N,O-羧甲基化羟丙基壳聚糖的制备及结构表征

用NaOH作为催化剂, 在异丙醇悬浮体系中环氧丙烷(PO)与壳聚糖(CS)在60 ℃下反应8 h, 制备取代度超过0.8的羟丙基壳聚糖(HPCS). HPCS在水溶液中与氯乙酸反应, 制备了一种结构新颖的两性聚合物N,O-羧甲基化羟丙基壳聚糖(HPCMS), 羧甲基取代度可控制在0.42～1.38之间. 采用NMR和FTIR对产物结构进行表征. 结果表明, 在壳聚糖的羟丙基化改性过程中, C6位羟基首先与环氧丙烷反应, 生成HPCS; 在与氯乙酸反应过程中, HPCS上的羟基和氨基同时与氯乙酸发生取代反应.     

羟丙基三甲基氯化铵壳聚糖的制备及其吸湿、保湿性能

抑菌活性;羟丙基三甲基氯化铵壳聚糖的制备及其吸湿、保湿性能     

羟丙基壳聚糖纳米微球的制备及其缓释效果

壳聚糖;羟丙基;纳米微球;牛血清蛋白;缓释     

羟丙基三甲基氯化铵壳聚糖制备的可控性研究

用壳聚糖与缩水甘油三甲基氯化铵反应制备羟丙基三甲基氯化铵壳聚糖,所得产物的结构受壳聚糖分子量和脱乙酰度、反应温度、反应时间、壳聚糖与缩水甘油三甲基氯化铵投料比的影响。实验结果表明：随着反应温度升高,羟丙基三甲基氯化铵壳聚糖的取代度增加,在70～80℃达最大;反应时间增加,取代度增加,产物分子量降低。缩水甘油三甲基氯化铵与壳聚糖比例达3：1前取代度随比例升高而增加。脱乙酰度和分子量越大的壳聚糖其季铵盐取代度越高。控制反应温度在30～90℃,反应时间3～10h,投抖比为1：1～4：1,可以得到取代度15％～909／6,分子量1万到100万的羟丙基三甲基氯化铵壳聚糖。     

氰乙基羟丙基壳聚糖的溶致和热致液晶性研究

从壳聚糖出发先羟丙基化再氰乙基化,合成了氰乙基羟丙基壳聚糖(羟丙基的摩尔取代度为3.2,氰乙基的取代度为1.0).氰乙基羟丙基壳聚糖(CNHPCS)和羟丙基壳聚糖(HPCS)两者都有胆甾型溶致液晶性,浓溶液呈现指纹状织构.在二氯乙酸中,前者的临界浓度(29%,质量分数,下同)高于后者(17%).这一结果可以用引入氰乙基增加了分子间作用力从而使得链刚性增加来解释.CNHPCS在熔点193℃和分解温度220℃之间很窄的温区内观察到有热致液晶胆甾相.CNHPCS固体膜的胆甾相螺距采用激光小角光散射法测定,结果与偏光显微镜测得的数值一致.     

元素分析法同时测定羟丙基壳聚糖的取代度和水分

建立了利用CHN元素分析法同时测定羟丙基壳聚糖(HPCS)的取代度和水分含量的新方法。方法可作为羟丙基壳聚糖取代度的标准方法,特别适合于吸水性较强的干燥法难以奏效的羟丙基壳聚糖的水分测定。其计算方法也可用于其他壳聚糖衍生物的测定研究。     

铜离子模板法合成了6—O—2‘—羟丙基壳聚糖

以铜离子为模板法了用环氧丙烷为改性剂，合成只在壳聚糖Ｃ５位－ＯＨ上取代的２’－羟丙基化衍生物，并用元素分析，ＩＲ和Ｘ－衍对改性立物进行了结构表征。     

铜离子模板法合成 6-O-2′-羟丙基壳聚糖

以铜离子为 模板，用环氧丙烷为 改性剂，合成只在 壳聚糖 Ｃ６ 位－ Ｏ Ｈ 上取代的 ２′羟丙基化衍生物，并用元素分析、 Ｉ Ｒ 和 Ｘ衍射对改性产物进行 了结构表征。     

交联化羟丙基壳聚糖对Cr(Ⅵ)的吸附与结构分析

研究了交联化羟丙基壳聚糖对Cr(Ⅵ)的吸附作用,探讨了溶液的pH值、反应时间、温度、初始浓度等因素对其吸附性能的影响,并且用FTIR、XRD和SEM对吸附前后物质进行了表征与结构分析。实验表明,pH是交联羟丙基壳聚糖吸附Cr(Ⅵ)的主要影响因素。在pH=5时,对Cr(Ⅵ)初始浓度为15mg/L的溶液,可控制温度在20℃左右吸附2h,吸附剂交联羟丙基壳聚糖用量为1g/100mL溶液即能达到满意的吸附效果。吸附后由于交联羟丙基壳聚糖与Cr(Ⅵ)的配位作用使得交联羟丙基壳聚糖的结晶性明显降低;Cr(Ⅵ)的配位使得交联羟丙基壳聚糖的表面形貌发生了改变。     

Preparation of O-(Silyl)benzyl Alcohols

Abstract: γ-Hydroxysilanes 4 can be easily prepared from bromosilyl ethers 3 by a reaction involving 1,4-migration of the silicon group from oxygen to carbon.     

