Q-switching of a diode cladding-pumped Erbium Fibrelaser at 2.7 μm

Reliable Q-switched operation of a cladding-pumped 2.7m ZBLAN fibre laser in the range of the power limit of self-destruction is shown for the first time. The laser is pumped by a multimode diode. Q-switching is achieved by two different techniques: a rotating mirror and an acousto-optical modulator. Pulse widths of 500ns with the rotating mirror and 300ns (FWHM) with the acousto-optical modulator and pulse energies in the J range are achieved.     

Light absorption in laser-heated cavities

The absorption of laser light in 0.25–1 mm diameter gold cavities, irradiated for the purpose of generating high-temperature blackbody radiation with intense laser radiation of either =0.44 m or =1.3 m wavelength, was investigated. For =0.44 m radiation the absorption exceeded 0.9 for all conditions, but dropped to only 0.3 for the smallest cavities irradiated at =1.3 m. Entrance hole and cavity filling with plasma seems important for the understanding of the observations.     

The refractivity of CO2 gas in the region of 10 μm

The refractivity of the CO₂ gas is measured with an experimental error of 2% in the 10-m region, using 10.4-m band CO₂ laser line. The frequency of the CO₂ laser is swept through the Doppler profile of the laser line. The experiment is achieved using a 0.63-m He–Ne/10.6-m CO₂-laser interferometer with a 2-m long vacuum cell. From the result, it is found that the Koch's formula also holds for the wavelengths in the 10-m region within an accuracy of 2%.     

En">Characters and Composition Factor Multiplicities for the Lie Superalgebra $${\mathfrak{g}}{\mathfrak{l}}$$ ( m / n )

The multiplicities a of simple modules L in the composition series of Kac modules V lambda for the Lie superalgebra (m/n ) were described by Serganova, leading to her solution of the character problem for (m/n ). In Serganova's algorithm all with nonzero a are determined for a given this algorithm, turns out to be rather complicated. In this Letter, a simple rule is conjectured to find all nonzero a for any given weight . In particular, we claim that for an r-fold atypical weight there are 2r distinct weights such that a = 1, and a = 0 for all other weights . Some related properties on the multiplicities a are proved, and arguments in favour of our main conjecture are given. Finally, an extension of the conjecture describing the inverse of the matrix of Kazhdan–Lusztig polynomials is discussed.     

Optical tuning of a tellurium cavity: optical modulation and bistability in the infrared region at room temperature

A new optical-optical modulator for the infrared region (4m < < 11m) is described. It is based on the tuning of the transmission of a plane parallel tellurium slab by free carriers created by multiphoton absorption of 10.6m and 5.3m radiation at room temperature. The operation of this device is described by a simple theory using the plane-wave approximation and the Drude-Zehner model. The assumptions of this theory were fulfilled by the experimental conditions, permitting a quantitative analysis of the registered modulations. Under certain working conditions pulse shortening (170 ns pulses of=5.3m were shortened by up to 20 ns) and fast switch-on of the device (switch-on time 2 ns) were observed. Moreover, the modulator exhibits limiter action and optical bistability which, for the first time, is observed in an intrinsic semiconductor device at room temperature.The substance of this paper was presented at the Conference on Ultrafast Phenomena in Spectroscopy at Reinhardsbrunn (GDR), in November 1980, and a preliminary account published in theProceedings of the meeting.     

A DCN laser interferometer for electron density measurements of plasmas

The main characteristic of this interferometric system is such that the systems can be used for DCN laser (=195m, 190m) and also for HCN laser (=337m) by changing the work medium, regulating the temperature of tube wall and adjusting the optic path, without changing any optic element.     

An Approach to Linear Scalable DH-PHEMT Model for Millimeterwave Application

This paper describes a scalable small-signal equivalent circuit for 0.25 m gatelength Double Heterojunction delta-doped PHEMTs. The scaling rules for all elements except the pad capacitances and bondwire inductances have been determined. Good agreement is obtained between simulation results and measured results for 2 times 20 m , 2 times 40 m, 2 times 60 m, 2 times 100 m gate width (number of gate fingers times unit gate width) DH PHEMT.     

