Search for ferromagnetism in ultrathin epitaxial films: Cr/Au(100), Cr/Cu(100), and Fe/Cu(100)

The surface magneto-optic Kerr effect (SMOKE) technique was used to search for ferromagnetism in monolayer-range films of Cr and Fe grown on Au(100) and Cu(100). The growth modes were characterized using low energy electron diffraction (LEED) and Auger electron spectroscopy. The fcc structure of Cr could not be stabilized on Cu(100). Ferromagnetism was not observed for the Cr/Au(100) films at temperature above 100 K. Ferromagnetism also was not observed for fcc Fe/Cu(100) grown at room temperature; but for growth at >150°C, a ferromagnetic, metastable state was observed for the top layer of the Fe film, in the absence of bulk ferromagnetism. The ferromagnetic Fe/Au(100) system was used to establish the sensitivity of the approach.     

Chemisorption of CO on Cu(100), Ag(110) and Au(110)

The adsorption of CO on Cu, Ag and Au is studied using core and valence photoemission, X-ray absorption and autoionization of core excited states. The purpose is to investigate the nature of the adsorption bond starting out from the well-established chemisorption system CO/Cu(100)-c(2 × 2), and from the results we suggest that CO forms chemisorbed phases also on Ag(110) and Au(110). The photoemission spectra show strong shake-up satellites both for the valence levels and the core levels. The separation to the satellite appearing closest to the main line is observed to follow the position of the substrate d-band relative to the Fermi level. The CO adsorption strength for the noble metals is deduced to decrease in the order Cu-Au-Ag. This is based on the widths of the XA resonances, which are related to the adsorbate-substrate interaction strength of the core excited states, and the relative shake-up intensities, which are expected to increase with a decreasing adsorption strength in the ground state. The same trends regarding the shake-up intensities are observed both for the valence and core levels.     

Oxygen adsorption on Cu3Au(100) above 350 K

The initial stage of oxygen adsorption on Cu₃Au(100) above 350 K has been investigated using Auger electron spectroscopy. In the temperature range 350–550 K the adsorption isotherms tend to saturate at levels which increase with temperature. Initial sticking coefficients in this temperature range are at least an order of magnitude less than those on Cu(100) and saturation levels vary from ? 5% of a monolayer at 350 K to ? 15% of a monolayer at 550 K. As the temperature is increased to within 100 K of the bulk order-disorder transformation, the rate of adsorption increases dramatically accompanied by apparent adsorption-induced rearrangement of the alloy surface. The degree of annealing following Ar⁺ bombardment is observed to affect the initial uptake of oxygen throughout the entire temperature range.     

Oxygen induced surface segregation of Cu on the Au0.7Cu0.3(100) surface

The oxygen induced surface segregation of Cu on the Au_0.7Cu_0.3(100) surface was investigated by means of LEED and AES techniques. The dissociative adsorption of O₂ did not take place on this clean surface for a long time exposure at least up to 10⁴ L, and so the oxygen was forcibly introduced onto the surface through a pre-deposition of few a layers of Cu and its successive oxidation. The oxygen coverage was controlled by a heat treatment, which leads the system to a thermal equilibrium state. For the clean surface, the segregation of Au was clearly observed and the surface concentration of Au was estimated to be about 86%, greater than the bulk concentration of 70%. At low coverages below 0.16 ML, no remarkable oxygen induced segregation of Cu was observed. But, above 0.2 ML, the surface concentration of Cu was proportional to the oxygen coverage. The (2 × 4) LEED pattern was observed in a wide range of oxygen coverage. The maximum intensity of the (2 × 4) was observed at about 0.45 ML.     

Cu(100),(111),(110)表面晶格振动和力常数

采用嵌入原子方法得到了描述Cu基态相互作用性质的半经验函数;推导了表面面间力常数的计算公式,并计算了Cu(100),(111),(110)表面面间力常数,由此揭示了原子间相互作用在体内和在表面附近的区别,以及它们在不同表面结构中的差异。采用递推方法计算了相应的表面振动的投影态密度,与电子能量损失谱(EELS)所得到的实验结果符合得较好。 关键词：     

Comparative study of the electronic structure of the ordered and disordered Cu3Au (100) and Cu3Au (110) surfaces

The influence of structural changes on the electronic structure has been investigated by a comparison of the angle-integrated valence and core level photoelectron spectra of ordered and disordered Cu₃Au(100) and (110) surfaces. The total width of the Au 5d and Cu 3d bands does not change with the ordering state or surface orientation. The spectra for the (100) surface are compared with selfconsistent calculations and good agreement is found, for the ordered state, however with a 0.6 eV correction of the calculated Fermi level position. We observe three Au 5d derived bands at 5.1, 6.0 and 6.9 eV, in contrast to previous experimental findings. Our results indicate the existence of shortrange order above the critical temperature.     

