衍射极限环光源纵向束流注入非线性优化

下一代同步辐射光源储存环动力学孔径较小,因而束流注入困难,可以通过纵向束流注入解决这一问题。为了使用更长的kicker脉冲,有必要降低高频频率以增加注入束流到储存束流的时移。因为同步辐射运动,时移更长的束流有更高的动量偏差,所以通过该方法进行注入需要储存环提供足够大的能量接受度和动力学孔径。用SSRF-U的候选磁聚焦结构来展示纵向束流注入非线性优化的可行方法。由一系列高频频率的最佳结果可知,低于界限频率时kicker脉冲不会继续增长。在束流模拟中,采用界限频率与合适六级铁强度,可使SSRF-U储存环束流注入达到最高效率。     

Scaling Law for Lattice Design of a Storage Ring

This paper describes and demonstrates the scaling law in the lattice design of a storage ring.When the size of the storage ring are enlarged or reduced according to a scale,the operating point ν and the beam emittance ε will be invarible.But while the energy of the storage ring is changed,the emittance will vary with the energy square.     

合肥先进光源储存环初步物理设计

我国最近立项建设的合肥先进光源将是一台软X射线与真空紫外衍射极限储存环光源,其电子束能量为2.2 GeV,周长为480 m,束流自然发射度为86 pm·rad,共有20个长直线节和20个短直线节。介绍了目前合肥先进光源储存环物理设计的进展情况,包括磁聚焦结构设计与优化,束流注入和集体效应的模拟与计算。     

Collimation with hollow electron beams

A novel concept of controlled halo removal for intense high-energy beams in storage rings and colliders is presented. It is based on the interaction of the circulating beam with a 5-keV, magnetically confined, pulsed hollow electron beam in a 2-m-long section of the ring. The electrons enclose the circulating beam, kicking halo particles transversely and leaving the beam core unperturbed. By acting as a tunable diffusion enhancer and not as a hard aperture limitation, the hollow electron beam collimator extends conventional collimation systems beyond the intensity limits imposed by tolerable losses. The concept was tested experimentally at the Fermilab Tevatron proton-antiproton collider. The first results on the collimation of 980-GeV antiprotons are presented.     

Low emittance lattice for the storage ring of the Turkish Light Source Facility TURKAY

The TAC(Turkish Accelerator Center) project aims to build an accelerator center in Turkey. The first stage of the project is to construct an Infra-Red Free Electron Laser(IR-FEL) facility. The second stage is to build a synchrotron radiation facility named TURKAY, which is a third generation synchrotron radiation light source that aims to achieve a high brilliance photon beam from a low emittance electron beam at 3 Ge V. The electron beam parameters are highly dependent on the magnetic lattice of the storage ring. In this paper a low emittance storage ring for TURKAY is proposed and the beam dynamic properties of the magnetic lattice are investigated.     

Low emittance lattice optimization using a multi-objective evolutionary algorithm

A low emittance lattice design and optimization procedure are systematically studied with a non-dominated sorting-based multi-objective evolutionary algorithm which not only globally searches the low emittance lattice, but also optimizes some beam quantities such as betatron tunes, momentum compaction factor and dispersion function simultaneously. In this paper the detailed algorithm and lattice design procedure are presented. The Hefei light source upgrade project storage ring lattice, with fixed magnet layout, is designed to illustrate this optimization procedure.     

Simulation and analysis of the transverse spectrum in HIRFL-CSR

Particles in a storage ring oscillate in the longitudinal and transverse dimensions. Therefore, the signal that beam has generated can be analyzed in the frequency domain to extract many beam parameters, such as tune, momentum spread, emittance and their evolution with time and so on. In this paper, the transverse spectrum in HIRFL-CSR was simulated and analyzed under different conditions, including electron cooling, hollow electron beam, solenoid effect, the tune shift caused by power supply ripple and the misalignment between ion and electron beams. The result of the simulation shows that the longitudinal magnetic field of the electron cooling device should be compensated by a “compensation solenoid”, and the power supply ripple must be controlled, otherwise the accumulation would be affected and the beam would be lost.     

