A long-pulse xenon ion laser as a pumping source for dye lasers

A simple xenon ion laser that is either sealed or has a gas flow mode is described. The laser delivered long pulses ( 15 μs) of almost 1 kW peak power. It has been used to pump a dye laser employing the same configuration as cw dye lasers. The system is inexpensive and can be mode-locked, enabling it to yield ultrashort pulses comparable in duration to those delivered by cw argon laser-pumped dye lasers but with much higher peak powers.     

Generation of picosecond optical phase conjugate pulses using cw mode-locked lasers

Low power picosecond optical phase conjugation has been demonstrated using cw mode-locked argon-ion and dye lasers via 4-wave mixing in ruby. Streak camera and power measurements show that the generated pulses are identical to the input pulses.     

Fluctuations in synchronously mode-locked dye lasers

We present detailed experimental data on random fluctuations of the pulse properties of a cw rhodamine 6G dye laser synchronously pumped by an acousto-optically mode-locked argon ion laser. It is shown that quantitative information about the fluctuations of the energy, the pulse repetition time and the duration of the pulses can be obtained from the power spectrum of the laser intensity which is measured with the use of an electronic spectrum analyser. This method is capable of revealing small, subpicosecond temporal pulse jitter. We show that the dye laser pulses exhibit an absolute r.m.s. jitter of 20 ps which is induced by the pump laser. The relative jitter in a dual system can be less than 1 ps because well defined correlations of the output fluctuations exist when two lasers are pumped by a common source.     

Linear picosecond electron-optical chronoscopy at a repetition rate of 140 MHz

A picosecond streak camera operating in synchronism with C.W. mode-locked lasers provides real-time integrated measurement of repetitive luminous phenomena with a temporal resolution of ～ 10 ps. The durations of pulses from an actively mode-locked argon ion laser (514.5 nm) have been measured to be ～ 90 ps and the system is particularly suitable for the measurement of dye fluorescence lifetimes.     

An interferometrically tuned and actively modelocked cw dye laser

An interferometer of the Michelson type is used to tune and to actively modelock an argon ion laser pumped cw dye laser. The interferometer constitutes a resonator mirror with a modulated reflecting coefficient. This modulation corresponds to a transient Fourier spectrum containing the whole emission band of the dye. In the center of this spectrum, a mode-locked train of picosecond pulses is generated. These pulses are tunable throughout the tuning range of the employed lasing medium in a simple and convenient way. Due to the inherent characteristic broad band output of the cw dye laser, the modulation envelope extends only for a fraction of the entire lasing period. Means of extending the said envelope to cover the complete laser output are discussed.     

Simple picosecond dye laser system pumped by a frequency doubled,optically compressed Q-switched mode-locked Nd:YAG laser

Using the frequency doubled output of the 3 ps pulses from a temporally compressed cw Q-switched and mode-locked Nd:YAG laser, a simple synchronously pumped dye laser was constructed to give frequency tunable operation with short pulses in the 5–10 ps range and peak powers of ～ 15 kW. A circularly scanning streak camera operating in stroboscopic mode was also used to examine pulse formation in the dye laser.     

Difference frequency generation with a synchronously mode-locked cw dye laser system

The generation of continuous trains of tunable infra-red pulses by the nonlinear mixing of the wave-lengths available from a self-contained synchronously mode-locked cw dye laser is described. The factors determining the optimization of the process are identified and their roles demonstrated.     

Generation of synchronised ultrashort pulses using a dual wavelength synchronously mode-locked CW dye laser

The properties of a dual wavelength synchronously mode-locked cw dye laser are described. Results are presented which show that good mode-locking is obtainable under dual wavelength conditions. Cross-correlation measurements indicate that the time separation of the pulses depends on gain saturation within the dye.     

Picosecond and subpicosecon pulse generation in synchronously pumped mode-locked cw dye lasers

Generation of tunable near-infrared picosecond and subpicosecond pulses in a synchronously pumped cw mode-locked Oxazine-1-perchlorate dye laser has been investigated for different values of the important system parameters. The experimental results confirm the predictions of a simple theoretical model which describes the steady-state pulse duration in terms of gain modulation strength, pump power, intracavity bandwidth, pump pulse length and cavity detuning. For a pump-pulse length of 100 ps and a bandwidth of more than 500 Å for the intracavity tuning element dye-laser pulses as short as 0.35 ps have been obtained. Under these conditions up to 100 mW of average output power were provided. In addition, mode-locking of an Oxazine 750 dye laser by synchronous pumping with the cw train of pulses obtained from the Oxazine-1-Perchlorate laser is reported.     

Characterization of the noise in continuously operating mode-locked lasers

An experimental and theoretical investigation of the fluctuations of the pulses from continuous-wave mode-locked lasers is presented. It is shown that these fluctuations can be detected and quantitatively characterized from measurements of the power spectrum of the light intensity. Such power spectra can be measured with great accuracy by shining the laser output on a suitable photodetector and by processing the detector signal with the use of an electronic spectrum analyzer. Different types of noise such as fluctuations of the pulse energy, pulse repetition time, and pulse duration, can be readily recognized from their characteristic spectral signature. Experimental results of noise measurements are presented for a synchronously mode-locked dye laser pumped by an acousto-optically mode-locked argon ion laser, and also for a colliding pulse passively mode-locked dye laser.     

