共查询到20条相似文献,搜索用时 125 毫秒
1.
2.
3.
4.
温度对液晶填充光子晶体光纤传输特性的影响 总被引:6,自引:0,他引:6
利用液晶的折射率是温度和波长函数的特性,在光子晶体光纤(PCF)芯区的空气柱中填充向列相液晶,通过改变温度来改变液晶的折射率,构成了一种温度凋制光子晶体光纤.用阶跃有效折射率模型研究了温度对这种光子晶体光纤在不同光波长时传输特性的影响,并进行了数值计算.结果表明液晶填充使光子晶体光纤的色散减小,由于折射率对温度和波长变化敏感,改变温度可以使光纤在长波长区域出现单模传输,在短波长时不会出现单模传输,即使包层相对孔径很小也不会出现无截止单模传输.温度升高使光纤的色散值增大,零色散波长向短波长方向移动.这些特性对温度调制光子晶体光纤器件的设计和应用具有一定的参考意义. 相似文献
5.
6.
应用于液压传感的光子晶体光纤特性 总被引:1,自引:1,他引:0
为实现结构紧凑、高灵敏度的光纤压力(液压)传感器,提出了一种应用于液压传感的边孔结构光子晶体光纤.基于全矢量有限元方法,研究了传统光子晶体光纤和边孔结构光子晶体光纤的有效折射、模式等特性以及在液压情况下的应力和应力特性.根据光弹效应给出了传统光子晶体光纤和边孔结构光子晶体光纤在液压情况下的折射率变化特性.模拟结果表明边孔结构光子晶体光纤可以获得更大的液压传感灵敏度,增大边孔半径可以提高液压传感灵敏度,因此结构优化的边孔结构光子晶体光纤可以实现高灵敏度的光纤压力(液压)压力传感器. 相似文献
7.
8.
双折射光子晶体光纤传输特性分析 总被引:6,自引:2,他引:6
采用时域有限差分法对光子晶体光纤导模的传输特性进行数值分析,通过该法可得到任意横向结构光子晶体光纤的色散特性和双折射特性。为提高精度,在计算中应用了各向异性完全匹配层作为吸收边界条件。光子晶体光纤的传输特性完全由其横向结构决定。用时域有限差分法对一类对称结构和两类非对称结构光子晶体光纤进行了数值分析,计算结果表明经合理设计的非对称结构光子晶体光纤中可存在较高的双折射(其双折射可达0.07)。表明时域有限差分法可有效应用于分析和设计具有特定色散和偏振特性的光子晶体光纤。 相似文献
9.
为实现结构紧凑、高灵敏度的光纤压力(液压)传感器,提出了一种应用于液压传感的边孔结构光子晶体光纤.基于全矢量有限元方法,研究了传统光子晶体光纤和边孔结构光子晶体光纤的有效折射、模式等特性以及在液压情况下的应力和应力特性.根据光弹效应给出了传统光子晶体光纤和边孔结构光子晶体光纤在液压情况下的折射率变化特性.模拟结果表明边孔结构光子晶体光纤可以获得更大的液压传感灵敏度,增大边孔半径可以提高液压传感灵敏度,因此结构优化的边孔结构光子晶体光纤可以实现高灵敏度的光纤压力(液压)压力传感器. 相似文献
10.
光子晶体光纤弯曲损耗特性研究 总被引:2,自引:3,他引:2
对光子晶体光纤的损耗特性进行了分析,并在实验上对两种典型的光子带隙型和全内反射型光子晶体光纤进行了研究.分别对两种不同结构的光子晶体光纤在弯曲半径2~15 mm范围内的损耗进行了测量.与传统光纤损耗实验结果的对比表明,两种光子晶体光纤的弯曲损耗均不明显,具有很强的抗弯曲损耗能力.实验也证实了光子晶体光纤弯曲损耗存在临界弯曲半径,在大于临界半径的情况下,几乎没有弯曲损耗.从结构上分析并证明光子晶体光纤弯曲损耗随填充比(d/Λ)的增加而减小,填充比越高弯曲损耗越小. 相似文献
11.
Photonic crystal fibers are a new class of single-material optical fibers with wavelength-scale air holes running down the
entire fiber length. Photonic crystal fibers were first developed in 1996 and have subsequently been the focus of increasing
scientific and technological interest in the field of fiber optics. The manufacturing, principles, basic properties, and some
applications of photonic crystal fibers are briefly described in this paper. A review of our recent work on the nonlinear
effects in photonic crystal fibers is presented, and special emphasis is placed on such effects as supercontinuum generation,
frequency conversion, and solitons observed when femtosecond light pulses propagate in these fibers. 相似文献
12.
G. Amouzad Mahdiraji Desmond M. Chow S. R. Sandoghchi F. Amirkhan E. Dermosesian Kwok Shien Yeo 《Fiber and Integrated Optics》2014,33(1-2):85-104
AbstractThe fabrication process of photonic crystal fibers based on a stack-and-draw method is presented in full detail in this article. In addition, improved techniques of photonic crystal fiber preform preparation and fabrication are highlighted. A new method of connecting a handle to a preform using only a fiber drawing tower is demonstrated, which eliminates the need for a high-temperature glass working lathe. Also, a new technique of modifying the photonic crystal fiber structural pattern by sealing air holes of the photonic crystal fiber cane is presented. Using the proposed methods, several types of photonic crystal fibers are fabricated, which suggests potential for rapid photonic crystal fibers fabrication in laboratories equipped with and limited to only a fiber drawing tower. 相似文献
13.
