Stoichiometry and conformation of the azacrown moiety in sodium complexes of azacrown ethers. A Raman/IR spectroscopic study. Part I: Complexes of 4,13-Diaza-18-crown-6

Three sodium complexes (bromide, iodide and thiocyanate) of 4,13-diaza-18-crown-6 were studied using Raman and IR spectroscopy and normal coordinate calculations to probe the stoichiometry of the complexes and the variation in the conformation of azacrown moiety on complex formation. complex formation is accompanied by characteristic shifts of the bands, especially of those in the 800–900 cm^–1 region. Complexes of both 11 and 21 stoichiometry were observed. Normal coordinate calculations showed the reduction of symmetry of azacrown moiety toC _i , in contrast to theC _2h symmetry known for the parent azacrown and potassium thiocyanate complex.     

Stoichiometry and conformation of the azacrown moiety in sodium complexes of azacrown ethers. A Raman/IR spectroscopic study. Part II: Complexes of 4,13-diaza-15-crown-5

4,13-Diaza-15-crown-5 and three of its sodium complexes (bromide, iodide and thiocyanate) were studied using Raman and IR spectroscopy and normal coordinate calculations, following the corresponding study on the sodium complexes of 4,13-diaza-18-crown-6 in the preceding paper. Complex formation was again accompanied by a characteristic shift of the bands, especially of those in the 800–900 cm^–1 region. The complexes of 4-13-diaza-15-crown-5 were distinct from those of 4-13-diaza-18-crown-6, in that both of the bands at 830 and 890 cm^–1 of the parent azacrown were affected on complex formation and in that only the 11 complex was formed. Normal mode calculations were made to predict conformations of the azacrown ring of the parent 4,13-diaza-15-crown-5 and its sodium complexes. Attention was paid to the different extent of mismatch in size of a sodium ion and azacrown cavities.     

Chair, boat and twist conformation of dodecamethylcyclohexasilane and undecamethylcyclohexasilane: a combined DFT and Raman spectroscopic study.

The conformations of dodecamethylcyclohexasilane Si6Me12 and undecamethylcyclohexasilane Si6Me11H have been investigated by ab initio calculations employing the B3LYP density functional with a 6-31+G(d) basis set. Local minima as well as transition structures were calculated with imposed symmetry constraints. For Si6Me12, three unique minima, which correspond to the chair, twist and boat conformations were located with relative zero-point-vibration-corrected energies of 0.0, 7.8 and 11.4 kJ mol(-1). A half-chair conformation with four coplanar silicon atoms connects the chair and twisted minima via an energy barrier of 16.0 and 8.2 kJ mol(-1), respectively. A second transition structure with a barrier of 3.9/0.3 kJ mol(-1) connects the twist with the boat structure. Solution Raman spectra of Si6(CH3)12 and Si6(CD3)12 fully corroborate these results. Below -40 degrees C, the symmetric SiSi ring breathing vibration is a single line, which develops a shoulder (originating from the twist conformer) at longer wavelengths whose intensity increases with increasing temperature. From a Van't Hoff plot, the chair/twist enthalpy difference is 6.6+/-1.5 kJ mol(-1) for Si6(CH3)12 and 6.0+/-1.5 kJ mol(-1) for Si6(CD3)12, which is in reasonable agreement with the ab initio results. Due to the low barrier, the boat conformation cannot be observed, because either the lowest torsional vibration level lies above it or a rapid interconversion between the twist and boat conformations occurs, resulting in averaged Raman spectra. For Si6Me11H, six local minima were located. The chair with the hydrogen atom in the axial position (axial chair) is the global minimum, followed by the equatorial chair (+1.9 kJ mol(-1)) and the three twist conformers (+5.3, +8.0 and +8.1 kJ mol(-1)). The highest local minimum (+11.9 kJ mol(-1)) is a C(s) symmetric boat with the hydrogen atom in the equatorial position. Two possible pathways for the chair-to-chair interconversion with barriers of 13.9 and 14.5 kJ mol(-1) have been investigated. The solution Raman spectra in the SiSi ring breathing region clearly show that below -50 degrees C only the axial and equatorial chairs are present, with an experimental deltaH-value of 0.46 kJ mol(-1). With increasing temperature a shoulder develops which is attributed to the combined twist conformers. The experimental deltaH-value is 6.9 kJ mol(-1), in good agreement with the ab initio results. Due to the low interconversion barriers, the various twist conformers cannot be detected separately.     

