O2/CO2气氛下CO对煤焦异相还原NO影响的研究

为揭示O₂/CO₂燃烧过程中高浓度的CO对煤焦异相还原NO的影响,在1073 K温度下使用山西褐煤在卧式炉上进行了实验。分别对O₂/CO₂浓度比及CO浓度下NO的还原特性进行详细实验研究。研究结果表明:在O₂/CO₂气氛下,O₂浓度为30%时具有较高的还原率;相同O₂浓度下O₂/CO₂气氛较空气气氛NO还原率高,表明在CO存在的条件下,高浓度的CO₂会促进NO的还原;当CO浓度从1.5%逐渐升高时,NO的还原率逐渐降低,到CO浓度为5%时,NO还原率比没有加入CO时还要低,而在空气气氛下CO浓度的变化对NO的还原率影响较小。     

Experimental and numerical investigation of hetero-/homogeneous combustion of CO/H2/O2/N2 mixtures over platinum at pressures up to 5 bar

The hetero-/homogeneous combustion of fuel-lean CO/H₂/O₂/N₂ mixtures over platinum is investigated at pressures up to 5 bar, inlet temperatures (T_IN) up to 874 K, and a constant CO:H₂ molar ratio of 2:1. Experiments are performed in an optically accessible channel-flow catalytic reactor and involve planar laser induced fluorescence (LIF) of the OH radical for the assessment of homogeneous (gas-phase) ignition and 1-D Raman measurements of major gas-phase species concentrations over the catalyst boundary layer for the evaluation of the heterogeneous (catalytic) processes. Simulations are carried out with an elliptic 2-D model that includes detailed heterogeneous and homogeneous chemical reaction schemes. The predictions reproduce the Raman-measured catalytic CO and H₂ consumption, and it is further shown that for wall temperatures in the range 975 ? T_w ? 1165 K the heterogeneous pathways of CO and H₂ are largely decoupled. However, for wall temperatures below a limiting value of 710–720 K and for the range of pressures and mixture preheats investigated, CO(s) blockage of the surface inhibits the catalytic conversion of both fuel components. The homogeneous ignition distance is well-reproduced by the model for T_IN > 426 K, but it is modestly overpredicted at lower T_IN. Possible reasons for these modest differences can be the values of third body efficiencies in the gas-phase reaction mechanism. The sensitivity of homogeneous ignition distance on the catalytic reactions is weak, while the H₂/O₂ subset of the CO/H₂/O₂ gaseous reaction mechanism controls the onset of homogeneous ignition. Pure hydrogen hetero-/homogeneous combustion results in flames established very close to the catalytic walls. However, in the presence of CO the gaseous combustion of hydrogen extends well-inside the channel core, thus allowing homogeneous consumption of H₂ at considerably shorter reactor lengths. Finally, implications of the above findings for the design of syngas-based catalytic reactors for power generation systems are discussed.     

SnO2/Co3O4 nanofibers using double jets electrospinning as low operating temperature gas sensor

SnO₂/Co₃O₄nanofibers(NFs)are synthesized by using a homopolar electrospinning system with double jets of positive polarity electric fields.The morphology and structure of SnO₂/Co₃O₄hetero-nanofibers are characterized by using field emission scanning electron microscope(FE-SEM),transmission electron microscope(TEM),x-ray diffraction(XRD),and x-ray photoelectron spectrometer(XPS).The analyses of SnO₂/Co₃O₄NFs by EDS and HRTEM show that the cobalt and tin exist on one nanofiber,which is related to the homopolar electrospinning and the crystallization during sintering.As a typical n-type semiconductor,Sn O₂has the disadvantages of high optimal operating temperature and poor reproducibility.Comparing with Sn O₂,the optimal operating temperature of SnO₂/Co₃O₄NFs is reduced from 350℃to 250℃,which may be related to the catalysis of Co₂O₂.The response of SnO₂/Co₃O₄to 100-ppm ethanol at 250℃is 50.9,9 times higher than that of pure Sn O₂,which may be attributed to the p–n heterojunction between the n-type Sn O₂crystalline grain and the p-type Co₂O₂crystalline grain.The nanoscale p–n heterojunction promotes the electron migration and forms an interface barrier.The synergy effects between Sn O₂and Co₂O₂,the crystalline grain p–n heterojunction,the existence of nanofibers and the large specific surface area all jointly contribute to the improved gas sensing performance.     

