周期排列的电介质小球所诱发的金属-电介质表面上的表面等离子激元的光学性质

研究了金属板的上下表面附近各放置一层按周期排列的电介质小球的体系的光学性质.用多重散射法计算的结果显示金属上侧的周期性排列的电介质小球可诱发金属-电介质表面上的表面等离子激元.这些表面等离子激元的存在可通过非常尖锐的吸收峰反映出来.对于无限厚的金属板，这些吸收峰的峰值位置主要与电介质小球的周期有关，且与解析理论符合得相当好.在有限厚度的金属板中，金属板的两侧表面会产生对称和反对称的两种表面等离子激元，从而使原来在无限厚的金属表面上所出现的单一频率的表面等离子激元劈裂为双频率.由于对称和反对称的表面等离子激元模式在金属板的两侧表面均有相当强的电磁场，因而它们可导致强的电磁波穿透.通过在金属板的下侧加入玻璃球层可将表面等离子激元的电磁场引导出金属，并产生透射波.用多重散射法计算的结果证实，在此体系中由表面等离子激元所引起的透射可达到相当的强度. 对该体系中的物理机理进行了详细分析，从而能够通过调节该体系中的一些参数来控制表面等离子激元出现的频率，使强吸收峰或强透射峰出现在所希望的频率上. 关键词： 表面等离子激元 吸收谱 透射     

The influence of wire shape on surface plasmon mode distribution

The influence of the nanowire shape on the excitation of surface plasmon polaritons at metallic nanowire arrays is studied numerically. For a system of silver nanowires housed on a polymer substrate, nanowires with rectangular and elliptical cross sections are compared. It was found that in the case of rectangular nanowires the excitation efficiency is higher for surface plasmons at the polymer–metal interface than for surface plasmons at the air–metal interface. Conversely, in the case of elliptical nanowires the air–metal plasmon modes are stronger. Further, it is noted that the nanowire shape directly influences the position of the surface plasmon resonance.     

On the propagation characteristics of metal clad waveguides with a quantum well

The electromagnetic modes of planar metal clad dielectric waveguides containing an n-doped quantum well (QW) are studied theoretically. Special attention is paid on the coupling between metal surface plasmons and intersubband plasmons and the manifestation of this coupling in the propagation characteristics of metal/QW/dielectric and multimode metal/QW/dielectric/metal waveguide structures. The results obtained indicate that the modification of the propagation characteristic induced by the above-mentioned coupling is substantial only in the case of metal/QW/dielectric waveguide structures.     

Surface plasmon-polaritons wave fields in the vicinity of a metallic nanohole

It is shown that metal surface with a nanohole can support surface plasmon-polaritons (SPP), whose wave fields are described by Hankel functions. These plasmons can be excited by an electromagnetic wave incident at the metal surface. The optical transmission through subwavelength holes in metal films can essentially be enhanced by interaction of the incident light with surface plasmons. Dependence of excitation of the wave field of SPP on the incidence angle and on the wavelength of incident light is considered.     

损耗对表面等离子体激元压缩态的影响

表面等离子体激元是金属表面电子集体振荡,它以波的形式在金属和介质之间的界面中传播.近期Huck等证明等离子体激元可以处在压缩态,本文利用量子光学的热库理论,研究金波导损耗对表面等离子体激元压缩态的影响,并对Huck等的实验结果给与理论解释. 关键词： 表面等离子体激元 压缩态 热库理论     

Resonant surface plasmons of a metal nanosphere treated as propagating surface plasmons

On the assumption that the resonant surface plasmons on a spherical nanoparticle are formed by standing waves of two counter-propagating surface plasmon waves along the surface, by using Mie theory simulation, we find that the dispersions of surface plasmon resonant modes supported by silver nanospheres match with those of the surface plasmons on a semiinfinite medium-silver interface very well. This suggests that the resonant surface plasmons of a metal nanosphere can be treated as a propagating surface plasmon wave.     

