测定双层组合介质接触热阻

 当激光辐照双层固体组合介质的外表面时，在变物性及界面接触热阻不变的条件下，数值计算了介质内部温度场时空分布。实验测定该双层介质背面对应点的温度曲线，与数值计算的结果进行比较，从而确定介质界面间的接触热阻。     

Elastoplastic contact between randomly rough surfaces

I have developed a theory of contact mechanics between randomly rough surfaces. The solids are assumed to deform elastically when the stress sigma is below the yield stress sigma(Y), and plastically when sigma reaches sigma(Y). I study the dependence of the (apparent) area of contact on the magnification. I show that in most cases the area of real contact A is proportional to the load. If the rough surface is self-affine fractal (Hurst exponent H) the whole way up to the lateral size L of the nominal contact area, then (assuming no plastic deformation) A approximately L(H).     

低温下固体接触热阻与接触电阻的实验研究

在低温工程中,两个接触固体之间存在着接触热阻与接触电阻,将对低温实验中热量及电流的传输产生显著的影响,是进行低温下物性研究的关键。自行研制了一套可同步实现固体接触热阻和接触电阻的测量装置,该系统具有较高的精度,可实现外界力、温度等对接触热阻的测量,同时具备接触电阻的实时测量功能。在此基础上,开展了外界压力、温度、电流对接触热阻和接触电阻的实验研究。实验结果显示:随着压力的增大,接触热阻与接触电阻随之减小;低温下,随着温度的增大接触热阻与接触电阻增大,接触电阻增大的速率要比接触热阻快。温度平衡时,20mA范围内的电流变化对接触电阻的影响显著,对接触热阻影响非常小。当界面温度达到室温后,首次观测到接触热阻和接触电阻会随着温度的增大而减小。     

Method for calculating the contribution of inelastic electron-electron scattering lifetimes of electronic states on (110) noble metal surfaces

A method for calculating the decay rate of surface states on the (110) noble metal surfaces within the GW approximation is described in detail. The band structure is described by a two-dimensional pseudo-potential model. As an example, the calculated lifetimes of surface states at the [`(Y)] \bar{Y} point on Cu(110) are presented. The calculated lifetime of the occupied state is approximately 2 times greater than that of the unoccupied state. The result obtained for the occupied surface state is in good agreement with the photoemission data.     

空间相机接触热阻的计算

为了解决空间相机接触热阻难以确定的问题,从接触面传导和辐射换热的角度考虑,给出了其接触热阻的计算方法。根据空间相机的材料、加工、装配及其特殊运行环境,得到一个合理的接触系数范围。以空间相机的正视相机为例,对其结构进行合理的简化,利用I-DEAS/TMG热分析模块建立有限元模型,仿真计算了低温稳态平衡工况,考查了热阻波动对温度分布的影响。正视相机热分析计算结果和热环境模拟试验数据较为吻合,最大偏差为0.45℃。研究结果表明,该接触热阻计算方法合理,可以预测太空环境中干接触的精密加工表面间的接触热阻。     

接触角与液固界面热阻关系的分子动力学模拟

本文利用分子动力学方法模拟了液体在固体表面的 接触角及液固界面热阻, 并探讨了二者之间的关系. 通过分别改变液固结合强度和固体的原子性质来分析接触角和界面热阻的关系及变化趋势. 模拟结果显示增强液固间相互作用时, 接触角减小的同时界面热阻也随之单调减小; 而改变固体原子间结合强度和原子质量时, 接触角几乎保持不变, 但界面热阻显著改变. 固体原子间结合强度和原子质量影响界面热阻的原因是其改变了固体的振动频率分布, 导致液固原子间的振动耦合程度发生变化. 本文的结果表明界面热阻不仅与由接触角所表征的液固结合强度有关, 还与液固原子间的振动耦合程度有关. 接触角与界面热阻间不存在单值的对应关系, 不能单一地将接触角作为液固界面热阻的评价标准. 关键词： 液固界面 接触角 界面热阻 分子动力学模拟     

Mass-filtered cobalt clusters in contact with epitaxially ordered metal surfaces

Mass-filtered cobalt clusters with a size between 5 nm and 12 nm have been deposited in situ under soft-landing conditions onto epitaxially ordered iron and nickel films. The spin and orbital moments of both the clusters as well as the substrate films have been investigated using the element-specific method of X-ray magnetic circular dichroism in photoabsorption. Here, the ferromagnetic films with in-plane magnetic anisotropies have been used to magnetize the clusters remanently without applying external magnetic fields during the measurements. Experimental results from the cobalt clusters are discussed with respect to the different substrates. Furthermore, the influence of oxygen exposure on the spin and orbital moments of cobalt clusters has been investigated in in situ oxidation experiments. PACS 73.22.-f; 75.70.-i; 75.75.+a; 81.07.-b     

Signature of a chemical bond in the conductance between two metal surfaces

Conductance in monatomic metal contacts is quantized; it increases in discrete steps of one conductance quantum 2e(2)/h. By contrast, in a vacuum barrier between two metal surfaces we find that conductance increases linearly and continuously with the interaction energy between individual atoms. This behavior shows unambiguously that current flow between single atoms is a measure for their chemical interaction. In the controlled environment of a scanning tunneling microscope it should allow us to study the formation of covalent bonds up to the point where these atoms finally jump into contact.     

