A high‐stability Eu complex has been achieved by coating with a silica glass via a low temperature sol–gel process using deuterated methanol. A three‐dimensional glass network protects the Eu complex from free oxygen and/or water to change the ligand structure. In addition, the chemical bond of the deuterated Eu complex is more stable than that of the conventional Eu complex. Therefore, we achieved a high‐thermal‐stability Eu complex encapsulated by a sol–gel derived silica glass using deuterated methanol instead of ethanol.
Bulk polycrystalline La0.8Li0.2MnO3 is found to switch between a low‐resistance state and a high‐resistance state on thermal cycling. The low‐temperature, high‐resistance state exhibits strong electroresistance whereas the high‐temperature, low‐resistance state does not. The change in resistance between the two distinct states is of two orders of magnitude. It is proposed that the observed metastability may serve as the basis for resistive thermal‐switching devices.
An original approach is proposed to study the magnetic phase separation phenomenon. It is based on the registration of the noise‐like FMR Fine Structure (FMR FS) caused by the magnetic interparticle dipole–dipole interaction between spatially separated ferromagnetic regions. Data obtained for a La0.7Pb0.3MnO3 single crystal point to the existence of spatially separated ferromagnetic regions. It is shown that FMR FS of the La0.7Pb0.3MnO3 single crystal is temperature reversible and disappears at the maximum of magnetoresistance.
We report a very simple and novel approach to produce anodic TiO2 nanotube arrays with highly defined and ordered tube openings. It is based on carrying out anodization through a slowly soluble photoresist coating. This eliminates the formation of undesired initiation layers on the tube tops and protects them to a certain extent from etching by the electrolyte.
We propose a theory of thin film photovoltaics in which one of the polycrystalline films is made of a pyroelectric material grains such as CdS. That film is shown to generate strong polarization improving the device open circuit voltage. Implications and supporting facts for the major photovoltaic types based on CdTe and CuIn(Ga)Se2 absorber layers are discussed.
A facile metal catalyst free route to synthesize boron doped (0.6%–1.0%) carbon nanotubes via ceramic nanowires in which the formation of the nanowires (probably serving as templates), the carbon nanotubes and their doping all occur unanimously in the reaction, is presented.
The multiferroic Pb(Fe1/2V1/2)O3 (PFV) bulk ceramic was fabricated by a conventional ceramic sintering method. The strong visible‐light photovoltaic effect in Sn‐doped‐In2O3(ITO)/PFV/ITO structure capacitor was observed. The open‐circuit voltage was up to ～0.7 V, which was much higher than the value (～0.3 V) in BiFeO3 film. The photo‐excited electric current is almost proportional to the incident light illumination intensity. The good visible‐light photovoltaic makes PFV ceramic a potential candidate for practical application in solar cell devices.
Optically transparent and high‐quality hybrid ZnO nanoparticle and anthracene embedded polyphenylsiloxane (PPS) glass films were spin‐coated on quartz substrates. A strong Förster resonant energy transfer (FRET) process was indicated by the observation of quenching of the ZnO emission and an enhancement of the anthracene emission at room temperature. The efficiency of this energy transfer between ZnO and the S1 vibronic states of the anthracene molecules can be optimized to exceed 90%.
Osmium diboride has been known for some time as a low compressibility material and a superhard material. It is suitable for hard coating applications. It is also a superconductor below 2.1 K. Using first‐principles calculations, the author investigated the geometry of its Fermi surface (FS) and calculated the related physical quantities. The theoretical results are used to predict the frequencies of the Shubnikov–de Haas quantum oscillations. Comparison with recent measurements of the magneto‐resistance oscillations in osmium diboride is made.
Steady‐state and time‐resolved photoluminescence of silicon nanoparticles dispersed in low‐polar liquids at above room temperature is studied. The roles of low‐polar liquids as well as mechanisms responsible for their temperature‐dependent photoluminescence are discussed. The thermal sensitivity of the photoluminescence is estimated and application of the nanoparticles as nanothermometers is proposed.