北京τ─粲工厂储存环磁聚焦结构的设计研究

对北京τ－粲工厂（BTCF）储存环磁聚焦结构设计中所涉及的一些关键物理问题作了探讨和研究，提出了可行性的方案．该方案的高亮度模式动力学孔径较大；单色模式的托歇克寿命较长、亮度较高；并且能兼容纵向极化束对撞模式．     

Beam dynamics of the superconducting wiggler on the SSRF storage ring

In the SSRF Phase-II beamline project, a superconducting wiggler(SW) will be installed in the electron storage ring. It may greatly impact on the beam dynamics due to the very high magnetic field. The emittance growth becomes a major problem, even after correction of the beam optics. A local achromatic lattice is studied, in order to combat the emittance growth and keep the performance of the SSRF storage ring as high as possible. Other effects of the SW are also simulated and optimized, including the beta beating, the tune shift, the dynamic aperture, and the field error effects.     

Design for the lattice with 4-DBA structure of the compact laser-electron storage ring

We try to design the lattice with 2 super periods and 4-DBA structure in order to provide more drifts for the future development of the TTX source. Due to the space limitation in the lab, the 4-DBA lattice is suitable.In the paper,we present the lattice design with a 4-DBA structure mainly for the pulse mode of the compact laser-electron storage ring (LESR). Element parameters of the lattice are optimized with the help of the professional software and beam dynamics such as intra-beam scattering (IBS) and Compton scattering (CS) are calculated. Besides, the fringe field effect is analyzed with the numerical method.     

Preliminary application of turn-by-turn data analysis to the SSRF storage ring

There is growing interest in utilizing the beam position monitor turn-by-turn (TBT) data to debug accelerators. TBT data can be used to determine the linear optics, coupled optics and nonlinear behaviors of the storage ring lattice. This is not only a useful complement to other methods of determining the linear optics such as LOCO, but also provides a possibility to uncover more hidden phenomena. In this paper, a preliminary application of a β function measurement to the SSRF storage ring is presented.     

四瓣高斯光束的Gyrator变换性质和矩形空心光束的产生

基于Gyrator变换,推导了四瓣高斯光束场分布的解析表达式,研究了四瓣高斯光束通过Gyrator变换后的光强分布和相位分布.结果表明:在Gyrator变换过程中,四瓣高斯光束能够转换为具有光涡旋的矩形空心光束,在获得矩形空心光束时其四顶角处光束强度最强,而四条边上的光束强度分布几乎是均匀的.对影响矩形空心光束强度和相位分布的光束参数和变换角进行了详细的分析,发现光束阶数不同,产生不同类型的空心光束;Gyrator变换的变换角则影响空心光束能量分布;空心光束亮环的大小由四瓣高斯光束的束腰宽度决定,束腰宽度越大,矩形空心光束的宽度越小.     

Optics for the lattice of the compact storage ring for a Compton X-ray source

We present two types of optics for the lattice of a compact storage ring for a Compton X-ray source. The optics design for different operation modes of the storage ring are discussed in detail. For the pulse mode optics, an IBS-suppression scheme is applied to optimize the optics for lower IBS emittance growth rate; as for the steady mode, the method to control momentum compact factor is adopted [Gladkikh P, Phys. Rev. ST Accel. Beams 8, 050702] to obtain stability of the electron beam.     

用于太赫兹光源的准等时性储存环的设计

介绍了一种获得准等时性储存环的方案,即调节Lattice参数,在色散段引入负色散函数从而降低线性滑相因子,获得短束团。根据此方案设计了用于相干太赫兹光源的准等时性储存环,结果给出了线形光学函数曲线以及粒子的动力学孔径,表明了通过调节四极铁参数可以达到降低束团长度获得准等时性储存环的目的。还设计了用于准等时性储存环弯铁处的真空室的3维模型,并对其类腔体部分的本征模进行了计算,得到特性阻抗与品质因数的比值在10-3量级以下,表明类腔体部分对束流的影响很小。     