Picosecond pulses from mode-locked dye lasers

Picosecond pulses have been generated in laser pumped (15 psec) and flashlamp pumped (6 psec) mode-locked dye lasers. Two-photon fluorescence and streak camera measurements are described.     

Continuous-wave mode-locked solid-state lasers with enhanced spatial hole burning

In Part I of this paper [1] experimental results were presented and discussed. In this part, we investigate theoretically the dynamics of end-pumped solid-state lasers due to enhanced spatial hole burning. This becomes possible by a fast numerical implementation of the saturated gain in the presence of strong spatial hole burning that allows to treat the multimode case for an arbitrary pumping level. We find for a wide range of laser parameters that the mode spacing of the cw running modes is essentially determined by the length of the gain medium and only weakly depends on the absorption depth of the pump transition. It is shown that spatial hole burning can lead to a completely flat saturated gain profile over half of the gain bandwidth. In mode-locked lasers, the flat gain due to spatial hole burning results in shorter pulses. But the pulses are neither Gaussian-nor sech-shaped as they are in actively or passively mode-locked lasers without spatial hole burning. Further, we show that soliton-like pulse shaping can be used to restore a transform-limited sech-shaped pulse in an end-pumped solid-state laser while exploiting the full gain bandwidth of the laser material.     

Passive mode locking of lasers by crossed-polarization gain modulation

We report on a novel approach for inducing passive mode locking of lasers without using any saturable absorber but exploiting the polarization degree of freedom of light. In our scheme, passive mode locking is achieved by crossed-polarization gain modulation caused by the reinjection of a polarization-rotated replica of the laser output after a time delay. The reinjection time delay defines resonance tongues that correspond to mode-locking operation. Numerical continuation reveals that the cw solution is destabilized through a Hopf bifurcation that defines the onset of multimode operation which evolves sharply into a mode-locked solution. Our approach can be applied to a large variety of laser systems. For vertical-cavity surface-emitting lasers, we demonstrate stable mode-locked pulses at repetition rates in the GHz range and pulse widths of few tens of picoseconds.     

Picosecond time resolved reflectivity of direct gap semiconductors

The relaxation of optically excited hot carrier distributions in GaAs and CdSe has been measured by time resolved reflectivity measurements with sub-picosecond optical pulses from a mode-locked cw dye laser. A characteristic transient in the reflectivity has been interpreted by an analysis of the perturbed optical dielectric function. Estimated energy loss rates are 0.4 eV/ps for electrons and holes having mean energies in the range of 1 to 2 eV for GaAs at room temperature.     

Synchronous Injection Locking Operation of Monolithic Diode Lasers Mode-Locked Diode Lasers

Synchronized mode-locking of monolithic mode-locked diode lasers has been demonstrated by injecting the light output from a master monolithic mode-locked diode laser. The master diode laser is a 10 GHZ hybridly mode-locked two section InGaASP quantum well laser. The slave lasers are a 10 GHz two section laser which is similar to the master laser, and a 20 GHz three section colliding pulse mode-locking laser. Both the slave lasers were greatly stabilized at 10 GHz frequency by a synchronous mode-locking mechanism under the injection of master laser pulses.     

同步泵浦-被动锁模染料激光器的基本方程及其解

利用自洽模型,推导出同步泵浦-被动锁模染料激光器的基本方程,并求出该系统输出的光脉冲宽度的解析表达式。由此,对这类混合锁模激光器系统的特性作了理论解析。 关键词：     

Bistable operation of a dual-wavelength synchronously mode-locked cw dye laser

Bistable operation of a dual-wavelength synchronously mode-locked cw dye laser is reported. Wavelength switching is found to depend on the pump power and the dye laser cavity lengths.     

Application of the coherent photon seeding technique to synchronously pumped and hybridly mode-locked dye lasers

The mode-locking performances of synchronously pumped and hybridly mode-locked dye lasers self-stabilized by coherent photon seeding (CPS) are investigated experimentally. The variation of the optimum values of the feedback parameters and the pulse quality of the stabilized laser with the cavity detuning is studied over a wide range of this parameter. The results presented for the case of pure synchronous pumping complement those previously reported for the generation of transform-limited pulses of variable length. The first experiment on the application of CPS to a conventional dual-jet hybridly mode-locked laser confirms the predictions of the numerical modelling.     

Diode-pumped, high-average-power femtosecond Cr3+ :LiCAF laser

We demonstrate a high-average-power continuous wave (cw) and cw mode-locked Cr3+ :LiCAF laser pumped by broad-area laser diodes. In cw lasing experiments, up to 580 mW of output was obtained with 4.35 W of incident pump. A semiconductor saturable absorber mirror was used to initiate stable, self-starting, mode locking. In the cw mode-locked regime, the Cr3+ :LiCAF laser produced nearly transform-limited, 67 fs long pulses near 800 nm with an average output power of 300 mW. The pulse repetition rate was 120 MHz, with a pulse energy of 2.5 nJ.     

CW mode-locked dye lasers for ultra fast spectroscopic studies

Continuously working dye lasers have produced pulses as short as 0.3 ps. The properties of passively and actively mode-locked dye lasers are described and compared. Methods of measuring pulse duration and applications of these lasers to photophysics and photobiology are discussed.