Re-evaluated data of dissociation constants of alendronic, pamidronic and olpadronic acids

The dissociation constants of (4-amino-1-hydroxybutylidene)bisphosphonic (alendronic) acid, (3-(dimethylamino)-1-hydroxypropylidene)bisphosphonic (olpadronic) acid and (3-amino-1-hydroxypropylidene)bisphosphonic (pamidronic) acid were obtained in aqueous solutions (0.10 M KCl) and micellar solutions of cetylpyridinium chloride (0.10 M CPC) at 25.0°C. With the exception of the third dissociation constant of alendronic acid, the dissociation constants of alendronic, olpadronic and pamidronic acids in aqueous solutions matched literature data. The possibility of sodium alendronate determination by acid-base titration by NaOH solution was theoretically grounded on the basis of re-evaluated data of alendronic acid dissociation constants.      

Preliminary results of a quick,simple method of detecting antimony in water samples

Preliminary results of development of a direct and fast method of determination of antimony in samples of tap water using GFAAS are presented. The found levels of antimony were lower than permitted for human consumption. A mixture of Pd and Mg(NO₃)₂ (concentrations in the injected solution: 8.6 μg mL⁻¹ and 5.8 μg mL⁻¹ respectively) was used as the chemical modifier. The pyrolysis and atomization temperatures were 1000 and 1700°C, respectively and the mean analytical recovery 98.2%.      

Textured nickel tapes prepared from commercially available material

Textured Ni tapes were fabricated from commercially available nickel pellets (98.5% Ni). Ingots produced by a melt process were cold rolled to 150–400 μm thick tapes. Texturing was achieved by annealing in a reducing atmosphere (Ar + 6.5% v/v H₂). Sharp cubic biaxial textured Ni tapes were obtained by thermal treatment at 1000°C for 2 hours in a reducing atmosphere. The tapes were characterized by scanning electron microscopy, X-ray diffraction and by electron backscattering diffraction. The tensile strength, the thermal expansion behavior and the Vickers hardness for the cold rolled tapes and for the heat-treated tapes were measured.      

N-hexylpyridinium bis(trifluoromethylsulfonyl)imide and Lewis acids — catalytic systems for Diels-Alder reaction

A comparative study of the Diels-Alder reactions between cyclopentadiene (1) and dienophiles (2 a–c) in N-hexylpyridinium bis(trifluoromethylsulfonyl)imide in a temperature range of 20–45°C is reported. The reaction rate constants and activation energies were calculated. Moreover, the catalytic systems based on N-hexylpyridinium bis(trifluoromethylsulfonyl)imide and Lewis acids were tested as a reaction media to perform the Diels-Alder reaction. Yb, Y, Mg, Zn triflates and chlorides (0.005 to 0.1 mmol) were used as catalysts. The recycling of catalytic system consisted of YCl3 and ionic liquid was performed.      

Ugi products containing boronate esters

The Ugi reaction with formylphenylboronic acid derivatives as the carbonyl component proceeds to give the corresponding boron-containing dipeptide derivatives (Ugi products) in good yields.      

Kinetics and mechanism of the C-S coupling reactions of aryl Grignard reagents with aryl arenesulfonates

The kinetics of the C-S coupling of arylmagnesium bromides with phenyl tosylate has been studied in THF: toluene at 90°C. The reaction is first order in Grignard reagent and first order in phenyl tosylate. Kinetic data, Hammett relationship and activation parameters are consistent with a nucleophilic addition mechanism involving rate determining attack of carbanion to sulfonyl group followed by a fast phenoxide group leaving.      