用平面波展开法对光子晶体光纤中电磁场的Maxwell方程组进行了求解。将光纤截面作为超元胞衍生出一个无边界的二维周期性系统,光纤纤芯等效为光子晶体中的缺陷,借助平面波法对其性质进行研究,模拟了半导体中的超格子。运用上述超格子模型,对与纤芯同列孔半径可变的高双折射及与包层中纤芯距离最近的孔半径可变的色散平坦光子晶体光纤的光学性质进行了研究,发现与纤芯同列的孔半径变化时,其双折射比传统光纤更强,而当包层中距离纤芯最近的孔半径取特定值时,可得到近零色散平坦光纤并在大范围内获得反常色散。与传统光纤和普通光子晶体光纤相比,这种新型的色散平坦光纤在密集波分复用(DWDM)光通信系统中具有更高的应用价值。 相似文献
14.
We have fabricated tapered photonic crystal fibers using a fusion splicer and experimentally observed the near-field mode distribution and the beam divergence of it. We have also compared characteristics of the tapered photonic crystal fiber with those of a tapered standard single-mode fiber. Unlike a tapered standard single-mode fiber, the mode field profile of a tapered photonic crystal fiber shows a good confinement of its field within the core region. The numerical apertures of tapered photonic crystal fibers are increased as the diameter of the fiber is decreased. 相似文献
15.
We have fabricated tapered photonic crystal fibers using a fusion splicer and experimentally observed the near-field mode distribution and the beam divergence of it. We have also compared characteristics of the tapered photonic crystal fiber with those of a tapered standard single-mode fiber. Unlike a tapered standard single-mode fiber, the mode field profile of a tapered photonic crystal fiber shows a good confinement of its field within the core region. The numerical apertures of tapered photonic crystal fibers are increased as the diameter of the fiber is decreased. 相似文献
16.
本文实验研究了飞秒脉冲在不同零色散点光子晶体光纤中传输时产生超连续谱的现象。首先,我们通过非线性薛定谔方程理论计算了激光脉冲分别在正、负色散光子晶体光纤中传输时产生的超连续谱;计算结果表明在正色散光子晶体光纤产生的超连续谱远远大于在负色散中产生的超连续谱。其次,在实验上采用零色散点分别为800 nm、1 060 nm和2 000 nm的光子晶体光纤,将脉宽为130 fs,中心波长800 nm,脉冲重复频率为80 MHz的脉冲输入这些光纤中产生超连续谱并研究其特性,实验结果表明光子晶体光纤的零色散点越小,在其中产生的超连续谱越宽越平坦。同时产生的超连续谱也与激光脉冲的能量和中心波长相关。 相似文献
17.
采用矢量耦合非线性薛定谔方程描述了超短光脉冲在双折射光子晶体光纤中的传输过程,并利用分步傅里叶方法求解该方程。数值模拟了中心波长为1550nm的超短光脉冲在不同色散参量的双折射光子晶体光纤中超连续谱的产生及其偏振特性。分析了光纤在不同色散区时,高阶色散和非线性效应对超连续谱及其偏振态的影响。结果表明,当超短光脉冲波长位于近光纤零色散点的反常色散区时,比其在光纤正常色散区和远离光纤零色散点的反常色散区更容易产生宽且平坦的超连续谱,所得到的光谱显示出了复杂的偏振态特性。 相似文献
18.
19.
Different supercontinuum generation processes in photonic crystal fibers pumped with a 1064-nm picosecond pulse
下载免费PDF全文
![点击此处可从《中国物理 B》网站下载免费的PDF全文](/ch/ext_images/free.gif)
Picosecond pulse pumped supercontinuum generation in photonic crystal fiber is investigated by performing a series of comparative experiments. The main purpose is to investigate the supercontinuum generation processes excited by a given pump source through the experimental study of some specific fibers. A 20-W all-fiber picosecond master oscillator-power amplifier (MOPA) laser is used to pump three different kinds of photonic crystal fibers for supercontinuum generation. Three diverse supercontinuum formation processes are observed to correspond to photonie crystal fibers with distinct dis- persion properties. The experimental results are consistent with the relevant theoretical results. Based on the above analyses, a watt-level broadband white light supercontinuum source spanning from 500 nm to beyond 1700 nm is demonstrated by using a picosecond fiber laser in combination with the matched photonic crystal fiber. The limitation of the group velocity matching curve of the photonic crystal fiber is also discussed in the paper. 相似文献
20.
传统有效折射率方法只能模拟具有相同空气孔大小的单包层光子晶体光纤.针对这一问题,提出了一种改进的有效折射率法,能够计算具有不同孔径的多包层光子晶体光纤的传输特性.并用此方法对三包层光子晶体光纤的基模有效折射率和色散等特性进行了数值模拟,结果与多极法模拟出的结果符合得很好.这种改进的有效折射率法拓展了传统有效折射率法的适用范围,对快速准确地分析和设计具有不同传输特性的多包层光子晶体光纤提供了理论依据.
关键词:
光子晶体光纤
多包层
有效折射率方法
色散 相似文献