Comparative study of Ag(I) selective poly(vinyl chloride) membrane sensors based on newly developed Schiff-base lariat ethers derived from 4,13-diaza-18-crown-6

The six Schiff-base lariat ether chelates based on 4,13-diaza-18-crown ether, have been synthesized and explored as a neutral ionophores for preparing poly(vinyl chloride) based membrane sensors selective to silver(I). The addition of potassium tetrakis(4-chlorophenyl) borate and various plasticizers, viz., o-NPOE, DBP, DBBP, DOP and CN has been found to substantially improve the performance of the sensors. The best performance was obtained with the sensor no. 5 having membrane of chelate (A₆) with composition (w/w) chelate (2.8%):PVC (45.7%):o-NPOE (48.6%):KTpClPB (2.8%). This sensor exhibits Nernstian response with slope 59.3 mV/decade of activity in the concentration range 5.6 × 10⁻⁸-1.0 × 10⁻¹ M Ag(I), performs satisfactorily over wide pH range of (3.0-8.0) with a fast response time (12 s). The sensor was also found to work satisfactorily in partially non-aqueous media up to 25% (v/v) content of acetonitrile, methanol or ethanol and can tolerate the concentration 1.0 × 10⁻² M of ionic (SDS, TBC) and nonionic (Triton X-100) surfactants. The proposed sensor can be used over a period of 4 months without significant drift in potentials. The response of the sensor was highly selective to Ag⁺ over a large number of cations and it could therefore be used for Ag⁺ estimation in blood of occupationally exposed persons.     

Experimental and theoretical study of the reaction of difluorostannylene with methyl chloride. The first direct IR spectroscopic detection of a complex between a carbene analog and an alkyl halide in low temperature inert matrix

Complex between a carbene analog (SnF₂) and organo halide (CH₃Cl) was stabilized by a low-temperature (Ar, 12 K) matrix isolation technique and characterized by IR spectroscopy for the first time. The bands at 567 and 543 cm^–1 were assigned to this complex. The potential energy surface of the system SnF₂ + CH₃CI was studied byab initio MP2/ 3-21G(d)//HF/3-21G(d) and semiempirical PM3 methods. Calculations shown that the reaction between SnF₂ and CH₃C1 results in the formation of a donor-acceptor complex. The calculated energy of the complex formation is 14.2 kcal mol^–1 (ab initio) and 15.7 kcal mol^–1 (PM3). Quantum-chemical calculations were used to interpret the IR spectrum of the complex. Insertion of SnF₂ into the C-Cl bond with formation of CH₃SnF₂Cl is an energetically favored process but it requires surpassing of a high energetic barrier and does not occur under the experimental conditions. A complex of CH₃CI with H₂O codeposited in argon matrix was detected by IR spectroscopy for the first time.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1121–1128, May, 1996.     

An infrared and Raman spectroscopic study of the Hofmann-type complexes and clathrates: M(piperidine)2Ni(CN)4; M(piperidine)2Ni(CN)4·1.5G (M=Cd, Co, Ni or Cu; G=benzene)

New Hofmann-type complexes and clathrates of the forms M(piperidine)₂Ni(CN)₄ and M(piperidine)₂Ni(CN)₄·1.5G (M=Cd, Co, Ni or Cu; G=benzene) were prepared in powder form and their infrared and Raman spectra are reported. The spectral features suggest that these compounds are similar in structure to the Hofmann-type clathrates except for the copper compounds. The complex and clathrate of Cu have different spectral features in comparison with its analogues due to the Jahn-Teller effect.     

