High‐pressure high‐temperature synthesis of Rh2O3‐II‐type In2O3 polymorph

The metastability of the bixbyite‐ and corundum‐type In₂O₃ polymorphs up to 33 GPa (at room temperature) is shown. While compressed (in diamond anvil cells) and laser‐heated, both polymorphs undergo a phase transition to the Rh₂O₃‐II‐type structure (space group Pbcn, No. 60). The direct transition from bixbyite to Rh₂O₃‐II structure has not yet been observed for any other oxide.

     

Photoluminescence thermometry with alkyl‐terminated silicon nanoparticles dispersed in low‐polar liquids

Steady‐state and time‐resolved photoluminescence of silicon nanoparticles dispersed in low‐polar liquids at above room temperature is studied. The roles of low‐polar liquids as well as mechanisms responsible for their temperature‐dependent photoluminescence are discussed. The thermal sensitivity of the photoluminescence is estimated and application of the nanoparticles as nanothermometers is proposed.

     

Fabrication and characteristics of solution‐processed graphene oxide–silicon heterojunction

We demonstrate the fabrication of a solid state heterojunction photovoltaic device with solution‐processed graphene oxide (GO) and n‐Si. Partially reduced GO with a high optical gap (2.8 eV) was spin‐coated on the n‐Si substrate and a heterojunction device was fabricated with the structure of Au/pr‐GO/n‐Si. In the fabricated device, incident light was transmitted through the thin GO film to reach the junction interface, generating photoexciton, and thereby a photovoltaic action was observed. By means of a built‐in electric potential at the GO/n‐Si junction, photoexcited electrons and holes can be separated, transported and collected at the electrodes.

     

Fast‐response organic–inorganic hybrid light‐emitting diode

We demonstrated important changes produced on the modulation frequency of hybrid organic–inorganic light‐emitting diodes to examine the applicability as a light source for visible optical communications. The fabricated device structure was 4,4′‐bis[N ‐(1‐napthyl)‐N ‐phenyl‐amino]biphenyl/4,4′‐(bis(9‐ethyl‐3‐carbazovinylene)‐1,1′‐biphenyl:4,4′‐bis[9‐dicarbazolyl]‐2,2′‐biphenyl/ZnS/LiF/MgAg. This device showed an improvement in the modulation frequency using ZnS instead of an organic material, tris(8‐hydroxyquinoline)aluminum. A maximum cutoff frequency of 20.6 MHz was achieved.

     

Solution‐processible polymer solar cells fabricated on a papery substrate

We report on solution‐processible polymer solar cells (PSCs) fabricated on a papery substrate using carton. Highly conductive PEDOT:PSS was used as a bottom anode and planarization layer, and a semi‐transparent top cathode was applied. This research could be an important approach to the development of all‐solution‐processible papery PSCs as well as paper electronics.

     

An L‐shaped nanoprobe for scanning electrochemical microscopy–atomic force microscopy

We present an L‐shaped nanoprobe for scanning electrochemical microscopy–atomic force microscopy (SECM–AFM) capable of imaging the surface topography and the electrochemical activity of nanostructures of interest. Owing to the geometry of the protrusive peak in the L‐shaped probe, the distance between the probe electrode and the substrate is maintained precisely at ～100 nm during surface scanning. The reduction in electrode‐to‐substrate distance significantly improves the positive feedback current on top of the electrochemically active nanomaterials. The L‐shaped nanoprobe successfully acquired simultaneous a topographical image and an electrochemical current image of individual carbon nanotubes (CNTs) in a two‐dimensional (2D) CNT network.

     

In‐situ neutron reflectometry probing competitive swelling and de‐swelling of thin polystyrene films

The competitive penetration of toluene with respect to oxygen, nitrogen and carbon dioxide into a thin and initially dry film of deuterated polystyrene (dPS) is compared to the reverse process of de‐swelling. In‐situ neutron reflectometry is used to follow the swelling and de‐swelling kinetics, allowing the determination of the total dPS thickness, roughness and solvent penetration. Swelling cannot be described in terms of case II diffusion due to the small film thickness and undersaturation results in a small swelling rate of 0.03 nm s^–1. De‐swelling is slower by more than two orders in magnitude, thereby underlining the difficulty to remove once incorporated solvent molecules. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

     

A novel fabrication method of CNT‐CP composite single nanowires self‐templated by dielectrophoresis and electropolymerization

A new method for fabricating carbon nanotube‐conducting polymer (CNT‐CP) composite single nanowires is reported. The method developed is highly efficient, reliable, and economical because it obviates the time consuming process of template fabrication and the post‐synthesis task of positioning nanowires. Single nanowires with diameters of 50‐500 nm are fabricated between electrodes, self‐templated by dielectrophoresis and electropolymerization. Fabrication of an individually addressed nanowire array with cantilever electrodes on a microchip is demonstrated.

     

Correlation‐induced magnetic order and magnetic phenomena in transition‐metal δ‐doped cubic ZnO

The properties of transition‐metal (V, Cr, Mn, Fe, Co, Ni) δ‐doped ZnO are reported based on ab‐initio electronic structure calculations where the on‐site electronic correlations are included using the Hubbard parameters. The calculated electronic and magnetic properties are considerably altered with respect to usual band‐structure calculations. Most of the studied systems are found to be either half‐metals or ferromagnetic/antiferromagnetic semiconductors and thus can be employed in a variety of spintronic applications as spin‐filter materials.

     

The effect of top contact on ZnO write‐once–read‐many‐times memory

Write‐once–read‐many‐times memory (WORM) devices were fabricated using Ti/Au and Au as top contacts on ZnO thin films on Si. Electrical characterization shows that both types of WORM devices have large resistance OFF/ON ratio (R ratio), small resistance distribution range, long retention and good endurance. WORM devices with Au top contact have better performance of higher R ratio because of a larger work function of Au compared to Ti.

