流动注射催化动力学光度法测定碘的研究

本文采用流动注射技术,利用微量碘离子催化铁的硫氰酸配合物与亚硝酸钠的褪色反应,实现水中微量碘离子的催化动力学光度测定。该法测定碘离子的线性范围是1．0～7．0μg／mL,检出限为0．5μg／mL,相对标准偏差为5．0％。方法用于实际水样中微量碘离子的测定,结果令人满意。     

放大化学反应法测定食盐中的微量碘

依据碘离子的还原性和单质碘的氧化性原理,建立一种食盐中微量碘的放大化学反应测定方法。食盐中微量碘经饱和氯水定量氧化后[1],在间接碘量法测定条件下,方法的灵敏度倍增至36倍,滴定的线性范围为0-4μg/mL,回归方程为:A3.5104c+0.0311,R2=0.9992,方法的回收率为100.3%~102.6%,相对标准偏差(RSD)为1.48%,测得食盐中含碘量为19.4μg/g。     

阻抑动力学分光光度法测定痕量碘

研究了在稀H3PO4介质中,痕量碘离子对NO-2催化溴酸钾氧化吖啶橙的阻抑作用,建立了测定痕量碘离子的阻抑动力学光度分析的新方法。测定碘离子的线性范围为0～0.40μg/mL,检出限为7.3×10-9g/mL。已用于食品中的微量碘的测定。     

阻抑动力学分光光度法测定食品中痕量碘

研究了在稀硫酸介质中,痕量碘离子对亚硝酸根催化溴酸钾氧化甲酚红的阻抑作用,建立了测定痕量碘离子的阻抑动力学光度分析的新方法。测定碘离子的线性范围为0～0.62μg/mL,检出限为7.43×10-9 g/mL。已用于食品中痕量碘的测定,结果满意。     

流动注射-氢化物发生-原子吸收光谱法测定雪中的微量铅

建立了测定雪中微量铅的流动注射-氢化物发生-原子吸收光谱法。在优化条件下。测定铅的线性范围为0～52．0ng／mL，线性回归方程为A=0．018c 0．016，相关系数r=0．9995，检出限为0．2ng／mL。用于雪中微量铅的测定，加标回收率为94．2％～107．3％，相对标准偏差为1．47％～3．22％。该方法的测定结果与标准加入法基本一致。     

催化动力学光度法测定微量碘的研究

基于微量碘离子对高碘酸钠氧化甲基紫反应的催化作用，建立了测定微量碘的动力学光度法。方法检出限０．２２μｇ／ｍＬ，线性范围０．３０～１．４０μｇｍＬ，包括其它卤素在内的大多数阴离子、阳离子不干扰测定，用于食盐中微量碘的测定，有满意的结果。     

阻抑动力学分光光度法测定微量碘

基于在稀磷酸介质中,痕量碘离子对亚硝酸根催化溴酸钾氧化甲基红的的阻抑作用,提出了测定痕量碘离子的阻抑动力学分光光度分析的方法.测定碘离子的线性范围在0.66 mg·L-1以内,检出限(3Sb/K)为7.5×10-6g·L-1.用于海带及食盐中微量碘的测定,测定结果的相对标准偏差(n=6)在1.4%～2.2%之间,测得方法的回收率为99.7%～100.1%.     

靛蓝胭脂红-溴酸钾体系催化光度法测定微量碘

研究了在室温及0．4mol/L H2SO4介质中碘离子对KBrO3氧化靛蓝胭脂红褪色反应的催化作用,建立了一种测定微量碘的新方法。碘离子浓度在0．20－2．0μg/mL范围内与△A呈线性关系,检测限为0．14μg/mL。多数常见离子无干扰。可用于海带中微量碘的测定。     

