Pd(PPh3)2Cl2-CuCl2/AC催化乙醇氧化羰化合成碳酸二乙酯

采用浸渍法制备了乙醇直接气相氧化羰化合成碳酸二乙酯的负载型催化剂,并在连续流动固定床反应装置上评价了催化剂的反应活性,考察了催化剂活性组分、载体、活性组分负载量等因素对催化反应活性的影响。结果表明,活性炭是较好的载体,CuCl2是较好的铜盐前驱体,添加了Pd(PPh3)2Cl2的CuCl2/AC催化剂活性更高。当Cu负载量为9.0%,Pd负载量为0.5%时,催化剂的活性较好。在优化的催化剂制备条件下,乙醇的转化率超过30%,碳酸二乙酯（DEC）的选择性达到95%。     

Facile synthesis of glycerol carbonate from glycerol using selenium‐catalyzed carbonylation with carbon monoxide

The commercial production of glycerol has increased considerably for several years, because of its rising inevitable formation as a by‐product of biodiesel. For the effective utilization of glycerol, a new synthesis of glycerol carbonate (4‐hydroxymethyl‐2‐oxo‐1,3‐dioxolane) that is used as solvents and raw material of plastics from glycerol was explored. By combined the selenium‐catalyzed carbonylation of slightly excess of glycerol with carbon monoxide and potassium carbonate under 0.1 MPa at 20°C for 4 h in DMF with the oxidation of resulting selenocarbonate salt with molecular oxygen (0.1 MPa, 20 °C) for 2 h, glycerol carbonate was obtained in good yields (83–84%). However, sodium hydride to form sodium alkoxide in situ lowered the yield of glycerol carbonate. Use of triethylamine, 1‐methylpyrrolidine, and DBU as bases gave poor results. Furthermore, styrene carbonate was obtained in excellent yield (90%) under similar reaction conditions. The catalytic synthesis of glycerol carbonate was also brought about in the mixed gas atmosphere (carbon monoxide:oxygen = 3:1, 0.1 MPa, 20°C). Glycerol carbonate and styrene carbonate were obtained in reasonable yields (197% and 119%, based on selenium used). © 2010 Wiley Periodicals, Inc. Heteroatom Chem 21:541–545, 2010; View this article online at wileyonlinelibrary.com . DOI 10.1002/hc.20640     

New synthesis of glycerol carbonate from glycerol using sulfur‐assisted carbonylation with carbon monoxide

The glycerol carbonate synthesis from glycerol, which is an inevitable by‐product of biodiesel production, was established. By combined sulfur‐assisted carbonylation of glycerol under 1.0 MPa of carbon monoxide at 80°C in DMF with oxidation by copper bromide(II), a facile synthetic method for glycerol carbonate in good yield was developed. © 2010 Wiley Periodicals, Inc. Heteroatom Chem 21:99–102, 2010; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/hc.20583     

An efficient catalytic method for fulvene synthesis

The effects of the nature and amount of base, substrate structure, amount of added water and solvent on the condensation of carbonyl compounds with cyclopentadiene in the presence of secondary amines were investigated. Based on these studies, a new efficient and green synthesis of fulvenes was developed.     

Pd/C: an efficient and heterogeneous protocol for oxidative carbonylation of diols to cyclic carbonate

The present protocol involves highly efficient and practical approach for the synthesis of cyclic carbonate via oxidative carbonylation of diols, glycerol, and its derivatives using Pd/C as a heterogeneous, inexpensive, and recyclable catalyst. The effect of various reaction parameters, such as solvent, base, time, and temperature was investigated and applied for the synthesis of value added cyclic carbonates in a good to excellent yield within shorter reaction time. The developed catalytic system circumvents the use of ligand and dehydrating agent with an additional advantage of palladium catalyst recovery and reuse for up to four consecutive cycles.     

Heterogeneous synthesis of glycerol carbonate from glycerol and dimethyl carbonate catalyzed by LiCl/CaO

In this article, a CaO-based catalyst was prepared by impregnating chloride salts on CaO to develop a highly efficient heterogeneous catalyst for the synthesis of glycerol carbonate (GC) from glycerol and dimethyl carbonate. LiCl/CaO exhibited a high catalytic activity under moderate reaction conditions. The effects of the LiCl loadings, the amount of catalyst and the calcination temperature on the catalytic activity were investigated. The highest yield of 94.19% glycerol carbonate was obtained at 65 °C on CaO loaded with 10% LiCl after 1 h, and the catalyst had high stability in reusing work. Scanning electron microscopy (SEM), X-ray diffraction (XRD), BET, CO₂-TPD, XPS and thermalgravity (TG) were used to characterize the prepared catalyst. It was found that the high catalytic activity of CaO after modification with LiCl is associated with the structural aspects and the amount of basicity of the catalyst. The Li₂O₂ species, which is a strong basic site that is formed by the substitution of the Ca²⁺ in CaO lattice by Li⁺, has great activity for transesterification.     