On the Auger-photoelectron coincidence spectroscopy spectra of Cu(100), Cu metal and CuOx/Cu surface

The M₃–VV Auger-photoelectron coincidence spectroscopy (APECS) spectrum of Cu(100) and the L₃–VV APECS spectra of Cu metal and CuOx/Cu surface are analyzed in detail. The narrowing and energy shift of the photoelectron line in the M₃–VV APECS spectrum is well predicted by the present theory. The spectrum shows the presence of the M₂–M₃(V)–VV(V) decay in which a hole in the 4s band hops away prior to the decay of M₃ hole. The analysis of the L₃ photoelectron spectra of Cu metal measured in coincidence with the ³F or ¹G Auger line raises a question concerning the presence of two different core–hole states upon the L₃ level ionization recently proposed by Thurgate and Jiang [Surf. Sci. 466 (2000) L807]. The analysis of the L₃–VV APECS spectrum of CuOx/Cu shows that the final-state charge–transfer interaction plays an important role in CuO.     

Shell‐isolated nanoparticle enhanced Raman spectroscopy (SHINERS) investigation of benzotriazole film formation on Cu(100), Cu(111), and Cu(poly)

Benzotriazole (BTAH) is well known as an effective corrosion inhibitor for Cu because of its ability to make a coordination polymer film on the surface that provides a barrier to Cu oxidation. BTA⁻ film formation was investigated on single‐crystal and polycrystalline Cu surfaces with shell‐isolated nanoparticle enhanced Raman spectroscopy (SHINERS) using silica‐encapsulated Au nanoparticles. Potential‐dependent spectra display reversible film formation on polycrystalline Cu and irreversible film formation on single‐crystal Cu. Grain boundaries leading to smaller BTA⁻‐Cu oligomers are proposed to be the reason for cathodic degradation of the BTA⁻ polymeric films on polycrystalline Cu. Copyright © 2011 John Wiley & Sons, Ltd.     

Relaxation and electronic states of Au(100), (110) and (111) surfaces

Using a first-principles method based on density functional theory, we investigate the surface relaxation and electronic states of Au(100), (110) and (111) surfaces. The calculated results show that the relaxations of the (100) and (110) surfaces of the metal are inward relaxations. However, the Au(111) surface shows an ‘anomalous’ outward relaxation, although several previous theoretical studies have predicted inward relaxations that are contrary to the experimental measurements. Electronic densities of states and the respective charge density distribution along the Z-axis of the relaxed surfaces are analyzed, and the origin of inward and outward relaxation is discussed in detail.     

Electron energy loss spectroscopy of the vibration modes of water on Ag(100) and Ag(115) surfaces and comparison to Au(100), Au(111) and Au(115)

Motivated by rather similar behavior of the Helmholtz capacitances of stepped Au(11n) and Ag(11n) electrodes we have extended a previous study on the vibration spectrum of water adsorbed at low temperatures on stepped gold surfaces to Ag(100), Ag(115) and Au(111) surfaces. On Ag(100) surfaces, the spectra show the presence of the typical H-bonded network of water molecules. The rather weak intensity, the absence of non-hydrogen bonded hydrogen atoms, the similarity to the infrared spectrum of ice crystallites, and the increase in the angular spread of the elastic peak are indicative of adsorption in form of three-dimensional clusters. This is stark contrast to Au(100) and Au(111) where the spectra match to a model involving stacks of water bilayers. The low coverage spectra on Ag(115) resemble the results on Au(115): A considerable fraction of the H-atoms remains in the non-H-bonded state and spectral features of water adsorbed at step-sites are identified. The first layer of water on Ag(115) surfaces should therefore have a similar structure as recently proposed in a theoretical study concerning water on Au(115). For larger doses, the experimental results on Ag(115) suggests the formation of three-dimensional clusters. This is contrary to Au(115) where the layered structure with a constant fraction of non-hydrogen-bonded H-atoms persists at higher doses.     

Bulk,surface and thermal effects in inverse photoemission spectra from Cu(100), Cu(110) and Cu(111)

We have performed a study of empty electronic bulk and surface states on the three low indexed copper surfaces employing momentum resolved inverse photoemission. The bulk electronic features may be well understood in the frame work of the bulk direct transition model using state of the art band structure calculations. Surface states of both, the crystal derived and the image potential induced type have been identified and were found to agree with previous work. Several radiative transitions into unoccupied bands were also investigated at elevated temperatures. Characteristic temperatures of an exponential attenuation law are distinctly different between surface and bulk transitions. However, no systematic behaviour of bulk transitions at different points of the Brillouin zone could be established.     

Relativistic oscillator strengths for some transitions in Cu(I), Ag(I) and Au(I)

Relativistic oscillator strengths have been calculated for transitions in the principal, sharp and diffuse series of Cu(I), Ag(I) and Au(I) spectra. The computations have been performed by employing a semiempirical method which includes exchange and core-polarization effects. A comparison is presented for the calculated ?_ik values with experimental and other theoretical data. The influence of core-polarization effects on oscillator strengths is discussed.