Microelectrodes for the measurement of cellular metabolism

The study of metabolism of cellular cultures is of great interest. Although some papers reports the monitoring of parameters such as pH, potassium, dissolved oxygen and temperature in cellular cultures using different kind of sensors, no definitive solution has been found to get reproducible and feasible results. The advantage of using sensors fabricated with microelectronic technology is focused on their small size, rapid response and the possibility of having an integrated array of microelectrodes, which favors the measurement of small volumes and fast cell metabolism changes. In this work, the viability of using a multisensor platform of microelectrodes, such as potassium and pH ISFETs, amperometric microelectrodes for dissolved O₂ and pseudo-reference microelectrodes for the study of metabolism of cellular cultures is described. Preliminary results of pH ISFETS’ response in neuronal cultures is reported.     

Tritium measurement in the Western Caucasus

Measurement of tritium in water of rains, springs, wells, mud volcanoes and rivers, lakes of the Western Caucasus (Krasnodar region) has been carried out since 1997 for hydrogeology, engineering geology, ecology and seismology. Electrolytic cells with spiral electrodes and the big multiwire proportional chamber were used for low tritium concentration measurements on expeditions. With the new design of the cell the enrichment factor of 64.0 ± 1.5 % was obtained during the electrolytic process. Correlation of tritium concentration is observed in mud volcanoes and spring water with regional seismicity. The long-term tritium data are shown in natural waters in South Russia.     

Direct measurement of the thermodynamics of vinylarene hydroamination

The thermodynamics for intermolecular hydroamination of vinylarenes with arylamines have been measured directly by conducting the addition processes, as well as cleavage of the addition products, under conditions in which amine, vinylarene, and phenethylamine are all present. The reaction of N-methylaniline with styrene is exothermic by about 10 kcal/mol but nearly thermoneutral in free energy. The free energies for additions of various primary arylamines to styrene and for additions of primary arylamines to indene, dihydronaphthalene, and two vinylarenes range from 1.3 to -3.5 kcal/mol (K = 0.16-155 M-1). The steric properties of the nucleophile significantly influenced the equilibrium constant for addition, but the electronic properties of the nucleophile had a minor effect on this equilibrium constant. These measurements have led to the first successful intermolecular addition of aniline to indene and 1,2-dihydronaphthalene and shed light on factors requiring consideration when choosing substrates and reaction conditions for this transformation.     

Precision measurement of the half-life of38Cl

The half-life of³⁸Cl obtained by thermal neutron capture was measured to be 37.236±0.009 min. Values of the energy levels of³⁸Ar from ^– decay of³⁸Cl were determined with a better precision than those available in the literature.     

On the existence of primary methods of measurement

 There is much discussion in chemical metrology about the definition of primary methods of measurement, just as a couple of years ago there was debate about its predecessors, absolute methods and definitive methods. It is argued in this paper that the designation of certain methods as being primary only makes sense if there is an outstanding property identified that is common to all primary methods, and not present for all non-primary methods. The aim to identify primary methods should not blur our notion that it is the good practice of analytical chemistry that produces good results, not a particular method of analysis.     

Frequency-domain measurement of the photodegradation process of fluorescein

The frequency-domain technique is applied to measure the photodegradation rate of fluorescein in aqueous solutions. The illuminating light is modulated, and the changes in fluorescence from the illuminated region are detected synchronously. A constant flow rate is imposed on the fluorescein solution to control the mass transport of fluorescein into the illuminated region. The fluorescence response is described by a model that assumes that photodegradation occurs from the triplet excited state. The predictions of the model are consistent with the observed variations in the fluorescence response with flow rate, modulation frequency and incident power. We discuss in this article how the dependence of the model parameters on experimental conditions can be used to infer the photodegradation rate as well as some of the details of the photodegradation mechanism. The results are consistent with the known mechanism of photodegradation of fluorescein. The frequency-domain technique gives a photodegradation rate of 53 s(-1) in an air-saturated solution and 37 s(-1) in solutions purged with argon gas.     

