5H-苯基联苯膦磺化产物的薄层色谱分离

1 引 言5H－苯基联苯膦（5H-phenyl-dibenzophosphole, PDBP）的磺化产物是一种多组分的复杂混合物,在石油化学工业具有很好的应用前景。5H－苯基联苯膦是三苯基膦的衍生物,是三苯基膦经桥连反应生成。经与发烟硫酸/硼酸的无水混合物反应,氢氧化钠中和,生成PDBP磺酸钠的混合物。混合物中除了可能含有目标产物二磺化PDBP和三磺化PDBP外,还可能含有取代位置不同的一磺化产物的异构体,二磺化和三磺化PDBP的氧化物,以及Na2SO4等。有关PDBP磺化产物分离方法的研究,目前尚未见报道。作者尝试用薄层色谱法来分离该混合物,通过…     

5H-苯基联苯膦磺化产物中氧化组分的结构鉴定

用薄层色谱法制备了5H-苯基联苯膦磺化产物中氧化组分，即A斑和B斑的纯品；分别用电喷雾质谱（ESI-MS）、^13C和^1H核磁共振波谱（^13C-NMR，^1H-NMR）及红外光谱法（IR）鉴定其结构。经ESI-MS、^13C-NMR、^1H-NMR和IR谱的解析，发现4种谱图相互对应，证明了A斑和B斑组分分别为二磺化和三磺化苯基联苯膦的氧化物，从而为选择最佳合成工艺条件提供依据。     

薄层色谱法测定消毒液和合成产品中的3,5-二甲基对氯苯酚

 对氯代二甲苯酚类化合物的薄层色谱分离条件进行了研究 ,建立了以苯 氯仿 (体积比为 2∶3 )的混合溶剂为展开剂 ,以GF2 54薄层板为层析板 ,直接测定 3 ,5 二甲基对氯苯酚含量的薄层色谱扫描方法。其被测组分的质量浓度在 0 185 8g/L～ 7 4 3 2 0g/L范围内与相应的峰面积的线性关系良好 ,相关系数为 0 9994。利用该方法对市售消毒液及氯代二甲苯酚类化合物合成过程中的题示化合物进行分析 ,取得了令人满意的结果。     

离子色谱法测定2-羧乙基苯基次膦酸中的氯离子

建立离子色谱法测定2-羧乙基苯基次膦酸中氯离子的含量。样品用超纯水溶解稀释,过0.22μm滤膜;选用SH–AC–2阴离子分离柱,以30 mmol/L Na OH溶液作为淋洗液,流量为1.0 m L/min,进样体积为50μL,以抑制电导检测器测定氯离子的含量。氯离子的质量浓度在0.01~1.00 mg/L范围内与色谱峰面积线性关系良好,相关系数为0.996,氯离子的检出限(S/N=3)为1.0μg/L。测定结果的相对标准偏差小于10%(n=6),样品加标回收率为94.7%~103.5%。该方法简便、快速且灵敏,可用于2-羧乙基苯基次膦酸中氯离子的测定。     

含全氟联苯结构的磺化聚二氮杂萘酮醚氧膦质子交换膜的制备与性能

将全氟联苯、 二(4-氟苯基)苯基氧膦与4-(4′-羟基)苯基-2,3-二氮杂萘酮共聚, 合成了含全氟联苯结构的聚二氮杂萘酮醚氧膦, 再经磺化反应, 制备了含全氟联苯结构的磺化聚二氮杂萘酮醚氧膦(sPEPOF-x, x为含氟重复单元的摩尔分数)质子交换膜. 由于强疏水全氟联苯结构促进了聚合物膜的亲水/疏水微相分离, 提高了质子电导率, 降低了溶胀率, sPEPOF质子交换膜表现出优良的综合性能. 在80 ℃下, sPEPOF-25质子交换膜的溶胀率仅为10%, 约为Nafion 117的一半, 而其电导率为0.099 S/cm, 约为Nafion 117的1.2倍, 且耐氧化稳定性好, 热稳定性高, 具有潜在的应用前景.     

5-(对-羟基苯基):-5-苯基乙内酰脲的反相高效液相手性分离测定法

以β－ＣＤ为手性流动相添加剂、苯巴比妥为内标,于ＦＬＣ－Ｃ８反相柱上建立了鼠肝微粒体中５－（对－羟基苯基）－５－苯基乙内酰脲（ｐ－ＨＰＰＨ）外消旋体的拆分方法。测得ｐ－ＨＰＰＨ对映体的线性范围为０．５～１１０ｍｇ／Ｌ（ｒ＝０．９９９６）;最低检出量为５ｎｇ（Ｓ／Ｎ＝３）;Ｓ－ｐ－ＨＰＰＨ的回收率为９３．６％±２．８％,Ｒ－ｐ－ＨＰＰＨ的回收率为９４．７％±１．８％;日内和日间精密度ＲＳＤ值均小于２％。所建立的方法具有结果准确、操作方便等特点。     

高效液相色谱法测定联苯取代衍生物的三种异构体

A method for the separation and deternunation of three isomers of 4-nitro-methyldiphenyl by reversed-phase HPLC is described.The method for quantitative analysis without standard substance was studied with satisfactory results.     