Detection of small N2O concentrations using a frequency doubled CO2 laser

A reliable procedure for remote high-accuracy laser detection of N₂O as one of the principal destroyers of the protective ozone layer of the Earth has been developed. The procedure is based on using a CO₂-laser system emitting efficiently in the 4.5 μm range. In this case lasing from isotopic modification ¹²C¹⁸O₂ of carbon dioxide with its subsequent frequency doubling by a nonlinear crystal is used. With the object of reducing the price the composition of the active medium (both for TEA laser and low-pressure longitudinal-discharge-excitation laser) has been optimized. New high-efficiency intracavity frequency doubling schemes based on nonlinear AgGaSe₂ crystals have been developed for CO₂-lasers of both types. Low concentrations of N₂O and concentrations of the principal background gases CO and H₂O have been measured under real atmosphere conditions with the aid of the lidar complex built around these lasers.     

表面杂质对NO+CO/Pt(100)反应体系振荡动力学的影响

提出了一个格气模型， 探讨催化表面的惰性杂质对NO+CO/Pt(100)反应体系振荡动力学行为的影响．研究发现表面杂质较少时，反应进程中表面重构能够形成相连通的1*1相和持续的振荡行为．当表面杂质不断增加时，反应进程中1*1相只能形成许多孤立的畴，从而在1*1相形成的随机的局域振荡的空间关联被削弱，因而体系全局的持续振荡行为演变为衰减振荡行为．当表面吸附的CO和NO的扩散速率增加时，局域振荡的空间协同又得到加强，体系又呈现出持续振荡行为．     

A new technique for the measurement of the product CO/CO2 ratio at the surface of char particles burning in a fluidized bed

A new experimental technique is proposed to measure the product CO/CO₂ ratio at the surface of spherical char particles during fluidized bed combustion. It is based on the measurement of the burning rate of a single char particle under low oxygen concentration conditions and on the use of an accurate prediction of the particle Sherwood number. This technique was applied to spherical char particles obtained from a bituminous coal which is characterized by a low attrition and fragmentation propensity. The product CO/CO₂ ratio was measured at a bed temperature of 850 °C and at a fluidization velocity of 0.3 m/s in a lab-scale apparatus operated with a bed of 0.5–0.6 mm sand. The char particle size was varied between 2 and 7 mm and the inlet oxygen concentration between 0.1% and 2.0%. Results showed that under the experimental conditions investigated carbon was mostly oxidized to CO₂ within the particle boundary layer, with a maximum fraction of carbon escaping as CO of 10–20% at the lowest oxygen concentrations and largest particle sizes.     

Fabrication of nanosized Pt on rutile TiO2 using a standing wave sonochemical reactor (SWSR) – observation of an enhanced catalytic oxidation of CO

Fine particles of rutile TiO₂ supporting nanosized particles of Pt were prepared by a simultaneous in situ sonochemical reduction and deposition method using a standing wave sonochemical reactor (SWSR). The mean diameter of sonochemically obtained Pt particles are of 2 nm. Following this sonochemical technique, rutile TiO₂ was also deposited with different weight percentages of Pt. Catalytic function of the prepared composite catalysts were tested by the oxidation of CO to CO₂. From the catalytic activity results, it has been found out that the catalysts prepared by the sonochemical method exhibited higher catalytic activity for CO oxidation, probably attributed to the higher Pt particle distribution achieved under sonication. Transmission electron microscopy (TEM), X-ray photoelectron spectra (XPS), and diffuse reflectance spectroscopy (DRS) were employed to characterize the resulting material.