火焰原子吸收法测定苹果汁中的钠

用浓硝酸及高氯酸消化苹果汁样品，以氯化钾作为电离缓冲剂，建立了测定苹果汁中钠的火焰原子吸收法。方法的线性范围为0～0．6μg／mL，线性回归方程为A=1．0182c 0．0462，相关系数r=0．9971，检出限为0.9μg／L。测定浓缩苹果汁、苹果原汁中钠的相对标准偏差分别为0．6％、1．3％，加标回收率分别为99.0％～lOl.3％、98．0％～103．2％。     

方波伏安法间接测定饲料中的高含量磷

在pH=5．5的六次甲基四胺-盐酸缓冲溶液中,硝酸铅与磷酸根和氯离子反应,生成磷酸氯化铅复盐沉淀,用方波伏安法测定过量的铅离子,从而间接测定无机磷。在最佳测定条件下,当0．04mol／L硝酸铅标准溶液的用量为1．0mL时,峰电流ip与磷的质量浓度c在0．2～20μg／mL内呈良好线性关系,线性回归方程为ip=-2．39c 54．82,相关系数为0．9876,检出限为0．085μg／mL。用于饲料中磷含量的测定,测定结果的相对标准偏差为1．24％～2．44％,加标回收率为95％～99％。     

二氧化碳和丙烯直接合成甲基丙烯酸的NiPMo/TiO2催化剂的研究

用溶胶-凝胶法以磷钼酸(MPA)的镍盐溶液水解钛酸四丁酯制备了NiPMo/TiO2催化剂.使用ICP、 XRD、 TG-DTA、 IR、 TPD-MS和微反应技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化反应性能.杂多钼酸盐与TiO2通过O2-在TiO2表面发生了键合.在623 K下,杂多阴离子仍保持原有的Keggin结构.CO2在Lewis酸位Ni(Ⅱ)和Lewis碱位Ni-O-Mo的桥氧协同作用下生成CO2卧式吸附态Ni(Ⅱ)←O-(CO)←(O--Ni).丙烯有多种吸附态在催化剂上吸附.在563 K、 1 MPa和空速1500 h-1的反应条件下,丙烯的摩尔转化率为3.2%,产物MAA选择性为95%.     

Synthesis of 1-benzyloxypyrazin-2(1H)-one derivatives

Different approaches for the synthesis of 1-benzyloxypyrazin-2(1H)-one derivatives from simple amino acids have been investigated. A library of 33 precursors for the preparation of N-hydroxy pyrazinones was obtained in moderate to good yields.     

Toward new camptothecins. Part 6: Synthesis of crucial ketones and their use in Friedländer reaction

In the context of the preparation of camptothecin and luotonin A analogs, the synthesis of some key keto-precursors and their use in Friedländer condensation are described. This paper also focuses on the stability of these keto intermediates and emphasizes the major differences between indolizinones and pyrroloquinazolinones series. Noteworthy is also the report of some original structures isolated as by-products of some experiments.     

CoFe2O4自形成磁性液体场致结构化对磁化的影响

The Langevin paramagnetic theory can’t describe the relation between magnetization of ferrofluids and applied magnetic field. The structuralization of ferrofluids, which is considered the main influence factor of the magnetization, is regarded. The part of magnetization works is deposited when the structure is forming. This action influences the magnetization of ferrofluids directly or indirectly. On the base of the “compressing” model, the Langevin function that usually describes the magnetization of ferrofluid is modified, and a well-fitted curve is obtained. An equation of the relation between the equivalent volume fraction after being “compressed” and the intensity of magnetic field is discovered, which approximately describes the process of magnetization. The relation between the approximate initial susceptibility and the volume fraction can be obtained from modified formula.     

Highly regioselective Buchwald–Hartwig amination at C-2 of 2,4-dichloropyridine enabling a novel approach to 2,4-bisanilinopyridine (BAPyd) libraries

The highly regioselective Buchwald–Hartwig amination at C-2 of the cheap and readily accessible reagent, 2,4-dichloropyridine with a range of anilines and heterocyclic amines is described. This new methodology is robust and provides a facile access to 4-chloro-N-phenylpyridin-2-amines on 0.25 mol scale. These intermediates undergo a further Buchwald–Hartwig amination at higher temperature to enable rapid exploration of the chemical space at C-4 and to provide a library of 2,4-bisaminopyridines.     

