A new type of two-dimensional packed+capillary column GC system. III. Instrumentation

Summary The constractional details of precolumns, its oven and connector have been given with two types of multiflow control modules. Two types of phases made in China, a silanized pellicular beads and a non silanized pellicular silica beads, with an optimum particle size of 20μm to 30μm were packed in the precolumn 20mm in length with the column efficiency of 4620 plates/meter at column temperature of 49°C. A 25m×0.22mm i.d. capillary column coated with bonded methylsilicone phase from Chrompack connected with the precolumn (250°C) has an efficiency of 5376 plates/meter for n-octane. But it decreased to 3149 plates/meter by decreasing the precolumn temperature to 130°C.     

A new type of two-dimensional packed + capillary column GC system. II. System and applications

Summary A packed column containing immobilized SE-54 liquid phase on pellicular silica beads ZIPAX and having a high efficiency and high mass transfer rate has been successfully used in a two-dimensional packed+capillary column system without a cold trap. The application of this system is demonstrated by the analysis of C₆-C₈ aromatic hydrocarbons and lowboiling hydrocarbons present in natural oils, and of highboiling components present in low concentrations in a low-boiling solvent.     

GC with LC-like packed capillary columns

Capillary columns of 0.3–0.35 mm internal diameter and 0.3–7.7 m length, packed with 3 to 30 μm octadecylsilica stationary phases as used for liquid chromatography, were applied to gas chromatographic separation of low boiling hydrocarbons. Van Deemter plots for these columns showed the optimum column efficiency to occur at linear velocities of 4–5 cm/s. A short column was applied to the rapid separation of components of a natural gas and impurities in standard gases, while a long column was applied to the separation of complex mixtures.     

A new type of capillary column for gas chromatography

A new type of capillary column for gas chromatography was proposed. A sorbent layer (for example, stationary liquid phase) is supported on the internal capillary surface, and the internal (interstitial) volume is packed with nonporous large particles of a sorbent (particle diameter is 0.1—0.6 of the capillary internal diameter). The external surface of the particles can also be coated with the sorbent layer (for example, stationary liquid phase). The specific separation efficiency (number of separation) on the new type column is by 1.6—2.3 times higher than that of the initial classical capillary column.     

Modification of a packed GC injector to a versatile capillary injector

A modification of a packed GC injector to a capillary injector is presented using a simple device which is connected to the GC column by an adsorption-free connector. It permits injections of large sample volumes up to 500 μl hexane solutions on normal 0.3 mm i.d. capillary columns. No special requirements for the stationary phase are necessary. Involatile residues remain inside the device which can be exchanged easily. High performance of separation and quantification is achieved.     

Gas chromatography of plasma amino acids using a wide bore column: Comparison with packed and capillary columns

A procedure is described in which a wide bore glass capillary column is used as an alternative to the more traditional packed column in the analysis of amino acid levels in plasma. The coefficients of variation for all amino acids (with the exception of aspartic acid) were better than 11% with recoveries ranging from 81% to 122%. The data are compared with the corresponding results obtained using a packed column and show significant differences (p < 0.005) between values for glycine, serine, isoleucine, proline, methionine, aspartic acid, phenylalanine, and lysine. A similar comparison between results from the wide bore and the fused-silica open tubular (FSOT) column shows better agreement. Adjustment of chromatographic conditions for the wide bore analysis yields results in good agreement with those from FSOT analysis but which still differe significantly from the backed column data.     

Analysis of gases containing inorganic and organic compounds using a combination of a thick-film capillary column and a packed adsorption column

A gas chromatographic system consisting of one multiport valve, two (hot-wire and flame-ionization) detectors and two analytical columns (one thick-film capillary and one packed adsorption column) is used for the analysis of gas samples containing a number of inorganic compounds (hydrogen, argon, oxygen, nitrogen, carbon monoxide, and carbon dioxide) and organic compounds. Examples include samples containing hydrocarbons up to n-nonane and benzene and toluene. The system also permits the analysis of more complicated samples containing, for example, alcohols, in addition to hydrocarbons.     

Cold trap/reinjection interface for two-dimensional gas chromatography

The construction and evaluation of an interface for two-dimensional gas chromatography is described. The interface consists of commercially available components and is attachable to available gas chromatographs without any major modifications. The interface has been constructed so as to permit “heartcutting” as well as solute band concentration. Trapping is performed in a simple cold trap of fused silica. Flow switching is accomplished by Deans switching. Factors of the over-all chromatographic performance are examined.     

The investigation and application of the packed glass capillary column with a core

A new type of packed glass capillary column (PGCC) with a core, and its potential usage in practice are described. The permeability of the column is considerably greater than that of conventional PGCC and its N/(P_i-P_o) value is also higher. This novel PGCC column has been successfully applied to the analysis of trace levels of ethyne, cyclopropane, propadiene, propyne, and other C₁? C₄ impurities in pure ethene, propene, 1,3-butadiene, and catalytic cracking gas samples as well as other petrochemical gases such as liquified petroleum gas.     

Programmed cold sample introduction and multidimensional preparative capillary gas chrornatography. Part I: Introduction,design and operation of a new mass flow controlled multidimensional GC system

A new design of a mass-flow controlled multidimensional switching system for capillary gas chromatography is introduced and discussed. Large sample amounts can be introduced with a required input band width onto the first column. A combination of cold sample introduction and successive high speed programmed heating of the injector liner is used for this purpose. The potential of such an approach for selective and fast high resolution separations with series coupled wide bore, thick film columns is emphasized, and illustrated for various concentrations.     

Determination of alcohols in gasoline blends using a multi-dimensional switching system

Methanol, 2-Me-propanol-2, propanol-2, benzene, toluene and xylenes in gasoline blends were determined using a valveless multi-dimensional switching system (MDSS) with two packed columns and temperature programming. Compounds of interest, interfering with paraffins and naphthenes, were in a sequence of four heart cuts transferred onto the second column. The resulting baseline separation enabled precise quantitative measurement within a short analysis time. Instrument settings, times of switching and integration parameters were stored in an instrument memory file (user table) and thus high precision in the measurements was achieved.     

The theoretical basis of column chromatography in multicomponent separations. Part 1: Analytical requirements and peak resolution. Development of a high performance column system

The point of our published papers since 1957 is reviewed. The relations between the required value of peak resolution, K₁ (or R), and peak separation, K₃ (eqn 9); K₁ and relative accuracy of a peak height quantitative method, P_h (eqn. 10); K₁ and relative accuracy of a peak area method, P_a, (eqn. 12) at different concentration ratios, ?, are derived. The final result in Table 2 shows a large influence of ? on the required value of K₁. The approximately linear relation between peak width and retention value (eqn. 18) exists not only in GC. but also in HPLC. Plate height values H¹ and H^∞ for a solute with capacity ratio, k′, equal to unity or approaching infinity, respectively, are used to evaluate the column efficiency (eqn. 20). The measuring methods (eqn. 21,22,23) and parameters effecting on H¹ and H^∞ are given for GC packed column (eqn. 24), GC open tubular column (eqn. 25) and HPLC (eqn. 26). In the light of this, columns of high efficiency were developed. Some typical chromatograms for high speed analysis and separation of complex mixtures are given.