共查询到20条相似文献,搜索用时 125 毫秒
1.
2.
3.
4.
本文揭示了钠、钾受基体元素碲干扰的现象和分析系统中酸度对钠、钾吸光度的影响,在理论上探讨了碲对钠、钾干扰的原因,利用加入盐酸和铝元素的方法分别排除碲对钾、钠的干扰,提出一个方便,实用的测定方法,回收率和RSD分别为95-102%和7.4%。 相似文献
5.
6.
高效液相色谱法测定工业废水中的硝基酚 总被引:2,自引:0,他引:2
采用反相高效液相色谱法,Nucleosil(R)C18柱(250×4.6mm,5μm),以甲醇∶水=60∶40(V∶V,pH值约为3)流动相,采用紫外检测器,检测波长280nm,在室温条件下测定工业废水中硝基酚类的含量.在0.02598-0.1299 mg/mL范围内邻硝基苯酚钠浓度与峰面积线性关系良好,线性相关系数为0.9992,平均回收率为94.36%,精密度RSD为3%;在0.02573-0.1286 mg/mL范围内对硝基苯酚钠浓度与峰面积线性关系良好,线性相关系数为0.9996,平均回收率为96.54%,精密度RSD为5%;间硝基苯酚钠在0.02515-0.1257 mg/mL浓度范围内,峰面积与浓度呈现良好的线性关系,线性相关系数为97.34%,平均回收率为103.08%.此方法操作简便,适用于生产质量控制. 相似文献
7.
8.
9.
10.
ICP-AES测定锰矿中二氧化硅含量 总被引:4,自引:0,他引:4
试样经氢氧化钠和过氧化钠混合熔剂碱熔,再用酸浸提,干过滤后定容.采用ICP-AES测定锰矿中二氧化硅含量.本法测定锰矿标样(冶金部标准样品505)中二氧化硅含量,其测定结果的相对标准偏差RSD为1.08%,测定平均值为33.93%(标样推荐值为33.58%). 相似文献
11.
建立了王水溶矿-电感耦合等离子体-质谱法测定矿石中的常量金的方法。该方法加标回收率94.0%—102.0%,精密度RSD 1.66%—4.01%,与传统的分析方法相比:该方法简单、快速、实用。 相似文献
12.
多种群精英共享遗传算法在异常光谱识别中的应用 总被引:1,自引:0,他引:1
提出了一种基于多种群精英共享遗传算法的异常光谱识别方法.该方法应用于红外光谱数据的分析,并在删除异常光谱样本后使用偏最小二乘方法进行建模.与使用蒙特卡洛交叉验证、留一交叉检验、马氏距离以及传统遗传算法进行异常光谱识别的方法相比,所提方法将水分预测模型的预测误差平方和(PRESS)分别降低了72.4%,39.5%,39.5%和14.5%;将脂肪含量的预测模型的PRESS值分别降低了86.2,75.9%,84.9%和19.9%;将蛋白质含量的预测模型的PRESS值分别降低了56.5%,35.7%,35.7%和18.2%.实验表明,所提方法不仅能适应不同成分光谱数据的异常识别,而且删除异常光谱数据后所建立的模型具有较高的预测能力和较好的稳健性. 相似文献
13.
Kai-Feng Yin 《中国物理 B》2022,31(11):110703-110703
Zero-field single-beam atomic magnetometers with transverse parametric modulation for ultra-weak magnetic field detection have attracted widespread attention recently. In this study, we present a comprehensive response model and propose a modification method of conventional first harmonic response by introducing the second harmonic correction. The proposed modification method gives improvement in dynamic range and reduction of linearity error. Additionally, our modification method shows suppression of response instability caused by optical intensity and frequency fluctuations. An atomic magnetometer with single-beam configuration is built to compare the performance between our proposed method and the conventional method. The results indicate that our method's magnetic field response signal achieves a 5-fold expansion of dynamic range from 2 nT to 10 nT, with the linearity error decreased from 5% to 1%. Under the fluctuations of 5% for optical intensity and ±15 GHz detuning of frequency, the proposed modification method maintains intensity-related instability less than 1% and frequency-related instability less than 8% while the conventional method suffers 15% and 38%, respectively. Our method is promising for future high-sensitive and long-term stable optically pumped atomic sensors. 相似文献
14.