Observation of an unusually facile fragmentation pathway of gas-phase peptide ions: a study on the gas-phase fragmentation mechanism and energetics of tryptic peptides modified with 4-sulfophenyl isothiocyanate (SPITC) and 4-chlorosulfophenyl isocyanate (SPC) and their 18-crown-6 complexes

Various peptide modifications have been explored recently to facilitate the acquisition of sequence information. N-terminal sulfonation is an interesting modification because it allows unambiguous de novo sequencing of peptides, especially in conjunction with MALDI-PSD-TOF analysis; such modified peptide ions undergo fragmentation at energies lower than those required conventionally for unmodified peptide ions. In this study, we systematically investigated the fragmentation mechanisms of N-terminal sulfonated peptide ions prepared using two different N-terminal sulfonation reagents: 4-sulfophenyl isothiocyanate (SPITC) and 4-chlorosulfophenyl isocyanate (SPC). Collision-induced dissociation (CID) of the SPC-modified peptide ions produced a set of y-series ions that were more evenly distributed relative to those observed for the SPITC-modified peptides; y(n-1) ion peaks were consistently and significantly larger than the signals of the other y-ions. We experimentally investigated the differences between the dissociation energies of the SPITC- and SPC-modified peptide ions by comparing the MS/MS spectra of the complexes formed between the crown ether 18-crown-6 (CE) and the modified peptides. Upon CID, the complexes formed between 18-crown-6 ether and the protonated amino groups of C-terminal lysine residues underwent either peptide backbone fragmentation or complex dissociation. Although the crown ether complexes of the unmodified ([M + CE + 2H]2+) and SPC-modified ([M* + CE + 2H]2+) peptides underwent predominantly noncovalent complex dissociation upon CID, the low-energy dissociations of the crown ether complexes of the SPITC-modified peptides ([M' + CE + 2H]2+) unexpectedly resulted in peptide backbone fragmentations, along with a degree of complex dissociation. We performed quantum mechanical calculations to address the energetics of fragmentations observed for the modified peptides.     

Complex formation of crown ethers with cations in the (water + organic solvent) mixtures: Part IX. Thermodynamics of interactions of Na ion with benzo-15-crown-5 ether in {(1 − x)DMA + xH2O} at T = 298.15 K

The thermodynamic functions of complex formation of benzo-15-crown-5 ether with sodium cation in {(1 − x)DMA + xH₂O} at T = 298.15 K have been calculated. The equilibrium constants of complex formation of benzo-15-crown-5 ether with sodium cation have been determined by conductivity measurements. The enthalpic effect of complex formation has been measured by calorimetric method at T = 298.15 K. The complexes are enthalpy stabilized and entropy destabilized. A simple model has been proposed to describe the relationship between the thermodynamic functions of complex formation of crown ethers with sodium cation and the structural and energetic properties of the mixed water-organic solvent. The linear enthalpy-entropy relationship for complex formation is also presented. The solvation enthalpy of the complex in {(1 − x)DMA + xH₂O} is discussed.     

Challenges in modelling and optimisation of stability constants in the study of metal complexes with monoprotonated ligands: Part I. A glass electrode potentiometric and polarographic study of a Cu-TAPSO-OH system

The behaviour of solutions containing 3-(N-tris[hydroxymethyl]methylamine)-2-hydroxypropanesulfonic acid (TAPSO) and copper(II) was studied by two analytical techniques, direct current polarography (DCP) and glass electrode potentiometry (GEP), at fixed total TAPSO to total copper(II) concentration ratios and various pH values, at 25 °C and ionic strength 0.1 M KNO₃. DCP and GEP, when used independently, were not able to provide a final metal-ligand model. Combined interpretation of data from DCP and GEP indicated the formation of six main species, CuL⁺, CuL(OH), CuL(OH)₂⁻, CuL₂, CuL₂(OH)⁻ and CuL₂(OH)₂²⁻ for which stability constants (as log β) were found to be 4.41, 11.43, 17.55, 8.08, 14.3 and 20.3, respectively. Five of these complexes, CuL(OH), CuL(OH)₂⁻, CuL₂, CuL₂(OH)⁻ and CuL₂ (OH)₂²⁻ are reported for the first time.