Determination of potential degradation products of piroxicam by HPTLC densiometry and HPLC

Summary HPTLC densitometry and HPLC are considered for the simultaneous determination of the degradation products of piroxicam (2-aminopyridine, DP-I and DP-II). The substances were separated on silica gel with fluorescence indicator in ethylacetate — toluene — diethylamine (10∶10∶5) and toluene — absolute ethanol — glacial acetic acid (8∶1.2∶0.5) systems. The measuring absorbance (detection of reflectance) of the separated substances was carried out “in situ” at 296 nm using 4-level calibration (external standard, nonlinear regresson function) in the concentration range 600–1200 ng 2-aminopyridine/spot and 300–600 ng DP-I and DP-II/spot. The HPLC method was carried out using RP-8 stationary phase and methanol + phosphate-citrate buffer, pH 3 mobile phase with addition of sodium pentanesulfonate (40+60, v/v). 2-aminopyridine wass detected at 300 nm, DP-I at 280 nm and DP-II at 248 nm. The concentration range for 2-aminopyridine is 2–40 μg/ml, for DP-I and DP-II 2–20 μg/ml (for an injection volume of 10 μl). The results were evaluated by linear regression analysis.     

Coupling protocol for thin layer chromatography/matrix-assisted laser desorption ionization

Summary This paper reports the investigation and optimization of the thin layer chromatography/matrix-assisted laser desorption/ionization (TLC-MALDI) coupling protocol. The fundamental coupling parameters which influence sensitivity and lateral analyte spreading are extraction solvent selection, extraction time, and pressure. Selection of the solvent is dependent upon its extraction efficiency, which has been correlated with extraction solventR _f value. Maximum extraction efficiency occurs after two minutes for the analyte/solvent system studied. High extraction efficiency solvents cause significant lateral spreading of analyte; up to a three-fold increase in initial analyte spot size. Analyte recovery was found to be limited by the silica gel inter-partice porosity and the solvent extraction efficiency. For maintaining chromatographic resolution and maximizing signal intensity, extraction solvents withR _f values between 0.4 to 0.6 are optimal. The upper analyte recovery limit, using extraction solvents within thisR _f range, is estimated at 22%. Dedicated to Professor Werner Haerdi on the occasion of his 70^th birthday.     

Determination of vanillin and related flavor compounds in natural vanilla extracts and vanilla-flavored foods by thin layer chromatography and automated multiple development

Summary Thin layer chromatography on silica gel high performance layers and automated multiple development was used to separate the polar aromatic flavor compounds vanillin, ethyl vanillin, 4-hydroxybenzaldehyde, 4-hydroxybenzoic acid, 4-hydroxybenzyl alcohol, vanillic acid, coumarin, piperonal, anisic acid, and anisaldehyde commonly found in extracts of natural and artificial vanilla flavors. The ratio of 4-hydroxybenzoic acid, 4-hydroxybenzaldehyde and vanillic acid to vanillin in natural vanilla extracts was used to confirm the authenticity of extracts purchased in the United States of America and the United Kingdom. Natural vanilla extracts purchased in Mexico and Puerto Rico were identified as counterfeit products based on changes in the above ratio and the presence of synthetic flavor compounds such as ethyl vanillin and coumarin. It is also demonstrated that the proposed method is suitable for the determination of natural and synthetic vanilla flavors in solvent extracts from food, beverage and confectionery products. The main advantage of thin layer chromatography for the analysis of vanilla extracts and food stuffs flavored with vanilla is its high sample throughput since sample preparation requirements are minimal and multiple samples can be separated simultaneously.     

毒鼠强薄层色谱分析的检出限

建立薄层色谱法快速对毒鼠强进行简易分析的方法,利用薄层色谱进行层析分离,采用特殊显色方法,对毒鼠强进行显色,以能正常观察到斑点的色泽状态,辅助GC-MS方法确定检出极限。薄层色谱法分析毒鼠强检出限可达5~10μg。能用此方法对大多数中毒案件提取的检材进行定性分析。     

Separation of PAHs in aerosol by thin layer chromatography for compound-specific stable carbon isotope analysis

A method using a thin layer chromatography (TLC) for compound-specific stable carbon isotope analysis of polycyclic aromatic hydrocarbons (PAHs) with four to seven rings was developed in this study. Five aerosol samples were used as test samples. Two stationary phases and eight developing systems were tested. The results indicated: (1) silica gel is superior to aluminum oxide and the silica gel precoated plate developed with hexane:chloroform (45:5, v/v) can give the best separation effect; (2) individual PAHs associated with aerosols can be effectively separated from unresolved complex mixture (UCM) by this procedure. The carbon isotope composition of PAHs can be measured with a standard deviation (S.D.) < 0.5‰, n = 4. No significant isotopic fractionation was observed during the TLC procedure. And this technique can be used as a potential tool for source identification of PAHs in the aerosols.     

Impregnated silica-based layers in thin layer chromatography

Abstract

Impregnated thin-layer chromatography (TLC) layers based on silica gel are presented. Impregnating agents such as metal cations, inorganic ions, chelating agents, chiral selectors, surfactants, ion-pairing reagents, and ionic liquids are discussed. The role of impregnated TLC layers in medicinal chemistry is highlighted. The historical overview of TLC separations on physically coated layers is given and some future prospects ahead of this technique are discussed.     

In-product jojoba determination using anticircular high performance thin layer chromatography

Cosmetic creams were analyzed for their content of jojoba wax and shea fat using anticircular HPTLC, a fast, precise, and reliable method. After optimization of the solvent system (petrol ether/diethyl ether) for the separation of jojoba wax and shea fat, the spots were visualized with phosphomolybdic acid by the “dip-in” technique, subsequently heated, and finally recorded by scanning with a densitometer at 546 nm. Results showed that one particular concentration range gives an optimum correlation between calibration curves and sample evaluations.