Chemical equilibrium of glycerol carbonate synthesis from glycerol

In this paper, the chemical equilibrium for the glycerol carbonate preparation from glycerol was investigated. The chemical equilibrium constants were calculated for the reactions to produce glycerol carbonate from glycerol. The theoretical calculation was compared with the experimental results for the transesterification of glycerol with dimethyl carbonate. Transesterification of glycerol with cyclic carbonates or alkyl carbonates is thermodynamically favourable for producing glycerol carbonate from glycerol according to the equilibrium constant. Increasing temperature can increase the chemical equilibrium constant for the reaction of glycerol with dimethyl carbonate. For the reaction of glycerol with ethylene carbonate, increasing temperature can decrease the chemical equilibrium constant. The reaction of glycerol with carbon dioxide is thermodynamically limited. High temperature and low pressure are favourable to the reaction of glycerol and urea.     

An efficient catalytic system for the hydrogenation of quinolines

A new catalytic system ([Ru(p-cymene)Cl₂]₂/I₂) has been developed for the hydrogenation of quinoline derivatives with high reactivity. For the 2-methyl-quinoline, the hydrogenation reaction can proceed smoothly at an S/C of 20,000/1 with complete conversion. The iodine additive is important for the reactivity.     

Fe(III)EDTA作为氧化羰化苯酚合成碳酸二苯酯一种有效的氧化还原催化助剂(英文)

研究了氧化羰化苯酚合成碳酸二苯酯反应。发现了Fe(III)EDTA在PdCl2/Fe(III)EDTA/1,4-苯醌/四丁基溴化铵催化体系中具有很好的助催化效果。讨论了上述催化体系中的每一组分的作用,并提出了一个催化反应机理。氧化羰化苯酚合成碳酸二苯酯反应的最佳温度为100℃~120℃。当反应在100℃、PCO=2.0 MPa、PO2=0.5 MPa、苯酚0.5 mol、PdCl20.28 mmol、n(PdCl2)∶n(Fe(III)EDTA)∶n(苯醌)∶n(四丁基溴化铵)=1∶1∶10∶40、4A分子筛5.0 g、4 h进行时,碳酸二苯酯的产率和选择性分别为8.35%和97.5%。压力越高对生成碳酸二苯酯越有利。     

Fe(III)EDTA作为氧化羰化苯酚合成碳酸二苯酯一种有效的氧化还原催化助剂

研究了氧化羰化苯酚合成碳酸二苯酯反应。发现了Fe(III)EDTA 在PdCl2/Fe(III)EDTA/1,4 苯醌/ 四丁基溴化铵催化体系中具有很好的助催化效果。讨论了上述催化体系中的每一组分的作用，并提出了一个催化反应机理。氧化羰化苯酚合成碳酸二苯酯反应的最佳温度为100℃～120℃。当反应在100℃、PCO=2.0MPa、PO2=0.5MPa、苯酚 0.5mol、 PdCl2 0.28mmol、n(PdCl2)∶n(Fe(III)EDTA)∶n(苯醌)∶n(四丁基溴化铵)=1∶1∶10∶40、 4A 分子筛 5.0g、 4h进行时，碳酸二苯酯的产率和选择性分别为8.35%和97.5%。压力越高对生成碳酸二苯酯越有利。     

A new heterogeneous catalyst for the oxidative carbonylation of phenol to diphenyl carbonate

Using layered double hydroxides as a support, both the palladium catalyst and the cobalt co-catalyst are heterogenised and proven to form an acceptable catalytic system for the heterogeneous oxidative carbonylation of phenol to diphenyl carbonate (DPC).     

An efficient mixed-ligand Pd catalytic system to promote C-N coupling for the synthesis of N-arylaminotriazole nucleosides

Make it unique! A mixed-ligand system of Pd/Synphos/Xantphos promotes effective C-N coupling in the synthesis of various N-arylaminotriazole and N-arylaminopurine nucleoside analogues. This catalytic system is strikingly powerful and efficient, allowing for unparalleled substrate scope and high product yields as well as promotion of C-Cl bond activation for C-N coupling (see scheme).     

