基于内腔布儒斯特双轴锥棱镜的掺镱光纤激光器的径向偏振模振荡

实验采用一个内腔布儒斯特双轴锥棱镜,在掺镱多模双包层光纤激光器中实现了径向偏振光振荡,并在长2 m的增益光纤中获得了高达6.2 mW的功率输出.研究揭示了从光纤激光器振荡中获得径向偏振光的新途径.然而,该激光器输出的径向偏振光的光强分布并不很均匀,且偏振消光比较低,需要进一步改进.     

Generation of radially polarized light beams of high quality using a step-index optical fiber

We present an experimental setup to generate radially polarized beams without using high-cost optical elements. In the setup a four-segment polarization converter is used in front of the fiber to produce a pseudo radially polarized beam. A traditional step-index fiber which supports only LP₀₁ and LP₁₁ modes is then used as a mode-cleaning device. A commercial mechanical fiber-squeezer polarization controller is applied to produce adequate pressure and twist onto the fiber. The four-segment polarization converter and the fiber squeezer polarization controller are adjusted by turns for improving the beam quality in intensity and polarization. Additionally, several methods of characterizing the polarization properties of radially polarized beams are reviewed. One of the latest methods is applied for characterizing the polarization properties of the radially polarized beams produced by using our technique. The results show the highquality of the obtained beams.     

Converging-axicon-based radially polarized ytterbium fiber laser and evidence on the mode profile inside the gain fiber

The radially polarized mode is achieved from an active Yb fiber by utilizing of an intracavity converging axicon, where the axicon acts as a TM(01) mode selector based on not only its Brewster convex surface but also the distance between its vertex and plane output coupler. The polarization state of the annular laser beam is checked by using a home-made eight-hole aperture. Furthermore, an uncoated plane glass plate is inserted into the cavity, and the reflected beam points to the existence of an annular lasing mode inside the gain fiber. The issues for developing high-power radially polarized fiber lasers also are considered.     

Experimental Research on Focusing Property of Radially Polarized Beam Based on Solid Immersion Lens

Realization of a near-field optical virtual probe based on an evanescent Bessel beam is strongly dependent on a radially polarized beam; this makes it essential to study the focusing property of the beam. In this paper, two experimental setups based on a fiber device and a liquid crystal device, respectively, are built to generate a radially polarized beam. This beam and an annular radially polarized beam are focused by means of a high numerical aperture objective and a solid immersion lens (SIL). Near-field distribution of the focus spot, the evanescent Bessel field, is experimentally measured with a scanning near-field optical microscope (SNOM). The full width at half maximum (FWHM) of the central peak of the evanescent Bessel field is about 200 nm in the close vicinity of the bottom surface of SIL. This has potential for use as a near-field optical virtual probe.     

Simple Nd:YAG laser generates vector and vortex beam

We report a simple Nd:YAG laser that emits radially polarized beam with helical wavefront. The laser cavity consists of a piece of laser crystal and a plane output coupler, and there is no additional polarization component inside it. The pump light is converted into annular profile through de-focal coupling into a multi-mode fiber. For the continuous-wave(CW) operation, the laser emits radially polarized vortex beam, and it is observed that the helical wavefront of the laser beam is switched from right handedness to left handedness when the output coupler is tilted slightly. For the Q-switched operation under the insertion of a Cr4t:YAG saturable absorber inside the cavity, we obtain radially polarized outputs with left-handedness helical wavefront. By tilting the laser crystal slightly, the laser output switches to azimuthal polarization at pump power larger than 4.5 W and left-handedness helical wavefront of laser beam is preserved.     

The propagation of radially polarized partially coherent beam through an optical system in turbulent atmosphere

The propagation of a radially polarized partially coherent beam through an optical system in turbulent atmosphere is investigated. Analytical propagation formulae for the radially polarized partially coherent beam through an optical system in turbulent atmosphere are derived, and some analyses are illustrated by numerical examples related to propagation properties of the radially polarized partially coherent beam through a double-lens system in turbulent atmosphere. It is shown that the optical system, structure constant of turbulent atmosphere and the initial coherent length have significant influence on intensity, degree of polarization and degree of coherence for radially polarized partially coherent beam.     