Ultrashort far-infrared superradiant emissions optically pumped by truncated hybrid 10 μm CO2 laster pulses

We investigate the generation of superradiant far-infrared 496 m CH₃F pulses and produce for the first time smooth and reproducible 373 m CH₃CN superradiant pulses by pumping with pulses from a hybrid 10 m CO₂ laser truncated within 10 ps by a plasma shutter of new design. Superradiance is confirmed by measurement of the pressure dependence of the intensity, the width and the delay versus the pump pulse. We observe pulse durations considerably under the limit of the inverse linewidth of the transition. Thus, we demonstrate for the first time that rapid truncation of the pump pulse is essential for reducing pulse duration of superradiant far-infrared emissions.     

High efficiency cw far infrared lasers at 119 μm and 127 μm

The optically pumped FIR laser lines at 119 m from CH₃OH and at 127 m from¹³CD₃OH are known to be the most powerful in the far infrared spectral region. We report on efficiency measurements for our waveguide laser system. The effect of various parameters was investigated, resulting in the highest efficiency ever reported for the 119 m line. The Stark effect and others parameters of the 127 m were measured, and a new¹³CD₃OH laser line at 175 m discovered, with the same pump transition. These measurements are helpful for completing the assignment already proposed for the 127 m line.     

Quantization of the Maxwell field in linear conformal invariant gauges

It is shown that the generalized Lorentz gauges provide all linear conformal invariant gauges, i.e. gauges such that A =0.     

Investigation of output parameters of a 4.3-μm longitudinal-discharge CO2 laser

A simple hot-cell-free 4.3-m CO₂ laser with longitudinal d.c. discharge is described and the results of its parametrization are presented. It is shown that for effective operation of the 4.3-m (10° 1-10°0 band) CO₂ laser, use of active mixtures containing 4 to 5% of carbon dioxide with 20% nitrogen is needed. The laser is mechanically Q-switched producing peak powers in excess of 60 W with a pulse duration of 300 ns FWHM. The 4.3-m laser is easily tunable and operates on the P and R branches of the 10°1-10°0 band of CO₂. The peculiarities of spectral performances are discussed.     

Ar ion laser assisted chemical etching of via holes in tungsten sheets in air

Ar ion laser assisted chemical etching of 150 m thick annealed tungsten sheets in air is reported. The material removal mechanism involves local heating by the laser to temperatures in the range of 1000–1500 °C that causes rapid oxidation of the W to WO₃ which volatilizes readily. Holes with straight walls and slightly enlarged entrances near the surface were drilled with etch rates as high as 11.5 m/s at 13.8 W, and a minimum hole diameter of 21 m at 8.1 W. The diameters of the holes and the etch rates were measured and found to increase as a function of the laser power. It was found that by increasing the laser power above 11–12 W, no change was observed in the hole diameters which remained constant at about 31 m, whereas the etch rates continued to increase even faster than at low powers. Distinct adjacent holes of 25 m diameter could be drilled with their centers separated by as little as 60 m. This is therefore also the etching resolution in the present study.     

Gain dynamics of the 4.3 μm CO2 laser

A detailed study of the gain dynamics of the pulsed, optically pumped 4.3 m CO₂ laser is described. Small-signal gain coefficients as high as 14%/cm are measured in a 4.3 m amplifier using low-power pulses from a 4.3 m probe laser. The measurements are compared with a rate-equation model and good quantitative agreement is obtained. The model, which uses no adjustable parameters, is described in detail. Gain is studied as a function of optical pumping power, gas mixture, gas pressure and discharge excitation of the 4.3 m amplifier. Optimization of the gain is discussed.     

Loss in low-finesse Ti:LiNbO3 optical waveguide resonators

We propose to measure the contrast of Fabry-Perot resonances in low-finesse (end face polished) integrated optical resonators to determine an upper limit of the waveguide attenuation coefficient. The method is discussed; its absolute accuracy increases with decreasing loss. As example, experimental results are presented for 3 and 10 m wide Ti: LiNbO₃ strip guides; the attenuation coefficients are 0.46 dB/cm (EH₁₁) in the narrower guide at =0.63 m, respectively 0.19 dB/cm (EH₁₁) and 0.09 dB/cm (HE₁₁) in the 10 m wide guide at =1.15 m.     

