transform is employed. Concurrently, a wavelet denoising technique is used to reduce the noise. This proposed multiplexing technique has been verified through strain measurements. Experimental results showed that for strains applied up to 1250 microepsilon the absolute error and cross-talk are within +/-20 microepsilon and 16 microepsilon, respectively. A strain resolution of 4 microepsilon is obtained.     

Thermally switchable and discretely tunable comb filter with a linearly chirped fiber Bragg grating

We propose and experimentally demonstrate a novel switchable and discretely tunable comb filter based on a thermally induced linearly chirped fiber Bragg grating. Experimentally we achieved a thermally induced optical bandpass filter that has eight switchable passband peaks with peak separations of 1.6 and 3.2 nm, a very narrow bandwidth (as small as 10 pm) of each peak, a tunable range of 16.5 nm, and a greater than 25 dB rejection ratio. Two spectral peaks separated by only 0.8 nm were also obtained with this comb filter. This filter provides the unique advantages of an all-fiber structure, switchable spectral peaks, independent tuning of the center wavelength and wavelength spacing of the spectral peaks, low polarization sensitivity, simple structure, ease of fabrication, and low cost.     

波长可调谐取样光纤光栅激光器的输出特性研究

建立了具有两个取样周期略有不同的取样光纤光栅反射镜的Vernier波长调谐机制的光纤分布布拉格反射式激光器的数值仿真模型,对激光器的输出特性进行了分析. 研究了激光器输出特性随着激光器前后光栅反射镜波长以及前后光栅反射镜反射率的变化关系. 提出了对两取样光栅反射率的优化配置方案,可以使输出激光的边模抑制比有所提高;同时对波长调节方式也进行了探讨;进行了实验研究. 关键词： 取样光纤光栅 光纤激光器 波长可调谐激光器     

All-optical microwave bandpass filter with negative coefficients based on a phase modulator and linearly chirped fiber Bragg gratings

A novel all-optical microwave bandpass filter with negative coefficients is presented. Positive and negative coefficients are obtained through conversion from phase modulation to intensity modulation by passing the phase-modulated optical carriers through chirped fiber Bragg gratings having group-delay responses with positive and negative slopes. A two-tap transversal microwave filter with one negative coefficient is experimentally implemented.     

Thermally tunable narrow-bandpass filter based on a linearly chirped fiber Bragg grating

We propose a new method for the development of a tunable optical bandpass filter (TOBF) based on a linearly chirped fiber Bragg grating (LCFBG). A NiCr wire heater is used to heat the LCFBG at a small point to introduce a narrow passband within the stop band of the LCFBG. The central wavelength of the passband is tuned by scanning the wire heater along the LCFBG. As an example demonstrating the effectiveness of the proposed method, we demonstrate a TOBF with a very small 3-dB bandwidth of approximately 7 pm, a tuning range of 16.4 nm, and a rejection ratio of more than 25 dB. Compared with previously reported tunable-fiber-based bandpass filters, this method provides the advantages of a large tuning range, continuous tunability, a switchable passband, a simple tuning mechanism, low cost, and narrow bandwidth.     

Wavelength-spacing-tunable multichannel filter incorporating a sampled chirped fiber Bragg grating based on a symmetrical chirp-tuning technique without center wavelength shift

We propose and experimentally demonstrate a simple and flexible scheme for a wavelength-spacing-tunable multichannel filter exploiting a sampled chirped fiber Bragg grating based on a symmetrical modification of the chirp ratio. Symmetrical bending along a sampled chirped fiber Bragg grating attached to a flexible cantilever beam induces a variation of the chirp ratio and a reflection chirp bandwidth of the grating without a center wavelength shift. Accordingly, the wavelength spacing of a sampled chirped fiber Bragg grating is continuously controlled by the reflection chirp bandwidth variation of the grating corresponding to the bending direction, which allows for realization of an effective wavelength-spacing-tunable multichannel filter. Based on the proposed technique, we achieve the continuous tunability of the wavelength spacing in a range from 1.51 to 6.11 nm, depending on the bending direction of the cantilever beam.     

