流体加载下加肋板结构的声辐射特性研究

本文采用有限元和边界元方法对加肋板结构的声辐射进行了计算分析,研究分析了加肋板结构的板厚、板面积、板边长比、肋骨惯性矩和间距、边界条件以及板材和流体介质等对结构辐射声功率的影响,得到了一些有意义的结论,从而为揭示加板结构声辐射规律,降低结构的声辐射提供了一定的依据。     

Acoustic scattering from fluid-loaded stiffened cylindrical shell: analysis using elasticity theory

The acoustic scattering from a fluid-loaded stiffened cylindrical shell is described by using elasticity theory. The cylindrical shell is reinforced by a thin internal plate which is diametrically attached along the tube. In this model, cylindrical shell displacements and constraints expressed from elasticity theory are coupled to those of the plate at the junctions, where plate vibrations are described by using plate theory. The present model is first validated at low frequency range (k1a approximately 5-40) by comparison with a previous model based on the Timoshenko-Mindlin thin shell theory and by experimental results. Theoretical and experimental resonance spectra are then analyzed in a high frequency range (k1a approximately 120-200). Only resonances due to the S0 wave are clearly observed in this frequency range, and their modes of propagation are identified. Furthermore, A0 wave propagation is detected, because of the presence of the reflection of this wave at the shell-plate junctions.     

The free and forced waves on a fluid-loaded elastic plate

The often-studied problem of the response of a fluid-loaded thin elastic plate to external forcing is considered again, with the aim of determining those “free waves” of the coupled system which can actually be excited. General properties of the quintic equation whose roots yield the free wavenumbers can be used to establish the character of those roots, and a generalized “coincidence condition” can be given at which the nature of the roots changes. It is argued, however, and demonstrated, that in general no significance can be attached to this condition or to any of the roots except that relating to the undamped subsonic surface wave. The far field contributions associated with all other waves, including the so-called “leaky waves”, may be altered merely by change of integration path from the stationary phase contour to the steepest descent contour in the complex wavenumber plane, and thus these contributions, which are exponentially small with distance, do not represent physically meaningful free modes. It is shown, however, that if a second limit process, associated with small fluid loading, is considered simultaneously with the far field limit, then the leaky waves can be unambiguously identified over a large, but not too large, range of distances, and that for such distances these waves generate a conical or plane beam (in three or two dimensions, respectively).     

正交加筋板声透射的板梁理论模型研究

为了研究正交加筋板的声透射问题,基于经典薄板和梁振动理论,建立了正交加筋板声透射的板梁理论模型。首先通过分析加强筋的受迫弯曲和扭转运动,求得了平板和加强筋线接触之间的反力和反力矩,然后将其引入到平板振动控制方程中,得到了正交加筋板声振方程,最后采用空间谐波展开法求解该方程得到了传声损失的表达式;在此基础上,首先研究了无限大平板和单向加筋的隔声性能,通过与解析解及两种简化模型的计算结果作对比,验证了所建理论模型的有效性;并进一步研究了加筋形式对正交加筋板隔声性能的影响。结果表明:选择合适的加筋形式可以有效避开结构的隔声波谷。     

Active modal control simulation of vibro-acoustic response of a fluid-loaded plate

Active modal control simulation of vibro-acoustic response of a fluid-loaded plate is presented. The active modal control of the vibro-acoustic response is implemented using piezoelectric actuators/sensors. The active modal damping is added to the coupled system via negative velocity feedback. The feedback gain between the piezoelectric actuators/sensors for the modal control is obtained using the in-vacuo modal matrix and the incompressible fluid-loaded modal matrix. The modal control performance of structural vibration and acoustic radiation of a baffled plate is numerically studied. It is shown that the proposed method increases the modal damping ratio and achieves reduction in the mean square velocity and the sound power for given modes of the fluid-loaded plate.     

