Electroreductive crossed pinacol coupling of aromatic ketones with aliphatic ketones and aldehydes

The intermolecular crossed pinacol coupling of aromatic ketones with aliphatic aldehydes and ketones was effected by electroreduction in the presence of chlorotrimethylsilane. The best result was obtained using a Pb cathode in Bu₄NPF₆/THF. The electroreduction of aromatic 1,4-, 1,5-, and 1,6-diketones under the same conditions gave four-, five-, and six-membered 1,2-diols with trans-stereoselectivity, while the reduction of these diketones with TiCl₄-Zn produced the cis-isomers of the same intramolecular crossed pinacol coupling products predominantly.     

A new spot test for aliphatic aldehydes and ketones

A new spot test for aliphatic aldehydes and ketones has been developed utilizing free-radical formation. Aliphatic aldehydes are detected in the range of 0.2–200 μg while aliphatic ketones are detected from 100–2000 μg. Benzaldehyde was the only other compound tested that gave a positive result.     

The mass spectra of some O-methyloximes of aliphatic aldehydes and ketones

The mass spectra of O-methyloximes of fifteen aliphatic aldehydes and ketones of various molecular weights and degrees of branching have been examined. All give molecular ions, and many of the fragmentations parallel those of aldoximes and ketoximes. The formation of some ions is better explained by the initial production of a novel substituted cyclopropene ion. O-Methyloximes of of the long-chain aldehydes and methyl ketones are readily distinguished by the masses of abundant products of McLafferty rearrangement at m/e 73 and 87, repectively.     

Temperature dependent near-UV molar absorptivities of aliphatic aldehydes and ketones in aqueous solution

Temperature dependent molar absorptivities are reported for acetone, 2-butanone, 2-pentanone, 3-pentanone, acetaldehyde, propionaldehyde, and n-butyraldehyde in aqueous solution. Molar absorptivities are given at eight temperatures in the range 6.5–69.5°C for wavelengths greater than 200 nm, a spectral resolution of 2.0 nm, and a spacing of 2.5 nm. For both ketones and aldehydes a shift to shorter wavelengths of approximately 10 nm is observed in the aqueous phase absorption spectrum relative to that found in the gas phase. For the ketones, there is an increase in the total intensity of the spectrum of approximately 5% over the range of temperatures studied. For the aldehydes a much larger change in the intensity of the absorption spectrum is observed, due to the temperature dependence of the hydration reaction RCHO + H₂O ⇄ RCH(OH)₂; K_hyd = [RCH(OH)₂/[RCHO]. The change in the spectral intensity with temperature is used to determine thermodynamic parameters for the hydration reaction, giving the following results (at 25°C): acetaldehyde, K_hyd = 1.13 ± 0.06, ΔH = −19.7±0.6kJ/mol, ΔS= −65.0±2.5J/mol-K; propionaldehyde, K_hyd=1.02±0.06, ΔH=-20.8±0.8kJ/mol, ΔS=-69.6±3.1J/mol-K; n-butyraldehyde, K_hyd=0.50±0.05, ΔH=-27.0±2.2kJ/mol, ΔS= −96.5± 8.2 J/mol-K. The implications of these results for aqueous phase atmospheric chemistry are discussed.     

The first example of a catalytic asymmetric aldol-Tishchenko reaction of aldehydes and aliphatic ketones

A number of combinations of Lewis acids and chiral ligands has been screened for the enantioselective direct tandem aldol condensation--Evans-Tishchenko reduction of aldehydes and ketones. Chiral ytterbium complexes were found to catalyze the condensation of aromatic aldehydes with 3-pentanone (and other ketones) giving rise to the anti-1,3-diol monoesters in good yield, and with high diastereocontrol and moderate levels of enantioselectivity. Three adjacent stereogenic centers are created in one reaction sequence in acyclic systems.     

Determination of low molecular weight aliphatic amines by HPLC in environmental water samples

A high resolution liquid chromatographic method is described for determination of low molecular weight (LMW) aliphatic amines in environmental waters. The analytes after isolation are derivatized by fluram and separated with isocratic elution on octyl (C₈) column, followed by fluorimetric detection in 395/495 nm. Different isolation procedures such as octadecylsilane (ODS) and strong cation exchanger (SCX) solid phase extraction (SPE) cartridges and Amberlite CG-120 resin were evaluated. The quantitative characteristics such as recovery, linear dynamic range, correlation coefficient, limit of detection (LOD), and relative standard deviation (RSD) are presented. Using this method, aliphatic amines were analyzed in rain and tap water as well as in waste water.     