Experimental verification of the theory of the successive production of striations in a glow discharge

The properties of the wave of stratification in the plasma of the positive column in a glow discharge in neon are measured. The measurements are compared with the results of the theory of the successive production of striations and good agreement is found.

---

. .

---

---

In conclusion the author thanks M. Novák for help in measuring and evaluating the experimental results, and F. Kroupa and V. Krejí for carefully reading this paper and for valuable remarks.     

The paramagnetic state (μ+e−) in silicon and tellurium at high temperature

The paramagnetic state (⁺e^–) in Si and Te was observed in a longitudinal magnetic field. The mean lifetimes of these states were obtained: _Si = 1.45(3) s, _Te = 12.5(8) s at 290 K, _Te = 12(2) s at 250 K.     

Bone-ablation mechanism using CO2 lasers of different pulse duration and wavelength

Bone ablation using different pulse parameters and four emission lines of 9.3, 9.6, 10.3, and 10.6 m of the CO₂ laser exhibits effects which are caused by the thermal properties and the absorption spectrum of bone material. The ablation mechanism was investigated with light- and electron-microscopy at short laser-pulse durations of 0.9 and 1.8 s and a long pulse of 250 s. It is shown that different processes are responsible for the ablation mechanism either using the short or the long pulse durations. In the case of short pulse durations it is shown that, although the mineral components are the main absorber for CO₂ radiation, water is the driving force for the ablation process. The destruction of material is based on explosive evaporation of water with an ablation energy of 1.3 kJ/cm³. Histological examination revealed a minimal zone of 10–15 m of thermally altered material at the bottom of the laser drilled hole. Within the investigated spectral range we found that the ablation threshold at 9.3 and 9.6 m is lower than at 10.3 and 10.6 m. In comparison the ablation with a long pulse duration is determined by two processes. On the one side, the heat lost by heat conduction leads to carbonization of a surface layer, and the absorption of the CO₂ radiation in this carbonized layer is the driving force of the ablation process. On the other side, it is shown that up to 60% of the pulse energy is absorbed in the ablation plume. Therefore, a long pulse duration results in an eight-times higher specific ablation energy of 10 kJ/cm³.     

Strong far-infrared laser action in carbonyl fluoride and vinyl fluoride

Intense far-infrared laser action is reported for carbonyl fluoride and vinyl fluoride. Eleven new lines with wavelengths between 339 m538 m were obtained by optically pumping carbonyl fluoride with numerous lines of the 10.4 m band of a cw CO₂ laser. Twenty-three lines with wavelengths in the range 172 m783 m were detected when pumping the recently discovered efficient FIR laser molecule vinyl fluoride. In addition, three very weak new lines were found using 1.1-difluoroethylen.     

Probability of predissociation of mesic molecules HμHe

The probability of predissociation of the HHe mesomolecules has been calculated for different hydrogen and helium isotopes. It is shown, that for pHe molecules the predissociation is the main channel for mesomolecular decay, while for tHe mesomolecules the main channel is a radiative decay. The KEK data on the relative smallness of the yield of -quanta from the radiative decay of mesomolecules d³He as compared with d⁴He can be explained if one takes into consideration the mesomolecular predissociation channel and the difference in their production rate.     

Time-resolved measurements of picosecond optical breakdown

Picosecond optical breakdown was investigated in order to assess its potential for performing highly localized incisions for laser surgery. Measurements of breakdown were performed using single 40-ps Nd: YAG laser pulses in distilled water. Novel optical pump-probe techniques were developed to characterize the transient spatial and temporal dynamics of the plasma, shock wave, and cavitation phenomena which are associated with the breakdown. The maximum cavity radius and the shock wave zone are shown to scale as the cube root of the pump pulse energy over almost three orders of magnitude. For pulse energies close to the threshold energy of 8 J, the shock range was 100–200 m and the cavity radius was 140 m. Complementary experiments were performed with 10-ns pulse durations. Since picosecond pulses have high peak intensities with low pulse energies, a significant enhancement in localizability may be achieved. The implications for ophthalmic microsurgery are discussed.