Improving the sensitivity of fiber-optic SPR sensor via radially polarized beam excitation

We study the sensing properties of an intensity-modulated fiber-optic surface plasmon resonance （SPR） sensor using radially polarized beam （RPB）. Because of the rotational symmetry of fiber and RPB, surface plasmon can be excited more efficiently at the sensor surface, which results in an obvious improvement of the sensitivity. Our experiments demonstrate that the sensitivity in the case of RPB illumination is three times higher than that of linearlv polarized beam illumination.     

Generation of a radially polarized laser beam by use of the birefringence of a c-cut Nd:YVO4 crystal

We demonstrated the generation of a radially polarized laser beam from an extremely simple laser resonator including a c-cut Nd:YVO4 crystal as a laser medium. The oscillation in the radial polarization was based on the optical path difference between an extraordinary ray and an ordinary ray induced by the birefringence of the crystal. By simply adjusting the distance between two cavity mirrors, only the extraordinary ray became stable for the oscillation, resulting in the generation of a radially polarized beam. The beam was very stable even at low power output and is expected to be a promising radially polarized laser source because of its excellent simplicity.     

Generation of azimuthally and radially polarized beams by coherent polarization beam combination

A new architecture for generating pure azimuthally and radially polarized beams is presented. It involves coherent polarization beam combination of two orthogonally polarized LP(11) fiber modes. Experimental results reveal that high purely polarized (polarization purity of 95% or better) azimuthal and radial beams can be generated.     

Efficient conversion of a radially polarized beam to a nearly Gaussian beam

We demonstrate an efficient method for transformation of a radially polarized Laguerre-Gaussian beam to a nearly Gaussian beam with much higher beam quality. The method is based on separation of the radially polarized mode into two degenerate modes and coherent addition of the modes after phase flattening. We transformed a high-power Nd:YAG radially polarized (0,1)(*) Laguerre-Gaussian beam with M(2)=2.52 and power of 30 W into a nearly Gaussian beam with M(2)=1.3. As a result, the brightness increased by a factor of approximately 2.5.     

Production of radially or azimuthally polarized beams in solid-state lasers and the elimination of thermally induced birefringence effects

Production and amplification of radially and azimuthally (tangentially) polarized laser beams are demonstrated. Based on the different focusing between radially and tangentially polarized light in thermally stressed isotropic laser rods, Nd:YAG laser oscillators were developed to produce low-loss stable oscillation in a single polarization. Pure radially polarized light at 70 W with M2 = 2 and on-axis impure radially polarized light at 150 W with M2 = 2.5 were achieved. The radially polarized beams were then amplified while good beam quality and polarization purity were retained. Complete elimination of thermal-birefringence-induced aberrations was demonstrated. This should allow much better beam quality from rod-based high-power lasers.     

Manipulation of the overall polarization orientation in the focal volume of high numerical objectives

We propose an approach for tuning the three-dimensional polarization of a focusing subwavelength spot by a high numerical aperture objective. The incident beams are composed of a radially polarized beam, an azimuthally polarized beam, and a linearly polarized beam with three different weighting factors, respectively. A specially designed adjustable amplitude angular selector is also inserted at the back aperture of the objective for tuning the polarization azimuthally. It is shown that any desired overall polarization orientation can be obtained. We calculated the overall polarization orientation in the focal volume. It is found that the polar angle of the overall polarization orientation can be arbitrarily tuned by the combination of a radially polarized beam and a linearly polarized beam with different weighting factors, and the azimuthal angle can be tuned by rotating the orientation of the linearly polarized beam azimuthally.     

Achievement of longitudinally polarized focusing with long focal depth by amplitude modulation

The longitudinal component of a focused beam is split into two parts along the optical axis to obtain a longitudinally polarized long focal depth using amplitude filtering based on Euler transformation and a radially polarized Bessel-Gaussian beam. Numerical results indicate that long focal depth and FWHM can be easily achieved with 9λ and 0.8λ, respectively. A radially polarized beam can be converted into a longitudinally polarized beam with a conversion efficiency of 51.0%. It can therefore be believed that the proposed scheme can be widely used to generate a longitudinally polarized beam for particle acceleration, laser cutting, and optical trapping.     

Three-dimensional multiple optical cages formed by focusing double-ring shaped radially and azimuthally polarized beams

We propose and simulate a method for generating a three-dimensional(3D) optical cage in the vicinity of focus by focusing a double-ring shaped radially and azimuthally polarized beam. Our study shows that the combination of an inner ring with an azimuthally polarized field and an outer ring with a radially polarized field and a phase factor can produce an optical cage with a dark region enclosed by higher intensity. The shape of the cage can be tailored by appropriately adjusting the parameters of double-mode beams. Furthermore, multiple 3D optical cages can be realized by applying the shift theorem of the Fourier transform and macro-pixel sampling algorithm to a double-ring shaped radially and azimuthally polarized beam.     