Stimulated emission of surface plasmons in metal-insulator-metal (transition metal type like) structures

Both stimulated emission and absorption of surface plasmons are considered in MIM (transition metal type like) junctions. The net stimulated emission coefficient (the difference between stimulated emission and stimulated absorption) and the dielectric loss (including free carrier) coefficient for surface plasmons in an Mg-Al₂O₃-Ni structure are calculated. Net amplification of the anti-symmetric plasma wave is predicted in the IR wavelength region.     

Enhanced light transmission through a single subwavelength aperture

The optical transmission through a subwavelength aperture in a metal film is strongly enhanced when the incident light is resonant with surface plasmons at the corrugated metal surface surrounding the aperture. Conversely, the aperture acts as a novel probe of the surface plasmons, yielding useful insights for optimizing the transmission enhancement. For the optimal corrugation geometry, a set of concentric circular grooves, three times more light is transmitted through the central subwavelength aperture than directly impinges upon it. This effect is useful in the fabrication of near-field optical devices with extremely high optical throughput.     

Surface plasmon interferometry: measuring group velocity of surface plasmons

Optical transmission spectroscopy on metal films with slit-groove pairs is conducted. Spectra of the light transmitted through the slit exhibit Fabry-Perot-type interference fringes due to surface plasmons propagating between the slit and the groove. The spectral dependence of the period of interference fringes is used to determine the group velocity of surface plasmons on flat gold and silver surfaces.     

Slow surface plasmons in amplifying media and ultrahigh-resolution nonlinear optical microscopy

The technique of ultrahigh-resolution nonlinear fluorescent microscopy based on standing surface plasmons is proposed. On the wavelength of a surface plasmon of 20 nm the expected lateral resolution should be 1–2 nm. Slow surface plasmons with the required mean free path of ～1 m are possible in the planar amplifying medium-metal-dielectric structures due to the compensation of loss in the metal by the amplification in the active medium. In the optical and near infrared range the undamped surface plasmons with the wavelength of 20–50 nm in thin silver films can be obtained at the material gain of active medium of (1–2) × 10⁴ cm ^?1. Possibilities of obtaining this gain in the plasmon structures remain to be seen.     

Dispersion of collective modes at inhomogeneous metal surfaces

A simple model in which electrons are assumed to be specularly reflecting on a plane located a distance u above the boundary of a homogeneous metallic region is proposed for studying dynamical properties of metal surfaces. This model is believed to incorporate essential effects of the inhomogeneity of a pure jellium surface in a new way. It leads to a strong reduction of hydrodynamic dispersion effects for long wavelengths surface plasmons, in agreement with experiment and with various previous calculations. The model is also applied to surface phonons and exact numerical dispersion curves for both surface phonons and plasmons at arbitrary wavelengths are presented.     

Terahertz radiation from interaction between an electron beam and a planar surface plasmon structure

The possibility of an electron beam exciting surface plasmons in conducting metal is discussed in this paper. A planar perfect-structure with subwavelength holes is proposed. The phenomenon that mimicking surface plasmon waves can be excited and amplified by an electron beam is proved theoretically and numerically. The mechanism of transmission through a subwavelength hole array is exploited to enhance the interaction between the electron beam and the mimicking surface plasmons.     

Surface plasmon photodetectors and their applications

Surface plasmon photodetectors are of vigorous current interest. Such detectors typically combine a metallic structure that supports surface plasmons with a photodetection structure based on internal photoemission or electron‐hole pair creation. Detector architectures are highly varied, involving surface plasmons on planar metal waveguides, on metal gratings, on nano‐particles, ‐islands, or ‐antennas, or involving plasmon‐mediated transmission through one or many sub‐wavelength holes in a metal film. Properties inherent to surface plasmons, such as sub‐wavelength confinement and their ability to resonate on tiny metallic structures, are exploited to convey useful characteristics to detectors in addressing applications such as low‐noise high‐speed detection, single‐plasmon detection, near‐ and mid‐infrared imaging, photovoltaic solar energy conversion, and (bio)chemical sensing. The operating principles behind surface plasmon detectors are reviewed, the literature on the topic is surveyed, and avenues that appear promising are highlighted.     

