Spectral polarization-dependent loss of cascaded long-period fiber gratings

We have measured the spectral polarization-dependent losses of cascaded long-period fiber gratings composed of single, double, and triple identical gratings and fabricated by exposure of a UV laser beam on one side of a fiber. The measurement was made by use of the Mueller matrix method for scanning the wavelength of the incident beam. The polarization-dependent loss was dramatically increased as the number of cascaded gratings was increased. The formation of the UV-induced geometric birefringence in the fiber grating and its relationship to the fine interference fringes formed by cascading gratings are discussed.     

Switchable multi-wavelength erbium-doped fiber ring laser based on cascaded polarization maintaining fiber Bragg gratings in a Sagnac loop interferometer

A switchable multi-wavelength erbium-doped fiber (EDF) ring laser based on cascaded polarization maintaining fiber Bragg gratings (PMFBGs) in a Sagnac loop interferometer as the wavelength-selective filter at room temperature is proposed. Due to the polarization hole burning (PHB) enhanced by the PMFBGs, stable single-, dual-, three- and four-wavelength lasing operations can be obtained. The laser can be switched among the stable single-, dual-, three- and four-wavelength lasing operations by adjusting the polarization controllers (PCs). The optical signal-to-noise ratio (OSNR) is over 50 dB.     

Tunable dual-wavelength fiber laser based on a single fiber Bragg grating in a Sagnac loop interferometer

We propose a simple dual-wavelength Er-doped fiber laser configuration based on a dual-wavelength fiber Bragg grating written on the splice joint between two different fibers for wavelength-selective filter in the Sagnac loop interferometer. The wavelength separation between the adjacent lasing wavelengths is 1.12 nm and the side-mode suppression ratio (SMSR) is over 55 dB. The output power variation is less than 0.8 dB over a two-minute period. Moreover, the lasing wavelength can be effectively tuned using the thermal heating method.     

Electro-optical fiber modulation in a Sagnac interferometer

The linear electro-optical effect was induced in optical fibers by thermal poling. A Sagnac all-spliced fiber loop was constructed incorporating an electro-optical fiber used as a phase modulator at 1.5 microm and stable switching was obtained. A rise time of approximately 40 ns was obtained, and signals <2 V generated a measurable optical response.     

Analysis of a Sagnac interferometer with low-birefringence twisted fiber

The fiber Sagnac interferometer of low birefringence and twist is analyzed numerically in the linear region. A novel method for measurement of the birefringence of the fiber and the angle of rotation of the axes inside the fiber loop of the interferometer is also presented.     

Temperature independent torsion sensor using a high-birefringent Sagnac loop interferometer

A high-birefringent (Hi-Bi) Sagnac loop interferometer for torsion measurement is demonstrated. The sensing head is formed by a section of standard single mode fiber spliced between the output ports of a Hi-Bi coupler at 3 dB. The sensing configuration is characterized in torsion, temperature and strain. The results obtained indicate the viability of a torsion sensor independent of the temperature and strain cross-sensitivity effects. Additionally, in the proposed configuration all measurements are performed without the need of a polarization controller, a device most often required in standard Sagnac loops applied for sensing.     

Detection of ultrafast phenomena by use of a modified Sagnac interferometer

We describe a time-division interferometer based on the Sagnac geometry for monitoring ultrafast changes in the real and the imaginary components of the refractive index as well as phase changes that are due to surface displacement. Particular advantages of this interferometer are its simple common-path design and operation at normal incidence with a microscope objective for both pumping and probing. Operation is demonstrated by detection of temperature changes and coherent phonon generation in a gold film.     

Signal-to-noise ratio of ultrashort pulses enhanced by a fiber Sagnac loop

A method to enhance the signal-to-noise ratio of ultrashort pulses is presented with picosecond pulses as an example. Numerical simulation and analysis show that the signal-to-noise ratio can be improved by four orders of magnitude using a fiber Sagnac loop with two different fibers. It is also found that there is an optimal length of the fiber for improving the signal-to-noise ratio. This is a useful method for improving the signal-to-noise ratio of the seed light in the chirped pulse amplification (CPA) or optical parametric chirped pulse amplification (OPCPA) systems.     