An approximate Green's function for a locally excited fluid-loaded thin elastic plate

In the classic treatment of the line-driven, fluid-loaded, thin elastic plate, a branch cut integral typically needs to be evaluated. This branch cut arises due to a square root operator in the spectral form of the acoustic impedance. In a previous paper [J. Acoust. Soc. Am. 110, 3018 (2001)], DiPerna and Feit developed a methodology, complex layer analysis (CLA), to approximate this impedance. The resulting approximation was in the form of a rational function, although this was not explicitly stated. In this paper, a rational function approximation (RFA) to the acoustic impedance is derived. The advantage of the RFA as compared to the CLA approach is that a smaller number of terms are required. The accuracy of the RFA is examined both in the Fourier transform domain and the spatial domain. The RFA is then used to obtain a differential relationship between the pressure and velocity on the surface of the plate. Finally, using the RFA in conjunction with the equation of motion of the plate, an approximate expression for the Green's function for a line-driven plate is obtained in terms of a sum of propagating and evanescent waves. Comparisons of these results with the numerical inversion of the exact integral show reasonable agreement.     

Noise reduction analysis for a stiffened finite plate

This paper presents an analytical solution for the vibration and acoustic responses of a finite stiffened plate that is covered with decoupling layers and subjected to external excitation. The theory of elasticity is used for the decoupling layer, and the stiffened plate is modeled by the plate theory and Euler–Bernoulli beam equation. Equations are constructed by the boundary conditions at the plate/coating and coating/fluid interfaces. The problem can be solved by the proposed method in this paper. Test verification shows that a good correlation exists between theoretical and test results. Thus, the theoretical study in this paper is correct. Numerical results show that shear waves insignificantly affect the structural vibration level difference (VR) under low frequencies. The noise reduction of the stiffened plate covered with decoupling layers is greatly influenced by the decoupling layer loss factor. A failure region of the vibration level difference is present in the low frequency band of the decoupling layer. Furthermore, the thickness of the decoupling layer significantly affects noise reduction.     

Bending wave propagation along a symmetric groove in an elastic plate

Normal bending waves propagating along a symmetric groove in an infinite elastic plate are considered. The characteristic equations in wave numbers of these modes are obtained for symmetric and antisymmetric modes of vibration. Critical frequencies and eigenfunctions of the problem are determined. Results of numerical calculations for the wave numbers, critical frequencies, and modes of vibration are presented.     

Wave propagation in a magneto-electroelastic plate

The wave propagation in a magneto-electro-elastic plate was studied. Some new characteristics were discovered: the guided waves are classified in the forms of the Quasi-P, Quasi-SV and Quasi-SH waves and arranged by the standing wavenumber; there are many patterns for the physical property of the magneto-electro-elastic dielectric medium influencing the stress wave propagation. We proposed a self-adjoint method, by which the guided-wave restriction condition was derived. After the corresponding orthogonal sets were found, the analytic dispersion equation was obtained. In the end, an example was presented. The dispersive spectrum, the group velocity curved face and the steady-state response curve of a magneto-electro-elastic plate were plotted. Then the wave propagations affected by the induced electric and magnetic fields were analyzed. Supported by the National Natural Science Foundation of China (Grant Nos. 10572001 and 10232040)     

有液层负载时各向异性薄板中Lamb波的传播

研究各向异性板有液层负载时板中Lamb波的传播.以微传感领域常用的ZnO等为例,从弹性波传播理论出发,结合边界条件,导得了各向异性薄板有液层负载时板中Lamb波传播的色散方程,这也同样适用于正交晶体系,正方晶体系和立方晶体系的晶体.数值计算结果表明,各向异性板中Lamb波相速度随液层厚度增加呈周期变化.当单面有液层负载的薄板厚度2d很小时,A₀模式的类Lamb波的微质量传感特性也作了讨论.     

加肋板稳态简谐响应的粘弹性阻尼控制研究

应用模态叠加法研究了用粘弹性阻尼控制加筋板的稳态简谐响应。考察了在板上加自由阻尼层和加粘弹性梁的情况,分析了阻尼材料损耗因子、阻尼层厚度以及粘弹性梁剖面尺寸对结构响应的影响。对3种阻尼处理情况进行了比较。结构的幅频特性表明,粘弹性材料能够有效地控制结构的共振响应。     

Time-domain analysis of second-harmonic generation of primary Lamb wave propagation in an elastic plate

