An MRI tissue equivalent lesion phantom using a novel polysaccharide material

A new polysaccharide material, TX-150, and method is described which will potentially allow formation of stable, multi-compartment MRI phantoms constructed without intervening septa. TX-150 can be made into water based gels which are nominally tissue equivalent. Although contiguous regions of different water content are not possible, as water diffusion will occur until equilibrium is reached, TX-150 gel T1 and T2 values can be adjusted independently, while maintaining a constant water composition, by appropriate additives. Unlike paramagnetic ions and chelates, metal phthalocyanines have been found to bind tightly to TX-150, thus, permitting formation of stable contiguous regions of differing T1 relaxation properties. Phantom T2 values can be effectively modified with 2-2-diphenyl-1 picrylhydrazyl, which has little affect on gel T1 values, to form septumless lesion phantoms of varying T1 and T2.     

Detection of microscopic anisotropy in gray matter and in a novel tissue phantom using double Pulsed Gradient Spin Echo MR

A double Pulsed Gradient Spin Echo (d-PGSE) MR experiment was used to measure and assess the degree of local diffusion anisotropy in brain gray matter, and in a novel "gray matter" phantom that consists of randomly oriented tubes filled with water. In both samples, isotropic diffusion was observed at a macroscopic scale while anisotropic diffusion was observed at a microscopic scale, however, the nature of the resulting echo attenuation profiles were qualitatively different. Gray matter, which contains multiple cell types and fibers, exhibits a more complicated echo attenuation profile than the phantom. Since microscopic anisotropy was observed in both samples in the low q regime comparable to that achievable in clinical scanner, it may offer a new potential contrast mechanism for characterizing gray matter microstructure in medical and biological applications.     

Functional MRI of the motor cortex using a conventional gradient system: comparison of FLASH and EPI techniques

Gradient echo (GE) and echo planar imaging (EPI) techniques are two different approaches to functional MRI (fMRI). In contrast to GE sequences, the ultra short EPI technique facilitates fMRI experiments with high spatial and temporal resolution or mapping of the whole brain. Although it has become the method of choice for fMRI, EPI is generally restricted to modern scanners with a strong gradient system. The aim of our study was to evaluate the applicability of EPI for fMRI of the motor cortex using a 1.5 T scanner with a conventional gradient system of 10 mT/m (rise time: 1 ms). Therefore, EPI was compared with a well-established high resolution fast low angle shot (FLASH) technique (matrix size 128²). The FLASH technique was applied additionally with a 64² matrix size to exclude influences caused by different spatial resolution, because the EPI sequence was restricted to a 64² matrix size. A total of 35 healthy volunteers were included in this study. The task consisted of clenching and spreading of the right hand. FLASH and EPI techniques were compared regarding geometric distortions as well as qualitative and quantitative fMRI criteria: Mean signal increase between activation and rest and the area of activation were measured within the contralateral, ipsilateral, and supplementary motor cortex. The quality of subtraction images between activation and rest, as well as the quality of z-maps and time course within activated regions of interest, was evaluated visually. EPI revealed significant distortions of the anterior and postior brain margins; lateral distortions (relevant for the motor cortex) could be neglected in most cases. The mean signal increase was significantly higher using FLASH 128² compared to FLASH 64² and EPI 64², whereas the activated areas proved to be smaller in FLASH 128² functional images. Both results can be explained by well-documented partial volume effects, caused by different voxel size. Similar quality of the subtraction images and of the time courses in different regions of interest were found for all techniques under investigation, but slightly reduced quality of z-map in FLASH 128². Within the limits of reproducibility and measurement accuracy, the location of contralateral activation was similar using FLASH and EPI sequences. In conclusion, EPI proved to be a reliable technique for fMRI of the motor cortex, even on an MR scanner with a conventional gradient system.     

Extended validation of a theoretical model for railway rolling noise using novel wheel and track designs

A theoretical model for railway rolling noise, TWINS, was first developed some years ago and was previously validated against field measurements for conventional wheel and track designs. This model has subsequently been used in the design of noise-reducing wheels and tracks. An outcome of the recent Silent Freight and Silent Track projects was a series of novel designs that were tested in a comprehensive field experiment. Alongside this development, the theoretical model has been updated to improve accuracy and include new features. The results of 34 wheel/track combinations that were measured in field experiments are compared with corresponding predictions using the improved model. It is found that the mean difference between measured and predicted overall A-weighted sound pressure levels is less than 2 dB while the standard deviation is 1.9 dB. The improved accuracy of the model is also shown by a reanalysis of the original validation experiments.     

