Charge balance equations for plutonium

Charge balance equations can be used to obtain relationships among oxidation states in plutonium solutions. These equations are prepared from the initial conditions in the solution; they can be checked using equations of mass and charge conservation.Mound is operated for the U. S. Department of Energy by EG&G Mound Applied Technologies, Inc., under Contract No. DE-AC04-88DP43495.     

Charge conservation applied to experimental data for plutonium solutions

The principle of charge conservation in isolated systems is used to analyze data recorded for an academic thesis. The analysis reveals a gradual chemical reduction of the plutonium during studies of its behavior in dilute aqueous acids. The reduction effect is reproduced in several different studies. The effect was apparently unnoticed by the author.     

Charge vs. spin density waves in the fullerene polymer

Using an effective model Hamiltonian, we performed bond-length-optimized RHF and UHF band structure calculations to describe the electronic structure of the fullerene polymer (C₆₀)_x. For the doped system, the RHF calculations predict a gap on the 100 meV scale, in good agreement with experimental data, and show a special kind of charge-density-wave solution. At certain geometries, when the intercage conjugation is hindered, the RHF calculations are triplet instable: A carefully chosen initial guess to UHF leads to a small-amplitude spin-density-wave solution. © 1997 John Wiley & Sons, Inc.     

Elementary steps for charge transport in DNA: thermal activation vs. tunneling

Using stacks of Watson–Crick base pairs as an important example of multichromophoric molecular assemblies, we studied charge migration in DNA with special emphasis on the mechanism of hole hopping between neighboring guanines (G) connected by the adenine–thymine (AT) bridge. The tight-binding model proposed for this elementary step shows that for short AT bridges, hole transfer between two G bases proceeds via quantum mechanical tunneling. By contrast, hopping over long bridges requires thermal activation. The condition for crossover between tunneling and thermal activation near room temperature is specified and applies to the analysis of experimental data. We show that thermal activation dominates, if the bridge between two G bases contains more than three AT pairs. Our theoretical findings predict that the replacement of AT base pairs by GC pairs increases the efficiency of hole transport only in the case of short base pair sequences. For long sequences, however, the opposite effect is expected.     

Charge recombination versus charge separation in donor-bridge-acceptor systems

Optimizing the ratio of the rates for charge separation (CS) over charge recombination (CR) is crucial to create long-lived charge-separated states. Mastering the factors that govern the electron transfer (ET) rates is essential when trying to achieve molecular-scale electronics, artificial photosynthesis, and also for the further development of solar cells. Much work has been put into the question of how the donor-acceptor distances and donor-bridge energy gaps affect the electronic coupling, V(DA), and thus the rates of ET. We present here a unique comparison on how these factors differently influence the rates for CS and CR in a porphyrin-based donor-bridge-acceptor model system. Our system contains three series, each of which focuses on a separate charge-transfer rate-determining factor, the donor-acceptor distance, the donor-bridge energy gap, and last, the influence of the electron acceptor on the rate for charge transfer. In these three series both CS and CR are governed by superexchange interactions which make a CR/CS comparative study ideal. We show here that the exponential distance dependence increases slightly for CR compared to that for CS as a result of the increased tunneling barrier height for this reaction, in accordance with the McConnell superexchange model. We also show that the dependence on the tunneling barrier height is different for CS and CR. This difference is highly dependent on the electron acceptor and thus cannot solely be explained by the differences in the frontier orbitals of the electron donor in these porphyrin systems.     

Rearrangement equations for plutonium

The percents of all oxidation states produced by Pu disproportionation, including unreacted starting material, can be obtained by new equations that are easy to apply. The equations are useful for quantifying the extent and the stoichiometry of disproportionation, the consequences of complexation, and the effects of temperature changes on the composition of the oxidation-state mixture.     

Work integrals for plutonium

Free energy changes in Pu disproportionation reactions can be measured by integrating the reaction isotherm with respect to one of the reaction products. Separate integrations can be made for the isotherms of the component reactions contributing to the equilibrium.Mound is operated for the U.S. Department of Energy by EG&G Mound Applied Technologies Incorporated under contract No. DE-AC04-88DP43495.     