Dispersive liquid-liquid microextraction and liquid chromatographic determination of pentachlorophenol in water

A simple and sensitive dispersive liquid-liquid microextraction method for extraction and preconcentration of pentachlorophenol (PCP) in water samples is presented. After adjusting the sample pH to 3, extraction was performed in the presence of 1% W/V sodium chloride by injecting 1 mL acetone as disperser solvent containing 15 μL tetrachloroethylene as extraction solvent. The proposed DLLME method was followed by HPLC-DAD for determination of PCP. It has good linearity (0.994) with wide linear dynamic range (0.1–1000 μg L⁻¹) and low detection limit (0.03 μg L⁻¹), which makes it suitable for determination of PCP in water samples.      

Cadmium ions and cadmium sulphide particles in γ-titanium dihydrogen phosphate. Synthesis, thermal behaviour and X-ray characterization

Layered compounds with CdS particles supported on the ion-exchanger, γ-titanium dihydrogen phosphate, were prepared by the stepwise reaction of the ion-exchanger and cadmium solution, followed by reaction with H₂S gas. The CdS content on the ion-exchanger is dependent on the timeframe of the H₂S gas flow. The materials obtained were layered, as shown by the X-ray measurements that exhibit both precursor and CdS diffraction peaks. The thermal treatment of the material obtained gives evidence of its stability (≤ 320°C) before the CdS decomposition, which occurs in a single step.      

Fabrication of biaxial textured NiO on Ni in a one-step process

A novel method for the preparation of biaxial textured nickel oxide on commercially available nickel via a modified surface oxidation epitaxy (SOE) process has been developed. Following studies of different heat-treatment procedures for both texturing of nickel and for the fabrication of nickel oxide the following method was found to yield the best results. Nickel was first textured under an argon — hydrogen atmosphere at 1000°C for 120 min, then the temperature was lowered to 800°C and the atmosphere was changed to argon with 3 ppm oxygen. Smooth and crack free c-axis textured and a–b aligned NiO buffer layers with an out-of-plane texture of 7.8° and an in-plane texture of 9.4° were successfully produced. Higher oxygen partial pressure and temperatures resulted in increased surface roughness and excessive grain growth.      

Kinetic study of the decomposition of Prussian Blue electrocatalytic layer during cathodic reduction of hydrogen peroxide

Kinetic study on the decomposition of Prussian Blue electrocatalytic layer during electrochemical reduction of hydrogen peroxide has been studied in relation to biosensor application of this electrocatalyst. The decomposition has been shown to proceed as a nearly exponential decay process and the corresponding first-order rate coefficients were determined. It has been shown that the decomposition proceeds about 10 times faster in pH 7.3 buffer solution as compared to pH 5.5 buffer. A linear dependence of the decomposition rate on the concentration of hydrogen peroxide has been found.      

Ionic liquid promoted synthesis of bis(indolyl) methanes

1-benzyl-3-methyl imidazolium hydrogen sulphate [bnmim][HSO₄] was found to be an effective catalyst for the condensation reaction of indoles and derivatives with benzaldehydes in microwave irradiation with lower reaction time and higher yields to give bis(indolyl) methanes.      

Palladium(0)-catalyzed amination of allylic natural terpenic functionalized olefins

The palladium(0) catalyzed amination of allylic acetates and carbonates derivatives from terpenic olefins was carried out under mild conditions. The reaction offers a very good method for the preparation of allylic amines and thus to provide a useful entry to new functionalized terpenic olefin products. The mechanism involving a formation of p-allyl-palladium intermediate complex is in good agreement with the results obtained with the optically active substrates, as well as via an analysis of the observed regio-and stereoselectivity.      