平面阵的方位估计算法及其误差分析

提出了一种基于信号相位匹配原理的平面阵方位估计的奇异值分解(SVDSPM)算法。推导了方位搜索需要的时延计算的一般公式,仿真分析了几种典型平面阵的方位估计性能,仿真结果表明:SVDSPM方位估计算法的性能优于MUSIC算法;理论分析了目标距离、传声器位置误差和接收通道幅度和相位不一致性等对定向性能的影响;以十字平面阵为例,仿真分析了上述几种因素对方位估计精度的影响,仿真结果表明:当传感器安装误差小于10 mm,接收通道幅度不一致性小于1.5 dB,接收通道相位不一致性小于10°和目标初始俯仰角大于45°时,方位估计的标准差小于0.5°。     

Assessment by MRI of local porosity in dough during proving. theoretical considerations and experimental validation using a spin-echo sequence

Proving is a key stage in the development of the final structure of bread, as invasive measurements may provoke dough collapse. Therefore, better understanding and better control of the nucleation and the growth of bubbles require the development of non-invasive methods of measurement. In the present work, a non-invasive method is presented for the measurement of local dough porosity from MR image analysis. For this, a direct relation between the gray level of a voxel and its gas fraction was established in the absence of heat and mass transfer. At whole dough scale for a one-dimensional expansion, the porosity estimated from the gray level was compared with the porosity estimated from total dough volume measurements in a range of [0.10, 0.74 m(3) of gas/m(3) of dough]. For short proving times (<30 min), MR image analysis underestimated porosity by a maximum of 0.03 m(3) of gas/m(3) of dough, but otherwise the difference between the two means of measurement was within the standard error of total dough measurements (+/-0.01 m(3) of gas/m(3) of dough). Maps of local porosity in dough during proving are also presented and discussed.     

CdS quantum dots in a novel glass with a very low activation energy and its variation of diffusivity with temperature

CdS quantum dots of different average sizes in the range 2 to 3.8 nm were grown by diffusion-limited growth process in indigenously made silicate glass. The absorption spectra showed a strong quantum confinement effect with a blue shift of the order of ~500 meV depending on the average size. Critical radius of quantum dots was found to be 1.8 nm. The size dispersion decreased from 15.2 to 12.5% with a 20% increase in the particle size. The activation energy for diffusion was found to be very low i.e. 193 kJ mol⁻¹ and the diffusion coefficient increased by 60% for 10 K rise in temperature. The PL emission spectra showed the presence of only deep traps around ~600 nm with a red shift of 200 nm. No shallow traps or band edge emission was observed. The PL peak position changed from 560 to 640 nm with a 35 K increase in annealing temperature.     

Muscle and fat quantification in MRI gradient echo images using a partial volume detection method. Application to the characterization of pig belly tissue

Complete dissection is the current reference method to quantify muscle and fat tissue on pig carcasses. Magnetic resonance imaging (MRI) is an appropriate nondestructive alternative method that can provide reliable and quantitative information on pig carcass composition without losing the spatial information. We have developed a method to quantify the amount of fat tissue and muscle in gradient echo MR images. This method is based on the method proposed by Shattuck et al. [12]. It provides segmentation of pure tissue and partial volume voxels, which allows separation of muscle and fat tissue including the fine insertions of intermuscular fat. Partial volume voxel signal is expected to be proportional to the signals of pure tissue constituting them or at least to vary monotonously with the proportion of each tissue. However, it is not always the case with gradient echo sequence due to the chemical shift effect. We studied this effect on a fat tissue/muscle interface model with variable proportion of water in the fat tissue and variable TE. We found that at TE=8 ms, for a 0.2-T MRI system, the requirement of Shattuck's method were filled thanks to the presence of water in fat tissue. Moreover, we extended the segmentation method with a simple correction scheme to compute more accurately the proportions of each tissue in partial volume voxels. We used this method to evaluate the fat tissue and muscle on 24 pig bellies using a gradient echo sequence (TR 700 ms, TE 8 ms, slice thickness 8 mm, number of averages 8, flip angle 90 degrees , FOV 512 mm, matrix 512*512, Rect. FOV 4/8, 19 slices, space between slices 2 mm). The image analysis results were compared with dissection results giving a prediction error of the muscle content (mean=2.7 kg) of 88.9 g and of the fat content (mean=2.7 kg) of 115.8 g without correction of the chemical shift effect in the computation of partial volume fat content. The correction scheme improved these results to, respectively, 81.5 and 107.1 g.     

Synthesis and characterization of a novel magnetic carrier with its composition of Fe3O4/carbon using hydrothermal reaction

In this study, a simple method to prepare a novel magnetic carrier based on carbon matrix has been built by heating the aqueous solution of glucose and oleic acid-stabilized Fe₃O₄ nanoparticle at 170 °C for 3 h. The results show that the surface hydrophobic modification of Fe₃O₄ nanoparticle is necessary for the successful synthesis of Fe₃O₄/C nanocomposition, and a possible formation mechanism of Fe₃O₄/C nanocomposition was presented. The influence of the reaction parameters such as the concentration of oleic acid-stabilized Fe₃O₄ nanoparticle, the reaction time, etc. on the product was also investigated. In the typical reaction (2.5 g/L of oleic acid-stabilized Fe₃O₄ nanoparticle, 0.5 M of glucose), Fe₃O₄/C nanocompositions with the average diameter in the range 100–200 nm were obtained and its saturation is 12.4 emu/g. In order to characterize Fe₃O₄/C nanocompositions, XPS, XRD, FT–IR, and Mössbauer spectra were employed.