Within the second-order perturbation approximation,this paper investigates the physical process of generation of the time-domain second harmonic by a primary Lamb wave waveform in an elastic plate.The present work is performed based on the preconditions that the phase velocity matching is satisfied and that the transfer of energy from the primary Lamb wave to the double frequency Lamb wave is not zero.It investigates the influences of the difference between the group velocities of the primary Lamb wave and the double frequency Lamb wave,the propagation distance and the duration of the primary Lamb wave waveform on the envelope shape of the time-domain second harmonic.It finds that the maximum magnitude of the envelope of the second-harmonic waveform can grow within some propagation distance even if the condition of group velocity matching is not satisfied.Our analyses also indicate that the maximum magnitude of the envelope of the second-harmonic waveform is kept constant beyond a specific propagation distance.Furthermore,it concludes that the integration amplitude of the time-domain second-harmonic waveform always grows with propagation distance within the second-order perturbation.The present research yields new physical insight not previously available into the effect of generation of the time-domain second harmonic by propagation of a primary Lamb wave waveform.     

SH wave propagation in a piezoelectric/piezomagnetic plate with an imperfect magnetoelectroelastic interface

In this paper, we investigate the SH wave propagation in a layered piezoelectric (PE) and piezomagnetic (PM) plate with an imperfect magnetoelectroelastic interface. A linear magnetoelectroelastic spring model is used to describe the weakness of the imperfect interface. On the basis of this model, dispersion curves and mode shapes of the SH waves are computed. In particular, a PZT-5A/CoFe₂O₄ composite plate is considered in the numerical examples to calculate the dispersion curves and the mode shapes for different combinations of the magnetic, electrical and elastic spring constants. The effects of the layer thickness ratio and the electric-magnetic boundary conditions on the dispersion curves are discussed in details. Our results show that for a general weak bonding case, the high modes of the dispersion curves are not monotonous in the range of small wave numbers. With the layer thickness ratio increasing, the wave velocities of the SH waves increase. The electric boundary conditions mainly determine the dispersion curves of the SH waves in the case of a small layer thickness ratio, i.e. a large thickness of the PE layer. The present results have relevant applications in the nondestructive testing and evaluation of the layered PE/PM plate-like wave devices.     

Broadband continuum generation in an irregularly multicore microstructured optical fiber

A broadband continuum generation is reported in a novel multicore microstructured optical fiber (MOF) where irregular air holes are randomly distributed in cladding. By launching ultrashort light pulses from a Ti:sapphire laser into a 190-mm-long fiber of this type, we have observed a group of continua generated from different cores, each with distinct color. 20-dB bandwidth of the broadest continuum is 1260 nm with an average power of 143 mW. The result confirms that the multicore MOF can be fabricated, with different dispersion profiles tailored for specific supercontinuum (SC) generation towards practical applications.     

固体板中SH板波非线性效应的实验观察

采用微扰近似和导波的模式展开分析方法,从理论上简要分析了SH板波的二次谐波发生效应;尽管在无限大固体介质中单个切变波的二次谐波发生效应非常微弱,但在一定条件下由两个切变波构成的SH板波可具有强烈的非线性效应;本文的主要工作就是对此结论加以实验验证。试制了激发SH板波的切变波斜劈换能器和接收二次谐波信号的液体斜劈换能器,建立了非线性SH板波的实验研究系统;通过详细的理论分析和对比实验研究,阐明了在一定条件下实验观察到的显著二次谐波信号来源于SH板波传播过程中的强烈非线性效应。此外,针对不同的SH板波传播距离,在远场条件下分别测量了相应的二次谐波幅频曲线;在基频SH板波与二倍频对称兰姆波相速度相等所对应的频率值附近,分析了二次谐波的振幅随传播距离的变化关系,结果证明在一定条件下SH板波的二次谐波振幅可随传播距离积累增长,即SH板波可具有强烈的非线性效应。     

一种分析周期加筋板声辐射的高效方法

为了研究周期加筋板的声辐射特性,建立了一种计算水中周期加筋板在简谐点力作用下的远场辐射声压的高效方法。该方法借助于傅里叶变换法只要先将耦合系统的声振方程,加强筋的弯曲和扭转运动方程,声学波动方程和耦合边界条件转换到波数域中,联合求解得到一组关于平板横向位移的无限大耦合代数方程组,再将该方程组截断成有限大小由数值方法求出波数域中的位移响应,便可结合稳相法得到远场辐射声压。与现有方法给出的结果对比发现二者完全吻合,验证了本文方法的有效性;通过数值方法研究了激励力位置、板厚,加强筋间距和宽度对周期加筋板声辐射特性的影响,得到了具有实际意义的结论。