15.
16.
分别采用干灰化法和HNO3-HClO4混合酸消解法消解鸡血藤样品,参考其他中药材火焰原子吸收法的测定方法,用火焰原子吸收光谱法测定了桂西南产鸡血藤中K、Na、Ca、Mg、Mn、Cu、Fe金属元素的含量。研究了不同消解方法对测定金属元素含量的影响、仪器的最佳工作条件、干扰消除情况,并作了方法的准确度和精密度考察。干法消解的加标回收率在97.5%—100.8%之间,RSD2.18%—4.17%(n=6);湿法消解回收率在97.1%—101.3%之间,RSD1.02%—3.74%(n=6)。干法消解测定的7种金属元素含量稍低于湿法消解测定的含量。文章为鸡血藤多种金属元素含量的测定提供了可靠的方法,为进一步解释鸡血藤的功能作用和开发鸡血藤的药用价值提供理论依据。 相似文献
17.
An interconnecting bus power optimization method combining interconnect wire spacing with wire ordering
下载免费PDF全文
![点击此处可从《中国物理 B》网站下载免费的PDF全文](/ch/ext_images/free.gif)
On-chip interconnect buses consume tens of percents of dynamic power in a nanometer scale integrated circuit and they will consume more power with the rapid scaling down of technology size and continuously rising clock frequency, therefore it is meaningful to lower the interconnecting bus power in design. In this paper, a simple yet accurate interconnect parasitic capacitance model is presented first and then, based on this model, a novel interconnecting bus optimization method is proposed. Wire spacing is a process for spacing wires for minimum dynamic power, while wire ordering is a process that searches for wire orders that maximally enhance it. The method, i.e., combining wire spacing with wire ordering, focuses on bus dynamic power optimization with a consideration of bus performance requirements. The optimization method is verified based on various nanometer technology parameters, showing that with 50% slack of routing space, 25.71% and 32.65% of power can be saved on average by the proposed optimization method for a global bus and an intermediate bus, respectively, under a 65-nm technology node, compared with 21.78% and 27.68% of power saved on average by uniform spacing technology. The proposed method is especially suitable for computer-aided design of nanometer scale on-chip buses. 相似文献
18.
19.
溶液阴极辉光放电发射光谱法易受水体样品中的基体效应影响,而且对于实际水体样品组份相对复杂,含有多种元素,受基体效应干扰更加明显,导致金属元素浓度预测精度降低。为了减少溶液阴极辉光放电发射光谱法中水体样品基体效应的影响,常常利用定量分析方法对金属元素进行分析。这些定量分析方法中,标准加入法尤其适合于待测物质基体效应较为显著或者含有干扰物质等情况,然而标准加入法容易受到背景信号的干扰,使测量结果产生误差,因此在进行标准加入法之前需要消除光谱数据的背景干扰。最简单的谱线干扰消除法是离峰校正法,此法扣除线峰左右两侧的背景强度值,以达到消除背景干扰的目的;小波变换法同样也适用于消除背景干扰,并且具备普适性,利用此法对小波进行多尺度分层,而后对小波低频系数进行处理,获得校正后的数据。在独立开发的溶液阴极辉光放电发射光谱系统上,利用基于标准加入法的离峰校正法和小波变换法对水溶液样品中Ca和Mg含量进行预测。实验结果比较发现,基于传统的标准加入法,测得5, 10和20 mg·L-1浓度的Ca样品的相对误差分别为157.0%, 105.1%和47.0%, Mg的相对误差分别为20.1%, 3.1%和2.8%。然而,结合标准加入法和离峰校正法后, Ca的相对误差分别降低至15.4%,-8.8%和3.3%, Mg的相对误差分别降低至14.5%, 0.1%和0.8%。采用小波变换算法消除背景干扰后的标准加入法, Ca元素的相对误差分别降至13.2%,-7.6%和-1.4%, Mg的相对误差分别降至13.4%,-0.4%和0.5%。结果表明,离峰校正法和小波变换法结合标准加入法测量Ca和Mg的准确度显着提高,两种方法能有效地消除背景干扰,降低基体效应,使预测精度升高。其中,小波变换法结合标准加入法可用于多种类型的背景校正场合,无需选择合适的背景校正点,而且预测精度更高,相比离峰校正法具有一定的优势。 相似文献