Side-pumped fiber laser

A neodymium-doped side-pumped double-clad fiber laser operating at 1.06 µm is described. We report here, what is, to our knowledge, the first exclusively repetitive side-pumping scheme with two monomode laser diodes. Side-pumping has been realized by prism-fiber couplers. A pump-light-loss analysis at the pump positions has been performed. An output power of 13.5 mW is obtained with both diode lasers. The highest slope efficiency of 66% with respect to absorbed pump power at 809 nm is achieved when pumping with only one diode.     

Random fiber laser

We investigate the effects of two-dimensional confinement on the lasing properties of a classical random laser system operating in the incoherent feedback (diffusive) regime. A suspension of 250 nm rutile (TiO2) particles in a rhodamine 6G solution was inserted into the hollow core of a photonic crystal fiber generating the first random fiber laser and a novel quasi-one-dimensional random laser geometry. A comparison with similar systems in bulk format shows that the random fiber laser presents an efficiency that is at least 2 orders of magnitude higher.     

Random distributed feedback fiber laser pumped by an ytterbium doped fiber laser

A random distributed feedback fiber laser operating at 1115 nm has been demonstrated experimentally in standard communication optical fibers by using a LD-pumped Yb-doped fiber laser as the pump source. We have studied the effect of different fiber spans on this new type of random fiber laser output power. It is shown that the generation power is the highest up to 198 mW in a 50 km fiber span. The slope efficiency is more than 28.7%. Stable, high-power continuous-wave (CW) lasing can be generated when the pump power is 3.6 W. The threshold power has also been calculated which well proves a random fiber laser operating via Rayleigh scattering, amplified through the Raman scattering.     

High-power photonic-bandgap fiber laser

An original architecture of an active fiber allowing a nearly diffraction-limited beam to be produced is demonstrated. The active medium is a double-clad large-mode-area photonic-bandgap fiber consisting of a 10,000 ppm by weight Yb(3+)-doped core surrounded by an alternation of high- and low-index layers constituting a cylindrical photonic crystal. The periodic cladding allows the robust propagation of a approximately 200 microm(2) fundamental mode and efficiently discriminates against the high-order modes. The M(2) parameter was measured to be 1.17. A high-power cw laser was built exhibiting 80% slope efficiency above threshold. The robust propagation allows the fiber to be tightly bent. Weak incidence on the slope efficiency was observed with wounding radii as small as 6 cm.     

Microstructured polymer fiber laser

A microstructured polymer optical fiber doped with Rhodamine 6G dye was fabricated and demonstrated as an optical amplifier and a fiber laser. As an amplifier, the fiber achieved a gain in excess of 30 dB. As a pulsed fiber laser, the fiber exhibited a threshold of 20 microJ, a slope efficiency of 18%, and a lifetime as high as 130,000 shots at 10 Hz. The maximum output energy was 16 microJ. The advantages that such fibers offer lie in the simplicity and flexibility of their fabrication and in their potential for use as compact, tunable solid-state sources.     

Ultrahigh-repetition-rate bound-soliton fiber laser

Ultrahigh-repetition-rate (over 100 GHz) bound-soliton pulses were experimentally generated in a fiber laser. Through incorporating a Loyt-type filter made of a piece of high birefringent fiber and an intracavity polarizer in a fiber laser, we found that not only ultrahigh-repetition-rate single-pulse soliton but also bound-soliton trains could be generated. Numerical simulations confirm the experimental observations.     

Self-polarized ytterbium-doped fiber laser

We demonstrate a linearly-polarized, ytterbium-doped fiber laser that uses an uncoated, undoped ceramic YAG plate as the output coupler, and the corresponding polarization extinction ratio of laser beam increases with incident pump power and then saturates at larger pump power. For comparison, the output coupler of the fiber laser is replaced by 10% reflectivity plane mirror, while the feature of the polarization of laser output is kept unchanged. The results show that the origin of the pump-dependent and self-started polarization is associated with the intensity-dependent nonlinear birefringence in the gain fiber.     