New catalytic systems for oxidative carbonylation of acetylene to maleic anhydride

A classification of polyfunctional catalytic systems based on discrimination of the main component (the catalyst participating in all stages of the formation of the product of catalytic reaction) and elucidating the functions of additional components of a catalytic system is suggested. The role of additional components in a number of new palladium-based catalytic systems used in the synthesis of maleic anhydride by oxidative carbonylation of acetylene was studied. It was established that the functions of Co and Fe phthalocyanine complexes (PcCo and Pc^*Fe, respectively) in the mechanism of the process are different. Translated fromIzvestia Akademii Nauk. Seriya Khimicheskaya, No. 10, pp. 1899–1905, October, 1999.     

Selective catalytic oxidative carbonylation of amino alcohols to ureas

[reaction: see text] Amino alcohols undergo W(CO)(6)-catalyzed oxidative carbonylation to the corresponding hydroxyalkylureas without protection of the hydroxyl group. Selected examples of 1,2-, 1,3-, 1,4-, and 1,5-amino alcohols were converted to the ureas in good to excellent yields, with only small amounts of the cyclic carbamates being formed. In contrast, the phosgene derivatives CDI and DMDTC undergo stoichiometric reactions with the amino alcohol substrates to afford ureas and cyclic carbamates with variable selectivity.     

An efficient method for the synthesis of alkylidenecyclobutanones by gold-catalyzed oxidative ring enlargement of vinylidenecyclopropanes

Rings of gold: Vinylidenecyclopropanes can undergo efficient oxidative ring enlargements under mild conditions to give the corresponding alkylidenecyclobutanone derivatives in good yields. A plausible mechanism for this transformation has been proposed, and a new Au(I) -N complex, which can be used as an efficient catalyst in this oxidation reaction, has been isolated.     

Efficient synthesis of ureas by direct palladium-catalyzed oxidative carbonylation of amines

A general synthesis of symmetrically disubstituted ureas and trisubstituted ureas by direct Pd-catalyzed oxidative carbonylation of primary amines or of a mixture of a primary and a secondary amine, respectively, with unprecedented catalytic efficiencies for this kind of process, is reported. Reactions are carried out at 90-100 degrees C in DME as the solvent in the presence of PdI(2) in conjunction with an excess of KI as the catalytic system and under 20 atm of a 4:1 mixture of CO and air. In some cases, working in the presence of an excess of CO(2) (40 atm) in addition to CO and air (60 atm total) had a beneficial effect on substrate reactivity and product yield. Cyclic five-membered and six-membered ureas were easily formed from primary diamines. The methodology has been successfully applied to the synthesis of pharmacologically active ureas, such as those deriving from alpha-amino esters or urea NPY5RA-972, a potent antagonist of the neuropeptide Y5 receptor.     

Synthesis of dimethyl carbonate by vapor phase oxidative carbonylation of methanol over Cu-based catalysts

Dimethyl carbonate (DMC) synthesis reaction by oxidative carbonylation of methanol has been studied using vapor phase flow reaction system in the presence of Cu-based catalysts. A series of Cu-based catalysts were prepared by the conventional impregnation method using activated carbon (AC) as support. The effect of various promoters and reaction conditions on the catalytic reactivities were intensively evaluated in terms of methanol conversion and DMC selectivity. The morphological analysis by X-ray diffraction and SEM was also conducted in order to characterize the emloyed catalysts. Regardless of catalyst compositions, the optimal reaction temperature for oxidative carbonylation of methanol was found to be around 120–130°C. The reaction rate was too slow below 100°C, while too much by-products was produced above 150°C. Among the various catalysts employed, CuCl₂/NaOH/AC catalyst with the molar ratio of OH/Cu=0.5–1.0, has shown the best catalytic performance, which appears to have a strong relationship with the formation of intermediate species, Cu₂(OH)₃Cl.     

An efficient catalyst for Pd-catalyzed carbonylation of aryl arenesulfonates

Aryl carboxylic esters were synthesized by Pd-catalyzed carbonylation of aryl p-fluorobenzenesulfonates or -tosylates. A unique Josiphos ligand was discovered through high-throughput catalyst screening, which was the key for the successful carbonylation of various substrates. This catalyst is effective and works well for both electron-rich and electron-poor aryl arenesulfonates. Isolated yields of up to 90% were obtained for aryl p-fluorobenzenesulfonates and -tosylates. [reaction: see text]