基于光纤叠栅的全光纤声光可调谐滤波器的特性分析

本文提出了一种基于光纤叠栅的全光纤声光可调谐滤波器, 与普通光纤布拉格光栅型全光纤声光可调谐滤波器相比, 该滤波器能够对光纤叠栅的两个中心波长进行同步调制. 理论分析了声波频率和声致应变幅度对基于光纤叠栅的全光纤声光可调谐滤波器的传输光谱的影响, 结果表明, 各阶次反射峰分别以两个主反射峰为中心呈对称关系, 且主反射峰与其所调制出的次反射峰之间的波长间隔与声波频率成正比, 而两个主反射峰所调制出的同阶次反射峰之间的波长间隔与声波频率无关; 声致应变幅度主要影响主反射峰及次反射峰的反射率的变化. 实验中, 分别测试声波频率为390 kHz和710 kHz的基于光纤叠栅的全光纤声光可调谐滤波器的传输光谱, 实验结果的变化趋势与仿真分析结果相一致.     

Multi-wavelength fiber ring laser based on a sampled chirped fiber Bragg grating with a hybrid gain medium

The novel multi-wavelength fiber ring laser based on a sampled chirped fiber Bragg grating with a single SOA or a hybrid gain medium is demonstrated, respectively. In case of a hybrid gain medium, the SMSR improvement of ~ 5 dB was obtained when compared with the system with a single SOA. The proposed fiber laser offers advantages such as simple structure, low loss, multi-wavelength lasing lines with moderate output power.     

大模场啁啾光纤光栅的光谱特性

将一种矩阵算法拓展应用于数值求解多模耦合模微分方程, 并使用该矩阵算法对大模场啁啾光纤光栅的光谱特性进行了理论研究。结果表明, 大模场多模光纤光栅因模式的自耦合和互耦合而使反射谱存在多个反射峰, 这与单模光纤光栅的反射谱不同。由于光栅周期存在啁啾, 大模场光纤光栅的反射峰分裂, 且峰值反射率减小。使用高斯切趾函数可使反射峰分裂在一定程度上得到改善。     

大模场啁啾光纤光栅的光谱特性

 将一种矩阵算法拓展应用于数值求解多模耦合模微分方程, 并使用该矩阵算法对大模场啁啾光纤光栅的光谱特性进行了理论研究。结果表明, 大模场多模光纤光栅因模式的自耦合和互耦合而使反射谱存在多个反射峰, 这与单模光纤光栅的反射谱不同。由于光栅周期存在啁啾, 大模场光纤光栅的反射峰分裂, 且峰值反射率减小。使用高斯切趾函数可使反射峰分裂在一定程度上得到改善。     

Tunable wavelength division multiplexing channel isolation filter based on dual chirped long-period fiber gratings

We propose and demonstrate a wavelength tunable wavelength division multiplexing channel isolation filter based on two concatenated chirped long-period fiber gratings (LPGs). An intergrating space (IGS), deliberately introduced between the two gratings, provides an extra phase difference between the core and cladding modes. Changing this phase by heating the IGS without affecting the gratings tunes the channels. A theoretical account of the filter action is also presented and the results are found to be in excellent agreement with the experiments. Unlike the filters based on normal concatenated chirped LPGs without an IGS, the current filter shows a linear tuning over an increased spectral range.     

Optimization of reflection spectra for phase-only sampled fiber Bragg gratings

In this paper, the reflection spectra of a phase-only sampled fiber Bragg grating is obtained by optimizing its phase profile. The standard simulated annealing method is improved for optimization, and superior phase profiles which contain as few segments as possible per sampling period are obtained for 8, 16 and 32 identical channels. As very well known, increased number of WDM channels results in higher grating length and refractive index modulation amplitude. It is observed that application of these phase profiles limits the increases in both of these parameters considerably.     

Arbitrary chirped fiber Bragg gratings on application of filtering for optical communications

This paper presents an analysis of how to obtain narrow transmission band in the centre of the spectrum of the arbitrary chirped fiber Bragg grating (ACFBG). Grating chirp coefficient and refractive index profile are the critical parameters in contributing to performance of fiber Bragg grating. The reflection spectra and transmission band were analyzed with different refractive index profile. Apodization techniques are used to get optimized reflection spectra. The simulations are based on solving coupled mode equations by transfer matrix method that describes the interaction of guided modes.