Drude polarizable force field for aliphatic ketones and aldehydes,and their associated acyclic carbohydrates

The majority of computer simulations exploring biomolecular function employ Class I additive force fields (FF), which do not treat polarization explicitly. Accordingly, much effort has been made into developing models that go beyond the additive approximation. Development and optimization of the Drude polarizable FF has yielded parameters for selected lipids, proteins, DNA and a limited number of carbohydrates. The work presented here details parametrization of aliphatic aldehydes and ketones (viz. acetaldehyde, propionaldehyde, butaryaldehyde, isobutaryaldehyde, acetone, and butanone) as well as their associated acyclic sugars (d-allose and d-psicose). LJ parameters are optimized targeting experimental heats of vaporization and molecular volumes, while the electrostatic parameters are optimized targeting QM water interactions, dipole moments, and molecular polarizabilities. Bonded parameters are targeted to both QM and crystal survey values, with the models for ketones and aldehydes shown to be in good agreement with QM and experimental target data. The reported heats of vaporization and molecular volumes represent a compromise between the studied model compounds. Simulations of the model compounds show an increase in the magnitude and the fluctuations of the dipole moments in moving from gas phase to condensed phases, which is a phenomenon that the additive FF is intrinsically unable to reproduce. The result is a polarizable model for aliphatic ketones and aldehydes including the acyclic sugars d-allose and d-psicose, thereby extending the available biomolecules in the Drude polarizable FF.     

Determination of hydride affinities of various aldehydes and ketones in acetonitrile

The hydride affinities of 21 typical aldehydes and ketones in acetonitrile were determined by using an experimental method, which is valuable for chemists choosing suitable reducing agents to reduce them. The focus of this paper is to introduce a very facile experimental method, which can be used to determine the hydride affinities of various carbonyl compounds in solution.     

Condensation of aldehydes and ketones

The Mannich reaction with methylene- and benzylidenediacetophenones has given: 1,3-dibenzoyl-4-piperidinobutane, 1,3-dibenzoyl-4-morpholinobutane, 1,3-dibenzoyl-4-diethylamino-2-phenylbutane, 1,3-dibenzoyl-2-phenyl-4-piperidinobutane, 1,3-dibenzoyl-4-diethylaminobutane, and 1,3-dibenzoyl-4-dimethylamino-2-phenylbutane. From the latter two compounds, 3-diethylaminomethyl-2,6-diphenylpyridine and 3-dimethylaminomethyl-2,4,6-triphenylpyridine have been obtained.For part XVII, see [7].     

Condensation of aldehydes and ketones

The alkaline condensation of β-aceto-and β-propionaphthalenes with furfural has given, respectively, 2-(α-furfuryl)-1, 3-di(β-naphthoyl)-propane and 3-(α-furyl)-2,4-di(β-naphthoyl)pentane; both δ-diketones have also been obtained by the Michael condensation. Under more severe conditions, two molecules of furfural condense with three molecules of β-acetonaphthalene to form 2, 4-di(α-furyl)-1, 3, 5-tri(β-naphthoyl)pentane. Under similar conditions, benzaldehyde exhibits only a feeble capacity for triketone condensation with β-acetonaphthalene. The condensation of β-propionaphthalene with furfural has given the new compound furylidenepropionaphthalene. It has been shown that both under the conditions of the improved Chichibabin pyridine synthesis and under the conditions of the Leuckhardt reaction, 3-(α-furyl)-1, 3-di(β-naphthoyl)propane gives 4-(α-furyl)-2, 6-di(β-naphthyl)pyridine.     

Condensation of aldehydes and ketones

The alkaline condensation of -aceto-and -propionaphthalenes with furfural has given, respectively, 2-(-furfuryl)-1, 3-di(-naphthoyl)-propane and 3-(-furyl)-2,4-di(-naphthoyl)pentane; both -diketones have also been obtained by the Michael condensation. Under more severe conditions, two molecules of furfural condense with three molecules of -acetonaphthalene to form 2, 4-di(-furyl)-1, 3, 5-tri(-naphthoyl)pentane. Under similar conditions, benzaldehyde exhibits only a feeble capacity for triketone condensation with -acetonaphthalene. The condensation of -propionaphthalene with furfural has given the new compound furylidenepropionaphthalene. It has been shown that both under the conditions of the improved Chichibabin pyridine synthesis and under the conditions of the Leuckhardt reaction, 3-(-furyl)-1, 3-di(-naphthoyl)propane gives 4-(-furyl)-2, 6-di(-naphthyl)pyridine.     