非均匀关联径向偏振部分相干光的产生

从理论和实验两方面对非均匀关联径向偏振部分相干光的产生进行了研究.理论上,基于相位关联与相干度的联系,推导出了非均匀关联径向偏振部分相干光的2×2阶交叉谱密度矩阵及相干度分布.实验上,利用一个相位型液晶空间光调制器的不同区域,对入射的完全相干的径向偏振光的两个正交偏振分量分别加载随机相位调制,并实验测量了这种光束的相干度分布及其对光强分布的影响.实验结果验证了光束相干度的非均匀关联结构,并且通过改变随机相位的高斯调制半宽可以改变光束的相干性分布.研究表明,随着随机相位的高斯调制半宽的增加,光束中两点间的相干度逐渐减小,其光强分布由圆环状逐渐变化为类平顶的光强分布.这种非均匀关联的径向偏振部分相干光在激光微操纵和材料加工等领域具有一定的潜在应用价值.     

Efficient extracavity generation of radially and azimuthally polarized beams

We demonstrate an efficient transformation of a linearly polarized Gaussian beam to a radially or an azimuthally polarized doughnut (0,1)* Laguerre-Gaussian beam of high purity. We use a spatially variable retardation plate, composed of eight sectors of a lambda/2 retardation plate, to transform a linear polarization distribution to radial/azimuthal distribution. We transformed an Nd:YAG Gaussian beam with M(2)=1.3 to a radially and azimuthally polarized (0,1)* Laguerre-Gaussian beams with M(2)=2.5 and degree of radial/azimuthal polarization of 96-98%.     

Propagation of radially polarized beams in the oceanic turbulence

Based on the extended Huygens–Fresnel principle and the unified theory of coherence and polarization of light, we investigate the propagation properties of a radially polarized beam through turbulent ocean. Analytic formulae for the spectral density, the spectral degree of polarization, and the beam characteristics of such a beam on propagation are discussed. It is shown that under the influence of oceanic turbulence, the radially polarized beam will change to a partially polarized one and the beam profile will approach to a Gaussian distribution.     

Optical trapping of gold nanoparticles by cylindrical vector beam

Optical trapping of gold nanoparticles is experimentally demonstrated using radially and azimuthally polarized beams. The transverse optical trapping stiffness of gold nanoparticles is measured. The radially polarized beam exhibits a higher trapping efficiency than the azimuthally polarized beam and the Gaussian beam. The transverse stiffness of particles with different diameters is measured experimentally and calculated via the discrete-dipole approximation method, and good agreement between theory and experiment is found.     

Focusing of radially polarized beam with radial cosine phase wavefront

Radially polarized beam has gained much interest recently due to its properties and applications. In this article, the focusing properties of radially polarized beam with radial cosine phase wavefront are investigated theoretically. Results show that when the radially polarized beam with radial cosine wavefront phase is focused, the focal pattern differs considerably with frequency parameter in the cosine function term. In the high numerical aperture focusing system, focal shift occurs, and novel focal patterns evolve considerably, for instance, from only one peak to two or multiple overlapping peaks. In addition, peak intensity ratio of radially polarized component to longitudinal polarized component in the focal region fluctuates smoothly for low-frequency parameter, then drops sharply, and comes back remarkably with increasing frequency parameter. Simultaneously focal shift increases slowly, and then decreases, suddenly, focal shift sign changes that results from focal switch phenomenon, and then fluctuates.     

Propagating a partially coherent radially polarized beam through aligned and misaligned ABCD optical systems

In the present work the propagation of a partially coherent radially polarized beam through aligned and misaligned ABCD optical systems is discussed. The elements of the beam coherence-polarization matrix for a partially coherent radially polarized beam propagating through these systems are derived for the first time. Using the derived analytical results the intensity distribution of the focused partially coherent radially polarized beam after a low-NA lens is investigated. It is shown that the coherence of the light source affects the beam intensity profile at the focal plane significantly, while for the given coherence of the light source the focal length of the used lens does not affect the beam intensity profile at the focal plane. This is consistent with the case of a partially coherent Hermite-Gaussian beam, as expected.