Rolling resistance moment of microspheres on surfaces: contact measurements

Using contact measurements, experimental evidence was obtained for the existence of the rolling resistance moment. The critical rolling distance prior to detachment is reported. Previously it has been argued that the critical rolling distance should be related to the lattice size and/or the molecular length of the particle and surface materials. However, there has been no theoretical prediction for the critical value and, currently, the reasons for its existence are not fully understood. For polystyrene latex (PSL) particles, measurements presented in the current study on silicon suggest much higher values for the critical rolling distance than previous anticipated levels. The current approach can also be employed to measure the work of adhesion between a spherical particle and a flat surface without the prior knowledge of the particle diameter since the rolling moment stiffness is directly proportional to the work of adhesion with no dependence on the diameter of the particle. Experimental results are compared with the available data and good agreement between the theoretical predictions and the experimental values is found.     

分子尺度上水和金属表面的相互作用

虽然水普遍存在,但人们在分子尺度上对水与固体表面的相互作用的理解却仍然处在初始阶段.文章简述了20年来人们对水在贵金属表面的吸附和浸润过程进行微观尺度上研究的进展,分析和讨论了水和表面作用的一般规律和所获得的经验教训,特别着重讨论了对上世纪80年代人们提出的经典双层冰模型的修正.     

分子尺度上水和金属表面的相互作用

虽然水普遍存在,但人们在分子尺度上对水与固体表面的相互作用的理解却仍然处在初始阶段.文章简述了20年来人们对水在贵金属表面的吸附和浸润过程进行微观尺度上研究的进展,分析和讨论了水和表面作用的一般规律和所获得的经验教训,特别着重讨论了对上世纪80年代人们提出的经典双层冰模型的修正.     

Nondestructive measurement of thermal contact resistance for the power vertical double-diffused metal-oxide-semiconductor

To obtain thermal contact resistance(TCR) between the vertical double-diffused metal-oxide-semiconductor(VDMOS) and the heat sink, we derived the relationship between the total thermal resistance and the contact force imposed on the VDMOS. The total thermal resistance from the chip to the heat sink is measured under different contact forces, and the TCR can be extracted nondestructively from the derived relationship. Finally, the experimental results are compared with the simulation results.     

Depositing aluminum as sacrificial metal to reduce metal–graphene contact resistance

Reducing the contact resistance without degrading the mobility property is crucial to achieve high-performance graphene field effect transistors. Also, the idea of modifying the graphene surface by etching away the deposited metal provides a new angle to achieve this goal. We exploit this idea by providing a new process method which reduces the contact resistance from 597 ? ·μm to sub 200 ? ·μm while no degradation of mobility is observed in the devices. This simple process method avoids the drawbacks of uncontrollability, ineffectiveness, and trade-off with mobility which often exist in the previously proposed methods.     

Temperature coefficient of resistance of thin metal films on ceramic surfaces

The temperature coefficients (TCR) of vacuum-deposited thin-metal-film resistors were measured in vacuum, air, argon, and silicone oil, and different characteristics were obtained. The resistors were made by evaporating a nickel-chrome alloy (Nichrome 80 to 20) in vacuum onto ceramic substrates to produce a 500-ohms-persquare film. Measurements were made of films which were uncoated and of films which were coated with a protection layer of silicone monoxide in thicknesses from 5000 to 10000 å. When measured under vacuum, the resistors displayed a TCR which was lower than that obtained in air, argon, or silicone oil. In an argon environment, the resistors had lower TCR characteristics than they had in air or silicone oil. Even when the resistor films were protected by a 10000-å-thick layer of silicone monoxide, their TCR behavior differed in different gas environments. Most of the TCR's measured in the temperature range from ?55Ω to +150Ω C were between 5 and 50 parts per million per degree centigrade.     

On the interaction between chemisorbed atoms at transition metal surfaces

A model hamiltonian is derived describing the interaction of two adsorbates. The nonorthogonality of the basis set is converted into a renormalization of the matrix elements. The interaction energy, direct and indirect of two hydrogen atoms and single particle spectral densities are calculated for adsorption on a semi infinite simple cubic solid. Correlation effects are included by a variational ansatz.     

Spin coupling between cold atoms and the thermal fluctuations of a metal surface

We describe an experiment in which Bose-Einstein condensates and cold atom clouds are held by a microscopic magnetic trap near a room-temperature metal wire 500 microm in diameter. The lifetime for atoms to remain in the microtrap is measured over a range of distances down to 27 microm from the surface of the metal. We observe the loss of atoms from the microtrap due to spin flips. These are induced by radio-frequency thermal fluctuations of the magnetic field near the surface, as predicted but not previously observed.