热声致冷效应演示实验

基于热声致冷原理,利用自制的热声堆,采用常见的材料和仪器,设计了扬声器驱动热声致冷实验演示装置.以空气作工质,在无冷却措施的情况下,系统运行200 s后,实现了13℃的降温及25℃的温跨.     

电动声源热声致冷机声学和计算实例

我们将各种热声致机简化为一包括声学终端在内的声管道系统，并通过实例讨论了致冷机的声学特性，该管道系统与一般声管道不同：１．在热声堆中热波和粘滞波不可不计。２．在热声堆与声管连接时，必需考虑合成波的体积流；而热声堆内只需考虑传播波的体积流。本文对此提出了阻抗连接条件的修正。实例使用电动扬声器为声源，给出了热声行波和驻波致冷的声学计算方法以及它们的声学特性，所用扬声器的标称伏安为１００ＶＡ，可为热声致     

400W行波热声发电系统的实验研究

本文阐述了为太阳能发电系统设计的400 W行波热声发电系统(TWTAEG)的实验研究过程.实验系统由行波热声发动机和直线发电机组成,系统采用平均压力为3.5 MPa的氦-氩混合气体为工质,其中氩气分压比为1.4%,系统运行频率为74Hz.实验中最大输出电功为446 W,此时的热电效率为13%;在输出电功为416 W时热...     

声致冷和声制冷机

本文介绍声致冷的基本原理、有关的数量关系和美国 ＬｏｓＡｌａｍｏｓ实验室推出的一台实验声制冷样机及其性能。     

新型热声发动机(制冷机)的研究与探索

文中通过分析热声系统的边界条件 ,以及热声系统中工质的声速对整个系统共振频率的影响 ,提出了两套降低系统共振频率 ,减小系统尺寸的方案 ,从而就理论上解决了这一热声领域的难题 ,为热声机的小型化、实用化提供了坚实的理论基础。该理论的计算结果与现有的实验结果相当吻合。     

热声发动机的CFD数值模拟

采用计算流体动力学(CFD)方法,对高频驻波热声发动机和热声斯特林发动机实验系统分别进行了二维和三维数值模拟。计算模型具有与实验系统相同的几何结构、尺寸和运行工况。对计算模型的有效性进行了研究,表明实现有限换热条件的板叠实物模型适合驻波热声发动机的模拟,而实现局域热平衡的多孔介质模型适合热声斯特林发动机的模拟。计算结果成功观测到了非线性的自激振荡演化过程,捕捉到了两种发动机的不同非线性现象。计算结果分别给出了两种热声发动机内部的声场分布特性和复杂流场。计算结果与实验结果的对比验证了CFD方法对高频驻波热声发动机和热声斯特林发动机模拟的有效性。     

热声斯特林发电系统的实验研究

本文介绍了一台由热声斯特林发动机及其驱动的直线发电机组成的热声斯特林发电系统原理样机.一方面为满足发电机与发动机间体积流率和相位的匹配要求,另一方面为了能在直线发电机活塞处获得较好的压力波与体积流率间相位关系、提高直线发电机的电功输出能力,装置保留了发动机原有的锥形谐振管.初步实验以氦气为工质,在2.5MPa平均压力、64Hz工作频率下,获得了97W的电功.本文还分析了该热声发电系统的效率,得出直线发电机声电转换效率超过了0.8.然而由于谐振管耗散了大量的声功,目前整机的热电转换效率还较低.     

非线性热声理论的研究进展

主要总结了热声系统中的非线性热声现象,指出了线性热声理论的不足,回顾了近十年来国内外热声工作者为解释这些非线性现象所做的理论探索,对其发展方向进行了展望.     

负载对热声发动机性能的影响

热声发动机作为一种完全没有运动部件的能量转化和传输机械具有广阔的应用前景.为了提高热声发动机的驱动性能,本文采用变负载法对热声发动机性能的影响因素进行了实验研究.实验结果表明,负载的阻力和容抗对热声发动机的加热温度、压比和声功引出有重要影响.同时,实验中还发现了能够使热声发动机瞬时消振和起振的实验方法,将极大方便对热声发动机的开关控制.     

热声发动机起振行为实验研究

研究了热声发动机起振过程,对Benavides构建的动力学模型的计算方法进行了优化,计算了控制压力、回热器参数和系统频率对热声发动机起振温度的影响。并进行了实验,计算结果与实验结果一致,证明了优化效果。     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Hybrid Wavelength and Code Division Multiple Access in Optical Networks

A review of schemes for multiple access in fiber optic networks shows that a hybrid of wavelength and code division multiple access (WCDMA) combines the best features of both. In particular, the hybrid scheme retains the large information carrying capacity of wavelength division multiple access (WDMA) and flexibility of code division multiple access (CDMA). In this paper WDMA, optical CDMA (OCDMA), and WCDMA networks are discussed. In OCDMA networks, concept of incoherent and coherent coding including inverse decoding and matched filter is introduced. The delay performance of both WDMA and WCDMA networks, under the simple suboptimum access protocols based on cyclic search, is computed. It has been shown quantitatively that tuning delay significantly affects the delay performance of both WDMA and WCDMA networks. Futhermore, delay performance of WCDMA networks is always better than the WDMA networks for the same tuning delay, load, and number of users.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.