All-fiber mode-locked fiber laser

An environmentally stable mode-locked fiber laser based on nonlinear polarization rotation is experimentally demonstrated. The laser is based on a novel laser configuration that has negligible low-power steady-state reflectivity from one side and, consequently, no CW gain. The laser is self starting and the configuration is implementable as an all-fiber laser with standard polarization-maintaining fiber-pigtailed components. A pulse duration of 5.6 ps is obtained at a repetition rate of 5.96 MHz and at an average power of 8 mW. As an application of the proposed laser configuration, 213 mW of supercontinuum (600-1750 nm) was demonstrated from a fiber laser system with no sections of free-space optics.     

Three-level neodymium fiber laser incorporating photonic bandgap fiber

We report a neodymium fiber laser incorporating an all-solid photonic bandgap fiber to suppress the four-level laser transition 4F(3/2)-4I(11/2). We demonstrate lasing at 907 nm on the three-level transition 4F(3/2)-4I(9/2) when pumping at 808 nm. The maximum slope efficiency obtained was 32% with a threshold pump power of 70 mW.     

基于飞秒激光直写光纤光栅的掺镱光纤激光器

 利用飞秒激光微加工技术,可以在光纤纤芯内直写出布拉格光栅,它与传统的光纤光栅制作方法相比,具有耗时短、无需光敏光纤、周期可任意设定、光栅稳定性高等优点。采用800 nm钛宝石飞秒激光器,在Hi1060光纤内写入一支8 mm长的布拉格光栅,光纤光栅的周期为2.9 μm,这是中心波长为1 042 nm的八阶光纤布拉格光栅。将所得光栅与一段有源的双包层光纤熔接,作为激光输出镜,利用975 nm的LD光纤模块作为泵浦源,采用端泵浦技术构成双包层光纤激光器。双包层光纤采用Nufern公司镱(Yb³⁺)离子掺杂双包层光纤,光纤长度3 m。所得激光器的输出功率为71.1 W,中心波长1 042 nm,带宽约为0.8 nm。     

基于飞秒激光直写光纤光栅的掺镱光纤激光器

利用飞秒激光微加工技术,可以在光纤纤芯内直写出布拉格光栅,它与传统的光纤光栅制作方法相比,具有耗时短、无需光敏光纤、周期可任意设定、光栅稳定性高等优点。采用800 nm钛宝石飞秒激光器,在Hi1060光纤内写入一支8 mm长的布拉格光栅,光纤光栅的周期为2.9 μm,这是中心波长为1 042 nm的八阶光纤布拉格光栅。将所得光栅与一段有源的双包层光纤熔接,作为激光输出镜,利用975 nm的LD光纤模块作为泵浦源,采用端泵浦技术构成双包层光纤激光器。双包层光纤采用Nufern公司镱(Yb3+)离子掺杂双包层光纤,光纤长度3 m。所得激光器的输出功率为71.1 W,中心波长1 042 nm,带宽约为0.8 nm。     

A self-seeded fiber laser incorporated with a fiber Bragg grating external cavity semiconductor laser

A self-seeded fiber laser incorporated with a fiber Bragg grating external cavity semiconductor laser (FBG-ECL) and a Mach-Zehnder interferometer (MZI) were reported in this paper. The MZI provided a Q-switching with response time in the order of micro-seconds. The FBG-ECL provided narrow pulses as seeds to shorten the Q-switched pulses. Experimentally, pulse width of 0.8 μs was measured, which was one fifth of the pulse width without self-seeding.     