Switchable dual-wavelength erbium-doped fiber-ring laser based on one polarization maintaining fiber Bragg grating in a Sagnac loop interferometer

A switchable erbium-doped fiber-ring laser providing dual-wavelength outputs with orthogonal polarizations when operating at room temperature is proposed. One polarization-maintaining fiber Bragg grating (PMFBG) in a Sagnac loop interferometer is used as the wavelength-selective filter. Due to the enhancement of the polarization hole burning (PHB) by the PMFBG, the laser can be designed to operate in stable dual-wavelength or wavelength-switching modes with a wavelength spacing of 0.336 nm at room temperature by adjusting a polarization controller (PC). The optical signal-to-noise ratio (OSNR) is over 42 dB. The amplitude variation over 90 min is less than 0.6 dB for both wavelengths.     

Measurement of the chromatic dispersion of an optical fiber by use of a Sagnac interferometer employing asymmetric modulation

We describe a novel method, based on asymmetric modulation in a Sagnac interferometer, that measures the chromatic dispersion of single-mode fibers. The interferometer incorporates a phase modulator and a test fiber, so the dispersion can be determined from the interference fringe seen when a sweep rf signal is applied to the modulator. This technique provides picosecond temporal resolution without the need for any fast diagnostic equipment and is capable of accurately measuring the average dispersion of fibers several kilometers long.     

Performance of a wavelength-tunable erbium-doped fiber laser using a Sagnac interferometer

We experimentally demonstrate a wavelength-tunable erbium-doped fiber laser that is composed of a ring cavity and a single-mode fiber Sagnac interferometer in a new and simple arrangement. We find that the fiber laser output wavelength is tunable by adjusting the filter effect of the Sagnac fiber loop through a fiber polarization controller set there. The quasi-single-wavelength continuously tunable laser outputs could be achieved within some wavelength range. The multi-wavelength laser outputs could also be observed under some appropriate settings of the polarization controller. A theoretical demonstration of the wavelength tunability about the transmission-type Sagnac loop filter has also been achieved using the Jones calculus theory.     

High precision micro-displacement fiber sensor through a suspended-core Sagnac interferometer

A sensing system for micro-displacement measurement based in a suspended-core fiber Sagnac interferometer is presented. The suspended-core fiber characterization was made through the use of an optical backscatter reflectometer, screening its multimodal and birefringent behavior. Its sensitivity to displacement measurements is shown to be due only to birefringence, being that core-cladding mode coupling is negligible. High precision (～0.45 μm) was obtained using three different measurement instruments, showing an extremely high stability and high insensitivity to temperature, demonstrating that the sensing system has the ability for low cost applications.     

Autocorrelation of the polarization-dependent loss in fiber routes

We study the spectral properties of polarization-dependent loss (PDL) in fiber routes with multiple spans and amplifiers. In these systems, PDL stems from a small number of lumped WDM components interconnected by PDL-free fibers, a configuration that is poorly described by the popular model of distributed PDL. We derive transparent and practical analytical expressions for the autocorrelation functions of the PDL vector and of the square PDL magnitude and show that they are strongly affected by the order of the individual PDL elements.     

Comparisons of multi-wavelength oscillations using Sagnac loop mirror and Mach-Zehnder interferometer for ytterbium doped fiber lasers

A multiwavelength Ytterbium-doped fiber ring laser operating at 1030 nm region is demonstrated using a Sagnac loop mirror and a Mach-Zehnder interferometer. We report the Performance comparisons of multi-wavelength oscillations in Yb³⁺ doped fiber lasers (YDFL) with typical commercial ytterbium doped silica fibers. By adjusting the polarization controller (PC), a widely tunable laser range of 22 nm from 1030 nm to 1050 nm is obtained. The Mach-Zehnder interferometer (MZI) design has exhibited simplicity in the operation for controlling the smallest wavelength spacing compared to Sagnac loop mirror method. In our observations, the smallest achieved stable wavelength spacing in Sagnac loop mirror setup and MZI setup were 2.1 nm and 0.7 nm, respectively. In case of nine-wavelength operation with a MZI setup, the stability, Full Width at Half Maximum (FWHM) and side mode suppression ratio (SMSR) of laser lines are not affected by increasing pump power, While for above four wavelength operation, the laser stability with Sagnac loop mirror becomes worse specially for higher input pump power and the power fluctuation among the wave-lengths would be also slightly larger.     