     

Trigonal Na3Li(SeO4)2·6H2O crystal – a novel SRS‐active material with high Raman gain coefficient

We discovered and characterized the χ ⁽³⁾‐active Na₃Li(SeO₄)₂·6H₂O crystal with considerably high Raman gain coefficients for laser physics and nonlinear optics. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

     

Spin–orbit coupling in low‐dimensional gold

We present experimental and theoretical evidence of the role played by the spin–orbit coupling in the electronic structure of a pseudomorphic Au monolayer on Nb(001) substrate. The bands found with the help of the angle‐resolved ultraviolet photoelectron spectroscopy (ARUPS) are compared with those obtained from ab initio self‐consistent calculations by the VASP and WIEN2k codes. The slab calculations are performed including geometric relaxation and using both the generalized‐gradient (GGA) and local‐density (LDA) approximations for the exchange–correlation energy. The dispersions and energy positions of the calculated bands agree with the experimentally determined band structure only if the LDA is used and the spin–orbit coupling is included. Therefore, both the structure relaxation and spin–orbit coupling are essential in understanding the electronic structure of the Au/Nb(001) system.

     

Atomic structure of pre‐Guinier–Preston zones in Al alloys

We propose X‐ray absorption (XAS) measurements as a novel approach to determine the atomic structure of pre‐Guinier–Preston zones. These nano‐clusters are formed during very early stages of aging AlCu alloys, immediately after solution heat treatment and quenching. X‐ray absorption near‐edge structure (XANES) spectra were taken from technical aluminum alloys at the copper K edge, revealing the local atomic environment of copper. The spectra of – after solution heat treatment – freshly quenched and of artificially aged alloys differ significantly from each other. We compare the measured XANES spectra with those calculated by the FEFF‐8 code. We show the importance of employing realistic, i.e. relaxed, atomic coordinates around the scattering atom type from ab‐initio calculations with SIESTA. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

     

Polybenzimidazole‐decorated carbon nanotube: A high‐performance proton conductor

Interaction between negatively charged Nafion^® and a positively charged polybenzimidazole‐decorated carbon nanotube leads to the formation of an ionic complex with high charge density for proton conduction, which can lead to an improvement in transport properties. Here we investigate the high‐temperature and low‐humidity proton conductivity of this nanocomposite membrane as a potential membrane for fuel cell applications.

     

High color rendering index and chromatic stability of top‐emitting white organic light‐emitting diodes capped with a supplementary green color conversion layer

We have demonstrated high color rendering index (CRI) and chromatic stability of top‐emitting white organic light‐emitting diodes (TEWOLEDs) by capping a supplementary green color conversion layer (CCL) on the cathode of single blue emitter based TEWOLEDs. By employing CCLs, blue photon energy is absorbed and converted to green emission efficiently, resulting in an improvement of CRI from 72 to 86. We attribute the increased high CRI to the broadening of the out‐coupled spectrum and an appropriate intensity match among the three primary colors. Meanwhile, the TEWOLEDs show extremely high chromatic stability. The results indicate that this method provides a new avenue to improve the CRI of TEWOLEDs.

     

The impact of twinning on the local texture of chalcopyrite‐type thin films

Twinning in a CuInS₂ layer in a completed thin‐film solar cell was analyzed by means of electron backscatter diffraction. This technique revealed the microstructure of the CuInS₂ thin films and local orientation relationships between the grains. At various locations within the layer it was possible to retrace how twinning occurred comparing the local orientations with the theoretically possible changes in orientation by twinning. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

     

Evidence of two‐photon absorption in strain‐free quantum dot GaAs/AlGaAs solar cells

We report the fabrication procedure and the characterization of an Al_0.3Ga_0.7As solar cell containing high‐density GaAs strain‐free quantum dots grown by droplet epitaxy. The production of photocurrent when two sub‐bandgap energy photons are absorbed simultaneously is demonstrated. The high quality of the quantum dot/barrier pair, allowed by the high quality of nanostructured strain‐free materials, opens new opportunities for quantum dot based solar cells.

     

Saturated low‐temperature conductivity in ultrafast semiconductor nanocomposites

This Letter presents studies on low‐field electrical conduction in the range of 4–300 K for an ultrafast material, i.e., InGaAs:ErAs grown by molecular beam epitaxy. The unique properties include nano‐scale ErAs crystallites in the host semiconductor InGaAs, a deep Fermi level and picosecond ultrafast photocarrier recombination. As the temperature drops, the conduction mechanisms are in the sequence of: thermal activation, nearest‐neighbor hopping, and variable‐range hopping. In the low‐temperature limit, finite‐con‐ductivity metallic behavior, not insulating, was observed. This unusual conduction behavior, related to the nanometer‐scale ErAs crystallite islands, is explained with the Abrahams scaling theory.

     

Combinatorial investigation of nanostructures formed in a titanium dioxide based nanocomposite film on top of fluor‐doped tin oxide layers

Nanostructures formed in a titanium dioxide (TiO₂)–poly(styrene)‐block‐poly(ethyleneoxide) nanocomposite film on top of fluor‐doped tin oxide (FTO) layers are investigated. The combinatorial approach is based on probing a wedge‐shaped FTO‐gradient with grazing incidence small angle X‐ray scattering (GISAXS) in combination with a moderate micro‐focus X‐ray beam. The characteristic lateral length is given by adjacent nanowire‐shaped TiO₂ regions. It decreases from 200 nm on the thick FTO layer to 90 nm on the bare glass surface.