KMnO4-mediated oxidative CN bond cleavage of tertiary amines: Synthesis of amides and sulfonamides

KMnO₄-mediated oxidative CN bond cleavage of tertiary amines producing secondary amine was introduced, which was trapped by electrophiles (acyl chloride and sulfonyl chloride) to form amides and sulfonamides. The reaction could take place at mild condition, tolerating a wide range of function groups and affording products in moderate to excellent yields.     

Chemistry of heterocyclic compounds at the A. E. Favorsky Irkutsk Institute of Chemistry, Siberian Branch of the Russian Academy of Sciences, over 50 years (Review)

The review contains a concise historical account and information on the most significant researches undertaken by the staff at the A. E. Favorsky Irkutsk Institute of Chemistry, Siberian Branch of the Russian Academy of Sciences on the Chemistry of Heterocyclic Compounds. Dedicated to Academician of the Russian Academy of Sciences B. A. Trofimov on his 70th jubilee. Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 10, pp. 1443–1502, October, 2008.     

A general and convenient synthesis of 4-(tosylmethyl)semicarbazones and their use in amidoalkylation of hydrogen,heteroatom, and carbon nucleophiles

A general synthesis of previously unknown semicarbazone-based α-amidoalkylating reagents, 4-(tosylmethyl)semicarbazones, has been developed. The synthesis involved three-component condensation of semicarbazones of aliphatic or aromatic aldehydes with the same or other aldehydes and p-toluenesulfinic acid. The scope and limitations of this reaction were investigated. The compounds obtained were demonstrated to be an efficient α-(4-semicarbazono)alkylating agents. They were reacted with H- (sodium borohydride), O- (sodium methylate), S- (sodium phenylthiolate), N- (pyrrolidine, sodium succinimide), P- (trialkyl phosphites), and C-nucleophiles (sodium diethyl malonate) to give the corresponding products of the tosyl group substitution, 4-substituted semicarbazones, including analogues of nitrofurazone. Among the prepared compounds tested in vitro for antibacterial and antifungal activity, three nitrofuryl-containing semicarbazones exhibited high biological activities with minimum inhibitory concentration (MIC) values of 8–32 μg/mL.     

Sulfur-directed metal-free and regiospecific methyl C(sp3)–H imidation of thioanisoles

Regiospecific and direct imidation of the methyl C(sp³)–H bond of thioanisoles is realized under mild and metal-free conditions with N-fluorobis(benzenesulfonyl)imide as an oxidant and nitrogen source. Proposed mechanism suggests that thionium ion intermediates and a Pummerer-type reaction are involved. The imidation has advantages such as high step-economy, excellent functionality tolerance, and regiospecificity, giving structurally diverse imidation products.     

Synthesis of novel chiral bidentate hydroxyalkyl-N-heterocyclic carbene ligands and their application in palladium-catalyzed Mizoroki–Heck couplings and asymmetric addition of diethylzinc to benzaldehyde

A small library of new chiral bidentate hydroxyalkyl-imidazolium salts 1 is conveniently synthesized on multi-gram scale from inexpensive and commercially available chiral pool amino acids. The corresponding carbenes, generated by deprotonation of imidazolium salts 1, in combination with palladium(II) chloride were tested in the Mizoroki–Heck coupling reaction. The most significant results in terms of yields and reactivities were achieved with low catalyst loading. The catalytic activities of these imidazolium salts were also investigated in the asymmetric addition of diethylzinc to benzaldehyde. The use of MgO nanoparticles as an additive in conjunction with these ligands played a crucial role in increasing the efficiency of these reactions.