Optics for the lattice of the compact storage ring for a Compton X-ray source

We present two types of optics for the lattice of a compact storage ring for a Compton X-ray source. The optics design for different operation modes of the storage ring are discussed in detail. For the pulse mode optics, an IBS-suppression scheme is applied to optimize the optics for lower IBS emittance growth rate; as for the steady mode, the method to control momentum compact factor is adopted [Gladkikh P, Phys. Rev. ST Accel. Beams 8, 050702] to     

Longitudinal momentum mining of beam particles in a storage ring

I describe a scheme for selectively isolating high density low longitudinal emittance beam particles in a storage ring from the rest of the beam without emittance dilution. I discuss the general principle of the method, called longitudinal momentum mining, beam dynamics simulations and results of beam experiments. Multi-particle beam dynamics simulations applied to the Fermilab 8 GeV Recycler (a storage ring) convincingly validate the concepts and feasibility of the method, which I have demonstrated with beam experiments in the Recycler. The method presented here is the first of its kind.     

Preliminary study of EEHG-based superradiant undulator radiation at the HLS-Ⅱ storage ring

We investigate storage ring-based Echo-Enabled Harmonic Generation(EEHG) superradiant undulator radiation as a possible scheme to obtain shorter wavelengths at the HLS-Ⅱ(Hefei Light Source-Ⅱ) storage ring. In this paper we give the designation of the storage ring based EEHG up to the 26 th harmonic, where 31 nm vacuum ultraviolet light is radiated from an 800 nm seeded laser. The novelty of our design is that both the two dispersion sections of EEHG are realized by the storage ring's own magnet structure. In particular, the whole ring is used as the first dispersion section, and two modulators of the traditional EEHG can be done with the same undulator. These two dispersion sections are realized by changing the superperiod of the present lattice structure, and more precisely by changing the focusing strengths of the present structure. Since no additional magnets and chicanes are used,the beam circulates around the storage ring repeatedly, and thus this storage ring-based EEHG can have a higher repetition rate than a linac-based EEHG.     

Simulation and analysis of the transverse spectrum in HIRFL-CSR

Particles in a storage ring oscillate in the longitudinal and transverse dimensions.Therefore,the signal that beam has generated can be analyzed in the frequency domain to extract many beam parameters,such as tune,momentum spread,emittance and their evolution with time and so on.In this paper,the transverse spectrum in HIRFI-CSR was simulated and analyzed under different conditions,including electron cooling,hollow electron beam,solenoid effect,the tune shift caused by power supply ripple and the misalignment between ion and electron beams.The result of the simulation shows that the longitudinal magnetic field of the electron cooling device should be compensated by a "compensation solenoid",and the power supply ripple must be controlled,otherwise the accumulation would be affected and the beam would be lost.     

Kicker magnet modulator in the 2-GeV Pohang light source

The 2.0-GeV Pohang light source (PLS) is a third-generation synchrotron light source that is the first such facility in Korea and the fifth in the world. The PLS mainly consisted of a full-energy injection linac and a storage ring. Four kicker magnets are installed in the storage ring tunnel to move the stored beam orbit in the storage ring closer to the injected beam from the beam transfer line. The injected beam then falls into the storage ring beam dynamic aperture. A kicker magnet modulator drives all four kicker magnets to maintain field balance and synchronized kick of the beam. Specification of the kicker magnet modulator is ~6.0-μs-full width, 200-ns flattop width with ±0.2% regulation, ~24-kA peak current, and 10-Hz repetition rate. Two thyratron switches (EEV CX-1536AX) are used in the system. As the inverse voltage is dangerous to thyratron operation, a new surge suppression circuit was developed. The kicker modulator has been operated very reliably since its installation in August 1995. In this article, design, simulation, and experimental results of the kicker magnet modulator are discussed. In addition, measurement result of spatial B-field distribution in the kicker magnet and maximum operating range of kicker magnet are discussed     

Research on taper zone coupling from single-core fiber to annular-core hollow beam fiber

Optical Review - We designed and manufactured a novel annular-core hollow beam fiber which could directly yield ring light with a central dark spot inside the beam employing MCVD technique and a...