Colliding-pulse harmonically mode-locked fiber laser

A Fabry–Perot semiconductor saturable absorber has been implemented in a colliding pulse configuration for stabilizing a harmonically mode-locked fiber laser. An environmentally stable CPM design is shown to enhance supermode suppression. Received: 24 October 2000 / Revised version: 28 November 2000 / Published online: 9 February 2001     

高功率窄线宽光纤激光技术

以波长拓展为主线介绍了单频光纤振荡器的研究进展,以功率提升为主线介绍了单频连续光纤放大器的发展现状,以产生窄线宽种子源的方法为依据总结了1 μm波段高功率窄线宽连续光纤激光器的国内外研究成果。分析当前高功率单频光纤激光器和高功率窄线宽光纤激光器的发展趋势和面临的主要挑战,梳理并讨论高功率窄线宽光纤激光的关键技术,并基于当前高功率窄线宽光纤激光器的发展现状介绍其在各领域的应用价值。     

Continuous-wave tunnel ring fiber laser

The continuous-wave oscillation of a tunnel ring fiber laser is demonstrated. The high losses encountered in tunneling systems are compensated for by a high-gain amplifying medium from barrier widths for 0 to lambda/2. The experimental observations are in good agreement with a simple theoretical model. This near-field probe system allows one to detect small displacements in the picometer range.     

Linearly-polarized Tm-doped double-clad fiber laser

We report a linearly polarized Tm doped fiber laser. The fiber laser was set up by using a piece of polarization maintaining Tm doped double clad fiber of 5 m length as gain medium and a polarization beam splitter as a polarization selector. The fiber laser was pumped by a fiber pigtailed laser diode working at 790 nm with a maximum output power of 90 W. The linearly polarized Tm laser operated at wavelength around 2030 nm. A maximum output power up to 21.9 W was achieved when the pump power was 63.27 W with a threshold of 11.92 W, a slope efficiency of about 43.7%, and a polarization extinction ratio of 92.7% (11.37 dB). In addition to the blue fluorescence, we also observed the violet fluorescence under high pump power level. The up-conversion fluorescence was considered to be attributed to the ¹ G ₄ → ³ H ₆, and ¹ D ₂ → ³ F ₄ transitions of Tm ions, respectively.     

Single-frequency thulium-doped distributed-feedback fiber laser

We have successfully demonstrated a single-frequency distributed-feedback (DFB) thulium-doped silica fiber laser emitting at a wavelength of 1735 nm. The laser cavity is less than 5 cm long and is formed by intracore UV-written Bragg gratings with a phase shift. The laser is pumped at 790 nm from a Ti:sapphire laser and has a threshold pump power of 59 mW. The laser has a maximum output power of 1 mW in a single-frequency, single-polarization radiation mode and is tunable over a few nanometers. To the best of the authors' knowledge, this is the first report of a single-frequency DFB fiber laser that uses thulium as the amplifying medium. The lasing wavelength is the longest demonstrated with DFB fiber lasers and yet is among the shortest obtained for thulium-doped silica fiber lasers.     

双端泵浦保偏光纤激光器

以两台808 nm半导体激光器LD1和LD2为泵浦源,对光纤激光器双端泵浦进行了研究,获得了6.5 W的激光输出。实验分别测出了LD1和LD2半导体激光器单端泵浦和双端泵浦时的输出功率,对双端泵浦输出功率与单端泵浦功率之和进行了比较,利用双端泵浦提高了泵浦效率和输出激光功率。同时测量了输出激光的偏振度,通过计算得到双端泵浦输出激光的偏振度为0.5。     

可调谐环形腔掺铒光纤激光器

使用高掺杂掺铒光纤制成了低噪声的环形腔光纤激光器。通过对文献中报道的环形腔结构光纤激光器输出的分析,指出了其存在的问题,并提出了减小其输出背景噪声的改进方案。通过实验验证了改进后的环形腔结构的低噪声特点,从原理上进行了解释。用不同掺铒光纤长度、泵浦功率、光栅波长及光栅反射率进行了实验,得到它们对输出光的性能影响。这种环形腔结构的光纤激光器可实现1525nm~1565nm连续可调谐输出。     

Soliton molecule in fiber laser

The soliton molecule is achieved in nonlinear polarization rotation fiber laser. The structure of soliton molecule is heterogeneous diatomic molecule. The soliton molecule originates from the splitting of the high energy soliton. The dips of the soliton molecule spectra show that there is the interaction between the constituents of the soliton molecule, resulting in that the constituents are in the bound state as a unit. The laser bias can change the fine structure of the soliton molecule, which can be observed in the autocorrelator and oscilloscope.