Preparation of O-(polyfluoroalkyl) alkylchlorophosphonates and O-(polyfluoroalkyl) aryl chlorophosphates by catalytic phosphorylation of polyfluoroalkanols

Conclusions A new method was developed for the synthesis of O-(polyfluoroalkyl) alkylchlorophosphonates and 0-(polyfluoroalkyl) aryl chlorophosphates, which consists in phosphorylating polyfluoroalkanols with an excess of the dichlorides of the corresponding phosphorus acids in the presence of salts of the Group II metals.Translated from Izvestiya Akademii Nauk SSSR, Seriya Khimicheskaya, No. 3, pp. 656–658, March, 1979.     

燮理阴阳胶囊的制备与质量标准研究

为研制燮理阴阳胶囊生产工艺,并建立相应的质量标准,采用正交实验法进行了工艺研究,采用薄层色谱法进行了鉴定,确立了水煎提取的工艺条件,建立了知母、熟地黄、淫羊藿的鉴别方法。该制剂的制备工艺简单易行,质量检定方法可行,质量稳定。     

Polyethyleneoxide-b-poly(isopropyl methacrylate) diblock copolymers as novel material for ultrafiltration membranes

Amphiphilic polyethyleneoxide-b-poly(isopropyl methacrylate) (PEO-b-PiPMA) diblock copolymers (BCP) with different molar masses are synthesized via atom transfer radical polymerization (ATRP). For that functionalized PEO monomethyl ether with two different molar masses, 10 and 20 kDa, are used as macroinitiator to obtain BCP in a molar mass range relevant for membrane fabrication. The BCP are used in the nonsolvent induced phase separation (NIPS) with the aim to obtain isoporous ultrafiltration membranes due to combination with its self-assembling properties (SNIPS). In various experiments, a strong effect of PEO homopolymer (hPEO) on the membrane formation process can be proven in which fractions of BCP with low molar mass might also play a role. These impurities are left in the BCP after ATRP due to incomplete purification. Under specific conditions, they induce formation of void-like superstructures on the membrane surface and in the cross section by a templating mechanism. Probably, large compound micelles play a key role in this scenario hindering the favored SNIPS process. The superstructure formation can be avoided by extensive purification of the BCP via dialysis or extraction. From the purified polymers, self-supported ultrafiltration membranes with an integrated hydrophilic component are successfully fabricated. Although they do not lead to isoporous surfaces after semiempirical determination of suitable solvent systems for the SNIPS process, there are convincing indications that the trade-off relation between selectivity and permeability can be overcome. © 2020 The Authors. Journal of Polymer Science published by Wiley Periodicals, Inc. , 2020 , 58, 2561–2574     

Preparation of magnetic chitosan microspheres and its applications in wastewater treatment

The methods of preparation of magnetic chitosan microspheres have been introduced. In addition, their applications in the wastewater treatment, based on different kinds of wastewater, have been reviewed, and their mechanisms have been discussed. Supported by the Key Natural Science Foundation of China (Grant No. 50633030)     

有机膦酸铜化合物的合成、结构及性质

由于在分子识别、传感器、催化等方面的潜在应用前景，近年来金属有机膦酸化学研究引起了人们广泛的关注。本文介绍有机膦酸铜化合物的结构、合成及性质研究方面所取得的一些进展。     

O-（4-双胍基苯甲酰基）壳聚糖盐酸盐的制备及其抗菌活性

通过壳聚糖与含双胍基结构的芳酰氯反应,得到具有抗菌活性的双胍基化壳聚糖衍生物。利用对双胍基苯甲酸盐酸盐与氯化亚砜的反应,得到盐酸对双胍基苯甲酰氯后,再在甲烷磺酸-二甲基亚砜（MeSO3H-DMSO）介质中与壳聚糖进行缩合反应,得到了O-（4-双胍基苯甲酰基）壳聚糖盐酸盐（p-BGBC）。用FT-IR、1H-NMR、GP...     

Preparation of electrospun chitosan/poly(vinyl alcohol) membranes

Electrospinning of chitosan from its solutions in 2% aqueous acetic acid was studied by adding poly(vinyl alcohol) (PVA) as a “guest” polymer. Properties of the chitosan/PVA solutions including viscosity, conductivity, and surface tension were measured, and effects of the polymer concentration, chitosan/PVA mass ratio and processing parameters (applied voltage, flow rate, capillary-to-collector distance) on the electrospinnability of chitosan/PVA were investigated. Analyses of scanning electron micrographs and transmission electron micrographs suggested that the chitosan/PVA ultrafine fibers were often obtained along with beads, and chitosan was located in the elctrospun fibers as well as in the beads. Uniform chitosan/PVA fibers with an average diameter of 99 ± 21 nm could be prepared from a 7% chitosan/PVA solution in 40:60 mass ratio. Results of Fourier transform infrared spectroscopy and X-ray diffraction demonstrated that there were possible hydrogen bonds between chitosan and PVA molecules, which could weaken the strong interaction in chitosan itself and facilitate chitosan/PVA electrospinnability. The electrospun chitosan/PVA membranes showed higher water uptake and would have potential applications in wound dressings.     

全氟辛酸甲基丙烯酰氧基乙酯单体的制备

全氟辛酸甲基丙烯酰氧基乙酯单体的制备;全氟辛酸;正交实验;酰氯化;酯化