Voltage-Gated Metal-Enhanced Fluorescence

We demonstrate the influence of electrical current on the ability of surface plasmons to amplify fluorescence signatures. An applied direct current across Silver Island Films (SIFs) of low electrical resistance perturbs the fluorescence enhancement. For a given applied current, surface plasmons in just-continuous films are sparsely available for fluorophore dipole-coupling and hence the enhanced fluorescence is gated as a function of the applied current. For thicker, low resistance films, sufficient charge carriers are now present in the metal that metal-enhanced fluorescence (MEF) is perturbed to a lesser extent, induced surface plasmons readily formed on the surface by the close-proximity dipole.     

Self-energy of a charge near a metal surface

A quantum mechanical expression for the self-energy of a charged particle near a metal surface has been derived. The expression incorporates the interaction of the charge with the surface and bulk plasmons including their dispersions in the hydrodynamic model. It is found that the inclusion of the plasmons dispersions gives result for the saturated value of the image potential for copper closer to experiment.     

金属衬底上石墨烯的红外近场光学

对石墨烯/铜体系开展了系统性的近场光学实验研究,成功观测到了区别于铜衬底的、来自石墨烯的近场光学响应信号,发现在表面台阶几何参数相同的铜衬底上的不同石墨烯样品表现出了截然不同的近场光学响应.     

Subwavelength propagation and localization of light using surface plasmons: A brief perspective

Surface plasmons at the metal–dielectric interface have emerged as an important candidate to propagate and localize light at subwavelength scales. By tailoring the geometry and arrangement of metallic nanoarchitectures, propagating and localized surface plasmons can be obtained. In this brief perspective, we discuss: (1) how surface plasmon polaritons (SPPs) and localized surface plasmons (LSPs) can be optically excited in metallic nanoarchitectures by employing a variety of optical microscopy methods; (2) how SPPs and LSPs in plasmonic nanowires can be utilized for subwavelength polarization optics and single-molecule surface-enhanced Raman scattering (SERS) on a photonic chip; and (3) how individual plasmonic nanowire can be optically manipulated using optical trapping methods.     

Hybrid states of Tamm plasmons and exciton-polaritons

We have demonstrated theoretically that it is possible to use the resonant coupling of exciton-polaritons in a planar microcavity and Tamm plasmons at a metal film on the surface of the structure to provide lateral spatial control of the exciton-polaritons within the cavity. The resonant coupling of the Tamm plasmons to cavity exciton-polaritons results in a triplet of hybrid plasmon–exciton-polariton modes with the lowest at a significantly lower energy than that of the unperturbed exciton-polaritons. Further, a patterned metal film on the structure surface can provide a sufficiently large lateral modulation of the excitation energy that localization of the exciton-polaritons within chosen regions of the cavity is possible. We show how the approach opens the way to a practical demonstration of polariton channels, traps, and devices, including logic gates.     

Airy plasmons: non‐diffracting optical surface waves

Airy beams represent an important class of non‐diffracting waves which can be realized on a flat surface. Being generated in the form of surface‐plasmon polaritons, such Airy plasmons demonstrate many remarkable properties: they do not diffract while propagating along parabolic trajectories, and they recover their shape after passing through obstacles. This paper reviews the basic physics of Airy plasmons in both paraxial and non‐paraxial cases, and describes the experimental methods for generation of Airy surface waves on metal surfaces, including a control of their trajectories, as well as the interference of Airy plasmons and hot‐spot generation. Many unusual properties of Airy plasmons can be utilized for useful applications, including plasmonic circuitry and surface tweezers. Picture: Observation of two colliding Airy plasmons.     

Generation and near-field imaging of Airy surface plasmons

We demonstrate experimentally the generation and near-field imaging of nondiffracting surface waves, plasmonic Airy beams, propagating on the surface of a gold metal film. The Airy plasmons are excited by an engineered nanoscale phase grating, and demonstrate significant beam bending over their propagation. We show that the observed Airy plasmons exhibit self-healing properties, suggesting novel applications in plasmonic circuitry and surface optical manipulation.