Multi-wavelength fiber laser in single-longitudinal mode operation using a photonic crystal fiber Sagnac interferometer

In this paper, we report a new configuration of a tunable multi-wavelength erbium-doped fiber laser based on the commercial optical multiplexers and a Sagnac interferometer which includes a section of a high-birefringent photonic crystal fiber. Four-wavelength laser emission lines were obtained simultaneously in single-longitudinal mode operation showing a power instability lower than 1 dB, and an optical signal-to-noise ratio higher than 65 dB for all the emitted wavelengths. This proposed configuration allows the individual control of the loss of each channel of the laser and because of it is based on the commercial ITU-grid multiplexers, the laser is adapted to the telecommunications channel’s normative.     

光纤Sagnac干涉仪中单光子干涉及路由控制

介绍一种光纤中稳定的单光子干涉以及单光子路由控制方式. 使用Sagnac单光子环形干涉仪，通过分时相位调制，改变其顺时针和逆时针两路光子间的相位差. 在Sagnac单光子环形干涉仪中，顺时针和逆时针两路光子走过的是同一段光纤，简便有效地补偿了光纤长度随时间缓变带来的相位涨落，而且两路光子经历了相同的偏振模色散，较好地抑制了偏振态波动对单光子干涉的影响. 在长达5km的1550nm单模光纤中，获得大于98%的单光子干涉和大于90%单光子路由控制；在长度为27和50km光纤环路中，分别获得大于94%和84%单 关键词： 单光子路由 单光子干涉 Sagnac单光子环形干涉仪 量子保密通信     

Fine adjustment of cavity loss by Sagnac loop for a dual wavelength generation

We experimentally demonstrate a fine adjustment of cavity loss by Sagnac loop for a dual wave-length generation. The single or dual wavelengths are obtained by controlling the losses on both cavities through a fiber optical loop mirror (FOLM). Wavelength separation on the dual laser is 0.98 nm. The dual or single wavelength is obtained by changes in temperature in the order of 10⁻¹°C around the maximum in the FOLM. Also, we investigate energy fluctuations on signal level saturation effect in the cavity through different pumping power that act on the EDF, where we note that from the 60-mW pumping begins to generate dual-wavelength and 80-mW stabilizes.     

Period-generating different modulation formats by inserting an electro-absorption modulator in a Sagnac fiber loop

Period-generating different modulation formats are presented using an electro-absorption modulator (EAM). The configuration is based on a Sagnac loop interferometer containing an EAM, a polarization controller and a time delay line. Different modulation formats are obtained by modulating the clockwise and counterclockwise propagating waves inside the Sagnac loop. The theoretical analysis is also obtained. Measured results demonstrate period-generating different modulation format by tuning the time delay line.     

Curvature measurement by using low-birefringence photonic crystal fiber based Sagnac loop

An optical fiber curvature sensor with low-birefringence photonic crystal fiber (PCF) based Sagnac loop is demonstrated experimentally. The low-birefringence PCF of about 40 cm long is inserted into Sagnac loop, and a section of it about 155 mm is used as the sensing element. The Sagnac output spectra under different curvatures are measured and analyzed. The results show that the wavelength shift of the transmission dip has a linear relationship with the curvature. The sensitivity of the curvature measurement of − 0.337 nm is achieved in the range of 0-9.92 m^− 1. And the temperature effect of the proposed sensor is also analyzed.     

Mach-Zehnder interferometer formed in a photonic crystal fiber based on a pair of long-period fiber gratings

We demonstrate implementation of an all-fiber Mach-Zehnder interferometer formed in a photonic crystal fiber (PCF). We formed the all-PCF Mach-Zehnder interferometer by mechanically inducing two identical long-period fiber gratings (LPGs) in the PCF. The spectral properties of a LPG and a LPG pair were investigated. The interference fringe formed within the stop band of the LPG pair varied with the period and the strength of the gratings, and the fringe spacing was decreased with increasing grating separation. From the fringe spacing measurement the differential effective group index of the PCF was calculated to be deltam approximately equal to 2.8 x 10(-3).