In this Letter we demonstrate that hydrogen‐terminated porous silicon (PSi) layers and powders can serve as highly efficient reductive templates for noble metal salts. The reduction results in metal nanoparticle (NP) formation in the pores of PSi. Gold NP formation has been monitored in‐situ by measuring the plasmon resonance response. Pt NPs, formed in the PSi matrix, were investigated by transmission electron microscopy and energy‐dispersive X‐ray analysis. Furthermore, hybrid Pt/PSi nanocomposites exhibit a high catalytic activity for CO oxidation.
We report on solution‐processible polymer solar cells (PSCs) fabricated on a papery substrate using carton. Highly conductive PEDOT:PSS was used as a bottom anode and planarization layer, and a semi‐transparent top cathode was applied. This research could be an important approach to the development of all‐solution‐processible papery PSCs as well as paper electronics.
We report a stacked Y2O3/TiOx resistive random access memory (RRAM) device, showing good high‐temperature switching characteristics of extremely low reset current of 1 μA at 150 °C, large off/on resistance window (>200) at 150 °C, large rectification ratio of ～300 at 150 °C and good current distribution at 85 °C. The good rectifying property, lower high‐temperature sneak current and tighter high‐temperature current distribution can be attributed to the combined results of the oxygen vacancies in TiOx and the related carrier depletion effect.
This Letter reports on the assembly on the tip of an optical fibre of a metamaterial film fabricated by a self‐assembly bottom‐up method, composed of silver nanowires embedded in an alumina matrix. By illuminating the film through the fibre in a reflection configuration, we observe experimentally the optical response of the metamaterial in agreement with theoretical predictions and interpreted as the excitation of surface plasmon‐polaritons in the cylindrical surface of the nanowires. These results pave the way for low‐cost optical fibre devices that incorporate metamaterial films.
A passive micro‐displacement sensor (for ～μm displacement) was fabricated based on a magnetoelectric laminate, in which the displacement change can result in a change of the magnetic flux around the magnetoelectric sensor. The displacement measurement was realized by measuring the magnetoelectric output voltage. The displacement detecting coefficient was ～2.5 mV/μm at a frequency of ～1 kHz. This passive displacement sensor possesses the advantages of low cost, high resolution, low energy consumption and good linearity and has potential for application in future displacement detectors.
Thin amorphous tantalum films are prepared on Si(111) substrates in a metallic glassy state. The amorphous monoatomic state of the film is characterized by X‐ray diffraction studies. The glassy state leads to a negative t emperature c oefficient of the r esistivity (TCR) for low sample temperatures <200 K which is attributed to incipient localization. Above 200 K a positive TCR is observed as expected for a normal Boltzmann transport regime. Upon heating the Si substrate to 1200 K TaSi2 is formed out of the amorphous tantalum film and the silicon substrate. The TaSi2 layer is crystalline as evident from X‐ray diffraction data.
We report the maskless fabrication of ultrathin suspended GaN membranes designed by focused ion beam treatment of the GaN epilayer surface with subsequent photoelectrochemical etching. This technological approach allows the fabrication of ultrathin membranes, as well as supporting micro/nanocolumns in a controlled fashion. The analysis of the spatial and spectral distribution of microcathodoluminescence demonstrates that the membranes exhibit mainly yellow luminescence. These results pave the way for the fabrication of ultrathin suspended GaN membranes for MEMS/NEMS applications.
Unlike the common phononic crystals (PCs) with different materials, the infinite periodically hinged identical beams on elastic foundations, considered as a special “single material” PC, also have transverse vibration band gaps (BGs). The modified transfer matrix method is proposed to calculate the band structure of this system. The propagation of transverse vibration of such a system with aluminium beams and soil foundation is studied. The results show that the system gives wider BGs than the common PC case at low frequency. The influence of the stiffness of foundation and geometrical parameters is analyzed to obtain a wider first BG.
The metastability of the bixbyite‐ and corundum‐type In2O3 polymorphs up to 33 GPa (at room temperature) is shown. While compressed (in diamond anvil cells) and laser‐heated, both polymorphs undergo a phase transition to the Rh2O3‐II‐type structure (space group Pbcn, No. 60). The direct transition from bixbyite to Rh2O3‐II structure has not yet been observed for any other oxide.