Primary methods for the measurement of electrolytic conductivity

This paper surveys the state of the art for primary methods for the evaluation of electrolytic conductivity in aqueous solutions as they are currently carried out in several national metrological institutes (NMIs). The theoretical and practical basic knowledge of this measurement is described. Analysis of and comments on the different approaches are offered to give emphasis to technical difficulties and possible solutions. Further development is foreseeable, ensuring a common effort for the sharing of expertise that has been undertaken at the NMIs. In particular, improvements are expected towards traceable measurements of solutions with conductivity values lower than those actually standardized, down to the level of ultrapure water.     

Lifetime of the traceability chain in chemical measurement

Since the uncertainty of each link in the traceability chain (measuring analytical instrument, reference material or other measurement standard) changes over the course of time, the chain lifetime is limited. The lifetime in chemical analysis is dependent on the calibration intervals of the measuring equipment and the shelf-life of the certified reference materials (CRMs) used for the calibration of the equipment. It is shown that the ordinary least squares technique, used for treatment of the calibration data, is correct only when uncertainties in the certified values of the measurement standards or CRMs are negligible. If these uncertainties increase (for example, close to the end of the calibration interval or shelf-life), they are able to influence significantly the calibration and measurement results. In such cases regression analysis of the calibration data should take into account that not only the response values are subjects to errors, but also the certified values. As an end-point criterion of the traceability chain destruction, the requirement that the uncertainty of a measurement standard should be a source of less then one-third of the uncertainty in the measurement result is applicable. An example from analytical practice based on the data of interlaboratory comparisons of ethanol determination in beer is discussed. Received: 5 October 2000 Accepted: 3 December 2000     

A new measurement of the 122Sb half-life

Journal of Radioanalytical and Nuclear Chemistry - Following significant discrepancies observed when decay-correcting 122Sb γ-peak count rates to a reference time, we looked at the literature...     

High resolution and the accurate measurement of intensities

Absolute intensities in several vibration rotation bands of CO₂ and in the pure rotation spectrum of CO have been measured. The results have been used to assess the precision and accuracy which such measurements can attain when made with a high resolution Fourier transform spectrometer.     

New approach to the measurement of polymer photooxidation

In an attempt to eradicate many of the problems associated with outdoor and accelerated testing of polymeric formulations, an apparatus was constructed for the sensitive measurement of oxygen uptake into a polymer during its incipient stages of photooxidation. The photooxidation curves of certain HDPE and LDPE formulations demonstrate a first order asymptotic approach to a limiting value which corresponds to the initial number of reactive centers that are available in the material for oxygen attack. An equation for oxygen uptake as a function of time is derived which incorporates the asymptotic value together with a constant whose value reflects the rate at which the asymptote is approached. These parameters are used to calculate the value of the initial quantum yield for oxygen uptake, a quantity which is indicative of the relative photostability of a given formulation. The kinetics parameters obtained from analyses of certain photooxidative curves confirm that the initial rate of photooxidation is proportional to the concentration of polymer hydroperoxide species which are present in the material as a result of oxidation during processing. The removal of these by thermal treatment of the material in an inert atmosphere results in the appearance of an induction period in the photooxidative profile. The experimental results suggest that this method of determining and interpreting photooxidative curves has certain potential for assessing the relative photostabilities of polymeric formulations.     

Recent developments in the measurement of interparticle forces

In the last twenty years there has been an explosion of experimental work devoted to determining the forces between colloidal particles. There have been considerable experimental and theoretical advances. In this review we shall concentrate on the experimental aspects. Currently there is no technique which directly measures the interaction between two individual particles as a function of their separation. Particle - particle forces can only be inferred. In this paper we review the experimental procedures which have been used to determine the nature and range of interparticle forces in this indirect way. The many different experimental techniques which have been developed are outlined and typical data presented. The relative merits and demerits of each technique is discussed and the way forward to measuring particle - particle interactions directly is proposed.