Complex formation reactions of palladium(II)-1,3-diaminopropane with various biologically relevant ligands. Kinetics of hydrolysis of glycine methyl ester through complex formation

The interaction of [Pd(DAP)(H₂O)₂]²⁺ (DAP = 1,3-diaminopropane) with some selected bio-relevant ligands, containing different functional groups, were investigated. The ligands used are dicarboxylic acids, amino acids, peptides and DNA constituents. Stoichiometry and stability constants of the complexes formed are reported at 25°C and 0.1 M ionic strength. The results show the formation of 1:1 complexes with amino acids and dicarboxylic acids. The effect of chelate ring size of the dicarboxylic acid complexes on their stability constants is examined. Peptides form both 1:1 complexes and the corresponding deprotonated amide species. DNA constituents form 1:1 and 1:2 complexes. The effect of dioxane on the acid dissociation constants of CBDCA and the formation constant of its complex with Pd(DAP)²⁺ was reported. The kinetics of hydrolysis of glycine methyl ester bound to [Pd(DAP)(H₂O)₂]²⁺ was studied at 25°C and 0.1M ionic strength.      

Efficient synthesis of diarylidene octahydroacridines by one-pot multi-component tandem reactions

A one-pot multi-component reaction is developed for the efficient synthesis of 4,5-dibenzylidene octahydroacridines in high yields. The reaction is performed by the tandem reaction of three molar equivalent aromatic aldehydes with two molar equivalent 4-alkylcyclohexanone in the system of NH₄OAc/HOAc under microwave irradiation.      

Synthesis and structure of new 3,7,10-substituted-phenothiazine derivatives

The synthesis of new 3,7-dibromophenothiazine derivatives bearing bromoalkyl, mercaptoalkyl and alkylthioacetate groups on the N atom at position 10 is reported. The Suzuki coupling reaction of one of these derivatives via the bromine atoms at positions 3 and 7 with bromothiophene derivatives is also discussed.      

The binary system PbO - BiVO4

Phase equilibria established in the PbO - BiVO₄ system over the whole component concentration range up to 1000°C have been investigated. A phase diagram has been constructed using DTA and XRD.      

Surfactant-assisted polyol preparation of nickel powders with different morphologies

Sub-micrometer nickel powders of controlled size and morphology were produced by a surfactant-assisted polyol method, using ethylene glycol (EG) as solvent and reductant in the presence of sodium dodecyl sulfate (SDS) surfactant and NaOH. The resultant Ni powders were characterized by XRD, SEM, EDS, and FTIR. Spherical, hexagonal, and triangular fcc Ni powders from 0.30 to 0.60 μm were obtained in the presence of SDS; irregular spherical fcc Ni powders were obtained in its absence. The concentrations of SDS, NaOH and Ni(CH₃COO)₂·4H₂O greatly influence the product morphology and size.      

Synthesis of Xenbucin using Suzuki reaction catalyzed by Pd/C in water

Xenbucin 1, an analgesic drug, was synthesized in 4 steps using two different routes. The biaryl fragment could successfully be produced via a Pd/C catalysed Suzuki coupling in water using sodium tetraphenylborate as a phenylation reagent. Overall yields of the routes were 36% and 59%, respectively.      

Electrical and optical properties of a single Sb2Se3 nanorod

In this paper we present the methods to chemically synthesize the Sb₂Se₃ nanorods and study the electrical and optical properties of a single Sb₂Se₃ nanorod with an average size of 70 nm in diameter and a length of about 1 μm to 2 μm. The techniques we devised can immobilize and allocate a single nano-object on an electron beam (E-beam) patterned smart substrate. It can also overcome the limitation of the spatial resolution of conventional optical techniques (∼ 1 mm) to obtain optical spectroscopy in an individual nano-object less than 100 nm in size. We also demonstrate the techniques in using E-beam defined metallic coordination markers as electrodes to measure the conductance of a single Sb₂Se₃ nanorod.      

2-(benzimidazol-2-yl)-3-hydroxychromone derivatives: spectroscopic properties and a possibile alternative intramolecular proton phototransfer

Three 2-(benzimidazol-2-yl)-3-hydroxychromone derivatives were synthesized. Their spectroscopic and fluorescent properties, due to excited state intramolecular proton transfer (ESIPT) from OH to carbonyl, were studied. Theoretical possibility of an alternative intramolecular H-bonding and experimental evidence for such behavior are discussed.