微型扬声器振动系统阻尼频率特性研究

受材料黏弹性的影响,微型扬声器振动系统的力阻与频率有关。通过理论推导建立了力阻与频率之间的模型,得到了微型扬声器振动系统力阻的计算公式,利用激光测振法测量得到的微型扬声器阻抗曲线和位移曲线可以方便地得到微型扬声器振动系统力阻频率响应,表明了其随频率增加而减小的频率特性。实验表明,采用该频率相关力阻模型计算阻抗曲线、位移曲线和频率响应曲线,与测量值吻合很好,明显好于传统频率非相关力阻模型所得曲线。     

依据扬声器的力学性质拓展其低频响应的电路原理初探

本文阐述了在低频段闭箱上扬声器轴向远场声压频平坦时，分别作用于扬声器阻尼，质量和弹性三元件上的力，以及这三个力与频率的关系以及这三个力间的相位关系，根据这些关系，提出了一种处理声频信号电压的电路原理，该电路将声频信号电压处理为分别上述作用于三元件上的力相对应的三个信号电压，这三信号电压相加后，再馈于扬声器，可拓展其低频响应。     

使用噪声整形的多比特数字扬声器系统

本文讨论了ＰＣＭ数字式换能器的特点，采用了过采样和噪声整形技术对比特数字扬声器系统进行改进，给出了计算机模拟结果。     

微型扬声器摆动模态对其辐射声场的影响*

与传统电动式扬声器单元相比,微型扬声器单元由于缺少定位支片等部件,更容易受到摆动模态的影响。该文利用激光传感器采集微型扬声器单元振膜各点振动位移,通过理论计算,从辐射声压级、辐射指向性等角度探究矩形微型扬声器单元摆动模态对其辐射声场的影响。经过研究发现,摆动模态会造成微型扬声器单元频响凹陷、中低频存在指向性等现象,对其辐射声场产生明显的影响。     

平板扬声器立体声重放的振动对比度控制方法*

利用激振器阵列通过振动对比度控制方法实现了在平板扬声器上重放立体声的声源局域化控制。首先利用激振器到测量点的导纳函数,最大化辐射区和整个平板振动区域的平均动能比值得到阵列的最优空间滤波器。然后分别计算最大化左右声道辐射区和整个振动区域平均动能比值的最优滤波器。最后将立体声信号分别通过对应辐射区最优滤波器滤波相加后,馈给激振器阵列激励平板在两辐射区辐射对应声道的信号。利用8个激振器控制0.48 m长、0.27 m宽、0.001 m厚铝板,在100 Hz～2000 Hz范围内,振动对比度的均值为12 dB。因此该方法可以获得较好的局域化控制效果,进而可以将左右声道的声源局域在平板扬声器的两侧。     

对力学非线性和磁场非线性综合作用下扬声器低频跳变的探讨

力学非线性和磁场非线性是扬声器非线性现象的两个因素。本文分析了仅力学非线性的扬声器低频振动方程的临界跳变条件，采用等效线性化法讨论了磁场非线性对扬声器跳变的影响。证实了抑制扬声器跳变的有效途径是增大电磁耦合因子B1。     

改进的5.1通路环绕声三扬声器虚拟重发系统

提出一种改进的5．1通路环绕声的三扬声器虚拟重发系统。本文首先指出,现有的两扬声器虚拟重发存在听音区域窄、声像稳定性差等缺陷。通过理论分析和心理声实验证明,采用一对布置在前方±30°的全频带扬声器和一个前方0°的高频中置扬声器组成5．1通路环绕声虚拟重发系统,不但可提高重发声像的稳定性,且扬声器布置实际可行,信号处理相对简单。因此所提出的虚拟系统及其扬声器布置是适合于电视和多媒体计算机的应用。     

磁流体扬声器特性的分析

本文分析了磁流体扬声器的特性并给出一些实验结果.磁流体可以提高扬声器的功率容量,防止音圈过热损坏.磁流体扬声器的输入电功率在音圈温度相同的条件下,比同类普通扬声器可以提高2倍多,从而增加了扬声器的声压灵敏度.磁流体的粘滞性具有阻尼音圈振动的作用,它改善了扬声器的频响,降低瞬态畸变.文中还讨论了磁流体扬声器设计中应注意的问题.     

参量阵扬声器在管道噪声控制中的研究*

为了解决管道有源噪声控制中声反馈造成的系统复杂度和计算量的增加,文中引入参量阵扬声器作为次级声源,利用其强指向性减小控制系统的声反馈。为了验证该方法可行性,本文分别在直管和L管中,对600 Hz单频噪声和频率范围为500 Hz~1000 Hz的窄带噪声进行了管道有源噪声控制,同时测量了参量阵扬声器的管内声场和降噪范围。结果表明,参量阵扬声器声反馈小,在没有声反馈补偿的条件下对单频噪声的降噪效果基本达到了声反馈补偿条件下普通扬声器的降噪效果,对窄带噪声的降噪效果稍差。此外,通过测量管道声场和降噪量,确定了参量阵扬声器的降噪区域为误差传感器下游整个管道,降噪面积为管道整个截面。这说明参量阵扬声器作为次级声源降低了系统的复杂度和算法的计算量,并取得了较好的降噪效果。     

扬声器中涡流的热效应

通过分析和比较两种扬声器涡流电学模型和两种扬声器热模型，提出一种分频段的非线性热模型类比线路，给出了对应的音圈稳态温度公式，并在高频段运用逐点测温的方法研究，论证了扬声器涡流随频率变化的规律及其对扬声器热效应的影响。     

扬声器锥形振膜环反谐振频率的计算

本文在求解扬声器锥形振膜低频振动的基础上,得到了计算扬声器锥壳环反谐振频率的精确公式,并借助特征频率反比于质量平方根的物理概念,推出了适于工程应用的近似公式,其偏差在３％以内。     