Approaching charge balance in organic light-emitting diodes by tuning charge injection barriers with mixed monolayers

Self-assembled monolayers (SAMs) of binary mixtures of 1-butylphosphonic acid and the trifluoromethyl-terminated analogue (4,4,4-trifluoro-1-butylphosphonic acid) were formed on ITO surfaces to tune the work function of ITO over a range of 5.0 to 5.75 eV by varying the mixing ratio of the two adsorbents. The mixed SAM-modified ITO surfaces were used as the anode in the fabrication of OLED devices with a configuration of ITO/SAM/HTL/Alq3/MX/Al, where HTL was the NPB or BPAPF hole-transporting layer and MX was the LiF or Cs(2)CO(3) injection layer. It was shown that, depending on the HTL or MX used, the maximum device current and the maximum luminance efficiency occurred with anodes of different modifications because of a shift in the point of hole/electron carrier balance. This provides information on the charge balance in the device and points to the direction to improve the performance.     

Surprising coordination for plutonium in the first plutonium(III) borate

The first plutonium(III) borate, Pu(2)[B(12)O(18)(OH)(4)Br(2)(H(2)O)(3)]·0.5H(2)O, has been prepared by reacting plutonium(III) with molten boric acid under strictly anaerobic conditions. This compound contains a three-dimensional polyborate network with triangular holes that house the plutonium(III) sites. The plutonium sites in this compound are 9- and 10-coordinate and display atypical geometries.     

Tuning of charge balance in bipolar host materials for highly efficient solution-processed phosphorescent devices

A novel bipolar host material, which meets the requirements of high triplet energy, good charge carrier transport properties, high solubility, and film-forming ability at the same time, has been designed and synthesized. Utilizing a new compound as host material, high-efficiency solution-processed blue and white phosphorescent organic light-emitting diodes (PHOLEDs) have been achieved.     

Two predominance-region diagrams for plutonium

Two predominance-region diagrams for plutonium are illustrated. One diagram plots the pH vs. the equilibrium fraction of hexavalent plutonium. The other diagram plots the equilibrium fraction of tetravalent plutonium vs. the plutonium oxidation number. Both diagrams define the boundaries of the regions where tri-, tetra-, penta-, and hexavalent plutonium are the predominant species. In each diagram, the two principal triple points are located at the intersections of three predominance-region boundary lines.Los Alamos National Laboratory is operated by the University of California for the U.S. Department of Energy under Contract No. W-7405-ENG-36.     

Triangular predominance-region diagrams for plutonium

Two predominance region diagrams can be prepared by plotting the equilibrium fractions of hexavalent vs. trivalent plutonium. The diagrams are differentiated by the species that predominate near their origins. Both diagrams have a curved boundary that separates permissible from forbidden oxidation-state combinations.     

Work surface for soluble plutonium

Summary A three-dimensional work surface for aqueous plutonium is illustrated. It is constructed by means of estimating work as a function of the ambient pH and redox potential in a plutonium solution. The surface is useful for illustrating the chemistry of disproportionation reactions. Work expressions are easier to use than work integrals.     

General disproportionation equations for plutonium

Disproportionation equations are illustrated for two oxidation numbers (N) and for the general case of any N. The new method illustrates the effect of N on the coefficients in disproportionation equations. An estimate of the equilibrium constant for the first hydrolysis reaction of tetravalent plutonium is obtained by a new approach. The estimated value agrees with many previous results.     

Alpha coefficients for tetravalent plutonium

The complexation of tetravalent plutonium in aqueous solutions derives from several sources including counterions, hydrolysis, additives, and impurities. A quantitative tool accounting for all such effects, known and unknown, is the alpha coefficient. It can be expressed in six ways by means of the equilibrium fractions of two Pu oxidation states.     

Two predominance-region diagrams for plutonium

Two predominance-region diagrams for plutonium are illustrated. One diagram plots the pH vs. the equilibrium fraction of hexavalent plutonium. The other diagram plots the equilibrium fraction of tetravalent plutonium vs. the plutonium oxidation number. Both diagrams define the boundaries of the regions where tri-, tetra-, penta-, and hexavalent plutonium are the predominant species. In each diagram, the two principal triple points are located at the intersections of three predominance-region boundary lines.Los Alamos National Laboratory is operated by the University of California for the U.S. Department of Energy under Contract No. W-7405-ENG-36.     

Charge transfer through DNA triggered by site selective charge injection into adenine

A positive charge, which was injected site selectively into adenine (A) of a DNA double strand, migrates along (A:T)n sequences in a distance independent way.     

Intrinsic predominance region diagram for plutonium

Summary A predominance-region diagram for aqueous plutonium can be prepared by plotting the equilibrium fractions of tetra- and hexavalent plutonium. An example illustrates how the triple points can be used to estimate hydrolysis constants.