Determination of aliphatic aldehydes in aqueous solution by chemiluminescence measurements

The determination of aliphatic aldehydes (5 × 10^-6 — 2.5 × 10^-4 mol) in aqueous solution was achieved by inhibition of the luminol chemiluminescence induced by hydrogen peroxide in the presence of potassium hexacyanoferrate(III).     

Determination of aliphatic aldehydes in waters by high-performance liquid chromatography

A method is described for the determination of linear aldehydes (C₁–C₈) in waters. Aldehydes are extracted into n-pentane after derivatization with 2,4-dinitrophenyhydrazine and quantified by reversed-phase high-performance liquid chromatography with detection at 365 nm. With a 250-ml sample, the limit of detection is 1 μg l^?1 for the C₁–C₈ aldehydes. The method is directly applicable to surface waters and drinking water. Analysis of different surface waters, treated water and a humic acid solution after ozonization showed that C₁–C₃ aldehydes predominated, their concentration increasing with increasing ozone dosage.     

Quantification of 2,4-dinitrophenyl-hydrazones of low molecular mass aldehydes and ketones using HPLC

Summary This study was undertaken to evaluate the HPLC separation and quantification of several low molecular mass aldehydes and ketones, which may be produced during combustion in alcohol-fueled automobiles, by means of their dinitrophenylhydrazone derivatives. Stationary phases (ODS), mobile phase components (acetonitrile or methanol with water) and detection sensitivity at 254 and 365 nm were evaluated. Separation of eight dinitrophenylhydrazones could be achieved in approximately 20 minutes using a Zorbax ODS or a Supelcosil LC-PAH column with a MeOH:H₂O (7525 v/v) mobile phase. Complete separations were not obtained with either a Nova-Pack C-18 or an Ultrasphere ODS column. The use of acetonitrile-water mobile phases produces poorer resolution at all compositions tested. Quantification of the compounds by several methods was compared, with the lowest standard deviations being seen with the external than 1.5 pmol for each of the 2,4-dinitrophenylhydrazones in the test solution. The method is being applied to the analysis of aldehydes and ketones in the exhaust of automobile engines fueled by ethanolgasoline mixtures.Presented at the 19th ISC. Aix-en-Provence, France, September 13–18, 1992.     

Analysis of high molecular weight esters and ketones in thymus

A crystalline mixture of esters from Thymus chamaedris is analyzed by mass spectrometry, and after hydrolysis, by gas chromatography. Two series of straight chain even aliphatic acids from C₁₆ to C₂₆, and from C₄₀ to C₄₈, and a series of straight chain even saturated primary alcohols, from C₈ to C₃₀, are its main constituents. Another crystalline mixture, isolated from Thymus caespititius, is shown by mass spectrometry and gas chromatography to be composed of a straight chain series of aliphatic ketones, from C₂₅ to C₃₇.     

Magnesium-catalysed hydroboration of aldehydes and ketones

The heteroleptic magnesium alkyl complex [CH{C(Me)NAr}(2)Mg(n)Bu] (Ar = 2,6-(i)Pr(2)C(6)H(3)) is reported as a highly efficient pre-catalyst for the hydroboration of aldehydes and ketones with pinacolborane.     

Determination of aliphatic aldehydes by liquid chromatography with pulsed amperometric detection

An electrochemical detection method for short-chain saturated and unsaturated aliphatic aldehydes separated by liquid chromatography in moderately acidic medium is described. A triple-step waveform of the potentials applied to the polycrystalline platinum electrode, is proposed for sensitive detection of aliphatic aldehydes in flowing streams avoiding tedious pre- or post-column derivatization and/or cleanup procedures. The influences of the perchloric acid concentration and dissolved oxygen in the mobile phase, on the amperometric and chromatographic performance were evaluated and considered in terms of sensitivity and selectivity. Under the optimised experimental conditions (i.e., deoxygenated 50mM HClO4) the proposed analytical method allowed detection limits between 0.2 microM for acrolein and 2.5 microM for valeraldehyde. Regression analysis of calibration data indicates that responses for all investigated compounds are linear over about 2 orders of magnitude above the LOD, with correlation coefficients >0.990. The method was successfully applied to the determination of formaldehyde, acetaldehyde, propionaldehyde and acrolein in real matrices such as spiked water and red wines with good mean recoveries (81-97%).