Sound radiation of panel-form loudspeaker using flat voice coil for excitation

A novel panel-form loudspeaker in which the panel of the speaker is excited by the forces generated through the flat voice coil of a rectangular electro-magnetic type exciter for sound radiation is presented. The exciter when properly designed has the advantage of exerting appropriate loads to the panel so that the major sound pressure level (SPL) dips of the speaker can be suppressed or even eliminated. For designing such panel-form speaker, a method formulated on the basis of the classical plate theory (CPT), Ritz method, and first Rayleigh integral is proposed for predicting the SPL curve of the speaker. An experimental investigation was performed to verify the feasibility of the proposed method. The effects of some system parameters on the major SPL dips of the proposed panel-form speakers are investigated by means of several numerical examples. The optimal locations of flat voice coils for exciting several panel-form speakers are determined to illustrate the important role of excitation location for enhancing sound quality of such speakers via the removal or suppression of the major SPL dips.     

An analytical model for a dodecahedron loudspeaker applied to the design of omni-directional loudspeaker arrays

The dodecahedron (12 sided) loudspeaker is used extensively for acoustic measurements as an approximation to an omni-directional sound source, for example in building acoustics and automotive applications. In many instances its use is favoured above other omni-directional source approximations e.g. open pipe because of its greater power. However, analysis by other authors has shown that the radiation deviates from omni-directional above a certain frequency. In this paper an analytical model of the sound pressure field generated by a dodecahedron loudspeaker is constructed. The sound pressure field generated by the model is then compared with measured data and good agreement is demonstrated. Having established and validated the model, it is adapted to form alternative spherical loudspeaker arrays based on Platonic and Archimedean solid geometry and also a number of spherical packing routines. The aim of the analysis is to determine the optimal geometry for an omni-directional source using pistonic loudspeakers.The analysis shows that constructive interference of the pressure field across the spherical baffle surface and not individual loudspeaker pistonic radiation characteristics is the most significant factor with respect to deviations from omni-directional radiation for a complete spherical array. Consequently, loudspeaker elements which physically occupy the spherical baffle surface to their maximum extent provide the most extended frequency range of omni-directional operation. The most optimal spherical array distribution is shown to be the dodecahedron.     

Transient modal radiation of axisymmetric sources: Application to loudspeakers

The present study proposes a transient model of the acoustic radiation of axisymmetric structures. The pressure field is approximated by the Rayleigh integral corresponding to a monopole source distribution over the non-planar vibrating surface. The displacement field is expanded on the linear modes of the structure and a change of variables in the Rayleigh integral is then proposed in the case of a monotonic profile function to compute the Spatial Impulse Response associated to each mode of vibration efficiently. The results are compared to the formulation obtained in the case of planar and spherical sources. The method of calculation is then derived in the case of a typical loudspeaker profile (association of a truncated cone with a spherical cap). Finally, the present approach is used to estimate the nonlinear radiation pattern of a prototype loudspeaker and predictions are compared to measurements in anechoic room.     

TEM喇叭天线低频辐射分析与天线设计

在超宽带TEM喇叭天线的设计中, 如何改善天线的低频性能是目前研究的关键问题。通过分析天线的阻抗渐变特性与时域辐射特性, 设计了一种新型TEM喇叭天线, 解决了天线末端反射的问题, 提高了天线低频性能。与传统的TEM喇叭天线相比, 新型TEM喇叭天线在全频段减小了方向图后瓣, 提高了低频时天线辐射主轴增益, 拓展了低频带宽。验证实验表明, 该天线带宽为160 MHz~2.5GHz, 180 MHz主轴增益2.3dB, 全频段方向图后瓣小于-2dB, 尺寸为48.5cm×38.1cm×35cm, 同时兼顾了天线的小型化与低频带宽。     

Ultrasonic radiation to enable improvement of direct methanol fuel cell

To improve DMFC (direct methanol fuel cell) performance, a new method using ultrasonic radiation is proposed and a novel DMFC structure is designed and fabricated in the present paper. Three ultrasonic transducers (piezoelectric transducer, PZT) are integrated in the flow field plate to form the ultrasonic field in the liquid fuel. Ultrasonic frequency, acoustic power, and methanol concentration have been considered as variables in the experiments. With the help of ultrasonic radiation, the maximum output power and limiting current of cell can be independently increased by 30.73% and 40.54%, respectively. The best performance of DMFC is obtained at the condition of ultrasonic radiation (30 kHz and 4 W) fed with 2 M methanol solution, because both its limiting current and output power reach their maximum value simultaneously (222 mA and 33.6 mW, respectively) under this condition. These results conclude that ultrasonic can be an alternative choice for improving the cell performance, and can facilitate a guideline for the optimization of DMFC.     

On frequency and temperature dependence of limiting efficiency in direct utilization of quasi-monochromatic radiation

The solution to the problem on limiting (thermodynamically permissible) efficiency η_m of direct conversion of energy of quasi-monochromatic radiation into work known from the literature leads to physically unacceptable results (η_m<0) in the range of small frequencies ν and temperatures T _ν of converted radiation. It is shown that the noted feature is a consequence of the approximate character of the mentioned solution obtained without taking into account background heat radiation: the exact solution obtained for η_m is valid for all ν and T _ν ≥ 0 and turns into the solution known earlier for $\overset{\lower0.5em\hbox{$\overset{\lower0.5em\hbox{ Fiziki, Vol. 70, No. 3, 2000, pp. 34–36.     

黑体辐射公式的量纲分析

量纲分析是研究物理问题的重要方法之一.本文对量纲分析的解题步骤做了梳理归纳,并对于黑体辐射公式进行了量纲分析.